Pezhman Fazeli Dehkordi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Pezhman Fazeli Dehkordi has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
- Mahmoud Ghazavi
Faculty of Civil Engineering, K. N. Toosi University of Technology, Tehran, Iran
3 shared publications - Afsaneh Fakhar
Department of Chemical Engineering Isfahan University of Technology Isfahan Iran
2 shared publications Alireza Mirabolghasemi Dehkordi
2 shared publications- Azadeh Alaei
Department of Civil Engineering, Qom University, Qom, Iran
2 shared publications Gholamreza Keyvani Hafshejani
2 shared publicationsMahmoud Ghazavi
Professor, Faculty of Civil Engineering, K.N. Toosi Univ. of Technology, Tehran 19967-15433, Iran
2 shared publications
Latest Publications
- Open Access
- 24 September 2026
- Published by Elsevier in Results in Engineering
- Vol. 32
Seismic performance of adjacent square footings on three-dimensional polymer geocell-reinforced sand
- 24 September 2026
- Published by Elsevier in Results in Engineering
- Vol. 32
Open AccessSeismic performance of adjacent square footings on three-dimensional polymer geocell-reinforced sand
- 21 September 2026
- Published by Springer Nature in Innovative Infrastructure Solutions
- Vol. 11 (10) , 585
Performance-based seismic design of steel plate shear walls using the endurance time method
- 21 September 2026
- Published by Springer Nature in Innovative Infrastructure Solutions
- Vol. 11 (10) , 585
Performance-based seismic design of steel plate shear walls using the endurance time method
- Open Access
- 27 June 2026
- Published by Elsevier in SSRN Electronic Journal
Seismic Response of Adjacent Square Footings Seated on 3D-Reinforced Polymer Composite
The Seismic behaviour and failure mechanism of two interference rigid rough identical square foundations supported by 3D-reinforced polymer composites (RPCs) are investigated using Abaqus 3D software. The study evaluates the change in seismic bearing pressure, tilt, efficiency factor, variation in displacement amplitude, and improvement in soil dynamic characteristics of the foundations as a function of the spacing ratio (Δ/B) between them. The RPC is modelled in its actual form, embedded in a sand bed, while the soil medium is assumed to follow the Mohr-Coulomb yield criteria. The results demonstrate that the use of RPC significantly reduces displacement amplitude, the tilt, and the propagation zone of vibration. The efficiency factor of settlement is found to be highest at Δ=0.5B, with negligible interference effects, and the foundations exhibit independent behaviour at Δ=3B.
- 27 June 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessSeismic Response of Adjacent Square Footings Seated on 3D-Reinforced Polymer Composite
The Seismic behaviour and failure mechanism of two interference rigid rough identical square foundations supported by 3D-reinforced polymer composites (RPCs) are investigated using Abaqus 3D software. The study evaluates the change in seismic bearing pressure, tilt, efficiency factor, variation in displacement amplitude, and improvement in soil dynamic characteristics of the foundations as a function of the spacing ratio (Δ/B) between them. The RPC is modelled in its actual form, embedded in a sand bed, while the soil medium is assumed to follow the Mohr-Coulomb yield criteria. The results demonstrate that the use of RPC significantly reduces displacement amplitude, the tilt, and the propagation zone of vibration. The efficiency factor of settlement is found to be highest at Δ=0.5B, with negligible interference effects, and the foundations exhibit independent behaviour at Δ=3B.
- 29 July 2025
- Published by Springer Nature in Iranian Journal of Science and Technology, Transactions of Civil Engineering
- Vol. 50 (3) , 2893-2909
Seismic Behavior of Steel Frames Surrounded by Basement Shear Walls Using Spectral Equations Solution
- 29 July 2025
- Published by Springer Nature in Iranian Journal of Science and Technology, Transactions of Civil Engineering
- Vol. 50 (3) , 2893-2909
Seismic Behavior of Steel Frames Surrounded by Basement Shear Walls Using Spectral Equations Solution
- 14 July 2023
- Published by Springer Nature in Arabian Journal for Science and Engineering
- Vol. 49 (1) , 1-25
Interacting Footings on Geo-Reinforced Soils: A State-of-the-Art Review
- 14 July 2023
- Published by Springer Nature in Arabian Journal for Science and Engineering
- Vol. 49 (1) , 1-25
Interacting Footings on Geo-Reinforced Soils: A State-of-the-Art Review
- 1 August 2021
- Published by American Society of Civil Engineers (ASCE) in International Journal of Geomechanics
- Vol. 21 (8) , 04021145
Stochastic Analysis for Bearing Capacity Determination of Shallow Foundations on Thin-Tilted Anisotropic Soils
The soil stratum is heterogeneous and may be tilted with significant influence on the footing bearing capacity (BC). In this paper, a combination of influence of the anisotropy orientation and thickness of soil layer and rock stratum inclination on the BC of strip footings was evaluated using a random finite-difference method (RFDM). The Monte Carlo simulation (MCS) approach was used to elucidate the effect of spatial variability, and soil strength characteristics were assumed as log-normal and bounded random fields. The failure mechanism and produced shear strain in probabilistic method were compared to those obtained from deterministic analysis. The results showed that the soil stratum inclination has a significant effect on the footing BC magnitude, which reaches a minimum value when the deposition orientation is 45°−ϕ/2 with the horizontal direction (ϕ = soil friction angle). Parametric studies were performed on the variability level of strength parameters, the correlation coefficient of strength characteristics, correlation length, soil layer thickness, and stratification orientation.
