Mateus Palharini Schwalbert
Research Subjects
Mateus Palharini Schwalbert has a total of 44 co-authors. Here are the top co-authors by number of shared publications:
Rodrigo A.C. Dias
WIKKI Brasil LTDA, Rua Aloisio Teixeira 278,Predio 3 Sala 301,Ilha Ci, BR-21941850 Rio De Janeiro, RJ, Brazil
3 shared publications- Antonio O.S. Moraes
WIKKI Brasil LTDA, Rua Aloisio Teixeira 278,Predio 3 Sala 301,Ilha Ci, BR-21941850 Rio De Janeiro, RJ, Brazil
2 shared publications - Edson de Andrade Araújo
Laboratory of Solutions in Petroleum Reservoir, Petroleum Engineering Academic Unit, Federal University of Campina Grande, Campina Grande 58429-900, PB, Brazil
2 shared publications - Jovani L. Favero
WIKKI Brasil LTDA, Rua Aloisio Teixeira 278,Predio 3 Sala 301,Ilha Ci, BR-21941850 Rio De Janeiro, RJ, Brazil
2 shared publications - Luiz Fernando L. R. Silva
Departmento de Engenharia Química, Escola de Química, Universidade Federal do Rio de Janeiro, Rio de Janeiro, Brazil
2 shared publications - Pedro Tupã Pandava Aum
Federal University of Para
2 shared publications
Latest Publications
- Open Access
Influence of Skin Factor on Oil Recovery and Economic Performance in Synthetic Layered Carbonate Models Based on Pre-Salt Well Profiles
Formation damage near the wellbore reduces permeability and limits well productivity, with its effect commonly quantified by the skin factor. This parameter can strongly influence both the technical performance and the economic feasibility of oil recovery projects. In Brazilian pre-salt carbonate reservoirs, acidizing is widely applied, often conducted immediately after well completion. However, the long-term production and economic implications of these treatments remain insufficiently quantified. In this study, synthetic carbonate reservoir models were constructed using porosity and permeability profiles derived from well data representative of pre-salt conditions. Ten models with flow capacities ranging from 3000 to 130,000 mD·m were simulated over 30 years of water injection, considering skin factors from −3 to +20. The results show that wells with flow capacities below 10,000 mD·m exhibited the strongest response to stimulation, achieving up to 35% higher cumulative oil recovery and more than a 100% increase in net present value (NPV) compared with unstimulated cases. For flow capacity values between 10,000 and 40,000 mD·m, production and economic improvements were marginal, with NPV differences typically within 10%. At higher flow capacity (>60,000 mD·m), the stimulation response became negligible, with NPV variations below 0.1%. These findings demonstrate that stimulation effectiveness is primarily governed by reservoir flow capacity. The integrated reservoir–economic evaluation framework developed in this study provides quantitative guidance for optimizing acidizing strategies in carbonate systems representative of deepwater pre-salt environments.
Open AccessInfluence of Skin Factor on Oil Recovery and Economic Performance in Synthetic Layered Carbonate Models Based on Pre-Salt Well Profiles
Formation damage near the wellbore reduces permeability and limits well productivity, with its effect commonly quantified by the skin factor. This parameter can strongly influence both the technical performance and the economic feasibility of oil recovery projects. In Brazilian pre-salt carbonate reservoirs, acidizing is widely applied, often conducted immediately after well completion. However, the long-term production and economic implications of these treatments remain insufficiently quantified. In this study, synthetic carbonate reservoir models were constructed using porosity and permeability profiles derived from well data representative of pre-salt conditions. Ten models with flow capacities ranging from 3000 to 130,000 mD·m were simulated over 30 years of water injection, considering skin factors from −3 to +20. The results show that wells with flow capacities below 10,000 mD·m exhibited the strongest response to stimulation, achieving up to 35% higher cumulative oil recovery and more than a 100% increase in net present value (NPV) compared with unstimulated cases. For flow capacity values between 10,000 and 40,000 mD·m, production and economic improvements were marginal, with NPV differences typically within 10%. At higher flow capacity (>60,000 mD·m), the stimulation response became negligible, with NPV variations below 0.1%. These findings demonstrate that stimulation effectiveness is primarily governed by reservoir flow capacity. The integrated reservoir–economic evaluation framework developed in this study provides quantitative guidance for optimizing acidizing strategies in carbonate systems representative of deepwater pre-salt environments.
