Zaki Bassyouni Nossair
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Zaki Bassyouni Nossair has a total of 45 co-authors. Here are the top co-authors by number of shared publications:
S.A. Zahorian
5 shared publicationsAhmed Tobal
Electronic Research Institute
4 shared publicationsI.I. Ibrahim
Helwan University,Electronics, Communication and Computer Department,Egypt
3 shared publications- Rasha Shoitan
Computer and Systems Department, Electronics Research Institute (ERI), Cairo 11843, Egypt
3 shared publications - Hamdy Abdelhamid
Electrical Engineering Department, College of Engineering and Information Technology, Ajman University, Ajman, United Arab Emirates
2 shared publications I. I. Ibrahim
Helwan University
2 shared publications
Latest Publications
- 6 July 2021
- Published by Springer Nature
- p. 297-309
Performance Improvement of Lossy Image Compression Based on Polynomial Curve Fitting and Vector Quantization
- 6 July 2021
- Published by Springer Nature
- p. 297-309
Performance Improvement of Lossy Image Compression Based on Polynomial Curve Fitting and Vector Quantization
- 1 December 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 55, 3-10
Image Recovery from Incomplete Walsh Measurements Based on Orthogonal Matching Pursuit
Orthogonal matching pursuit (OMP) is a common reconstruction technique for sparse signal, which greedily calculates an estimated value for the original signal. Although OMP is fast and suitable for large sized applications, it requires a large number of measurements and suffers from low reconstruction accuracy. Many research suggested improving its reconstruction quality by transforming the image to the sparse domain; however this method increases the computational complexity especially at the encoding side. In this research, the Walsh measurement matrix is suggested to be applied directly on the image without any transformation to enhance the performance of the OMP technique. The use of the Walsh matrix reduces the computational complexity by getting rid of a transformation step at the encoder, and improves the OMP reconstruction accuracy as well. The proposed method has been applied on various test images and compared to the conventional BCS-OMP method. Simulation results have shown that using the proposed method has improved the quality of the output images by 2–7dB than the conventional one depending on the test image used. In addition, the computational complexity at the encoder and at the decoder for the proposed BCS-OMP technique is much less than that of the conventional technique.
- 1 December 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 55, 3-10
Image Recovery from Incomplete Walsh Measurements Based on Orthogonal Matching Pursuit
Orthogonal matching pursuit (OMP) is a common reconstruction technique for sparse signal, which greedily calculates an estimated value for the original signal. Although OMP is fast and suitable for large sized applications, it requires a large number of measurements and suffers from low reconstruction accuracy. Many research suggested improving its reconstruction quality by transforming the image to the sparse domain; however this method increases the computational complexity especially at the encoding side. In this research, the Walsh measurement matrix is suggested to be applied directly on the image without any transformation to enhance the performance of the OMP technique. The use of the Walsh matrix reduces the computational complexity by getting rid of a transformation step at the encoder, and improves the OMP reconstruction accuracy as well. The proposed method has been applied on various test images and compared to the conventional BCS-OMP method. Simulation results have shown that using the proposed method has improved the quality of the output images by 2–7dB than the conventional one depending on the test image used. In addition, the computational complexity at the encoder and at the decoder for the proposed BCS-OMP technique is much less than that of the conventional technique.
- 1 December 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 235-239
Modeling of Double-gate LDMOSFET Devices including Self-heating
Current analysis based on two-dimensional surface potential model and based on one-dimensional model is presented in this work as well. The impact of controlling the drift region resistance by controlling the bias and/or gate metal work function of a separately added second gate of the LDMOSFET electrostatic is more investigated. Compact models for the current including self-heating were introduced. Self-heating modeling was done using a simple resistive thermal network excited with a current source representing power dissipation in the device. The introduced models are verified to have good agreement with the numerical simulation results. The results of the study show that the introduced structure with its newly introduced separately biased second gate suffers from self-heating when increasing second gate bias which mandates a trade-off between its on-resistance and self-heating behavior.
