Ya. S. Zimin
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Ya. S. Zimin has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
- Valery I. Savchenko
Federal Research Center of Problems of Chemical Physics and Medicinal Chemistry, Russian Academy of Sciences, Chernogolovka 142432, Russia
4 shared publications A. V. Nikitin
Institute of Problems of Chemical Physics, Russian Academy of Sciences, Chernogolovka, Moscow oblast, Russia
3 shared publications- Alexey V. Nikitin
N.N. Semenov Federal Research Center for Chemical Physics, Russian Academy of Sciences, Moscow 119991, Russia; Federal Research Center of Problems of Chemical Physics and Medicinal Chemistry, Russian Academy of Sciences, Chernogolovka 142432, Russia
3 shared publications I. V. Sedov
Institute of Problems of Chemical Physics, Russian Academy of Sciences, Chernogolovka, Moscow oblast, Russia
3 shared publications- Igor V. Sedov
Federal Research Center of Problems of Chemical Physics and Medicinal Chemistry, Russian Academy of Sciences, Chernogolovka, Russia
3 shared publications V. S. Arutyunov
Institute of Problems of Chemical Physics, Russian Academy of Sciences, Chernogolovka, Moscow oblast, Russia
3 shared publications
Latest Publications
- 1 August 2022
- Published by Pleiades Publishing Ltd in Russian Journal of Applied Chemistry
- Vol. 95 (8) , 1199-1206
Noncatalytic Syngas Production Processes and Possibilities of Reducing the СО2 Emission into the Environment
The development of noncatalytic procedures for processing hydrocarbon gases is an important way to increase the efficiency of gas-chemical processes and decrease their power consumption. The paper deals with thermodynamic and kinetic modeling of noncatalytic processes of the partial oxidation and steam and carbon dioxide conversion of methane in the temperature interval 1400–1800 K and with analysis of the process for syngas production by matrix conversion of rich methane–oxygen mixtures. Comparison of the kinetic calculations with the experimental data demonstrated the possibility of applying published models to the description of the matrix conversion of methane. The possibility of developing a highly efficient technology based on noncatalytic partial oxidation of hydrocarbons for the syngas production without СО2 emission into the environment is discussed.
- 1 August 2022
- Published by Pleiades Publishing Ltd in Russian Journal of Applied Chemistry
- Vol. 95 (8) , 1199-1206
Noncatalytic Syngas Production Processes and Possibilities of Reducing the СО2 Emission into the Environment
The development of noncatalytic procedures for processing hydrocarbon gases is an important way to increase the efficiency of gas-chemical processes and decrease their power consumption. The paper deals with thermodynamic and kinetic modeling of noncatalytic processes of the partial oxidation and steam and carbon dioxide conversion of methane in the temperature interval 1400–1800 K and with analysis of the process for syngas production by matrix conversion of rich methane–oxygen mixtures. Comparison of the kinetic calculations with the experimental data demonstrated the possibility of applying published models to the description of the matrix conversion of methane. The possibility of developing a highly efficient technology based on noncatalytic partial oxidation of hydrocarbons for the syngas production without СО2 emission into the environment is discussed.
- Open Access
- 6 May 2022
- Published by Pleiades Publishing Ltd in Petroleum Chemistry
- Vol. 62 (5) , 515-525
Equilibrium Composition of Products Formed by Non-catalytic Conversion of Hydrocarbons
The kinetic patterns of the attainment of the equilibrium product composition in non-catalytic processes of partial oxidation and of steam and carbon dioxide reforming of hydrocarbons in the temperature range 1400–1800 K, characteristic of these processes, were analyzed. The need for such analysis is caused by the rapidly increasing consumption of natural gas as a chemical feedstock and by growing attention to environmental problems, in particular, to a decrease in СО 2 emissions or to partial CO 2 utilization. The forward and reverse water gas shift reactions (WGSRs) play an important role in approach to the equilibrium product composition in these processes. Analysis has shown that the elementary reactions characteristic of forward and reverse WGSRs start to play a significant role long before the equilibrium in the system is attained. Already in the intermediate steps of the process, the distribution of the major reaction products, Н 2 , СО, Н 2 О, and СО 2 , almost corresponds to the equilibrium value of K t = ([H 2 ][CO 2 ])/([CO][H 2 O]), close to the WGSR equilibrium constant K eq , and further conversion of the products occurs at K t values close to K eq .