- 22 November 2024
- Published by Springer Nature in Carbonates and Evaporites
- Vol. 39 (4) , 1-22
Evaluation of carbonate rock acidizing under different reservoir conditions and damage scenarios: a systematic review
- 22 November 2024
- Published by Springer Nature in Carbonates and Evaporites
- Vol. 39 (4) , 1-22
Evaluation of carbonate rock acidizing under different reservoir conditions and damage scenarios: a systematic review
- Open Access
Influence of Matrix-Acidizing Design on Oil Recovery and Economics in Carbonate Reservoirs Undergoing Waterflooding Offshore in Brazil
Acidification, a widely employed technique for well stimulation, utilizes a variety of acid systems. However, the literature provides limited insights into the economic and oil recovery implications of these treatments. Therefore, this work aims to analyze the economic impact on the oil recovery of different acid treatment designs in formations with varying degrees of heterogeneity and flow capacity. For this purpose, matrix acidization simulations were conducted using Matrix software to obtain the skin profile for each type of treatment. Subsequently, numerical simulations were performed using IMEX software from the CMG Group to analyze oil production and compare the economic results of different acid treatments. The main findings indicate that reservoirs with low flow capacities benefit more from stimulation operations, yielding a higher financial return when stimulated compared to untreated wells. In fact, there seems to be a range of flow capacity values, from around 20,000 to 40,000 mD.m, above which the net present value (NPV) of stimulated wells is equal to or even lower than that of damaged untreated wells.
Open AccessInfluence of Matrix-Acidizing Design on Oil Recovery and Economics in Carbonate Reservoirs Undergoing Waterflooding Offshore in Brazil
Acidification, a widely employed technique for well stimulation, utilizes a variety of acid systems. However, the literature provides limited insights into the economic and oil recovery implications of these treatments. Therefore, this work aims to analyze the economic impact on the oil recovery of different acid treatment designs in formations with varying degrees of heterogeneity and flow capacity. For this purpose, matrix acidization simulations were conducted using Matrix software to obtain the skin profile for each type of treatment. Subsequently, numerical simulations were performed using IMEX software from the CMG Group to analyze oil production and compare the economic results of different acid treatments. The main findings indicate that reservoirs with low flow capacities benefit more from stimulation operations, yielding a higher financial return when stimulated compared to untreated wells. In fact, there seems to be a range of flow capacity values, from around 20,000 to 40,000 mD.m, above which the net present value (NPV) of stimulated wells is equal to or even lower than that of damaged untreated wells.
- 31 October 2022
- Published by Society of Petroleum Engineers (SPE)
Short and Long-Term Fracture Permeability Tests Under Stress on Pre-Salt Low Permeability Carbonates After Acid Treatment or with Proppants
For relatively low permeability Pre-salt carbonates reservoirs, the question of progressive closure of the stimulated and acidized fractures is raised since their evolution over time could be the main cause of the production decline. Aiming at quantifying the time-dependent behavior and stress sensitivity of the acidized fracture or propped fracture, a series of fracture permeability tests were carried out in laboratory on tight Pre-salt carbonate samples from various facies of a Brazil offshore well. For creating fracture, direct shear tests were performed on initially intact cylindrical carbonate plugs in a conventional triaxial cell. The fresh fractures are then submitted to acid flow over certain duration before permeability measurement under stress. Long term fracture permeability tests lasting over several months have been carried out and were compared with the short-term tests. Correlation with mechanical properties were also investigated. We compare the performances of propped fracture to acid washed one to formalize recommendations for fracture stimulations in the Pre-salt carbonates. The propped fractures clearly performed well, with negligeable stress-sensitivity on fracture conductivity and no noticeable effect of time over 50 days. Mixed results were found for the acid-washed fractures, in which some showed little stress-sensitivity and little time-effect while others the contrary.
- 31 October 2022
- Published by Society of Petroleum Engineers (SPE)
Short and Long-Term Fracture Permeability Tests Under Stress on Pre-Salt Low Permeability Carbonates After Acid Treatment or with Proppants
For relatively low permeability Pre-salt carbonates reservoirs, the question of progressive closure of the stimulated and acidized fractures is raised since their evolution over time could be the main cause of the production decline. Aiming at quantifying the time-dependent behavior and stress sensitivity of the acidized fracture or propped fracture, a series of fracture permeability tests were carried out in laboratory on tight Pre-salt carbonate samples from various facies of a Brazil offshore well. For creating fracture, direct shear tests were performed on initially intact cylindrical carbonate plugs in a conventional triaxial cell. The fresh fractures are then submitted to acid flow over certain duration before permeability measurement under stress. Long term fracture permeability tests lasting over several months have been carried out and were compared with the short-term tests. Correlation with mechanical properties were also investigated. We compare the performances of propped fracture to acid washed one to formalize recommendations for fracture stimulations in the Pre-salt carbonates. The propped fractures clearly performed well, with negligeable stress-sensitivity on fracture conductivity and no noticeable effect of time over 50 days. Mixed results were found for the acid-washed fractures, in which some showed little stress-sensitivity and little time-effect while others the contrary.
