Osama. M. Hemeda
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Osama. M. Hemeda has a total of 133 co-authors. Here are the top co-authors by number of shared publications:
A. Tawfik
Tanta University
20 shared publications- Mahmoud Aly Hamad
Basic Science Department-Higher Institute of Engineering and Technology, Alexandria, Egypt
19 shared publications - Ahmed Henaish
Physics Department, Faculty of Science, Tanta University, Tanta, Egypt
10 shared publications - Adly H. El Sayed
Alexandria University
8 shared publications T. Sharshar
Physics Department, Faculty of Science, Kafrelsheikh University, Kafr El-Sheikh, Egypt
8 shared publicationsD.M. Hemeda
6 shared publications
Latest Publications
- 17 January 2024
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 53 (4) , 1738-1751
Interplay Between Structural and Magnetic Properties and Positron Annihilation Studies for Mn-Zn Nano-Ferrites
- 17 January 2024
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 53 (4) , 1738-1751
Interplay Between Structural and Magnetic Properties and Positron Annihilation Studies for Mn-Zn Nano-Ferrites
- Open Access
- 22 March 2022
- Published by MDPI AG in Nanomaterials
- Vol. 12 (7) , 1045
Structure, Morphology and Electrical/Magnetic Properties of Ni-Mg Nano-Ferrites from a New Perspective
Using the auto combustion flash method, (x = 0, 0.2, 0.6, 0.8 and 1) nano-ferrites were synthesized. All samples were thermally treated at 973 K for 3 h. The structural analysis for the synthesized samples was performed using XRD, high-resolution transmission electron microscopy (HRTEM), and FTIR. Scanning electron microscopy (SEM) was undertaken to explore the surface morphology of all the samples. The thermal stability of these samples was investigated using thermogravimetric analysis (TGA). XRD data show the presence of a single spinel phase for all the prepared samples. The intensity of the principal peak of the spinel phase decreases as Mg content increases, showing that Mg delays crystallinity. The Mg content raised the average grain size (D) from 0.084 μm to 0.1365 μm. TGA shows two stages of weight loss variation. The vibrating sample magnetometer (VSM) measurement shows that magnetic parameters, such as initial permeability (μi) and saturation magnetization (Ms), decay with rising Mg content. The permeability and magnetic anisotropy at different frequencies and temperatures were studied to show the samples’ magnetic behavior and determine the Curie temperature (TC), which depends on the internal structure. The electrical resistivity behavior shows the semi-conductivity trend of the samples. Finally, the dielectric constant increases sharply at high temperatures, explained by the increased mobility of charge carriers, and decreases with increasing frequency.- 22 March 2022
- Published by MDPI AG in Nanomaterials
- Vol. 12 (7) , 1045
Open AccessStructure, Morphology and Electrical/Magnetic Properties of Ni-Mg Nano-Ferrites from a New Perspective
Using the auto combustion flash method, (x = 0, 0.2, 0.6, 0.8 and 1) nano-ferrites were synthesized. All samples were thermally treated at 973 K for 3 h. The structural analysis for the synthesized samples was performed using XRD, high-resolution transmission electron microscopy (HRTEM), and FTIR. Scanning electron microscopy (SEM) was undertaken to explore the surface morphology of all the samples. The thermal stability of these samples was investigated using thermogravimetric analysis (TGA). XRD data show the presence of a single spinel phase for all the prepared samples. The intensity of the principal peak of the spinel phase decreases as Mg content increases, showing that Mg delays crystallinity. The Mg content raised the average grain size (D) from 0.084 μm to 0.1365 μm. TGA shows two stages of weight loss variation. The vibrating sample magnetometer (VSM) measurement shows that magnetic parameters, such as initial permeability (μi) and saturation magnetization (Ms), decay with rising Mg content. The permeability and magnetic anisotropy at different frequencies and temperatures were studied to show the samples’ magnetic behavior and determine the Curie temperature (TC), which depends on the internal structure. The electrical resistivity behavior shows the semi-conductivity trend of the samples. Finally, the dielectric constant increases sharply at high temperatures, explained by the increased mobility of charge carriers, and decreases with increasing frequency. - 1 January 2021
- Published by Elsevier in Journal of Physics and Chemistry of Solids
- Vol. 148, 109688
Synthesis of nanometer-sized PbZr Ti1-O3 for gamma-ray attenuation
- 1 January 2021
- Published by Elsevier in Journal of Physics and Chemistry of Solids
- Vol. 148, 109688
Synthesis of nanometer-sized PbZr Ti1-O3 for gamma-ray attenuation
- 8 September 2020
- Published by Springer Nature in Journal of Inorganic and Organometallic Polymers and Materials
- Vol. 31 (2) , 731-740
Synthesis, Electric and Magnetic Characterization of Nickel Ferrite/PANI Nano-Composite Prepared by Flash Auto Combustion Method
- 8 September 2020
- Published by Springer Nature in Journal of Inorganic and Organometallic Polymers and Materials
- Vol. 31 (2) , 731-740
Synthesis, Electric and Magnetic Characterization of Nickel Ferrite/PANI Nano-Composite Prepared by Flash Auto Combustion Method
