Sahil Garg
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Sahil Garg has a total of 19 co-authors. Here are the top co-authors by number of shared publications:
- Arun Kumar Singh
Semiconductor Research Centre, Department of Electronics and Communication Engineering, Punjab Engineering College (Deemed to be University), Chandigarh, India
4 shared publications Neena Gupta
Semiconductor Research Centre, Department of Electronics and Communication Engineering, Punjab Engineering College (Deemed to be University), Chandigarh, India
4 shared publicationsSanjeev Kumar
Department of Physics, Punjab Engineering College (Deemed to Be University), Chandigarh, India
3 shared publications- Aimin Song
Institute of Nanoscience and Applications, Southern University of Science and Technology, Shenzhen, China
2 shared publications - Prince Jain
Parul Institute of Technology, Parul University
2 shared publications - Shahrir Rizal Kasjoo
Faculty of Electronic Engineering Technology, Universiti Malaysia Perlis (UniMAP), Arau 02600, Perlis, Malaysia
2 shared publications
Latest Publications
- 29 December 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nanotechnology
- Vol. 23 (1536125X) , 55-62
MoS2 Self-Switching Diode-Based Low Power Single and Three-Phase Bridge Rectifiers
This work presents the molybdenum di-sulphide three-phase bridge rectifier integrated circuit utilizing the novel self-switching diode. The self-switching diode has a planar architecture having I- V behavior similar to an ideal diode. The structure of SSD is utilized to design single phase and three phase rectifiers. The performance in terms of rectification efficiency, total harmonic distortion, ripple factor and cut-off frequency has been evaluated and compared for both single and three phase SSDBR. The three-phase self-switching diode bridge rectifier (3P-SSDBR) has a cut-off frequency of ∼400 MHz with minimum total harmonic distortion (THD) and ripple factor (RF) of 4.73% and 0.59, respectively. While, the single phase self-switching diode bridge rectifier (1P-SSDBR) has a cut-off frequency of ∼300 MHz with minimum total harmonic distortion (THD) and ripple factor (RF) of 47.86% and 1.94, respectively. Further, to validate the obtained results, the simulation models have been calibrated with experimental and theoretical findings.
- 29 December 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nanotechnology
- Vol. 23 (1536125X) , 55-62
MoS2 Self-Switching Diode-Based Low Power Single and Three-Phase Bridge Rectifiers
This work presents the molybdenum di-sulphide three-phase bridge rectifier integrated circuit utilizing the novel self-switching diode. The self-switching diode has a planar architecture having I- V behavior similar to an ideal diode. The structure of SSD is utilized to design single phase and three phase rectifiers. The performance in terms of rectification efficiency, total harmonic distortion, ripple factor and cut-off frequency has been evaluated and compared for both single and three phase SSDBR. The three-phase self-switching diode bridge rectifier (3P-SSDBR) has a cut-off frequency of ∼400 MHz with minimum total harmonic distortion (THD) and ripple factor (RF) of 4.73% and 0.59, respectively. While, the single phase self-switching diode bridge rectifier (1P-SSDBR) has a cut-off frequency of ∼300 MHz with minimum total harmonic distortion (THD) and ripple factor (RF) of 47.86% and 1.94, respectively. Further, to validate the obtained results, the simulation models have been calibrated with experimental and theoretical findings.
- 2 May 2022
- Published by Elsevier in Micro and Nanostructures
- Vol. 167
Thermoelectric rectification in graphene based Y-junction
- 2 May 2022
- Published by Elsevier in Micro and Nanostructures
- Vol. 167
Thermoelectric rectification in graphene based Y-junction
- 20 September 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nanotechnology
- Vol. 20 (1536125X) , 733-738
Thermoelectric Effect in Graphene-Based Three-Terminal Junction
This paper presents the thermoelectric properties of graphene-based three-terminal junction on SiO 2 /Si substrate. The device demonstrates rectified output voltage while applying electrical (AC/DC) signal or temperature gradient at the input terminals. The voltage detection sensitivity of 736.38 mV/mW and noise equivalent power of 26 pW/Hz 1/2 is achieved at 15 V. At the temperature gradient of 150 K, the proposed device exhibits a thermal voltage of 0.83 mV at the output terminal. Accordinlgy, Seebeck coefficient of 82 and 123 μVK –1 is obtained at 300 and 450 K, respectively considering back-gate voltage of 0 V. The results are further validated by the analytical model and are well in agreement with the simulation results obtained utilizing Silvaco TCAD software. The results suggest that the proposed G-TTJ can be realised for future energy harvesting applications in addition to microwave/THz detection.
- 20 September 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nanotechnology
- Vol. 20 (1536125X) , 733-738
Thermoelectric Effect in Graphene-Based Three-Terminal Junction
This paper presents the thermoelectric properties of graphene-based three-terminal junction on SiO 2 /Si substrate. The device demonstrates rectified output voltage while applying electrical (AC/DC) signal or temperature gradient at the input terminals. The voltage detection sensitivity of 736.38 mV/mW and noise equivalent power of 26 pW/Hz 1/2 is achieved at 15 V. At the temperature gradient of 150 K, the proposed device exhibits a thermal voltage of 0.83 mV at the output terminal. Accordinlgy, Seebeck coefficient of 82 and 123 μVK –1 is obtained at 300 and 450 K, respectively considering back-gate voltage of 0 V. The results are further validated by the analytical model and are well in agreement with the simulation results obtained utilizing Silvaco TCAD software. The results suggest that the proposed G-TTJ can be realised for future energy harvesting applications in addition to microwave/THz detection.
- 16 June 2021
- Published by IOP Publishing in Semiconductor Science and Technology
- Vol. 36 (7) , 075017
InGaAs self-switching diode-based THz bridge rectifier
Here, an In 0.53 Ga 0.47 As-based self-switching diode bridge rectifier (SSDBR) is presented utilizing Silvaco TCAD computer simulations. A zero-bias self-switching diode exhibiting nonlinear current–voltage characteristics has been utilized for the device design. The output current, threshold voltage and maximum operating frequency of the device can be easily tuned by adjusting the channel width and length of the SSD, whereas the properties of conventional rectifiers are typically material-dependent. The AC and DC characteristics of the SSDBR are presented, demonstrating full wave rectification up to frequencies of 0.240 THz with a noise-equivalent power of 39.90 pW (Hz 1/2 ) −1 . Furthermore, the simulated results are validated by developing an analytical model for an InGaAs-based SSDBR.
- 16 June 2021
- Published by IOP Publishing in Semiconductor Science and Technology
- Vol. 36 (7) , 075017
InGaAs self-switching diode-based THz bridge rectifier
Here, an In 0.53 Ga 0.47 As-based self-switching diode bridge rectifier (SSDBR) is presented utilizing Silvaco TCAD computer simulations. A zero-bias self-switching diode exhibiting nonlinear current–voltage characteristics has been utilized for the device design. The output current, threshold voltage and maximum operating frequency of the device can be easily tuned by adjusting the channel width and length of the SSD, whereas the properties of conventional rectifiers are typically material-dependent. The AC and DC characteristics of the SSDBR are presented, demonstrating full wave rectification up to frequencies of 0.240 THz with a noise-equivalent power of 39.90 pW (Hz 1/2 ) −1 . Furthermore, the simulated results are validated by developing an analytical model for an InGaAs-based SSDBR.