Ruihua Tang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Ruihua Tang has a total of 23 co-authors. Here are the top co-authors by number of shared publications:
Mingyue Xie
College of Bioresources Chemical and Materials Engineering, Shaanxi University of Science & Technology, Xi'an 710021, P. R. China
3 shared publicationsXueyan Yan
College of Bioresources Chemical and Materials Engineering, Shaanxi University of Science & Technology, Xi’an, People’s Republic of China
3 shared publicationsJohn P. Giesy
Toxicology Center, University of Saskatchewan, Saskatoon, Canada
2 shared publicationsMin Li
College of Bioresources Chemical and Materials Engineering, Shaanxi University of Science & Technology, Xi'an 710021, P. R. China
2 shared publicationsNur Alam
Limerick Pulp and Paper Centre, University of New Brunswick, Fredericton, New Brunswick E3B 5A3, Canada
2 shared publications- Yonghao Ni
Fujian Agriculture and Forestry University
2 shared publications
Latest Publications
- 16 April 2024
- Published by Springer Nature in Cellulose
- Vol. 31 (8) , 5115-5131
Carboxymethyl chitosan/alginate/polyethylene glycol composite hydrogel for nucleic acid lysis solution storage at the point of care
- 16 April 2024
- Published by Springer Nature in Cellulose
- Vol. 31 (8) , 5115-5131
Carboxymethyl chitosan/alginate/polyethylene glycol composite hydrogel for nucleic acid lysis solution storage at the point of care
- 27 June 2023
- Published by Royal Society of Chemistry (RSC) in Analytical Methods
- Vol. 15 (26) , 3240-3250
A wash-free, elution-free and low protein adsorption paper-based material for nucleic acid extraction
Nucleic acid detection technologies have been widely utilized for various diseases. Conventional laboratory tests are less suitable for use in resource-limited settings as they are time-consuming, high-cost, complex, and heavily dependent on benchtop equipment. Rapid nucleic acid detection methods that consist of rapid nucleic acid extraction steps could overcome these challenges. A paper-based platform has been utilized to develop various rapid nucleic acid extraction methods owing to its cost-effectiveness, portability, and easy-modification. However, the existing paper-based nucleic acid extraction technologies mainly focus on improving the adsorption capacity of nucleic acids without reducing the non-specific adsorption capacity of proteins. In this study, paper-based nucleic acid extraction technology with wash-free, elution-free, and low protein adsorption was developed. The fabrication of paper involves the mixing of polyethylene glycol (PEG)-modified cotton fiber, chitosan (COS)-modified cotton fiber, and cotton fiber to form PEG-modified cotton fiber/chitosan-modified cotton fiber/cotton fiber (PEG-CF/COS-CF/CF) paper by the wet molding method. The result showed that PEG-CF/COS-CF/CF paper has a desirable pore size (23.9 ± 4.03 μm), good mechanical strength (dry: 9.37 Mpa and wet: 0.28 Mpa), and hydrophilicity (contact angle: 42.6° ± 0.36°). NH3 + groups of COS and OH− groups of PEG were observed on its surface and the adsorption efficiency of nucleic acid in TE buffer was 42.48% ± 0.30%. The limit of detection of pure DNA with this PEG-CF/COS-CF/CF paper by qPCR was as low as 25 ng. Additionally, this platform could successfully extract nucleic acid from 30 μL of a saliva sample, highlighting its potential use for clinical sample testing. The proposed paper-based nucleic acid extraction platform shows tremendous potential for disease diagnosis in resource-limited settings.
