R. M. N. Muhad
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
R. M. N. Muhad has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
- Mohammad Zulkifly Abdullah
School of Mechanical Engineering, Engineering Campus, Universiti Sains Malaysia, Nibong Tebal, Malaysia
4 shared publications - Muhammad Abdul Mujeebu
Department of Building Engineering, College of Architecture and Planning, Imam Abdulrahman Bin Faisal University, Dammam, Saudi Arabia
4 shared publications A.A. Mohamad
2 shared publications- Aman Mohd Ihsan Mamat
Universiti Teknologi MARA
2 shared publications M. Z. Abu Bakar
School of Chemical Engineering, Universiti Sains Malaysia , Engineering Campus, Nibong Tebal, Penang, Malaysia
2 shared publicationsM.K. Abdullah
2 shared publications
Latest Publications
- 17 October 2015
- Published by Penerbit UTM Press in Jurnal Teknologi (Sciences & Engineering)
- Vol. 76 (11)
EFFECTS OF ETHANOL BLENDS ON GASOLINE ENGINE PERFORMANCE AND EXHAUST EMISSIONS
Automotive sector is one of the major contributors to air pollution and global warming due to the carbon residue and smoke opacity emission. Today, the trend of decreasing sources of petroleum fuel has led to innovation of other resources such as alternative fuel. Alternative fuel can be produced from biomass such as alcohol in which it is produced by fermentation of sugar, cane and corn. This experiment was conducted to investigate the effects of ethanol on gasoline engine performance and exhaust emissions. A four-stroke, single cylinder engine was tested by different range of ethanol volume percentages i.e. 10% (E10), 20% (E20) and 30% (E30) blended with fossil gasoline. The experiment was carried out at variations of engine speed and constant load. The engine speeds used for a constant load at 2 Nm were 2000rpm, 2500rpm and 3000rpm. From the results obtained, it shows that the brake specific fuel consumption for the blended fuel is better than gasoline fuel. Combustion efficiency of gasoline engine has improved with the use of ethanol-gasoline blends. Exhaust emissions such as CO and smoke opacity are decreased due to the presence of oxygenated properties of ethanol in blended fuel. However, emissions of CO2 are increased due to the high combustion temperature. In overall, the E20 shows the best results for all measured parameters at all engine test conditions.
- 17 October 2015
- Published by Penerbit UTM Press in Jurnal Teknologi (Sciences & Engineering)
- Vol. 76 (11)
EFFECTS OF ETHANOL BLENDS ON GASOLINE ENGINE PERFORMANCE AND EXHAUST EMISSIONS
Automotive sector is one of the major contributors to air pollution and global warming due to the carbon residue and smoke opacity emission. Today, the trend of decreasing sources of petroleum fuel has led to innovation of other resources such as alternative fuel. Alternative fuel can be produced from biomass such as alcohol in which it is produced by fermentation of sugar, cane and corn. This experiment was conducted to investigate the effects of ethanol on gasoline engine performance and exhaust emissions. A four-stroke, single cylinder engine was tested by different range of ethanol volume percentages i.e. 10% (E10), 20% (E20) and 30% (E30) blended with fossil gasoline. The experiment was carried out at variations of engine speed and constant load. The engine speeds used for a constant load at 2 Nm were 2000rpm, 2500rpm and 3000rpm. From the results obtained, it shows that the brake specific fuel consumption for the blended fuel is better than gasoline fuel. Combustion efficiency of gasoline engine has improved with the use of ethanol-gasoline blends. Exhaust emissions such as CO and smoke opacity are decreased due to the presence of oxygenated properties of ethanol in blended fuel. However, emissions of CO2 are increased due to the high combustion temperature. In overall, the E20 shows the best results for all measured parameters at all engine test conditions.
- Open Access
- 30 June 2015
- Published by Universiti Malaysia Pahang Al-Sultan Abdullah Press (UMPSA Press) in Journal of Mechanical Engineering and Sciences
- Vol. 8, 1498-1506
NUMERICAL HEAT TRANSFER ANALYSIS OF WASTE HEAT EXCHANGER FOR EXHAUST GAS ENERGY RECOVERY
Waste heat is heat that is usually thrown into the environment even though it could still be reused for some useful and economic purpose. For example, any exhaust gas stream with a temperature of above 80°C has the potential for significant waste heat recovery. Therefore, an attempt to reuse the exhaust waste energy to transfer the energy to any energy cycle is a worthwhile effort. In the present study, the waste energy from the exhaust gas of an internal combustion engine is recovered by converting it to ammonia (NH3) as an organic operating fluid in the Organic Rankine Cycle (ORC), which aims to produce 3 kW turbine power. To achieve a specific amount of energy, a key component in waste heat recovery is the heat exchanger. In the present study, a steady-state numerical analysis of heat transfer is conducted for various dimensional configurations of the waste heat exchanger using ammonia. The findings showed that the exhaust gas mass flow rate only has a very minimal effect on the length of the pipe when the exhaust temperature exceeds 400°C.
