VFVítor Pereira Faro

Vítor Pereira Faro

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Vítor Pereira Faro has a total of 31 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Case study on the design of horizontal geothermal heat exchangers in residual clayey soil in southern Brazil

    by Amanda Fetzer Visintin, Bianca Penteado de Almeida Tonus, Karen Santos Schmidt, Natalia Gelinski Ratacheki, Vítor Pereira Faro

    Shallow geothermal systems based on ground source heat pumps constitute an energyefficient solution for space heating and cooling; however, their application in Brazil remains limited, particularly with respect to horizontal ground heat exchangers installed in residual soils. This paper presents a case study on the analytical design of a horizontal Slinky-type ground heat exchanger intended for the thermal conditioning of a 25 m2 experimental test room located in Maringá, Paraná, southern Brazil, operating approximately 40 h per week. The subsurface profile is composed of residual clayey soil derived from basaltic bedrock, whose geotechnical and thermal properties were determined through laboratory and in situ investigations. The design was carried out using an analytical methodology specifically developed for horizontal geothermal systems, which accounts for seasonal ground temperature variations, soil thermal conductivity and diffusivity, and peak building thermal loads. The results reveal a pronounced asymmetry between operating modes, with a required pipe length of approximately 306 m for summer cooling and 126 m for winter heating. A compact horizontal Slinky configuration was adopted to satisfy site constraints while maximizing heat exchange per unit area. Sensitivity analysis indicates that soil thermal conductivity is the dominant parameter governing exchanger length, followed by thermal diffusivity and heat pump performance. The findings highlight the importance of site-specific thermal characterization and the use of appropriate design methodologies for horizontal geothermal systems in subtropical and residual soil environments.

  • Open Access

    Modelo físico para análise da infiltração em solo não saturado

    by Isabel Cristina Salah, Vitor Pereira Faro

    Este trabalho apresenta o desenvolvimento e a aplicação de um modelo físico destinado ao estudo da infiltração em solo não saturado, com monitoramento da variação de umidade em condições controladas de precipitação. O modelo foi construído em caixa de acrílico com 93 × 93 cm de base e 120 cm de altura, preenchida com solo da Serra do Mar, Paraná, compactado em camadas de 5 cm. A caracterização incluiu análise granulométrica, limites de consistência, massa específica dos grãos e curva de retenção de água pelo método do papel filtro. A precipitação foi simulada por sistema pressurizado com aspersor, capaz de reproduzir intensidades de 64, 79 e 105 mm/h, e o monitoramento realizado com sensores de umidade EC-5 distribuídos em cinco profundidades e calibrados para o solo estudado. Os resultados indicaram que o avanço da frente de umedecimento foi condicionado pela intensidade e pelo volume acumulado da precipitação, bem como pela umidade inicial do solo. Conclui-se que o modelo físico constitui ferramenta experimental simples, confiável e aplicável em estudos de instabilidade de encostas.

  • Open Access

    Geotechnical treatment analysis for headrace tunnel in gneissic rock mass

    by Soraia Bastos Katereniuk, Alessander Christopher Morales Kormann, Vítor Pereira Faro, Pedro de Carvalho Thá

    This article presents the methodology adopted for the geotechnical design of the support applied to the headrace tunnels of the Laúca Hydropower Plant (AHE Laúca), located in Angola. The plant's headrace system consists of six parallel tunnels, each with an average length of 1900 meters, excavated in a gneissic rock mass. To determine the supports required to maintain excavation stability during the construction phase and the plant's operation, geological and geotechnical tests and investigations were conducted. The results of these investigations supported the studies presented here, providing parameters such as compressive strength and deformability of the rock mass, as well as shear strength of the rock mass discontinuities. The definition of appropriate support to ensure excavation stability was based on the Q-system rock mass classification. After the preliminary design of the support for excavations in competent rock mass, classified as Classes I to III, the proposed support was subjected to verification and validation through local stability analyses. These analyses were performed using the Unwedge software for the End of Construction load case, and a combined approach of local stability and coupled flow analysis using the Unwedge and Phase software for the operational phase load condition. The results highlighted the necessity of a drainage system consisting of perforated drains in the rock mass, in addition to the standard treatment comprising anchors and shotcrete. This system was crucial for reducing pore pressures acting on potentially unstable wedges around the excavations, particularly in scenarios where one tunnel remained empty while the others were in operation. Currently, all tunnels in the project are in operation and have undergone emptying processes due to operational demands. On none of these occasions were issues observed with the tunnel floor, nor were there any reports of block falls from the walls or crown.


