Zafar Namazian
Research Subjects
Zafar Namazian has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
Heidar Hashemi
4 shared publicationsS.A.M. Mehryan
Islamic Azad Univ, Dept Mech Engn, Yasooj Branch, Yasuj, Iran
4 shared publicationsA. R. Hosseini Asl
1 shared publicationAli J. Chamkha
Prince Mohammad Bin Fahd University
1 shared publication- Amin Najafi
School of Automotive Engineering, Iran University of Science and Technology (IUST), Tehran, Iran
1 shared publication Farideh Namazian
1 shared publication
Latest Publications
- 7 October 2019
- Published by Emerald Publishing in International Journal of Numerical Methods for Heat & Fluid Flow
- Vol. 29 (10) , 3685-3706
The impacts of non-uniform magnetic field on free convection heat transfer of a magnetizable micropolar nanofluid
Purpose The purpose of this study is to numerically study the heat transfer of free convection of a magnetizable micropolar nanofluid inside a semicircular enclosure. Design/methodology/approach The flow domain is under simultaneous influences of two non-uniform magnetic fields generated by current carrying wires. The directions of the currents are the same. Although the geometry is symmetric, it is physically asymmetric. The impacts of key parameters, including Rayleigh number Ra = 10(3)-10(6), Hartman number Ha = 0-50, vortex viscosity parameter Delta = 0-4, nanoparticles volume fraction phi = 0-0.04 and magnetic number Mn-f = 0-1000, on the macro- and micro-scales flows, temperature and heat transfer rate are studied. Finding The outcomes show that dispersing of the nanoparticles in the host fluid increases the strength of macro- and micro-scale flows. When Mn-f = 0, the increment of the vortex viscosity parameter increases the strength of the particles micro-rotations, while this characteristic is decreased by growing Delta for Mn-f not equal 0. The increment of Delta and Ha decreases the rate of heat transfer. The increment of Ha decreases the enhancement percentage of heat transfer rate because of dispersing nanoparticles, known as En parameter. In addition, the value of Delta has no effect on En. Moreover, the average Nusselt number Nu(avg) and En remain constant by increasing the magnetic number Mn-f for different volume fraction values. Originality/value The authors believe that all of the results, both numerical and asymptotic, are original and have not been published elsewhere yet.
- 7 October 2019
- Published by Emerald Publishing in International Journal of Numerical Methods for Heat & Fluid Flow
- Vol. 29 (10) , 3685-3706
The impacts of non-uniform magnetic field on free convection heat transfer of a magnetizable micropolar nanofluid
Purpose The purpose of this study is to numerically study the heat transfer of free convection of a magnetizable micropolar nanofluid inside a semicircular enclosure. Design/methodology/approach The flow domain is under simultaneous influences of two non-uniform magnetic fields generated by current carrying wires. The directions of the currents are the same. Although the geometry is symmetric, it is physically asymmetric. The impacts of key parameters, including Rayleigh number Ra = 10(3)-10(6), Hartman number Ha = 0-50, vortex viscosity parameter Delta = 0-4, nanoparticles volume fraction phi = 0-0.04 and magnetic number Mn-f = 0-1000, on the macro- and micro-scales flows, temperature and heat transfer rate are studied. Finding The outcomes show that dispersing of the nanoparticles in the host fluid increases the strength of macro- and micro-scale flows. When Mn-f = 0, the increment of the vortex viscosity parameter increases the strength of the particles micro-rotations, while this characteristic is decreased by growing Delta for Mn-f not equal 0. The increment of Delta and Ha decreases the rate of heat transfer. The increment of Ha decreases the enhancement percentage of heat transfer rate because of dispersing nanoparticles, known as En parameter. In addition, the value of Delta has no effect on En. Moreover, the average Nusselt number Nu(avg) and En remain constant by increasing the magnetic number Mn-f for different volume fraction values. Originality/value The authors believe that all of the results, both numerical and asymptotic, are original and have not been published elsewhere yet.
- 1 December 2018
- Published by Elsevier in Journal of Molecular Liquids
- Vol. 271, 914-925
MHD natural convection of a micropolar nanofluid flowing inside a radiative porous medium under LTNE condition with an elliptical heat source
- 1 December 2018
- Published by Elsevier in Journal of Molecular Liquids
- Vol. 271, 914-925
MHD natural convection of a micropolar nanofluid flowing inside a radiative porous medium under LTNE condition with an elliptical heat source
- 1 June 2017
- Published by Elsevier in Journal of Molecular Liquids
- Vol. 236, 48-60
Cu-water micropolar nanofluid natural convection within a porous enclosure with heat generation
- 1 June 2017
- Published by Elsevier in Journal of Molecular Liquids
- Vol. 236, 48-60
Cu-water micropolar nanofluid natural convection within a porous enclosure with heat generation
- Open Access
- 1 September 2016
- Published by Walter de Gruyter GmbH in Archive of Mechanical Engineering
- Vol. 63 (3) , 355-366
Investigation on Effect of Air Velocity in Turbulent Non-Premixed Flames
In this study, the turbulent non-premixed methane-air flame is simulated to determine the effect of air velocity on the length of flame, temperature distribution and mole fraction of species. The computational fluid dynamics (CFD) technique is used to perform this simulation. To solve the turbulence flow, k-ε model is used. In contrast to the previous works, in this study, in each one of simulations the properties of materials are taken variable and then the results are compared. The results show that at a certain flow rate of fuel, by increasing the air velocity, similar to when the properties are constant, the width of the flame becomes thinner and the maximum temperature is higher; the penetration of oxygen into the fuel as well as fuel consumption is also increased. It is noteworthy that most of the pollutants produced are NOx, which are strongly temperature dependent. The amount of these pollutants rises when the temperature is increased. As a solution, decreasing the air velocity can decrease the amount of these pollutants. Finally, comparing the result of this study and the other work, which considers constant properties, shows that the variable properties assumption leads to obtaining more exact solution but the trends of both results are similar.