- 16 May 2020
- Published by Springer Nature in Journal of Superconductivity and Novel Magnetism
- Vol. 33 (9) , 2753-2757
Investigations on Enhancing Thermomagnetic Properties in CoxZn1−xFe2O4
- 16 May 2020
- Published by Springer Nature in Journal of Superconductivity and Novel Magnetism
- Vol. 33 (9) , 2753-2757
Investigations on Enhancing Thermomagnetic Properties in CoxZn1−xFe2O4
- 6 May 2020
- Published by Springer Nature in Journal of Superconductivity and Novel Magnetism
- Vol. 33 (8) , 2521-2525
The Simulated Magnetocaloric Properties for Ni0.5Cu0.25Zn0.25Fe2O4 Nanoferrites
- 6 May 2020
- Published by Springer Nature in Journal of Superconductivity and Novel Magnetism
- Vol. 33 (8) , 2521-2525
The Simulated Magnetocaloric Properties for Ni0.5Cu0.25Zn0.25Fe2O4 Nanoferrites
- 3 May 2020
- Published by Taylor & Francis in Phase Transitions
- Vol. 93 (5) , 470-490
Improvement of magnetic and dielectric properties of magnetoelectric BST-NCZMF nano-composite
A series of composite “BST”+ “NCZMF” were prepared using high energy ball milling method. The structural characterization for synthesized samples were carried out using (XRD), (FTIR) and (HRTEM). The surface morphology of BST at different ferrite content (x%) was studied by (SEM). XRD pattern confirms that both parent phases BST and spinel NCZMF are pure phases. The sample x = 40% has the highest value of tetragonality factor which may be candidate for ME application and piezoelectric sensors. For the sample x = 40% the second stage is shifted to higher temperature which confirms that the thermal stability of the sample is increased by increasing the ferrite content for this sample. The EDX has been utilized to confirm the grains of these two phases. FTIR show the successful formation of composite samples which is also observed from XRD pattern. The hysteresis loops show low coercive field (Hc) indicating that our composite are soft magnetic material. The permeability of nanocomposite samples were measured as a function of temperature in the range from 300 to 700 K at constant frequencies 1KHZ and 10KHZ. Magnetoelectric coefficient decreases with increasing magnetic field for all composite samples at higher magnetic field the magnetoelectric coefficient get saturated producing constant ΔE / ΔH. the dielectric loss decrease by increasing frequency, this means that our composite samples can be used at higher frequency with low dielectric loss.
- 3 May 2020
- Published by Taylor & Francis in Phase Transitions
- Vol. 93 (5) , 470-490
Improvement of magnetic and dielectric properties of magnetoelectric BST-NCZMF nano-composite
A series of composite “BST”+ “NCZMF” were prepared using high energy ball milling method. The structural characterization for synthesized samples were carried out using (XRD), (FTIR) and (HRTEM). The surface morphology of BST at different ferrite content (x%) was studied by (SEM). XRD pattern confirms that both parent phases BST and spinel NCZMF are pure phases. The sample x = 40% has the highest value of tetragonality factor which may be candidate for ME application and piezoelectric sensors. For the sample x = 40% the second stage is shifted to higher temperature which confirms that the thermal stability of the sample is increased by increasing the ferrite content for this sample. The EDX has been utilized to confirm the grains of these two phases. FTIR show the successful formation of composite samples which is also observed from XRD pattern. The hysteresis loops show low coercive field (Hc) indicating that our composite are soft magnetic material. The permeability of nanocomposite samples were measured as a function of temperature in the range from 300 to 700 K at constant frequencies 1KHZ and 10KHZ. Magnetoelectric coefficient decreases with increasing magnetic field for all composite samples at higher magnetic field the magnetoelectric coefficient get saturated producing constant ΔE / ΔH. the dielectric loss decrease by increasing frequency, this means that our composite samples can be used at higher frequency with low dielectric loss.
- Open Access
- 1 May 2020
- Published by Elsevier in Journal of Materials Research and Technology
- Vol. 9 (3) , 2934-2945
Preparation, characterization, and thermal conductivity of polyvinyl-formaldehyde/MWCNTs foam: A low cost heat sink substrate
- 1 May 2020
- Published by Elsevier in Journal of Materials Research and Technology
- Vol. 9 (3) , 2934-2945
Open AccessPreparation, characterization, and thermal conductivity of polyvinyl-formaldehyde/MWCNTs foam: A low cost heat sink substrate
- 17 April 2020
- Published by Springer Nature in Applied Nanoscience
- Vol. 10 (7) , 2315-2327
Influence of PbO phase content on structural and optical properties of PZT nanopowders
- 17 April 2020
- Published by Springer Nature in Applied Nanoscience
- Vol. 10 (7) , 2315-2327
Influence of PbO phase content on structural and optical properties of PZT nanopowders
- 31 January 2020
- Published by Springer Nature in Applied Physics A
- Vol. 126 (2) , 1-9
Electrical properties and positron annihilation studies of nano-crystalline CoLaxFe2−xO4 prepared by ceramic method
- 31 January 2020
- Published by Springer Nature in Applied Physics A
- Vol. 126 (2) , 1-9
Electrical properties and positron annihilation studies of nano-crystalline CoLaxFe2−xO4 prepared by ceramic method