  • Open Access

    Analysis of field monitoring of precipitation and pore pressure over seven years at Morro do Boi of Serra do Mar/Brazil

    by Giancarlo Domingues, Vítor Pereira Faro, Elisangela Aparecida Mazzutti

    The stability of slopes or the occurrence of mass movements is directly related to the incidence of rainfall. In this work a qualitative analysis of the historical series was made for the period between May 2012 and February 2019, where the development of pore pressures was evaluated, analyzing the behaviors of the instruments, correlating their readings with precipitation and with variations in the water table. Pore pressure was measured using vibrating wire piezometers, and precipitation data was collected using pluviometers with tipper buckets, whose readings were obtained by a datalogger model ML1-FL. From the data collected, it was possible to estimate the duration of a rainfall event for the soil, as that time interval between the occurrence of rain and the dissipation of excess pore pressure. These intervals are between 3 and 26 days in duration. The main results were: the period between the end of June and August is the driest and the highest precipitation occurs from December to early June; Precipitation of up to 100 mm of daily accumulation is well distributed throughout the year and occurs in all seasons. The pore pressure values developed were low, with a maximum of 9.3 kPa for the deepest piezometer on elevation 92.40 m. There is a delay between the occurrence of precipitation and the recording of the peak pore pressure. The in-depth knowledge of variations in precipitation and pore pressure can support the development of more robust geotechnical engineering projects. This preventive approach, based on concrete data and correlations, offers a more reliable strategy for mitigating the risks associated with landslides, directly contributing to the safety and continuous operation of the BR-101/SC highway.

  • Field and laboratory estimation of thermal conductivity of unsaturated soils using thermal cone penetration test (T-CPT)

    by Bianca Penteado de Almeida Tonus, Letícia Becher Niedvieski, Carlos Emmanuel Ribeiro Lautenschläger, Cristina de Hollanda Cavalcanti Tsuha, Vítor Pereira Faro


  • Open Access

    Soil stabilization with water treatment plant sludge for road paving

    by Elisangela Aparecida Mazzutti, Rodrigo André Klamt, Vítor Pereira Faro

    One of the methods to minimize the negative impact caused by inadequate disposal of Water Treatment Plant Sludge (WTPS) is to mix it with the soil, applying the material in engineering works. In this research, the objective was the use of WTPS for soil stabilization purposes, verifying the improvement of the characteristics and properties with 0%, 15%, 30% and 50% of sludge, for application in the base and sub-base layers of road pavements. Characterization, compaction, permeability, Resistance to Simple Compression (RCS), and California Bearing Ratio (CBR) tests were carried out. However, none of the mixes met all the necessary requirements for use in the pavement layers, but it is concluded that there was an increase in the RCS, CBR and impermeability of the mixtures compared to the reference mixture (100% soil). The RCS increased 142.75% of the soil for a blend with 30% sludge, CBR increased 76.52% of the soil for mixture with 50% WTPS, and the permeability of blends with 15%, 30% and 50% sludge was lower than then with only the soil. These results show that these mixtures can be useful for other types of applications in Geotechnics, being able to contribute to the sustainable destination of WTPS.


  • Open Access

    Soil cracking due to wetting-drying cycles and its relation to solar radiation in southern Brazil

    by Elisangela Do Prado Oliveira, Karoline Soecki, Roberta Brondani Minussi, Vitor Pereira Faro, Alessander Christopher Morales Kormann

    The drying up of soils is a natural process that occurs in the drier seasons. In 2020 the center-south region of Brazil experienced a period of great drought, drawing attention to the problem. Water loss through evaporation generates stresses in the surface layer of the soil. When these stresses exceed their tensile strength, the soil cracks. In this work, different types of soils from the city of Irati-PR, Brazil, were studied in order to assess the evolution of cracking during the dry season. The collected material was divided into two groups. The first one was exposed to the weather conditions, having precipitation and solar radiation as main agents. The second group was kept away from the weather conditions. Day by day the cracking process was recorded. The images obtained were processed using the software ImageJ®. The Cracking Index Factor evolution of each soil was obtained through pixel counting. The correlation between solar radiation and Cracking Index Factor was investigated. After the analysis, the results show a higher Cracking Index Factor for soils with higher plasticity indexes, indicating that the type of soil affected the results. In addition to plasticity, the fines content of the soils has an influence on the pattern and amount of cracking. The results also showed that solar radiation is directly related to cracking and that after the first wetting and drying cycle all soils are more vulnerable to higher cracking than previously observed.