- 1 December 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 235-239
Modeling of Double-gate LDMOSFET Devices including Self-heating
Current analysis based on two-dimensional surface potential model and based on one-dimensional model is presented in this work as well. The impact of controlling the drift region resistance by controlling the bias and/or gate metal work function of a separately added second gate of the LDMOSFET electrostatic is more investigated. Compact models for the current including self-heating were introduced. Self-heating modeling was done using a simple resistive thermal network excited with a current source representing power dissipation in the device. The introduced models are verified to have good agreement with the numerical simulation results. The results of the study show that the introduced structure with its newly introduced separately biased second gate suffers from self-heating when increasing second gate bias which mandates a trade-off between its on-resistance and self-heating behavior.
- Open Access
- 17 June 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 7, 80380-80389
A Fully Automated Spot Detection Approach for cDNA Microarray Images Using Adaptive Thresholds and Multi-Resolution Analysis
- 17 June 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 7, 80380-80389
Open AccessA Fully Automated Spot Detection Approach for cDNA Microarray Images Using Adaptive Thresholds and Multi-Resolution Analysis
- 1 June 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 344-349
Image Compression Using Polynomial Fitting
A new efficient method to compress images using polynomial curve fitting approximation techniques is presented in this paper. The polynomial curve fitting represents many pixels by a smaller number of polynomial coefficients. The presented method is based on two distinct scanning techniques of the image under compression. In the first technique, we scan the image row by row, and in this case, we use first or second order polynomial to represent the chosen number of pixels from the row. In the second case, we scan the image using a block of pixels with variable dimensions and represent each block by a first order two-dimensional polynomial. Experimentally the method gives an acceptable compression ratio with reasonable reconstructed image quality.
- 1 June 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 344-349
Image Compression Using Polynomial Fitting
A new efficient method to compress images using polynomial curve fitting approximation techniques is presented in this paper. The polynomial curve fitting represents many pixels by a smaller number of polynomial coefficients. The presented method is based on two distinct scanning techniques of the image under compression. In the first technique, we scan the image row by row, and in this case, we use first or second order polynomial to represent the chosen number of pixels from the row. In the second case, we scan the image using a block of pixels with variable dimensions and represent each block by a first order two-dimensional polynomial. Experimentally the method gives an acceptable compression ratio with reasonable reconstructed image quality.
- 27 May 2019
- Published by Springer Nature in Journal of Computational Electronics
- Vol. 18 (3) , 882-892
Two-dimensional model for double-gate LDMOSFET devices
- 27 May 2019
- Published by Springer Nature in Journal of Computational Electronics
- Vol. 18 (3) , 882-892
Two-dimensional model for double-gate LDMOSFET devices
- 1 April 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-7
Performance Improvement of Orthogonal Matching Pursuit Based on Wilkinson Matrix for Block Compressive Sensing
Compressed sensing is a new paradigm to sample compressible signals below the Nyquist rate, whilst still allowing near optimal reconstruction of the signal. In this paper, a new structured Wilkinson matrix is proposed as a measurement matrix to improve the performance of the block compressive sensing technique which is based on the orthogonal matching pursuit (OMP) algorithm. OMP is simpler to implement and potentially faster than linear programming algorithms but it suffers from two problems: the lack of reconstruction quality, and the need for a large number of measurements. The use of the new structured Wilkinson matrix has improved the OMP reconstruction quality, increased the compression ratio and reduced the computational time. In our experiments, the proposed method was applied to three different test images: Lenna, Barbara and heart MRI. Compared to conventional CS algorithms, the proposed method improves the reconstruction quality by approximately 10 dB with less computational time.
- 1 April 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-7
Performance Improvement of Orthogonal Matching Pursuit Based on Wilkinson Matrix for Block Compressive Sensing
Compressed sensing is a new paradigm to sample compressible signals below the Nyquist rate, whilst still allowing near optimal reconstruction of the signal. In this paper, a new structured Wilkinson matrix is proposed as a measurement matrix to improve the performance of the block compressive sensing technique which is based on the orthogonal matching pursuit (OMP) algorithm. OMP is simpler to implement and potentially faster than linear programming algorithms but it suffers from two problems: the lack of reconstruction quality, and the need for a large number of measurements. The use of the new structured Wilkinson matrix has improved the OMP reconstruction quality, increased the compression ratio and reduced the computational time. In our experiments, the proposed method was applied to three different test images: Lenna, Barbara and heart MRI. Compared to conventional CS algorithms, the proposed method improves the reconstruction quality by approximately 10 dB with less computational time.