- 6 May 2022
- Published by Pleiades Publishing Ltd in Petroleum Chemistry
- Vol. 62 (5) , 515-525
Open AccessEquilibrium Composition of Products Formed by Non-catalytic Conversion of Hydrocarbons
The kinetic patterns of the attainment of the equilibrium product composition in non-catalytic processes of partial oxidation and of steam and carbon dioxide reforming of hydrocarbons in the temperature range 1400–1800 K, characteristic of these processes, were analyzed. The need for such analysis is caused by the rapidly increasing consumption of natural gas as a chemical feedstock and by growing attention to environmental problems, in particular, to a decrease in СО 2 emissions or to partial CO 2 utilization. The forward and reverse water gas shift reactions (WGSRs) play an important role in approach to the equilibrium product composition in these processes. Analysis has shown that the elementary reactions characteristic of forward and reverse WGSRs start to play a significant role long before the equilibrium in the system is attained. Already in the intermediate steps of the process, the distribution of the major reaction products, Н 2 , СО, Н 2 О, and СО 2 , almost corresponds to the equilibrium value of K t = ([H 2 ][CO 2 ])/([CO][H 2 O]), close to the WGSR equilibrium constant K eq , and further conversion of the products occurs at K t values close to K eq .
- 1 November 2021
- Published by Elsevier in Chemical Engineering Research and Design
- Vol. 175, 250-258
Impact of post-flame processes on the hydrogen yield in partial oxidation of methane in the matrix reformer
- 1 November 2021
- Published by Elsevier in Chemical Engineering Research and Design
- Vol. 175, 250-258
Impact of post-flame processes on the hydrogen yield in partial oxidation of methane in the matrix reformer
- 13 July 2021
- Published by Pleiades Publishing Ltd in Petroleum Chemistry
- Vol. 61 (7) , 762-772
Non-Catalytic Steam Reforming of C1–C4 Hydrocarbons
The paper reports the results of a kinetic modeling and thermodynamic analysis of non-catalytic steam reforming (NCSR) of methane and C2–C4 hydrocarbons at 1400–1800 K. The hydrocarbon-to-syngas conversion sequence and the time periods of the major process steps were identified. The initial step consists of hydrocarbon pyrolysis to acetylene and H2 with essentially no involvement of H2O. Noticeable H2O conversion starts at a significantly later point than thermal hydrocarbon conversion, under the effects of radicals formed from the pyrolysis. The H2O conversion results in the generation of OH● radicals, which subsequently react with acetylene to form CO and H2. The key step in the NCSR of C1–C4 hydrocarbons, as well as in their high-temperature interaction with CO2 (carbon-dioxide conversion) is conversion of the acetylene formed from the hydrocarbon pyrolysis. The study findings are important for the optimization of high-temperature syngas production via partial oxidation of hydrocarbons.
- 13 July 2021
- Published by Pleiades Publishing Ltd in Petroleum Chemistry
- Vol. 61 (7) , 762-772
Non-Catalytic Steam Reforming of C1–C4 Hydrocarbons
The paper reports the results of a kinetic modeling and thermodynamic analysis of non-catalytic steam reforming (NCSR) of methane and C2–C4 hydrocarbons at 1400–1800 K. The hydrocarbon-to-syngas conversion sequence and the time periods of the major process steps were identified. The initial step consists of hydrocarbon pyrolysis to acetylene and H2 with essentially no involvement of H2O. Noticeable H2O conversion starts at a significantly later point than thermal hydrocarbon conversion, under the effects of radicals formed from the pyrolysis. The H2O conversion results in the generation of OH● radicals, which subsequently react with acetylene to form CO and H2. The key step in the NCSR of C1–C4 hydrocarbons, as well as in their high-temperature interaction with CO2 (carbon-dioxide conversion) is conversion of the acetylene formed from the hydrocarbon pyrolysis. The study findings are important for the optimization of high-temperature syngas production via partial oxidation of hydrocarbons.