- 1 August 2021
- Published by American Society of Civil Engineers (ASCE) in International Journal of Geomechanics
- Vol. 21 (8) , 04021145
Stochastic Analysis for Bearing Capacity Determination of Shallow Foundations on Thin-Tilted Anisotropic Soils
The soil stratum is heterogeneous and may be tilted with significant influence on the footing bearing capacity (BC). In this paper, a combination of influence of the anisotropy orientation and thickness of soil layer and rock stratum inclination on the BC of strip footings was evaluated using a random finite-difference method (RFDM). The Monte Carlo simulation (MCS) approach was used to elucidate the effect of spatial variability, and soil strength characteristics were assumed as log-normal and bounded random fields. The failure mechanism and produced shear strain in probabilistic method were compared to those obtained from deterministic analysis. The results showed that the soil stratum inclination has a significant effect on the footing BC magnitude, which reaches a minimum value when the deposition orientation is 45°−ϕ/2 with the horizontal direction (ϕ = soil friction angle). Parametric studies were performed on the variability level of strength parameters, the correlation coefficient of strength characteristics, correlation length, soil layer thickness, and stratification orientation.
- 10 February 2021
- Published by Taylor & Francis in European Journal of Environmental and Civil Engineering
- Vol. 26 (11) , 5088-5112
Bearing capacity-relative density behavior of circular footings resting on geocell-reinforced sand
Geocell reinforcement (GR) improves load-deformation behavior of shallow foundations. A series of instrumented large-scale plate load tests was performed to ascertain such improvements and to correlate that to the relative density (Dr ) of geocell-reinforced sand (GRS). Variable effects on stiffness, bearing capacity (BC), load dispersion and strain-stress behaviors are discussed. The extensive tests made it possible to arrive at a simplified analytical procedure for predicting the BC of circular footings on GRS, taking into account probable shear failure mechanisms and monitored GR deformation. These results allowed the validation and generalization of the procedure reduced from an equivalent-layer BC model considering ‘confinement’ and ‘stress dispersion’ effects on the failure mechanism. Load dispersion angle and strains increase with increasing the sand Dr resulted in significant stress reduction below the GR. This was found most beneficial for the higher densities ranges. The proposed analytical approach can confidently be used for practical design purposes.
- 10 February 2021
- Published by Taylor & Francis in European Journal of Environmental and Civil Engineering
- Vol. 26 (11) , 5088-5112
Bearing capacity-relative density behavior of circular footings resting on geocell-reinforced sand
Geocell reinforcement (GR) improves load-deformation behavior of shallow foundations. A series of instrumented large-scale plate load tests was performed to ascertain such improvements and to correlate that to the relative density (Dr ) of geocell-reinforced sand (GRS). Variable effects on stiffness, bearing capacity (BC), load dispersion and strain-stress behaviors are discussed. The extensive tests made it possible to arrive at a simplified analytical procedure for predicting the BC of circular footings on GRS, taking into account probable shear failure mechanisms and monitored GR deformation. These results allowed the validation and generalization of the procedure reduced from an equivalent-layer BC model considering ‘confinement’ and ‘stress dispersion’ effects on the failure mechanism. Load dispersion angle and strains increase with increasing the sand Dr resulted in significant stress reduction below the GR. This was found most beneficial for the higher densities ranges. The proposed analytical approach can confidently be used for practical design purposes.
- 16 October 2020
- Published by Springer Nature in Arabian Journal of Geosciences
- Vol. 13 (20) , 1-12
Behaviour of circular footings confined by rigid base and geocell reinforcement
- 16 October 2020
- Published by Springer Nature in Arabian Journal of Geosciences
- Vol. 13 (20) , 1-12
Behaviour of circular footings confined by rigid base and geocell reinforcement
- Open Access
- 9 April 2019
- Published by SCI AND TECH UNIVERSAL INC in Scientia Iranica
- Vol. 28 (1) , 96-108
Parametric study from laboratory tests on twin circular footings on geocell-reinforced sand
Bearing capacity (BC) test results are presented for bounded and unbounded twin circular footings on unreinforced and geocell-reinforced (GCR) sand. Analysis of the results demonstrate material, scale and size effects on the BC for a given combination in materials (sand-GCR), footing (single-twin) and the problem geometric dimensions. The significance of these combinations on BC and settlements is used to arrive at suitably modified BC factors for design that could be generalized. Plots given relative to reference cases for which BC design solutions are available provide correction factors to modify classical BC equations. Values of the BC and BC factors represent the lumped effect of all or separate problem variables including scale and any experimental limitations. Compared with previous works, these results give deeper critical depths for twin footings on unreinforced and GCR sand and BC higher than 4 times the reference case.
- 9 April 2019
- Published by SCI AND TECH UNIVERSAL INC in Scientia Iranica
- Vol. 28 (1) , 96-108
Open AccessParametric study from laboratory tests on twin circular footings on geocell-reinforced sand
Bearing capacity (BC) test results are presented for bounded and unbounded twin circular footings on unreinforced and geocell-reinforced (GCR) sand. Analysis of the results demonstrate material, scale and size effects on the BC for a given combination in materials (sand-GCR), footing (single-twin) and the problem geometric dimensions. The significance of these combinations on BC and settlements is used to arrive at suitably modified BC factors for design that could be generalized. Plots given relative to reference cases for which BC design solutions are available provide correction factors to modify classical BC equations. Values of the BC and BC factors represent the lumped effect of all or separate problem variables including scale and any experimental limitations. Compared with previous works, these results give deeper critical depths for twin footings on unreinforced and GCR sand and BC higher than 4 times the reference case.