Gabriel Pereira das Neves
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Gabriel Pereira das Neves has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Bruno Augusto Angelico
Department of Telecommunications and Control Engineering, Escola Politcnica, University of So Paulo, So Paulo, Brazil
5 shared publications - Ricardo Coração de Leão Fontoura de Oliveira
Faculdade de Engenharia Eltrica e de Computao, Universidade Estadual de Campinas (UNICAMP), Campinas, Brazil
3 shared publications Bruno Augusto Angélico
Telecommunication and Control Engineering Department, Escola Politécnica University of São Paulo São Paulo Brazil
1 shared publication- Bruno Augusto Angélico
Laboratory of Control and Automation (LCA), Telecommunications and Control Engineering Department (PTC), Escola Politécnica (EP), Universidade de São Paulo (USP), São Paulo, Brazil
1 shared publication - Claudio Garcia
Escola Politécnica of the University of São Paulo, São Paulo, SP, Brazil
1 shared publication - José Roberto Castilho Piqueira
University of São Paulo
1 shared publication
Latest Publications
- 19 November 2024
- Published by Springer Nature in Journal of Control, Automation and Electrical Systems
- Vol. 36 (1) , 1-8
Model-Free Sliding Mode Control Applied to a Gyroscope System
- 19 November 2024
- Published by Springer Nature in Journal of Control, Automation and Electrical Systems
- Vol. 36 (1) , 1-8
Model-Free Sliding Mode Control Applied to a Gyroscope System
- 27 September 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE/ASME Transactions on Mechatronics
- Vol. 30 (4) , 2756-2765
Quasi-LPV Modeling and $H_\infty$ Gain-Scheduled State-Feedback Control Applied to a Control Moment GyroscopeThis article presents two contributions for addressing continuous-time linear parameter-varying (LPV) systems with parameters characterized by bounded variation rates. The first contribution introduces a novel procedure for designing a polynomial quasi-LPV model applicable to a class of nonlinear systems. This method takes into account multiple operating conditions and yields a quasi-LPV model suitable for addressing tracking problems without the need for the inclusion of integrators. The second contribution proposes a novel $\mathcal {H}_\infty$ gain-scheduled state-feedback design condition. This technique is formulated using linear matrix inequalities in conjunction with a search for a bounded scalar parameter, which is beneficial for obtaining controllers that offer improved performance. Both the modeling and control design strategies are validated through practical applications involving a control moment gyroscope.
- 27 September 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE/ASME Transactions on Mechatronics
- Vol. 30 (4) , 2756-2765
Quasi-LPV Modeling and $H_\infty$ Gain-Scheduled State-Feedback Control Applied to a Control Moment GyroscopeThis article presents two contributions for addressing continuous-time linear parameter-varying (LPV) systems with parameters characterized by bounded variation rates. The first contribution introduces a novel procedure for designing a polynomial quasi-LPV model applicable to a class of nonlinear systems. This method takes into account multiple operating conditions and yields a quasi-LPV model suitable for addressing tracking problems without the need for the inclusion of integrators. The second contribution proposes a novel $\mathcal {H}_\infty$ gain-scheduled state-feedback design condition. This technique is formulated using linear matrix inequalities in conjunction with a search for a bounded scalar parameter, which is beneficial for obtaining controllers that offer improved performance. Both the modeling and control design strategies are validated through practical applications involving a control moment gyroscope.
- 21 November 2022
- Published by Elsevier in Mechatronics
- Vol. 89
gain-scheduled state-feedback design with experimental validation in a control moment gyroscope represented as a polynomial LPV model- 21 November 2022
- Published by Elsevier in Mechatronics
- Vol. 89
gain-scheduled state-feedback design with experimental validation in a control moment gyroscope represented as a polynomial LPV model- 25 May 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 777-782
A discrete LQR applied to a self-balancing reaction wheel unicycle: Modeling, construction and control
This work presents the modeling, construction and control of a self-balancing unicycle assisted by reaction wheel. It is a nonlinear, unstable and multivariable system. A useful model is presented, based on the Lagrangian mechanics. Construction steps are explicitly described and some implementation aspects, regarding the reaction wheel actuator limitation, are highlighted. A discrete-time LQR controller is validated in simulation and in practical tests with the real system.
- 25 May 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 777-782
A discrete LQR applied to a self-balancing reaction wheel unicycle: Modeling, construction and control
This work presents the modeling, construction and control of a self-balancing unicycle assisted by reaction wheel. It is a nonlinear, unstable and multivariable system. A useful model is presented, based on the Lagrangian mechanics. Construction steps are explicitly described and some implementation aspects, regarding the reaction wheel actuator limitation, are highlighted. A discrete-time LQR controller is validated in simulation and in practical tests with the real system.