- 27 June 2023
- Published by Royal Society of Chemistry (RSC) in Analytical Methods
- Vol. 15 (26) , 3240-3250
A wash-free, elution-free and low protein adsorption paper-based material for nucleic acid extraction
Nucleic acid detection technologies have been widely utilized for various diseases. Conventional laboratory tests are less suitable for use in resource-limited settings as they are time-consuming, high-cost, complex, and heavily dependent on benchtop equipment. Rapid nucleic acid detection methods that consist of rapid nucleic acid extraction steps could overcome these challenges. A paper-based platform has been utilized to develop various rapid nucleic acid extraction methods owing to its cost-effectiveness, portability, and easy-modification. However, the existing paper-based nucleic acid extraction technologies mainly focus on improving the adsorption capacity of nucleic acids without reducing the non-specific adsorption capacity of proteins. In this study, paper-based nucleic acid extraction technology with wash-free, elution-free, and low protein adsorption was developed. The fabrication of paper involves the mixing of polyethylene glycol (PEG)-modified cotton fiber, chitosan (COS)-modified cotton fiber, and cotton fiber to form PEG-modified cotton fiber/chitosan-modified cotton fiber/cotton fiber (PEG-CF/COS-CF/CF) paper by the wet molding method. The result showed that PEG-CF/COS-CF/CF paper has a desirable pore size (23.9 ± 4.03 μm), good mechanical strength (dry: 9.37 Mpa and wet: 0.28 Mpa), and hydrophilicity (contact angle: 42.6° ± 0.36°). NH3 + groups of COS and OH− groups of PEG were observed on its surface and the adsorption efficiency of nucleic acid in TE buffer was 42.48% ± 0.30%. The limit of detection of pure DNA with this PEG-CF/COS-CF/CF paper by qPCR was as low as 25 ng. Additionally, this platform could successfully extract nucleic acid from 30 μL of a saliva sample, highlighting its potential use for clinical sample testing. The proposed paper-based nucleic acid extraction platform shows tremendous potential for disease diagnosis in resource-limited settings.
- 3 June 2023
- Published by Springer Nature in Cellulose
- Vol. 30 (10) , 6457-6469
A nitrocellulose/cotton fiber hybrid composite membrane for paper-based biosensor
Nitrocellulose (NC) membrane was fabricated and tested for its potential use in various paper-based biosensors for use in point-of-care testing. However, contemporary technologies are complex, expensive, non-scalable, limited by conditions, and beset with potentially adverse effects on the environment. Herein, we proposed a simple, cost-effective, scalable technology to prepare nitrocellulose/cotton fiber (NC/CF) composite membranes. The NC/CF composite membranes with a diameter of 20 cm were fabricated in 15 min using papermaking technology, which contributes to scalability in the large-scale production of these composites. Compared with existing commercial NC membranes, the NC/CF composite membrane is characterized by small pore size (3.59 ± 0.19 μm), low flow rate (156 ± 55 s/40 mm), high dry strength (up to 4.04 MPa), and wet strength (up to 0.13 MPa), adjustable hydrophilic-hydrophobic (contact angles ranged from 29 ± 4.6 to 82.8 ± 2.4°), the good adsorption capacity of protein (up to 91.92 ± 0.07 μg). After lateral flow assays (LFAs) detection, the limit of detection is 1 nM, which is similar to commercial NC membrane (Sartorius CN 140). We envision the NC/CF composite membrane as a promising material for paper-based biosensors of point-of-care testing applications.
- 3 June 2023
- Published by Springer Nature in Cellulose
- Vol. 30 (10) , 6457-6469
A nitrocellulose/cotton fiber hybrid composite membrane for paper-based biosensor
Nitrocellulose (NC) membrane was fabricated and tested for its potential use in various paper-based biosensors for use in point-of-care testing. However, contemporary technologies are complex, expensive, non-scalable, limited by conditions, and beset with potentially adverse effects on the environment. Herein, we proposed a simple, cost-effective, scalable technology to prepare nitrocellulose/cotton fiber (NC/CF) composite membranes. The NC/CF composite membranes with a diameter of 20 cm were fabricated in 15 min using papermaking technology, which contributes to scalability in the large-scale production of these composites. Compared with existing commercial NC membranes, the NC/CF composite membrane is characterized by small pore size (3.59 ± 0.19 μm), low flow rate (156 ± 55 s/40 mm), high dry strength (up to 4.04 MPa), and wet strength (up to 0.13 MPa), adjustable hydrophilic-hydrophobic (contact angles ranged from 29 ± 4.6 to 82.8 ± 2.4°), the good adsorption capacity of protein (up to 91.92 ± 0.07 μg). After lateral flow assays (LFAs) detection, the limit of detection is 1 nM, which is similar to commercial NC membrane (Sartorius CN 140). We envision the NC/CF composite membrane as a promising material for paper-based biosensors of point-of-care testing applications.