- 30 June 2015
- Published by Universiti Malaysia Pahang Al-Sultan Abdullah Press (UMPSA Press) in Journal of Mechanical Engineering and Sciences
- Vol. 8, 1498-1506
Open AccessNUMERICAL HEAT TRANSFER ANALYSIS OF WASTE HEAT EXCHANGER FOR EXHAUST GAS ENERGY RECOVERY
Waste heat is heat that is usually thrown into the environment even though it could still be reused for some useful and economic purpose. For example, any exhaust gas stream with a temperature of above 80°C has the potential for significant waste heat recovery. Therefore, an attempt to reuse the exhaust waste energy to transfer the energy to any energy cycle is a worthwhile effort. In the present study, the waste energy from the exhaust gas of an internal combustion engine is recovered by converting it to ammonia (NH3) as an organic operating fluid in the Organic Rankine Cycle (ORC), which aims to produce 3 kW turbine power. To achieve a specific amount of energy, a key component in waste heat recovery is the heat exchanger. In the present study, a steady-state numerical analysis of heat transfer is conducted for various dimensional configurations of the waste heat exchanger using ammonia. The findings showed that the exhaust gas mass flow rate only has a very minimal effect on the length of the pipe when the exhaust temperature exceeds 400°C.
- 11 April 2011
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- Vol. 33 (13) , 1260-1270
The Development and Performance Analysis of Partially Premixed LPG Porous Medium Combustor
Porous medium combustion has interesting advantages compared with free flame combustion due to higher burning rates, an increased power dynamic range, extension of the lean flammability limits, and low emissions of pollutants. This article presents the development and testing of a partially premixed porous medium combustor with liquified petroleum gas as fuel. The discrete porous medium is made up of Al2O3 spheres, the size of which is optimized by computer simulation. The NOx and CO emissions are measured for different numbers of porous layers and for different sizes of ceramic spheres, under both steady state and transient conditions of combustion. The data so obtained are plotted and compared with that of free flame combustion. The results show that the burner has good combustion efficiency and significantly lower NOx and CO emissions compared to the conventional combustor.
- 11 April 2011
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- Vol. 33 (13) , 1260-1270
The Development and Performance Analysis of Partially Premixed LPG Porous Medium Combustor
Porous medium combustion has interesting advantages compared with free flame combustion due to higher burning rates, an increased power dynamic range, extension of the lean flammability limits, and low emissions of pollutants. This article presents the development and testing of a partially premixed porous medium combustor with liquified petroleum gas as fuel. The discrete porous medium is made up of Al2O3 spheres, the size of which is optimized by computer simulation. The NOx and CO emissions are measured for different numbers of porous layers and for different sizes of ceramic spheres, under both steady state and transient conditions of combustion. The data so obtained are plotted and compared with that of free flame combustion. The results show that the burner has good combustion efficiency and significantly lower NOx and CO emissions compared to the conventional combustor.
- 1 January 2010
- Published by Begell House Inc. Publishers in Journal of Porous Media
- Vol. 13 (7) , 655-669
3-D NUMERICAL MODELING AND EXPERIMENTAL INVESTIGATION OF A PARTIAL PREMIX-TYPE POROUS MEDIUM BURNER USING LIQUEFIED PETROLEUM GAS FUEL
This article deals with the numerical modeling, development, and performance testing of a novel partial premix-type burner with a discrete porous medium using liquefied petroleum gas as fuel. The porous structure is made up of solid Al(2)O(3) spheres. The simulation is carried out with sphere sizes of 20 and 30 mm and with different layers of porous medium. The main objective of the study is to analyze the temperature distribution and emission characteristics of the porous medium burner compared with the conventional free flame combustion. Three-dimensional steady state combustion simulation is performed by FLUENT 6.2.16 and GAMBIT 2.2.30. The eddy dissipation model is employed for combustion, and the flow turbulence is simulated using the standard k-epsilon model with standard wall function. The results show that the burner has good combustion efficiency and significantly lower NO(x) and CO emissions compared to the conventional combustor. A test rig is fabricated and experiments are performed to validate the simulation results and are found to be in good agreement.
- 1 January 2010
- Published by Begell House Inc. Publishers in Journal of Porous Media
- Vol. 13 (7) , 655-669
3-D NUMERICAL MODELING AND EXPERIMENTAL INVESTIGATION OF A PARTIAL PREMIX-TYPE POROUS MEDIUM BURNER USING LIQUEFIED PETROLEUM GAS FUEL
This article deals with the numerical modeling, development, and performance testing of a novel partial premix-type burner with a discrete porous medium using liquefied petroleum gas as fuel. The porous structure is made up of solid Al(2)O(3) spheres. The simulation is carried out with sphere sizes of 20 and 30 mm and with different layers of porous medium. The main objective of the study is to analyze the temperature distribution and emission characteristics of the porous medium burner compared with the conventional free flame combustion. Three-dimensional steady state combustion simulation is performed by FLUENT 6.2.16 and GAMBIT 2.2.30. The eddy dissipation model is employed for combustion, and the flow turbulence is simulated using the standard k-epsilon model with standard wall function. The results show that the burner has good combustion efficiency and significantly lower NO(x) and CO emissions compared to the conventional combustor. A test rig is fabricated and experiments are performed to validate the simulation results and are found to be in good agreement.
- 1 November 2009
- Published by Elsevier in Journal of Environmental Management
- Vol. 91 (2) , 550
Corrigendum to “Combustion in porous media and its applications – A comprehensive survey” [Journal of Environmental Management 90 (2009) 2287–2312]
- 1 November 2009
- Published by Elsevier in Journal of Environmental Management
- Vol. 91 (2) , 550
Corrigendum to “Combustion in porous media and its applications – A comprehensive survey” [Journal of Environmental Management 90 (2009) 2287–2312]
- 1 June 2009
- Published by Elsevier in Journal of Environmental Management
- Vol. 90 (8) , 2287-2312
Combustion in porous media and its applications – A comprehensive survey
- 1 June 2009
- Published by Elsevier in Journal of Environmental Management
- Vol. 90 (8) , 2287-2312
Combustion in porous media and its applications – A comprehensive survey