- 1 June 2021
- Published by Pleiades Publishing Ltd in Russian Journal of Applied Chemistry
- Vol. 94 (6) , 787-792
Oxidative Cracking of Propane in the Presence of Hydrogen
An effect of hydrogen additions to the initial mixture on the parameters of the oxidative cracking of propane at atmospheric pressure, temperatures of 500–750°C, reaction time of 2 s, and С3H8/О2 initial ratio ~2 was experimentally investigated. It was shown that small amounts of hydrogen promote the process due to the formation of additional active radicals OH• and H•. Performance of the oxidative cracking of propane in a large excess of hydrogen results in an increase in the yield of methane and ethane, while the yield of ethylene, the target product of the process, decreases.
- 1 June 2021
- Published by Pleiades Publishing Ltd in Russian Journal of Applied Chemistry
- Vol. 94 (6) , 787-792
Oxidative Cracking of Propane in the Presence of Hydrogen
An effect of hydrogen additions to the initial mixture on the parameters of the oxidative cracking of propane at atmospheric pressure, temperatures of 500–750°C, reaction time of 2 s, and С3H8/О2 initial ratio ~2 was experimentally investigated. It was shown that small amounts of hydrogen promote the process due to the formation of additional active radicals OH• and H•. Performance of the oxidative cracking of propane in a large excess of hydrogen results in an increase in the yield of methane and ethane, while the yield of ethylene, the target product of the process, decreases.
- 1 January 2021
- Published by Ioffe Institute Russian Academy of Sciences in Журнал технической физики
- Vol. 91 (5) , 713
К 125-летию со дня рождения лауреата Нобелевской премии академика Николая Николаевича Семенова Матричная конверсия природного газа в синтез-газ и водород как перспективное направление газохимии и энергетики
The basic principles of a new technology of non-catalytic oxidative reforming of hydrocarbon gases into syngas and hydrogen, based on the combustion of rich hydrocarbon-air or hydrocarbon-oxygen mixtures stabilized by the surface of a permeable matrix, are presented. The kinetics of the process, the prospects for its technological implementation and the most interesting applications are discussed.
- 1 January 2021
- Published by Ioffe Institute Russian Academy of Sciences in Журнал технической физики
- Vol. 91 (5) , 713
К 125-летию со дня рождения лауреата Нобелевской премии академика Николая Николаевича Семенова Матричная конверсия природного газа в синтез-газ и водород как перспективное направление газохимии и энергетики
The basic principles of a new technology of non-catalytic oxidative reforming of hydrocarbon gases into syngas and hydrogen, based on the combustion of rich hydrocarbon-air or hydrocarbon-oxygen mixtures stabilized by the surface of a permeable matrix, are presented. The kinetics of the process, the prospects for its technological implementation and the most interesting applications are discussed.
- 27 July 2020
- Published by Pleiades Publishing Ltd in Petroleum Chemistry
- Vol. 60 (7) , 818-826
Effect of Hydrogen, Carbon Monoxide, Synthesis Gas, and Steam Additives on the Characteristics of Matrix Conversion of Rich Methane–Oxygen Mixtures
An experimental study and detailed kinetic modeling of characteristics of the matrix conversion of a methane–oxygen mixture with the addition of hydrogen, carbon monoxide, synthesis gas, and steam have been carried out. It has been shown that the most significant effect on the product composition is provided by the admixture of steam, which reduces the yield of acetylene and at the same time increases the H2/CO ratio. The kinetic simulation results appear to agree well with the experimental data obtained.
- 27 July 2020
- Published by Pleiades Publishing Ltd in Petroleum Chemistry
- Vol. 60 (7) , 818-826
Effect of Hydrogen, Carbon Monoxide, Synthesis Gas, and Steam Additives on the Characteristics of Matrix Conversion of Rich Methane–Oxygen Mixtures
An experimental study and detailed kinetic modeling of characteristics of the matrix conversion of a methane–oxygen mixture with the addition of hydrogen, carbon monoxide, synthesis gas, and steam have been carried out. It has been shown that the most significant effect on the product composition is provided by the admixture of steam, which reduces the yield of acetylene and at the same time increases the H2/CO ratio. The kinetic simulation results appear to agree well with the experimental data obtained.