Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Armando Blanco-Alvarez has a total of 11 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Determination of Added-Mass Coefficients in Eccentrically Confined Square Cylinders Using Deforming-Mesh and Immersed-Boundary Methods

    by Bruno Oettinger-Barrientos, Armando Blanco-Alvarez, Gonzalo Tampier

    Accurate prediction of hydrodynamic forces on confined oscillating structures is essential in applications related to nuclear engineering, energy systems, offshore devices, and mechanical components subjected to flow-induced vibrations. In this work, two computational fluid dynamics (CFD) methodologies implemented in ANSYS CFX are compared to determine the added-mass coefficients for a square cross-section cylinder confined within a square container: a deforming-mesh method (DMM) and an immersed-boundary method (IBM). Unlike previous studies restricted either to concentric square cylinders or to eccentric configurations treated with potential flow, the present study addresses eccentric confined configurations by solving the incompressible Navier–Stokes equations and focuses primarily on the prediction of added mass under strong confinement. Horizontal, vertical, and combined eccentric displacements are analyzed in detail. Mesh-independence, domain-size sensitivity, and temporal-convergence analyses are performed. Results show that both methods provide closely matching added-mass predictions over a wide range of eccentricities, with relative differences typically below 1% for moderate eccentricities, although discrepancies increase under extreme confinement. Relative to the concentric configuration, the added-mass coefficient increases by about 44% for the most eccentric vertical case and by about 87% for the most eccentric corner-approach case. Force decomposition and pressure-field analysis show that this increase is governed primarily by pressure-induced inertial effects, whereas viscous shear plays a secondary role under the conditions considered. From a practical standpoint, the immersed-boundary method reduced the computational time by approximately 92% in the most demanding case.

  • Open Access

    IpFlux: A New Advanced Tool for Hydraulics Analysis in Open Channels

    by Roger Iván Ponce-Segovia, Carmela Ramos-Orlandino, Armando Blanco-Alvarez

    IpFlux is a cost-free software developed to provide a simplified, accessible, and accurate solution for hydraulic analysis in open-channel flows. It addresses the need for tools that support rapid decision-making during early design stages, especially when conventional software may be too complex, resource-intensive, or costly. Written in Python, IpFlux features an intuitive interface and implements both explicit and implicit formulations to compute normal and critical depths, hydraulic jumps, flow through weirs and gates, backwater curves, and compound cross-sections. Thanks to its focused interface and direct data entry, IpFlux enables significantly faster estimations than traditional tools used for similar hydraulic calculations, particularly in early project stages. The software’s accuracy and applicability are demonstrated by comparing its outputs against classical references and selected results from established tools such as HEC-RAS and ANSYS Fluent. While IpFlux is not intended to replace advanced simulation software, it offers a reliable and user-friendly alternative for preliminary analyses in engineering projects, as well as for educational purposes in hydraulic engineering.

  • Open Access

    Comparison of Different Numerical Interface Capturing Methods for the Simulation of Faraday Waves

    by Armando Blanco, Richard Oliva, Daniel Machado, Dominique Legendre

    Faraday instability is a classic problem that occurs due to the relative displacement of the interface that separates two immiscible fluids placed in a closed container under oscillating acceleration parallel to gravity. The interface deformation and the induced flow patterns of this two-phase flow are very complex and numerical simulations could allow a deeper understanding of the dynamics of these systems. Some tests have been performed to establish a reference solution, but further validation is needed in order to ensure the validity of these solutions. In this work, we compare some numerical solutions for the linear and nonlinear regimes using the phase field scheme with predictions obtained using different numerical schemes such as Front Tracking, Volume of Fluid, and Element-based Finite Volume Method. The results show that, in both linear and nonlinear regimes, some important differences in the prediction of the interface dynamics between the methods are observed, and the need to provide a reference numerical solution for future benchmarks is highlighted.


  • Open Access

    Numerical modelling of the oscillatory flow effect around submarine pipeliness

    by Marian Yegres, Armando Blanco Álvarez

    This work describes the dynamics of an underwater pipeline subjected to an incident flow composed of a uniform flow and a sinusoidal component. The motion equations of the pipeline and the fluid flow around the pipeline are solved simultaneously with a numerical model that considers in-line oscillations (one degree of freedom) and a second numerical model that additionally includes cross flow (two degrees of freedom). The amplitude response and drag forces on the pipe are compared for both models considering parameters such as the difference between the excitation and natural frequencies of pipelines and the relative value between the sinusoidal and uniform components of the incident flow. Important differences in numerical predictions of both models are observed when the excitation frequency is greater than the natural frequency of the system and when the amplitude of the oscillatory component of the incident flow is greater than the amplitude of the uniform flow.

  • Open Access

    Genome-wide gene expression analysis in mouse embryonic stem cells

    by Juan Sainz, Fernando García-Alcalde, Armando Blanco, Ángel Concha

    Embryonic stem cell studies have generated great interest, due to their ability to form a wide variety of matured cells. However, there remains a poor understanding of mechanisms regulating the cell state of embryonic stem cells (ESCs) and of the genes they express during early differentiation. Gene expression analysis may be a valuable tool to elucidate either the molecular pathways involved in self-renewal and pluripotency, or early differentiation and to identify potential molecular therapy targets. The aim of this study was to characterize at the molecular level the undifferentiated mouse ESC state and the early development towards embryoid bodies. To attempt this issue, we performed CodeLink Mouse Uniset I 20K bioarrays in a well-characterized mouse ESC line, MES3, 3- and 7 day-old embryoid bodies and we compared our findings with those in adult tissue cells. Gene expression results were subsequently validated in a commercial stem cell line, CGR8 (ATCC). Significance Analysis of Microarrays (SAM) was used to identify statistically significant changes in microarray data. We identified 3664 genes expressed at significantly greater levels in MES3 stem cells than in adult tissue cells, which included 611 with 3-fold higher gene expression levels versus the adult cells. We also investigated the gene expression profile during early embryoid body formation, identifying 2040 and 2243 genes that were up-regulated in 3- and 7- day-old embryoid bodies, respectively. Our gene expression results in MES3 cells were partially confirmed in CGR8 cells, showing numerous genes that are expressed in both mouse stem cells. In conclusion, our results suggest that commonly expressed genes may be strong candidates for involvement in the maintenance of a pluripotent and undifferentiated phenotype and in early development.