Laura M. Thoma
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Laura M. Thoma has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
- Kenichi Kuroda
Department of Biologic and Materials Sciences & Prosthodontics, School of Dentistry, University of Michigan, Ann Arbor, MI 48109, USA
3 shared publications - Edmund F. Palermo
Rensselaer Polytechnic Institute
2 shared publications - Blaise R. Boles
Department of Molecular, Cellular, and Developmental Biology, University of Michigan, Ann Arbor, Michigan, United States of America
1 shared publication Carly R. Dukart
University of Minnesota, Morris
1 shared publicationDavid L. Hermanson
Univ Minnesota, Div Sci & Math, Morris, MN 56267 USA
1 shared publication- Demetrio Antonio da Silva Filho
Institute of Physics, University of Brasília, Brasília, Brazil
1 shared publication
Latest Publications
- Open Access
- 10 July 2014
- Published by American Chemical Society (ACS) in Biomacromolecules
- Vol. 15 (8) , 2933-2943
Cationic Methacrylate Polymers as Topical Antimicrobial Agents against Staphylococcus aureus Nasal Colonization
The in vitro and in vivo antimicrobial activity of primary ammonium ethyl methacrylate homopolymers (AEMPs) was investigated. AEMPs with different degrees of polymerization (DP = 7.7–12) were prepared by reversible addition–fragmentation chain-transfer (RAFT) polymerization. The AEMPs showed higher inhibitory effects against Gram-positive bacteria, including methicillin-resistant Staphylococcus aureus (MRSA), than Gram-negative bacteria. The AEMPs also showed potent anti-S. aureus activity in the presence of fetal bovine serum, whereas the activity of the antibiotic mupirocin was reduced under the same conditions. The AEMPs showed very little or no hemolytic activity. The cytotoxicity of AEMPs against mammalian cells HEp-2 and COS-7 was concentration-dependent, and the cell viability significantly decreased at higher polymer concentrations. The AEMPs significantly reduced the number of viable S. aureus cells in the nasal environment of cotton rats when compared to that of the control. This study demonstrates that AEMPs have potential for use in treating topical S. aureus infections.
- 10 July 2014
- Published by American Chemical Society (ACS) in Biomacromolecules
- Vol. 15 (8) , 2933-2943
Open AccessCationic Methacrylate Polymers as Topical Antimicrobial Agents against Staphylococcus aureus Nasal Colonization
The in vitro and in vivo antimicrobial activity of primary ammonium ethyl methacrylate homopolymers (AEMPs) was investigated. AEMPs with different degrees of polymerization (DP = 7.7–12) were prepared by reversible addition–fragmentation chain-transfer (RAFT) polymerization. The AEMPs showed higher inhibitory effects against Gram-positive bacteria, including methicillin-resistant Staphylococcus aureus (MRSA), than Gram-negative bacteria. The AEMPs also showed potent anti-S. aureus activity in the presence of fetal bovine serum, whereas the activity of the antibiotic mupirocin was reduced under the same conditions. The AEMPs showed very little or no hemolytic activity. The cytotoxicity of AEMPs against mammalian cells HEp-2 and COS-7 was concentration-dependent, and the cell viability significantly decreased at higher polymer concentrations. The AEMPs significantly reduced the number of viable S. aureus cells in the nasal environment of cotton rats when compared to that of the control. This study demonstrates that AEMPs have potential for use in treating topical S. aureus infections.