- 1 December 2021
- Published by Elsevier in Journal of Petroleum Science and Engineering
- Vol. 207
Rheological effects on the acidizing process in carbonate reservoirs
- 1 December 2021
- Published by Elsevier in Journal of Petroleum Science and Engineering
- Vol. 207
Rheological effects on the acidizing process in carbonate reservoirs
- 1 September 2021
- Published by Elsevier in Journal of Natural Gas Science and Engineering
- Vol. 93
Temperature impact on linear and radial wormhole propagation in limestone, dolomite, and mixed mineralogy
- 1 September 2021
- Published by Elsevier in Journal of Natural Gas Science and Engineering
- Vol. 93
Temperature impact on linear and radial wormhole propagation in limestone, dolomite, and mixed mineralogy
- 30 October 2018
- Published by Society of Petroleum Engineers (SPE) in SPE Production & Operations
- Vol. 34 (01) , 90-108
Anisotropic-Wormhole-Network Generation in Carbonate Acidizing and Wormhole-Model Analysis Through Averaged-Continuum Simulations
Summary: The optimal design of matrix-acidizing operations in carbonate reservoirs is a discussion in progress. Although several models are available to the industry for predicting wormhole propagation, most of them are not sufficiently practical to be used in real treatment designs, or they were developed to represent coreflood data and cannot be simply scaled up to represent wormhole formation in complex well geometries. This problem is addressed by Furui's wormhole-propagation model (Furui et al. 2012a), which is a modification of the Buijse and Glasbergen (2005) empirical correlation, including a scaleup procedure to represent field carbonate-acidizing operations using laboratory coreflood data. It is a practical engineering tool that can be used for treatment designs in horizontal wells, including barefoot and perforation-cluster completions in fairly isotropic and homogeneous reservoirs. In this work, an analysis of Furui's model is performed, including the effect of anisotropy (x, y, z permeability) in the carbonate reservoir. The analysis includes both radial and elliptical wormhole propagation that forms from an openhole completion, and the spherical or ellipsoidal wormhole propagation that emerges from each perforation in a perforation-cluster completion that makes the use of a limited-entry technique for achieving an acceptable acid placement. The development is made using extensive 3D numerical simulations with a two-scale continuum model and a finite-volume method to represent the dissolution of the porous medium. The numerical model is tuned to represent real results through matching experimental coreflood data and dissolution patterns. Conclusions are obtained regarding both isotropic and anisotropic formations. In isotropic formations with the radial propagation of wormholes, simulations indicate that a number from four to six wormholes propagates radially in each plane. When the propagation is spherical, simulations result in a number from 16 to 24 wormholes, propagating spherically from the point of acid injection. In anisotropic formations, the radial stimulated zone might become an elliptical stimulated zone, depending on the acid-injection rate and the permeability-heterogeneity magnitude. The major axis of the elliptical stimulated zone coincides with the direction of a higher permeability and a longer permeability-correlation length, and it is longer for larger acid-injection rates. In the same manner, the spherical wormhole-propagation pattern might become an ellipsoidal stimulated zone in anisotropic formations.
- 30 October 2018
- Published by Society of Petroleum Engineers (SPE) in SPE Production & Operations
- Vol. 34 (01) , 90-108
Anisotropic-Wormhole-Network Generation in Carbonate Acidizing and Wormhole-Model Analysis Through Averaged-Continuum Simulations
Summary: The optimal design of matrix-acidizing operations in carbonate reservoirs is a discussion in progress. Although several models are available to the industry for predicting wormhole propagation, most of them are not sufficiently practical to be used in real treatment designs, or they were developed to represent coreflood data and cannot be simply scaled up to represent wormhole formation in complex well geometries. This problem is addressed by Furui's wormhole-propagation model (Furui et al. 2012a), which is a modification of the Buijse and Glasbergen (2005) empirical correlation, including a scaleup procedure to represent field carbonate-acidizing operations using laboratory coreflood data. It is a practical engineering tool that can be used for treatment designs in horizontal wells, including barefoot and perforation-cluster completions in fairly isotropic and homogeneous reservoirs. In this work, an analysis of Furui's model is performed, including the effect of anisotropy (x, y, z permeability) in the carbonate reservoir. The analysis includes both radial and elliptical wormhole propagation that forms from an openhole completion, and the spherical or ellipsoidal wormhole propagation that emerges from each perforation in a perforation-cluster completion that makes the use of a limited-entry technique for achieving an acceptable acid placement. The development is made using extensive 3D numerical simulations with a two-scale continuum model and a finite-volume method to represent the dissolution of the porous medium. The numerical model is tuned to represent real results through matching experimental coreflood data and dissolution patterns. Conclusions are obtained regarding both isotropic and anisotropic formations. In isotropic formations with the radial propagation of wormholes, simulations indicate that a number from four to six wormholes propagates radially in each plane. When the propagation is spherical, simulations result in a number from 16 to 24 wormholes, propagating spherically from the point of acid injection. In anisotropic formations, the radial stimulated zone might become an elliptical stimulated zone, depending on the acid-injection rate and the permeability-heterogeneity magnitude. The major axis of the elliptical stimulated zone coincides with the direction of a higher permeability and a longer permeability-correlation length, and it is longer for larger acid-injection rates. In the same manner, the spherical wormhole-propagation pattern might become an ellipsoidal stimulated zone in anisotropic formations.