Mingzhi Yuan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Mingzhi Yuan has a total of 39 co-authors. Here are the top co-authors by number of shared publications:
Bin Chen
3 shared publications- Xiaoling Zhou
Harbin Institute of Technology
3 shared publications Hongliang Dong
2 shared publications- Lianyang Chen
Xinjiang Polytechnic Institute
2 shared publications - Pan Wang
Harbin Institute of Technology
2 shared publications - Resta Agung Susilo
Center for High Pressure Science and Technology Advanced Research, Shanghai 201203, China
2 shared publications
Latest Publications
- 22 September 2026
- Published by American Physical Society (APS) in Physical Review B
- Vol. 114 (14)
Plastic deformation of MgO under high-pressure cyclic compression
- 22 September 2026
- Published by American Physical Society (APS) in Physical Review B
- Vol. 114 (14)
Plastic deformation of MgO under high-pressure cyclic compression
- Open Access
- 31 March 2026
- Published by Elsevier in Materials Today Communications
- Vol. 52
Size dependence of lattice strain anisotropy in nickel and ceria under non-hydrostatic compression
- 31 March 2026
- Published by Elsevier in Materials Today Communications
- Vol. 52
Open AccessSize dependence of lattice strain anisotropy in nickel and ceria under non-hydrostatic compression
- 2 December 2024
- Published by AIP Publishing in Applied Physics Letters
- Vol. 125 (23)
Irreversible phase transition of the Fe50Mn30Cr10Co10 high entropy alloy under stress
The Fe50Mn30Cr10Co10 high entropy alloy has attracted research interest in recent years due to its ability to overcome the strength-ductility trade-off. A recent study reported that a nanolaminate dual-phase microstructure, derived from the bidirectional transformation of Fe50Mn30Cr10Co10 alloy under stress, might be the main reason for its exceptional mechanical properties. Here, we report a unidirectional and irreversible phase transition from a face-centered-cubic to a hexagonal-close-packed (HCP) structure in the Fe50Mn30Cr10Co10 alloy under stress, using the in situ high-pressure x-ray diffraction method. An almost pure HCP phase is obtained at pressures exceeding 20 GPa. It remains stable in further loading and unloading processes. Transmission electron microscopy analysis indicates that dislocation motion along the {111}⟨11 2¯⟩ slip system results in the irreversible phase transition and the formation of nanolamellar microstructures in the Fe50Mn30Cr10Co10 alloy. Our study provides insights into understanding the deformation mechanism of Fe50Mn30Cr10Co10 alloy and suggests the potential to design the alloy through high-pressure manufacturing.
- 2 December 2024
- Published by AIP Publishing in Applied Physics Letters
- Vol. 125 (23)
Irreversible phase transition of the Fe50Mn30Cr10Co10 high entropy alloy under stress
The Fe50Mn30Cr10Co10 high entropy alloy has attracted research interest in recent years due to its ability to overcome the strength-ductility trade-off. A recent study reported that a nanolaminate dual-phase microstructure, derived from the bidirectional transformation of Fe50Mn30Cr10Co10 alloy under stress, might be the main reason for its exceptional mechanical properties. Here, we report a unidirectional and irreversible phase transition from a face-centered-cubic to a hexagonal-close-packed (HCP) structure in the Fe50Mn30Cr10Co10 alloy under stress, using the in situ high-pressure x-ray diffraction method. An almost pure HCP phase is obtained at pressures exceeding 20 GPa. It remains stable in further loading and unloading processes. Transmission electron microscopy analysis indicates that dislocation motion along the {111}⟨11 2¯⟩ slip system results in the irreversible phase transition and the formation of nanolamellar microstructures in the Fe50Mn30Cr10Co10 alloy. Our study provides insights into understanding the deformation mechanism of Fe50Mn30Cr10Co10 alloy and suggests the potential to design the alloy through high-pressure manufacturing.