- 1 September 2021
- Published by Elsevier in Carbohydrate Polymers
- Vol. 268, 118259
Dissolvable sugar barriers to enhance the sensitivity of nitrocellulose membrane lateral flow assay for COVID-19 nucleic acid
- 1 September 2021
- Published by Elsevier in Carbohydrate Polymers
- Vol. 268, 118259
Dissolvable sugar barriers to enhance the sensitivity of nitrocellulose membrane lateral flow assay for COVID-19 nucleic acid
- 17 July 2021
- Published by Springer Nature in Cellulose
- Vol. 28 (13) , 8641-8651
Improving the sensitivity of cellulose fiber-based lateral flow assay by incorporating a water-dissolvable polyvinyl alcohol dam
Lateral flow assay (LFA) is an important point-of-care (POC) test platform due to the associated portability, on-site testing, and low cost for diagnosis of pathogen infections and disease biomarkers. However, compared to high-end analyzers in hospitals, LFA devices, in particular, paper- based LFA tests, fall short in accuracy. This study focuses on two ways to improve LFAs: (1) using cellulose fibers, rather than glass fibers for a sample pad, and (2) incorporating a one-step simple, facile, and low cost PVA dam into the LFA. Both strategies (cellulose fiber as a sample pad and water dissolvable PVA dam) contributed to delaying the controlled biomolecule’s flow through the nitrocellulose membrane’s capillary channels resulting in increased bio-recognition time, thus contributing to the enhancement of LFA sensitivity. PVA modified cellulose fiber-based LFA demonstrated 10 times higher sensitivity than the cellulose fiber-based unmodified LFA, whereas 2 times enhancement was obtained in the cellulose fiber-based sample pad LFA compared to the glass fiber-based sample pad LFA. Ultimately, 20 times increase in sensitivity was achieved in the modified LFA device. This study shows that PVA and eco-friendly cellulose fibers could be incorporated into other paper based POC testing devices for future development.
- 17 July 2021
- Published by Springer Nature in Cellulose
- Vol. 28 (13) , 8641-8651
Improving the sensitivity of cellulose fiber-based lateral flow assay by incorporating a water-dissolvable polyvinyl alcohol dam
Lateral flow assay (LFA) is an important point-of-care (POC) test platform due to the associated portability, on-site testing, and low cost for diagnosis of pathogen infections and disease biomarkers. However, compared to high-end analyzers in hospitals, LFA devices, in particular, paper- based LFA tests, fall short in accuracy. This study focuses on two ways to improve LFAs: (1) using cellulose fibers, rather than glass fibers for a sample pad, and (2) incorporating a one-step simple, facile, and low cost PVA dam into the LFA. Both strategies (cellulose fiber as a sample pad and water dissolvable PVA dam) contributed to delaying the controlled biomolecule’s flow through the nitrocellulose membrane’s capillary channels resulting in increased bio-recognition time, thus contributing to the enhancement of LFA sensitivity. PVA modified cellulose fiber-based LFA demonstrated 10 times higher sensitivity than the cellulose fiber-based unmodified LFA, whereas 2 times enhancement was obtained in the cellulose fiber-based sample pad LFA compared to the glass fiber-based sample pad LFA. Ultimately, 20 times increase in sensitivity was achieved in the modified LFA device. This study shows that PVA and eco-friendly cellulose fibers could be incorporated into other paper based POC testing devices for future development.
- 16 August 2019
- Published by Springer Nature in Cellulose
- Vol. 26 (13-14) , 8087-8099
Sensitivity enhancement of lateral flow assay by embedding cotton threads in paper
- 16 August 2019
- Published by Springer Nature in Cellulose
- Vol. 26 (13-14) , 8087-8099
Sensitivity enhancement of lateral flow assay by embedding cotton threads in paper