- 24 April 2012
- Published by American Chemical Society (ACS) in Biomacromolecules
- Vol. 13 (5) , 1554-1563
Design and Synthesis of Self-Degradable Antibacterial Polymers by Simultaneous Chain- and Step-Growth Radical Copolymerization
Self-degradable antimicrobial copolymers bearing cationic side chains and main-chain ester linkages were synthesized using the simultaneous chain- and step-growth radical polymerization of t-butyl acrylate and 3-butenyl 2-chloropropionate, followed by the transformation of t-butyl groups into primary ammonium salts. We prepared a series of copolymers with different structural features in terms of molecular weight, monomer composition, amine functionality, and side chain structures to examine the effect of polymer properties on their antimicrobial and hemolytic activities. The acrylate copolymers containing primary amine side chains displayed moderate antimicrobial activity against E. coli but were relatively hemolytic. The acrylate copolymer with quaternary ammonium groups and the acrylamide copolymers showed low or no antimicrobial and hemolytic activities. An acrylate copolymer with primary amine side chains degraded to lower molecular weight oligomers with lower antimicrobial activity in aqueous solution. This degradation was due to amidation of the ester groups of the polymer chains by the nucleophilic addition of primary amine groups in the side chains resulting in cleavage of the polymer main chain. The degradation mechanism was studied in detail by model reactions between amine compounds and precursor copolymers.
- 24 April 2012
- Published by American Chemical Society (ACS) in Biomacromolecules
- Vol. 13 (5) , 1554-1563
Design and Synthesis of Self-Degradable Antibacterial Polymers by Simultaneous Chain- and Step-Growth Radical Copolymerization
Self-degradable antimicrobial copolymers bearing cationic side chains and main-chain ester linkages were synthesized using the simultaneous chain- and step-growth radical polymerization of t-butyl acrylate and 3-butenyl 2-chloropropionate, followed by the transformation of t-butyl groups into primary ammonium salts. We prepared a series of copolymers with different structural features in terms of molecular weight, monomer composition, amine functionality, and side chain structures to examine the effect of polymer properties on their antimicrobial and hemolytic activities. The acrylate copolymers containing primary amine side chains displayed moderate antimicrobial activity against E. coli but were relatively hemolytic. The acrylate copolymer with quaternary ammonium groups and the acrylamide copolymers showed low or no antimicrobial and hemolytic activities. An acrylate copolymer with primary amine side chains degraded to lower molecular weight oligomers with lower antimicrobial activity in aqueous solution. This degradation was due to amidation of the ester groups of the polymer chains by the nucleophilic addition of primary amine groups in the side chains resulting in cleavage of the polymer main chain. The degradation mechanism was studied in detail by model reactions between amine compounds and precursor copolymers.
- 17 December 2010
- Published by American Chemical Society (ACS) in Biomacromolecules
- Vol. 12 (1) , 260-268
Mechanism of Polymer-Induced Hemolysis: Nanosized Pore Formation and Osmotic Lysis
Hemolysis induced by antimicrobial polymers was examined to gain an understanding of the mechanism of polymer toxicity to human cells. A series of cationic amphiphilic methacrylate random copolymers containing primary ammonium groups as the cationic functionality and either butyl or methyl groups as hydrophobic side chains have been prepared by radical copolymerization. Polymers with 0−47 mol % methyl groups in the side chains, relative to the total number of monomeric units, showed antimicrobial activity but no hemolysis. The polymers with 65 mol % methyl groups or 27 mol % butyl groups displayed both antimicrobial and hemolytic activity. These polymers induced leakage of the fluorescent dye calcein trapped in human red blood cells (RBCs), exhibiting the same dose−response curves as for hemoglobin leakage. The percentage of disappeared RBCs after hemolysis increased in direct proportion to the hemolysis percentage, indicating complete release of hemoglobin from fractions of RBCs (all-or-none leakage) rather than partial release from all cells (graded leakage). An osmoprotection assay using poly(ethylene glycol)s (PEGs) as osmolytes indicated that the PEGs with MW > 600 provided protection against hemolysis while low molecular weight PEGs and sucrose had no significant effect on the hemolytic activity of polymers. Accordingly, we propose the mechanism of polymer-induced hemolysis is that the polymers produce nanosized pores in the cell membranes of RBCs, causing an influx of small solutes into the cells and leading to colloid-osmotic lysis.