- Open Access
- 25 May 2021
- Published by Wiley in Asian Journal of Control
- Vol. 24 (4) , 1575-1584
Model‐free control of mechatronic systems based on algebraic estimation
This paper presents the practical application of a class of model‐free control considering the algebraic estimation approach. Two mechatronic systems are considered: a reaction wheel inverted pendulum (RWIP) and a two degree‐of‐freedom (2‐DOF) helicopter. For the RWIP, since it is under‐actuated, it is proposed a modified ultra‐local model including a feedback of the reaction wheel velocity, and then, the algebraic estimator obtains the parameters of this ultra‐local model around the unstable equilibrium point. For the 2‐DOF helicopter, the ultra‐local model is estimated during a tracking task in a wide range of operation. Some insights on how to choose the fixed parameters of controller are presented. Simulation and practical results corroborate the efficiency of the method, without needing any information on the systems' dynamics.
- 25 May 2021
- Published by Wiley in Asian Journal of Control
- Vol. 24 (4) , 1575-1584
Open AccessModel‐free control of mechatronic systems based on algebraic estimation
This paper presents the practical application of a class of model‐free control considering the algebraic estimation approach. Two mechatronic systems are considered: a reaction wheel inverted pendulum (RWIP) and a two degree‐of‐freedom (2‐DOF) helicopter. For the RWIP, since it is under‐actuated, it is proposed a modified ultra‐local model including a feedback of the reaction wheel velocity, and then, the algebraic estimator obtains the parameters of this ultra‐local model around the unstable equilibrium point. For the 2‐DOF helicopter, the ultra‐local model is estimated during a tracking task in a wide range of operation. Some insights on how to choose the fixed parameters of controller are presented. Simulation and practical results corroborate the efficiency of the method, without needing any information on the systems' dynamics.
- Open Access
- 1 January 2021
- Published by SWGE Sistemas Ltda in Procedings Do Xv Simpósio Brasileiro de Automação Inteligente
- Vol. 1 (1)
Direct Extremum-Seeking Control applied to a quadruple tank system
This article presents a model-free control technique based on an extremum seeking control algorithm (ESC). The idea is to use ESC as a direct controller to minimize the quadratic error. Considering that it is possible to minimize the error to zero, it is then possible to track a reference. In addition, the technique can guarantee operation for different points of application, as well as for time-varying parameters. This technique was tested, through simulations, in a quadruple tank system.
- 1 January 2021
- Published by SWGE Sistemas Ltda in Procedings Do Xv Simpósio Brasileiro de Automação Inteligente
- Vol. 1 (1)
Open AccessDirect Extremum-Seeking Control applied to a quadruple tank system
This article presents a model-free control technique based on an extremum seeking control algorithm (ESC). The idea is to use ESC as a direct controller to minimize the quadratic error. Considering that it is possible to minimize the error to zero, it is then possible to track a reference. In addition, the technique can guarantee operation for different points of application, as well as for time-varying parameters. This technique was tested, through simulations, in a quadruple tank system.
- Open Access
- 7 December 2020
- Published by Sociedade Brasileira de Automatica
- Vol. 2 (1)
H2 gain-scheduled state-feedback synthesis conditions applied to a quadruple tank system
This article presents design conditions for controllers with polynomial dependence on the parameters for LPV systems.The technique is used to solve the problem of controlling a quadruple tank considering variations in valve opening. First, the nonlinear modeling of the system is presented as well with an analysis of its characteristics, and then an approximation to the dynamics is proposed in terms of a pure LPV polynomial model. As a main contribution, a sufficient condition based on LMIs is proposed for the design of scheduled controllers by state feedback with performance criterion based on the H2 norm. The design condition is general in the sense of treating LPV models with an arbitrary number of parameters and degree of polynomial dependence. Simulation in three distinct scenarios are presented to illustrate the design methodology and the quality of the controller designed for the quadruple tank.
- 7 December 2020
- Published by Sociedade Brasileira de Automatica
- Vol. 2 (1)
Open AccessH2 gain-scheduled state-feedback synthesis conditions applied to a quadruple tank system
This article presents design conditions for controllers with polynomial dependence on the parameters for LPV systems.The technique is used to solve the problem of controlling a quadruple tank considering variations in valve opening. First, the nonlinear modeling of the system is presented as well with an analysis of its characteristics, and then an approximation to the dynamics is proposed in terms of a pure LPV polynomial model. As a main contribution, a sufficient condition based on LMIs is proposed for the design of scheduled controllers by state feedback with performance criterion based on the H2 norm. The design condition is general in the sense of treating LPV models with an arbitrary number of parameters and degree of polynomial dependence. Simulation in three distinct scenarios are presented to illustrate the design methodology and the quality of the controller designed for the quadruple tank.