An. A. Salei
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
An. A. Salei has a total of 2 co-authors. Here are the top co-authors by number of shared publications:
V. I. Goleus
Державний вищий навчальний заклад "Український державний хіміко-технологічний університет
1 shared publication- Victor I. Goleus
Ukrainian State University of Chemical Engineering
1 shared publication
Latest Publications
- Open Access
- 18 October 2019
- Published by Vasyl Stefanyk Carpathian National University in Physics and Chemistry of Solid State
- Vol. 20 (3) , 300-305-305
Effect of Transition Metals Oxide Additives on the Properties of Mixed-Alkali Glass for Electric Insulating Coatings on Aluminum
In order to reduce the cost of the thick-film technology of microcircuits and heating elements, as well as to expand its areas of use, it became necessary to expand the range of materials that, along with ceramics and steel, can also be used as substrates for these products. One of these advanced materials is aluminum. Electrically insulated coatings on metals are subjected to repeated heating and cooling while their produce and use, which promotes the creation of temperature stresses in the coating and leads to their chipping. Therefore, in order to improve the water resistance and adhesion strength of electrical insulation coatings on aluminum, CuO, ZrO2 and Bi2O3 additives were examined. There was found an increase in water resistance with a simultaneous increase in the adhesion strength of the enamel coating with an aluminum substrate with the addition of not more than 3 pts. wt. of copper oxide (II), up to 1 pts. wt. of zirconium oxide (IV), and up to 4 pts. wt. of bismuth oxide (III) w.r.t. 100 pts. wt. of glass.
- 18 October 2019
- Published by Vasyl Stefanyk Carpathian National University in Physics and Chemistry of Solid State
- Vol. 20 (3) , 300-305-305
Open AccessEffect of Transition Metals Oxide Additives on the Properties of Mixed-Alkali Glass for Electric Insulating Coatings on Aluminum
In order to reduce the cost of the thick-film technology of microcircuits and heating elements, as well as to expand its areas of use, it became necessary to expand the range of materials that, along with ceramics and steel, can also be used as substrates for these products. One of these advanced materials is aluminum. Electrically insulated coatings on metals are subjected to repeated heating and cooling while their produce and use, which promotes the creation of temperature stresses in the coating and leads to their chipping. Therefore, in order to improve the water resistance and adhesion strength of electrical insulation coatings on aluminum, CuO, ZrO2 and Bi2O3 additives were examined. There was found an increase in water resistance with a simultaneous increase in the adhesion strength of the enamel coating with an aluminum substrate with the addition of not more than 3 pts. wt. of copper oxide (II), up to 1 pts. wt. of zirconium oxide (IV), and up to 4 pts. wt. of bismuth oxide (III) w.r.t. 100 pts. wt. of glass.
- 27 January 2015
- Published by Springer Nature in Glass and Ceramics
- Vol. 71 (9) , 333-335
Calculation of the Viscosity of Enamel Glass Near the Softening Temperature
- 27 January 2015
- Published by Springer Nature in Glass and Ceramics
- Vol. 71 (9) , 333-335
Calculation of the Viscosity of Enamel Glass Near the Softening Temperature