YLYi Liu

Yi Liu

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Yi Liu has a total of 16 co-authors. Here are the top co-authors by number of shared publications:

  • Deepika Dave

    Marine Institute, Center for Aquaculture and Seafood Development, Memorial University of Newfoundland, St. John’s, NL A1C5R3, Canada

    3 shared publications
  • Francesca Maria Kerton

    Memorial University of Newfoundland

    3 shared publications
  • Sheila Trenholm

    Center for Aquaculture and Seafood Development, Fisheries and Marine Institute of Memorial University of Newfoundland, 155 Ridge Road, St. John's NL, A1C 5R3, Canada

    3 shared publications
  • Julia Pohling

    Center for Aquaculture and Seafood Development, Fisheries and Marine Institute of Memorial University of Newfoundland, 155 Ridge Road, St. John's NL, A1C 5R3, Canada

    2 shared publications
  • Kelly Hawboldt

    Department of Process Engineering, Memorial University of Newfoundland and Labrador, P.O. Box 4200, St. John's, NL A1C 5S7, Canada

    2 shared publications
  • Wade Murphy

    Center for Aquaculture and Seafood Development, Fisheries and Marine Institute of Memorial University of Newfoundland, 155 Ridge Road, St. John's NL, A1C 5R3, Canada

    2 shared publications

Latest Publications

  • Two-step demineralization of shrimp (Pandalus Borealis) shells using citric acid: an environmentally friendly, safe and cost-effective alternative to the traditional approach

    by Julia Pohling, Deepika Dave, Yi Liu, Wade Murphy, Sheila Trenholm

    Removal of minerals from crustacean shells during chitin extraction is traditionally achieved using hydrochloric acid. However, the environmental, health and safety concerns of hydrochloric acid have led to investigation of potential alternatives for this application. In most previously reported studies using other acids, the residual ash content in the demineralized shells could not be reduced to below 1%, which is required for high-grade applications of chitin. In the present study, near-complete demineralization of Pandalus Borealis shells was achieved using citric acid through one-step and two-step processes within 2 hours at room temperature. Fresh shrimp shells were pretreated by thorough grinding and washing. In the one-step demineralization, a residual ash content of 0.59% was obtained by treating the shells with twice the stoichiometric amount of citric acid for 2 h. The residual ash content was further reduced to 0.19% with implementation of a two-step process, in which the majority of minerals in the shells were first dissolved within 35 min using 1.5 times the stoichiometric amount of citric acid, followed by the second demineralization using 8 times the stoichiometric amount of citric acid for 60 min. The two-step process consumed a lower amount of citric acid in comparison to the one-step process (approx. 13.8% less 50% citric acid for every 1000 kg of fresh shrimp shells processed). The low residual mineral content achieved was comparable to the conventional process using hydrochloric acid, indicating the potential of using citric acid for demineralization of shrimp shells to produce premium-quality chitin.


  • Recent progress on immobilization technology in enzymatic conversion of marine by-products to concentrated omega-3 fatty acids

    by Yi Liu, Deepika Dave

    A comprehensive summary of recent research progress applying immobilization technology in sustainable development of marine biomass to value-added products.


  • Availability of marine collagen from Newfoundland fisheries and aquaculture waste resources

    by Deepika Dave, Yi Liu, Lesley Clark, Nisarg Dave, Sheila Trenholm, Jillian Westcott


  • Conversion of chitin and N-acetyl- d -glucosamine into a N-containing furan derivative in ionic liquids

    by Xi Chen, Yi Liu, Francesca M. Kerton, Ning Yan

    Direct conversion of chitin to 3-acetamido-5-acetylfuran (3A5AF) in a range of ionic liquids (ILs) has been systematically investigated. 10 ILs with different cations and anions were tested as the solvent and 25 additives were screened. The results revealed that the presence of Cl in the IL is essential. In addition to the solubility enhancement of chitin in Cl containing ILs, the Cl anion appeared to participate in the chitin reaction cycle in IL solvents. 3A5AF can be obtained in some ILs, such as [BMIm]Cl, without any additive. Significantly enhanced yields of 3A5AF were obtained in [BMIm]Cl using boric acid and hydrochloric acid (HCl) as additives at 180 °C, a lower temperature than using organic solvents (215 °C). Kinetic studies showed that the product formed very quickly within 10 min, with much higher initial rate than using organic solvents. Recovered chitin was characterized by X-ray diffraction (XRD), Fourier transform infrared spectroscopy (FTIR) and elemental analysis (EA). In an effort to improve the yield, extraction and distillation were attempted for both chitin and chitin monomer, N-acetyl-D-glucosamine (NAG). Further studies were performed on NAG to see if acidic ILs would lead to enhanced reactivity. However, these were less effective.


