Liang Yang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Liang Yang has a total of 44 co-authors. Here are the top co-authors by number of shared publications:
Guomin Cui
Shanghai Key Laboratory of Multiphase Flow and Heat Transfer in Power Engineering, School of Energy and Power Engineering, University of Shanghai for Science and Technology, Shanghai 200093, China
8 shared publicationsDaoping Liu
Shanghai Key Laboratory of Multiphase Flow and Heat Transfer in Power Engineering, School of Energy and Power Engineering, University of Shanghai for Science and Technology, Shanghai 200093, China
7 shared publicationsYingming Xie
University of Shanghai for Science and Technology
6 shared publicationsJuan Wang
5 shared publicationsNi Liu
University of Shanghai for Science and Technology
4 shared publicationsBinlin Dou
3 shared publications
Latest Publications
- 18 September 2026
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 40 (39) , 21699-21711
Numerical Simulation of Gas Production from Natural Gas Hydrate Reservoirs in the South China Sea via Staged Depressurization
Depressurization is generally regarded as the most practical method for extracting marine natural gas hydrates. However, conventional single-stage depressurization often leads to rapid temperature drops and excessive water production, which can increase the risk of formation collapse. Therefore, considering both safety and economic efficiency, this study established a numerical model based on geological data from the SH7 site in the Shenhu area of the South China Sea and designed multiple depressurization strategies. The dynamic gas production behavior under both single-stage and staged depressurization schemes over a 1000 day period was investigated. The depressurization amplitude coefficient (CDA) and the depressurization return ratio (RDR) are introduced to quantify the trade-off between production efficiency and depressurization risks. The results indicate that although a larger depressurization in single-stage depressurization enhances early gas production and improves the gas-to-water ratio, it also results in higher water production and reduced long-term recovery. When the initial depressurization and production timing are properly configured, the staged depressurization strategy can effectively stimulate reservoir potential, increasing cumulative gas production by approximately 18.6% compared with conventional single-stage depressurization. Furthermore, staged strategies achieve higher gas production rates while maintaining a lower CDA, demonstrating a favorable balance between economic benefit and operational safety.
- 18 September 2026
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 40 (39) , 21699-21711
Numerical Simulation of Gas Production from Natural Gas Hydrate Reservoirs in the South China Sea via Staged Depressurization
Depressurization is generally regarded as the most practical method for extracting marine natural gas hydrates. However, conventional single-stage depressurization often leads to rapid temperature drops and excessive water production, which can increase the risk of formation collapse. Therefore, considering both safety and economic efficiency, this study established a numerical model based on geological data from the SH7 site in the Shenhu area of the South China Sea and designed multiple depressurization strategies. The dynamic gas production behavior under both single-stage and staged depressurization schemes over a 1000 day period was investigated. The depressurization amplitude coefficient (CDA) and the depressurization return ratio (RDR) are introduced to quantify the trade-off between production efficiency and depressurization risks. The results indicate that although a larger depressurization in single-stage depressurization enhances early gas production and improves the gas-to-water ratio, it also results in higher water production and reduced long-term recovery. When the initial depressurization and production timing are properly configured, the staged depressurization strategy can effectively stimulate reservoir potential, increasing cumulative gas production by approximately 18.6% compared with conventional single-stage depressurization. Furthermore, staged strategies achieve higher gas production rates while maintaining a lower CDA, demonstrating a favorable balance between economic benefit and operational safety.
- 16 September 2026
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 14 (38) , 17030-17042
Synergistic Promotion of CO2 Hydrate Formation by Hydrophilic/Hydrophobic Amino Acids: Experiment and Mechanism
The development of environmentally friendly promoters is a critical frontier in hydrate-based carbon capture and storage technologies. In this study, the effects of hydrophilic glutamic acid and hydrophobic tryptophan on induction time and gas storage capacity were investigated. Experimental results demonstrate that glutamic acid significantly accelerates formation kinetics, shortening the induction time of to 23 min at 0.3 wt %, which represents an 80.83% reduction compared to pure water. Meanwhile, tryptophan excels in enhancing storage capacity, reaching a maximum of 129.00 m3/m3 at 0.5 wt %, which is 5.6 times that of the control. To address the limitations associated with single amino acids and explore the potential of a compound system, hydrate formation experiments were conducted using a combination of hydrophilic and hydrophobic amino acids. The optimal binary combination of 0.1 wt % glutamic acid and 0.1 wt % tryptophan exhibited a remarkable synergistic effect by reducing the induction time to 8.5 min, a 92.92% reduction, and increasing gas storage capacity to 135.25 m3/m3, which is 5.88 times that of the control. Spectroscopic analysis reveals that this enhancement stems from the formation of dense intermolecular hydrogen-bond networks and optimized gas–liquid interfacial properties. Furthermore, surface tension measurements confirm a significant reduction to 64.891 mN/m, effectively minimizing interfacial mass transfer resistance. Additionally, differential scanning calorimetry (DSC) provides thermodynamic evidence that this synergistic network substantially enhances the structural stability of the formed hydrates. This work elucidates the synergistic mechanism of amino acid blends and provides theoretical support for the development of efficient and eco-friendly promoters for hydrate-based carbon capture.