- 17 December 2010
- Published by American Chemical Society (ACS) in Biomacromolecules
- Vol. 12 (1) , 260-268
Mechanism of Polymer-Induced Hemolysis: Nanosized Pore Formation and Osmotic Lysis
Hemolysis induced by antimicrobial polymers was examined to gain an understanding of the mechanism of polymer toxicity to human cells. A series of cationic amphiphilic methacrylate random copolymers containing primary ammonium groups as the cationic functionality and either butyl or methyl groups as hydrophobic side chains have been prepared by radical copolymerization. Polymers with 0−47 mol % methyl groups in the side chains, relative to the total number of monomeric units, showed antimicrobial activity but no hemolysis. The polymers with 65 mol % methyl groups or 27 mol % butyl groups displayed both antimicrobial and hemolytic activity. These polymers induced leakage of the fluorescent dye calcein trapped in human red blood cells (RBCs), exhibiting the same dose−response curves as for hemoglobin leakage. The percentage of disappeared RBCs after hemolysis increased in direct proportion to the hemolysis percentage, indicating complete release of hemoglobin from fractions of RBCs (all-or-none leakage) rather than partial release from all cells (graded leakage). An osmoprotection assay using poly(ethylene glycol)s (PEGs) as osmolytes indicated that the PEGs with MW > 600 provided protection against hemolysis while low molecular weight PEGs and sucrose had no significant effect on the hemolytic activity of polymers. Accordingly, we propose the mechanism of polymer-induced hemolysis is that the polymers produce nanosized pores in the cell membranes of RBCs, causing an influx of small solutes into the cells and leading to colloid-osmotic lysis.
- 13 April 2010
- Published by American Chemical Society (ACS) in Journal of Chemical Education
- Vol. 87 (5) , 522-525
Regiochemistry of Poly(3-hexylthiophene): Synthesis and Investigation of a Conducting Polymer
- 13 April 2010
- Published by American Chemical Society (ACS) in Journal of Chemical Education
- Vol. 87 (5) , 522-525
Regiochemistry of Poly(3-hexylthiophene): Synthesis and Investigation of a Conducting Polymer
- 29 August 2009
- Published by The Electrochemical Society in ECS Transactions
- Vol. 16 (49) , 89-93
Wind to Ammonia: Electrochemical Processes in Room Temperature Ionic Liquids
In this project, an alternative approach to synthesize ammonia electrochemically from wind energy, nitrogen gas, and ethanol is reported. Initial electrolyses have been attempted using room temperature ionic liquids (RTILs) as the electrolyte solvent in the presence of lithium ions. Bis(trifluoromethanesulfonyl)imide salts of 1-Ethyl-3-methylimidizolium (EMI-TFSI) and 1-Butyl-1-methylpyrrolidinium (PYR14-TFSI) were tested in this investigation. These results are compared to the use of tetrahydrofuran as the solvent. The data suggests EMI-TFSI is not an appropriate ionic liquid for the lithium mediated reduction of N2, whereas the increased electrochemical stability of PYR14-TFSI offers greater promise. Current efficiencies (3.8%) for NH3 formation in THF are consistently higher than PYR14-TFSI at atmospheric temperatures and pressures. The amount of ammonia synthesized was quantified by performing the Berthelot reaction.
- 29 August 2009
- Published by The Electrochemical Society in ECS Transactions
- Vol. 16 (49) , 89-93
Wind to Ammonia: Electrochemical Processes in Room Temperature Ionic Liquids
In this project, an alternative approach to synthesize ammonia electrochemically from wind energy, nitrogen gas, and ethanol is reported. Initial electrolyses have been attempted using room temperature ionic liquids (RTILs) as the electrolyte solvent in the presence of lithium ions. Bis(trifluoromethanesulfonyl)imide salts of 1-Ethyl-3-methylimidizolium (EMI-TFSI) and 1-Butyl-1-methylpyrrolidinium (PYR14-TFSI) were tested in this investigation. These results are compared to the use of tetrahydrofuran as the solvent. The data suggests EMI-TFSI is not an appropriate ionic liquid for the lithium mediated reduction of N2, whereas the increased electrochemical stability of PYR14-TFSI offers greater promise. Current efficiencies (3.8%) for NH3 formation in THF are consistently higher than PYR14-TFSI at atmospheric temperatures and pressures. The amount of ammonia synthesized was quantified by performing the Berthelot reaction.