  • Combined Experimental and Computational Studies on the Physical and Chemical Properties of the Renewable Amide, 3‐Acetamido‐5‐acetylfuran

    by Yi Liu, Christopher N. Rowley, Francesca M. Kerton

    The pKa of 3‐acetamido‐5‐acetylfuran (3A5AF) was predicted to be in the range 18.5–21.5 by using the B3LYP/6‐311+G(2d,p) method and several amides as references. The experimental pKa value, 20.7, was determined through UV/Vis titrations. Its solubility was measured in methanol‐modified supercritical CO2 (mole fraction, 3.23×10−4, cloud points 40–80 °C) and it was shown to be less soluble than 5‐hydroxymethylfurfural (5‐HMF). Dimerization energies were calculated for 3A5AF and 5‐HMF to compare hydrogen bonding, as such interactions will affect their solubility. Infrared and 1H nuclear magnetic resonance spectra of 3A5AF samples support the existence of intermolecular hydrogen bonding. The highest occupied molecular orbital, lowest unoccupied molecular orbital, and electrostatic potential of 3A5AF were determined through molecular orbital calculations using B3LYP/6‐311+G(2d,p). The π–π* transition energy (time‐dependent density functional theory study) was compared with UV/Vis data. Calculated atomic charges were used in an attempt to predict the reactivity of 3A5AF. A reaction between 3A5AF and CH3MgBr was conducted. As 3A5AF is a recently developed renewable compound that has previously not been studied extensively, these studies will be helpful in designing future reactions and processes involving this molecule.


  • Renewable resources from the oceans: Adding value to the by-products of the aquaculture and fishing industries

    by Francesca M. Kerton, Yi Liu, Jennifer N. Murphy, Kelly Hawboldt

    This paper presents an overview of this field of research, outlines some of the opportunities available to add value to fishery by-product streams alongside some of our most recent studies and data in this area. In Atlantic Canada around 418 000 tonnes per year waste is produced at fish processing plants. This waste could be used to give a range of products as it is made up of diverse substances including scrap meat, bones, shells and process water. Possible products include fish oils, gelatin, biopolymers and minerals. These could be used in a range of industries from food, medicine and biotechnology to mining, chemical, oil and gas sectors. Chitin is a biopolymer that makes up to 30% of the waste in crustacean (shrimp, lobster and crab) shells. We have been looking at new uses for it beyond its application as a biomedical material. Our results in this area will be described. Finfish processing plants produce a varied waste stream but an oil-rich product can be isolated and used as a heating oil. Blue mussel shells are a by-product of mussel farming/processing in Newfoundland and could facilitate the development of new material outputs. These shells are rich in calcium carbonate and have the potential to be transformed into adsorbents and catalyst supports.


  • Green chemistry and the ocean-based biorefinery

    by Francesca M. Kerton, Yi Liu, Khaled W. Omari, Kelly Hawboldt

    Research into renewable chemicals, fuels and materials sourced from the oceans at Memorial University and elsewhere is employing green chemical technologies for the transformation of algae and food industry waste streams into useful products. A very small proportion of biomass utilization research is currently focused on these feedstocks and efforts focused in this area could reduce land space competition between food and chemical/fuel production. This perspective highlights some of the achievements and potential opportunities surrounding the use of algae and waste from shellfish and finfish processing. In particular, investigations in this field have used alternative solvents (water, supercritical carbon dioxide and methanol or ionic liquids) extensively. Supercritical Fluid Extraction (SFE) has been used to extract lipids and pigments from algae, and oils from fish-processing plant waste streams. Water can be used to isolate potentially high value biologically-active oligosaccharides from some seaweeds. Biotechnological approaches are showing promise in the separation of biopolymers from shellfish waste streams. Production of new nitrogen-containing bioplatform chemicals (e.g. 3-acetamido-5-acetylfuran) from aminocarbohydrates (chitin, chitosan and N-acetylglucosamine) is being pursued.