Nothando Cynthia Shiba
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Nothando Cynthia Shiba has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Xinying Liu
University of South Africa (UNISA)
2 shared publications - Yali Yao
School of Chemical and Metallurgical Engineering, University of the Witwatersrand, Johannesburg, South Africa
2 shared publications - Diane Hildebrandt
University of Adelaide, Adelaide, Australia
1 shared publication - Freeman Ntuli
Department of Chemical, Materials and Metallurgical Engineering Botswana International University of Science and Technology Palapye Botswana
1 shared publication
Latest Publications
- Open Access
- 20 June 2025
- Published by Elsevier in Journal of CO2 Utilization
- Vol. 99
Stoichiometric perovskites as new class supports for Fe and Co in Fischer Tropsch Synthesis: A review
- 20 June 2025
- Published by Elsevier in Journal of CO2 Utilization
- Vol. 99
Open AccessStoichiometric perovskites as new class supports for Fe and Co in Fischer Tropsch Synthesis: A review
- Open Access
Insight into the Physicochemical Properties of Co-Based Catalysts in Fischer–Tropsch Synthesis
The effect of the different supports and catalyst-reducing agents on the Fischer–Tropsch (FT) reaction was investigated. The large surface area SiO2 support with a smaller pore volume deposited fine, evenly distributed Co3O4. Cubic-shaped Co3O4 appeared in clusters on the TiO2 support, whereas Co3O4 existed as single large particles on the Al2O3 support. The activity data obtained were discussed in terms of cluster size, particle size, particle shape, and mass transport limitations. The SiO2-supported catalysts showed a higher activity for the formation of paraffinic products when reduced in H2 at 250 °C. This is attributed to the formation of the CoO-Co active bond, which enhanced the activation of CO and the hydrogenation reactions. A higher activity was observed for the TiO2-supported catalyst at a higher reduction temperature (350 °C) when the mass of Co metal was higher. It afforded more paraffinic products due to enhanced secondary hydrogenation of olefins at higher reaction rates. The large Co3O4 supported on Al2O3 showed the least activity at both reduction temperatures due to strong metal-support interactions. The H2-reduced catalysts exhibited superior activity compared to all the syngas-reduced catalysts. Syngas reduction led to surface carbon deposition and the formation of surface carbides which suppressed the hydrogenation reactions and are selective to olefinic products.
Open AccessInsight into the Physicochemical Properties of Co-Based Catalysts in Fischer–Tropsch Synthesis
The effect of the different supports and catalyst-reducing agents on the Fischer–Tropsch (FT) reaction was investigated. The large surface area SiO2 support with a smaller pore volume deposited fine, evenly distributed Co3O4. Cubic-shaped Co3O4 appeared in clusters on the TiO2 support, whereas Co3O4 existed as single large particles on the Al2O3 support. The activity data obtained were discussed in terms of cluster size, particle size, particle shape, and mass transport limitations. The SiO2-supported catalysts showed a higher activity for the formation of paraffinic products when reduced in H2 at 250 °C. This is attributed to the formation of the CoO-Co active bond, which enhanced the activation of CO and the hydrogenation reactions. A higher activity was observed for the TiO2-supported catalyst at a higher reduction temperature (350 °C) when the mass of Co metal was higher. It afforded more paraffinic products due to enhanced secondary hydrogenation of olefins at higher reaction rates. The large Co3O4 supported on Al2O3 showed the least activity at both reduction temperatures due to strong metal-support interactions. The H2-reduced catalysts exhibited superior activity compared to all the syngas-reduced catalysts. Syngas reduction led to surface carbon deposition and the formation of surface carbides which suppressed the hydrogenation reactions and are selective to olefinic products.
- Open Access
Effect of Pre-Treatment Conditions on the Activity and Selectivity of Cobalt-Based Catalysts for CO Hydrogenation
We investigated the effect of pre-treatment conditions on the activity and selectivity of cobalt catalysts for Fischer–Tropsch synthesis (FTS) by varying both the reduction atmosphere and the reduction temperature. Catalysts supported on SiO2, Al2O3, and TiO2, prepared via incipient wetness impregnation, were evaluated, and activation temperatures in the range 250–350 °C were considered. Activation with syngas led to a better product selectivity (low CH4, high selectivity to liquid hydrocarbons, and low paraffin to olefin ratio (P/O)) than the catalysts reduced in H2 at lower activation temperatures. The CoxC species suppressed the hydrogenation reaction, and it is hypothesised that this resulted in the high selectivity of olefins observed for the syngas pre-treated catalysts. On the basis of the experimental results, we postulated that a synergistic effect between Co0 and CoxC promotes the production of the long chain hydrocarbons and suppresses the formation of CH4. In addition, for systems aimed at producing lower olefins, syngas activation is recommended, and for the FTS plants that focus on maximising the production of higher molecular weight products, H2 activation might be considered. These results provide insights for the future FTS catalyst design and for target product-driven operations.
Open AccessEffect of Pre-Treatment Conditions on the Activity and Selectivity of Cobalt-Based Catalysts for CO Hydrogenation
We investigated the effect of pre-treatment conditions on the activity and selectivity of cobalt catalysts for Fischer–Tropsch synthesis (FTS) by varying both the reduction atmosphere and the reduction temperature. Catalysts supported on SiO2, Al2O3, and TiO2, prepared via incipient wetness impregnation, were evaluated, and activation temperatures in the range 250–350 °C were considered. Activation with syngas led to a better product selectivity (low CH4, high selectivity to liquid hydrocarbons, and low paraffin to olefin ratio (P/O)) than the catalysts reduced in H2 at lower activation temperatures. The CoxC species suppressed the hydrogenation reaction, and it is hypothesised that this resulted in the high selectivity of olefins observed for the syngas pre-treated catalysts. On the basis of the experimental results, we postulated that a synergistic effect between Co0 and CoxC promotes the production of the long chain hydrocarbons and suppresses the formation of CH4. In addition, for systems aimed at producing lower olefins, syngas activation is recommended, and for the FTS plants that focus on maximising the production of higher molecular weight products, H2 activation might be considered. These results provide insights for the future FTS catalyst design and for target product-driven operations.
- 1 February 2017
- Published by Elsevier in Waste Management
- Vol. 60, 191-200
Extraction and precipitation of phosphorus from sewage sludge
- 1 February 2017
- Published by Elsevier in Waste Management
- Vol. 60, 191-200
Extraction and precipitation of phosphorus from sewage sludge