- 16 September 2026
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 14 (38) , 17030-17042
Synergistic Promotion of CO2 Hydrate Formation by Hydrophilic/Hydrophobic Amino Acids: Experiment and Mechanism
The development of environmentally friendly promoters is a critical frontier in hydrate-based carbon capture and storage technologies. In this study, the effects of hydrophilic glutamic acid and hydrophobic tryptophan on induction time and gas storage capacity were investigated. Experimental results demonstrate that glutamic acid significantly accelerates formation kinetics, shortening the induction time of to 23 min at 0.3 wt %, which represents an 80.83% reduction compared to pure water. Meanwhile, tryptophan excels in enhancing storage capacity, reaching a maximum of 129.00 m3/m3 at 0.5 wt %, which is 5.6 times that of the control. To address the limitations associated with single amino acids and explore the potential of a compound system, hydrate formation experiments were conducted using a combination of hydrophilic and hydrophobic amino acids. The optimal binary combination of 0.1 wt % glutamic acid and 0.1 wt % tryptophan exhibited a remarkable synergistic effect by reducing the induction time to 8.5 min, a 92.92% reduction, and increasing gas storage capacity to 135.25 m3/m3, which is 5.88 times that of the control. Spectroscopic analysis reveals that this enhancement stems from the formation of dense intermolecular hydrogen-bond networks and optimized gas–liquid interfacial properties. Furthermore, surface tension measurements confirm a significant reduction to 64.891 mN/m, effectively minimizing interfacial mass transfer resistance. Additionally, differential scanning calorimetry (DSC) provides thermodynamic evidence that this synergistic network substantially enhances the structural stability of the formed hydrates. This work elucidates the synergistic mechanism of amino acid blends and provides theoretical support for the development of efficient and eco-friendly promoters for hydrate-based carbon capture.
- 9 September 2026
- Published by American Chemical Society (ACS) in Energy & Fuels
Numerical Simulation of Inter-Well Synergistic Effects during Multi-Well Depressurization Production of Natural Gas Hydrates
Well layout configuration is critical for gas hydrate production as it dictates pressure spreads and dissociation front propagation. This study conducted numerical simulations for single-well, two-well, and several multi-well layouts. Gas production rate, water production rate, and volume ratio of gas to water were calculated to describe production behavior based on the geological conditions of the SH7 site in the Shenhu Area, northern South China Sea, to investigate multi-well development dynamics. A synergistic effect coefficient (Sec) was introduced to quantify the production enhancement per well in multi-well systems. Results demonstrate that while increasing well count enhances total recovery, the gains are inherently nonproportional, revealing a distinct synergistic effect limitation. Well layout and spacing significantly control performance; specifically, the ring layout and larger well spacing outperforms others by establishing a more homogenized pressure distribution. Mechanistic analysis reveals that while inter-well pressure superposition expands the effective dissociation region, the increasing competition among flow pathways and phase redistribution progressively constrain further enhancement. These coupled processes govern the nonproportional evolution of synergistic effects. These findings provide a mechanistic basis for optimizing well spacing and architecture in large-scale hydrate commercialization.