- 3 June 2022
- Published by American Physical Society (APS) in Physical Review B
- Vol. 105 (22) , L220101
Deformation of -MgO aggregates: Deviatoric stress as a control on deformation mechanismsDeformation behavior of multiphase aggregates has great significance for materials design and understanding the dynamics of the Earth. Here we studied the deformation of zircon ()-MgO aggregates and found that the introduction of MgO reduced overall deviatoric stress in the aggregates and thus controlled deformation mechanisms of the zircon phase. Zircon primarily deforms by a dominant slip; however, activity of zircon slip increases with the introduction of an increased ratio of MgO into the aggregates, as suggested by the experiments and simulations. We also found both zircon and MgO in the aggregates retained strong deformation texture, which is likely related to the symmetric variants of the dominant slip system of the hard zircon phase. Our results help to clarify the discrepancies in previous studies and understand which phase may dominate the seismic anisotropy in geosciences.- 3 June 2022
- Published by American Physical Society (APS) in Physical Review B
- Vol. 105 (22) , L220101
Deformation of -MgO aggregates: Deviatoric stress as a control on deformation mechanismsDeformation behavior of multiphase aggregates has great significance for materials design and understanding the dynamics of the Earth. Here we studied the deformation of zircon ()-MgO aggregates and found that the introduction of MgO reduced overall deviatoric stress in the aggregates and thus controlled deformation mechanisms of the zircon phase. Zircon primarily deforms by a dominant slip; however, activity of zircon slip increases with the introduction of an increased ratio of MgO into the aggregates, as suggested by the experiments and simulations. We also found both zircon and MgO in the aggregates retained strong deformation texture, which is likely related to the symmetric variants of the dominant slip system of the hard zircon phase. Our results help to clarify the discrepancies in previous studies and understand which phase may dominate the seismic anisotropy in geosciences.- 25 May 2021
- Published by Royal Society of Chemistry (RSC) in CrystEngComm
- Vol. 23 (23) , 4152-4159
Revealing the unusual grain growth of nanoparticles in calcination: oriented attachment in the solid state
The grain size doubling of nickel nanocrystals in calcination reveals that oriented attachment (OA), which generally involves the use of a liquid medium, can occur in solid state as well and dominate the nano-grain coarsening.
- 25 May 2021
- Published by Royal Society of Chemistry (RSC) in CrystEngComm
- Vol. 23 (23) , 4152-4159
Revealing the unusual grain growth of nanoparticles in calcination: oriented attachment in the solid state
The grain size doubling of nickel nanocrystals in calcination reveals that oriented attachment (OA), which generally involves the use of a liquid medium, can occur in solid state as well and dominate the nano-grain coarsening.
- 24 May 2021
- Published by AIP Publishing in Applied Physics Letters
- Vol. 118 (21) , 213101
Fragmentation and structural transitions of few-layer graphene under high shear stress
A key factor that determines the mechanical and electrical performance of graphene-based materials and devices is how graphene behaves under extreme conditions, yet the response of few-layer graphene to high shear stress has not been investigated experimentally. Here we applied high pressure and shear to graphene powder using a rotational diamond anvil cell and studied the recovered sample with multiple means of characterization. Sustaining high pressure and shear, graphene breaks into nanometer-long clusters with generation of large number of defects. At a certain stress level, it transforms to amorphous state and carbon onions. The reduction of infrared reflectivity in the severely sheared phase indicates the decrease in conductivity. Our results unveil the shear sensitive nature of graphene, point out the effects of shear on its physical properties, and provide a potential method to manipulate this promising material.
- 24 May 2021
- Published by AIP Publishing in Applied Physics Letters
- Vol. 118 (21) , 213101
Fragmentation and structural transitions of few-layer graphene under high shear stress
A key factor that determines the mechanical and electrical performance of graphene-based materials and devices is how graphene behaves under extreme conditions, yet the response of few-layer graphene to high shear stress has not been investigated experimentally. Here we applied high pressure and shear to graphene powder using a rotational diamond anvil cell and studied the recovered sample with multiple means of characterization. Sustaining high pressure and shear, graphene breaks into nanometer-long clusters with generation of large number of defects. At a certain stress level, it transforms to amorphous state and carbon onions. The reduction of infrared reflectivity in the severely sheared phase indicates the decrease in conductivity. Our results unveil the shear sensitive nature of graphene, point out the effects of shear on its physical properties, and provide a potential method to manipulate this promising material.