- 1 April 2018
- Published by Zhejiang University Press in Frontiers of Information Technology & Electronic Engineering
- Vol. 19 (4) , 503-512
Improving the reconstruction efficiency of sparsity adaptive matching pursuit based on the Wilkinson matrix
Sparsity adaptive matching pursuit (SAMP) is a greedy reconstruction algorithm for compressive sensing signals. SAMP reconstructs signals without prior information of sparsity and presents better...
- 1 April 2018
- Published by Zhejiang University Press in Frontiers of Information Technology & Electronic Engineering
- Vol. 19 (4) , 503-512
Improving the reconstruction efficiency of sparsity adaptive matching pursuit based on the Wilkinson matrix
Sparsity adaptive matching pursuit (SAMP) is a greedy reconstruction algorithm for compressive sensing signals. SAMP reconstructs signals without prior information of sparsity and presents better...
- 1 November 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 5-9
Performance improvement of the decoding side of the BCS-SPL technique
This paper proposes different approaches to reduce the blurring effect of the reconstructed images and the computational complexity at the decoding side of the block compressive sensing with smooth projected landweber (BCS-SPL). It was found that the reason of the lack of reconstruction quality and computational complexity are due to the use of wiener filter and thresholding method. Therefore, each proposed approach uses a different thresholding method to improve the reconstruction quality and reduce computational complexity. Many simulation experiments have been conducted to evaluate the proposed approaches and compare them to several other conventional compressive sensing techniques. Our simulation results show that the proposed approaches improves the reconstruction quality by up to 5 dB relative to the other conventional techniques and also reduce the computational complexity time.
- 1 November 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 5-9
Performance improvement of the decoding side of the BCS-SPL technique
This paper proposes different approaches to reduce the blurring effect of the reconstructed images and the computational complexity at the decoding side of the block compressive sensing with smooth projected landweber (BCS-SPL). It was found that the reason of the lack of reconstruction quality and computational complexity are due to the use of wiener filter and thresholding method. Therefore, each proposed approach uses a different thresholding method to improve the reconstruction quality and reduce computational complexity. Many simulation experiments have been conducted to evaluate the proposed approaches and compare them to several other conventional compressive sensing techniques. Our simulation results show that the proposed approaches improves the reconstruction quality by up to 5 dB relative to the other conventional techniques and also reduce the computational complexity time.
- 1 October 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 181-184
Improved CNFET performance based on genetic algorithm parameters optimization
The performance of Carbon Nanotube Field Effect Transistors (CNFETs) depends critically on device parameters such as CNT diameter, number of nanotubes, and inter-nanotube spacing. To achieve a minimum Power-Delay Product (PDP) of the CNFET based digital design, the Genetic Algorithm (GA) is used in this paper to optimize CNFET device parameters. The results of GA optimization are found to be 10 carbon nanotubes with 1.33nm CNT diameter and 4nm spacing between them. The performance of CNFET digital circuits (such as XOR2, 2×1 MUX and D-latch) based on these optimum values is compared with that designed based on typical parameters. The simulation results demonstrate better performance of proposed CNFET based circuits with the significant reduction of PDP values in comparison with previous designs.
- 1 October 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 181-184
Improved CNFET performance based on genetic algorithm parameters optimization
The performance of Carbon Nanotube Field Effect Transistors (CNFETs) depends critically on device parameters such as CNT diameter, number of nanotubes, and inter-nanotube spacing. To achieve a minimum Power-Delay Product (PDP) of the CNFET based digital design, the Genetic Algorithm (GA) is used in this paper to optimize CNFET device parameters. The results of GA optimization are found to be 10 carbon nanotubes with 1.33nm CNT diameter and 4nm spacing between them. The performance of CNFET digital circuits (such as XOR2, 2×1 MUX and D-latch) based on these optimum values is compared with that designed based on typical parameters. The simulation results demonstrate better performance of proposed CNFET based circuits with the significant reduction of PDP values in comparison with previous designs.