- 9 September 2026
- Published by American Chemical Society (ACS) in Energy & Fuels
Numerical Simulation of Inter-Well Synergistic Effects during Multi-Well Depressurization Production of Natural Gas Hydrates
Well layout configuration is critical for gas hydrate production as it dictates pressure spreads and dissociation front propagation. This study conducted numerical simulations for single-well, two-well, and several multi-well layouts. Gas production rate, water production rate, and volume ratio of gas to water were calculated to describe production behavior based on the geological conditions of the SH7 site in the Shenhu Area, northern South China Sea, to investigate multi-well development dynamics. A synergistic effect coefficient (Sec) was introduced to quantify the production enhancement per well in multi-well systems. Results demonstrate that while increasing well count enhances total recovery, the gains are inherently nonproportional, revealing a distinct synergistic effect limitation. Well layout and spacing significantly control performance; specifically, the ring layout and larger well spacing outperforms others by establishing a more homogenized pressure distribution. Mechanistic analysis reveals that while inter-well pressure superposition expands the effective dissociation region, the increasing competition among flow pathways and phase redistribution progressively constrain further enhancement. These coupled processes govern the nonproportional evolution of synergistic effects. These findings provide a mechanistic basis for optimizing well spacing and architecture in large-scale hydrate commercialization.
- 21 October 2024
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 38 (21) , 20851-20860
The Mechanism of CO2 Hydrate Formation by the Synergistic Effect of Kinetic Promoters
- 21 October 2024
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 38 (21) , 20851-20860
The Mechanism of CO2 Hydrate Formation by the Synergistic Effect of Kinetic Promoters
- 28 March 2023
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 11 (14) , 5367-5375
Experimental Study on the Mechanism of Enhanced CO2 Hydrate Generation by Thermodynamic Promoters
- 28 March 2023
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 11 (14) , 5367-5375
Experimental Study on the Mechanism of Enhanced CO2 Hydrate Generation by Thermodynamic Promoters
- 6 September 2022
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 10 (37) , 12127-12138
Clathrate Hydrate Framework Construction Enhanced by Waste Bio-Shavings for Efficient Methane Storage
- 6 September 2022
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 10 (37) , 12127-12138
Clathrate Hydrate Framework Construction Enhanced by Waste Bio-Shavings for Efficient Methane Storage
- 30 March 2022
- Published by Springer Nature
- p. 392-399
Rapid Methane Hydrate Formation in Open-Cell Copper Foam
- 30 March 2022
- Published by Springer Nature
- p. 392-399
Rapid Methane Hydrate Formation in Open-Cell Copper Foam
- 17 October 2019
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 11 (45) , 21934-21942
Effective immobilization of nanoscale Pd on a carbon hybrid for enhanced electrocatalytic performances: stabilization mechanism investigations
The grand challenge inhibiting the use of electrocatalysts is the degradation of active species which results in poor durability and long-term performances. Studying the origin of active metal particle stabilization mechanisms by using supports and the immobilization-induced changes of active particles is of significant importance. This study describes the preparation of Pd nanoparticles supported by carbon hybrid NPG–CN, revealing that the mass and specific activities (1987 A g−1 Pd and 28.7 A m−2) of this catalyst for formic acid oxidation significantly exceed those of commercial Pd/C, and excellent stability and enhanced CO-poisoning tolerance properties are obtained. The origin of this behavior is probed by surface analytical techniques and identical-location transmission electron microscopy (IL-TEM), and the enhanced activity of Pd/NPG–CN is ascribed to the electronic effect of the substrate, the high content of surface metallic Pd0, and the reduced extent of active Pd leaching and physical ripening during the FOA process compared with commercial Pd/C. In addition, theoretical calculations demonstrate that NPG–CN can efficiently trap Pd atoms, which accumulate and form Pd clusters at trapping (nucleation) sites.
- 17 October 2019
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 11 (45) , 21934-21942
Effective immobilization of nanoscale Pd on a carbon hybrid for enhanced electrocatalytic performances: stabilization mechanism investigations
The grand challenge inhibiting the use of electrocatalysts is the degradation of active species which results in poor durability and long-term performances. Studying the origin of active metal particle stabilization mechanisms by using supports and the immobilization-induced changes of active particles is of significant importance. This study describes the preparation of Pd nanoparticles supported by carbon hybrid NPG–CN, revealing that the mass and specific activities (1987 A g−1 Pd and 28.7 A m−2) of this catalyst for formic acid oxidation significantly exceed those of commercial Pd/C, and excellent stability and enhanced CO-poisoning tolerance properties are obtained. The origin of this behavior is probed by surface analytical techniques and identical-location transmission electron microscopy (IL-TEM), and the enhanced activity of Pd/NPG–CN is ascribed to the electronic effect of the substrate, the high content of surface metallic Pd0, and the reduced extent of active Pd leaching and physical ripening during the FOA process compared with commercial Pd/C. In addition, theoretical calculations demonstrate that NPG–CN can efficiently trap Pd atoms, which accumulate and form Pd clusters at trapping (nucleation) sites.