- 1 September 2016
- Published by Walter de Gruyter GmbH in Archive of Mechanical Engineering
- Vol. 63 (3) , 355-366
Open AccessInvestigation on Effect of Air Velocity in Turbulent Non-Premixed Flames
In this study, the turbulent non-premixed methane-air flame is simulated to determine the effect of air velocity on the length of flame, temperature distribution and mole fraction of species. The computational fluid dynamics (CFD) technique is used to perform this simulation. To solve the turbulence flow, k-ε model is used. In contrast to the previous works, in this study, in each one of simulations the properties of materials are taken variable and then the results are compared. The results show that at a certain flow rate of fuel, by increasing the air velocity, similar to when the properties are constant, the width of the flame becomes thinner and the maximum temperature is higher; the penetration of oxygen into the fuel as well as fuel consumption is also increased. It is noteworthy that most of the pollutants produced are NOx, which are strongly temperature dependent. The amount of these pollutants rises when the temperature is increased. As a solution, decreasing the air velocity can decrease the amount of these pollutants. Finally, comparing the result of this study and the other work, which considers constant properties, shows that the variable properties assumption leads to obtaining more exact solution but the trends of both results are similar.
- Open Access
- 15 July 2016
- Published by Oxford University Press (OUP) in Journal of Mechanics
- Vol. 33 (2) , 205-212
Numerical Simulation of Particle-Gas Flow Through a Fixed Pipe, Using One-Way and Two-Way Coupling Methods
A numerical simulation of the particle-gas flow in a vertical turbulent pipe flow was conducted. The main objective of the present article is to investigate the effects of dispersed phase (particles) on continuous phase (gas). In so doing, two general forms of Eulerian-Lagrangian approaches namely, one-way (when the fluid flow is not affected by the presence of the particles) and two-way (when the particles exert a feedback force on the fluid) couplings were used to describe the equations of motion of the two-phase flow. Gas-phase velocities which are within the order of magnitude as that of particles, volume fraction, and particle Stokes number were calculated and the results were subsequently compared with the available experimental data. The simulated results show that when the particles are added, the fluid velocity is attenuated. With an increase in particle volume fraction, particle mass loading and Stokes number, velocity attenuation also increases. Moreover, the results indicate that an increase in particle Stokes number reduces the special limited particle volume fraction, according to which one-way coupling method yields plausible results. The results have also indicated that the significance of particle fluid interaction is not merely a function of volume fraction and particle Stokes number.
- 15 July 2016
- Published by Oxford University Press (OUP) in Journal of Mechanics
- Vol. 33 (2) , 205-212
Open AccessNumerical Simulation of Particle-Gas Flow Through a Fixed Pipe, Using One-Way and Two-Way Coupling Methods
A numerical simulation of the particle-gas flow in a vertical turbulent pipe flow was conducted. The main objective of the present article is to investigate the effects of dispersed phase (particles) on continuous phase (gas). In so doing, two general forms of Eulerian-Lagrangian approaches namely, one-way (when the fluid flow is not affected by the presence of the particles) and two-way (when the particles exert a feedback force on the fluid) couplings were used to describe the equations of motion of the two-phase flow. Gas-phase velocities which are within the order of magnitude as that of particles, volume fraction, and particle Stokes number were calculated and the results were subsequently compared with the available experimental data. The simulated results show that when the particles are added, the fluid velocity is attenuated. With an increase in particle volume fraction, particle mass loading and Stokes number, velocity attenuation also increases. Moreover, the results indicate that an increase in particle Stokes number reduces the special limited particle volume fraction, according to which one-way coupling method yields plausible results. The results have also indicated that the significance of particle fluid interaction is not merely a function of volume fraction and particle Stokes number.
- 27 December 2012
- Published by Trans Tech Publications, Ltd. in Advanced Materials Research
- Vol. 622-623, 1492-1497
Aeroacoustic Analysis of Automobile Antenna in Various Positions
In this paper, we investigate the effect of antenna location on aerodynamic and acoustic parameters. In order to study this, five different antenna positions are considered. The chosen positions are based on the common situation in actual cars. The finite volume numerical method is used. The obtained results show that the location of antenna at the trunk, perpendicular to the surface, produces the minimum noise.
- 27 December 2012
- Published by Trans Tech Publications, Ltd. in Advanced Materials Research
- Vol. 622-623, 1492-1497
Aeroacoustic Analysis of Automobile Antenna in Various Positions
In this paper, we investigate the effect of antenna location on aerodynamic and acoustic parameters. In order to study this, five different antenna positions are considered. The chosen positions are based on the common situation in actual cars. The finite volume numerical method is used. The obtained results show that the location of antenna at the trunk, perpendicular to the surface, produces the minimum noise.