Daniele Spada
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Daniele Spada has a total of 32 co-authors. Here are the top co-authors by number of shared publications:
- Marcella Bini
University of Pavia
10 shared publications Benedetta Albini
3 shared publicationsIrene Quinzeni
Dept. of Chemistry University of Pavia viale Taramelli 16 27100 Pavia Italy
3 shared publicationsMaria Cristina Mozzati
3 shared publicationsPietro Galinetto
3 shared publications- Alberto Cini
Dipartimento di Fisica e Astronomia, Università degli Studi di Firenze, Sesto Fiorentino, Firenze, I-50019, Italy
2 shared publications
Latest Publications
- 19 December 2022
- Published by Elsevier in Materials Research Bulletin
- Vol. 160
Understanding the electrochemical features of ZnFe2O4, anode for LIBs, by deepening its physico-chemical properties
- 19 December 2022
- Published by Elsevier in Materials Research Bulletin
- Vol. 160
Understanding the electrochemical features of ZnFe2O4, anode for LIBs, by deepening its physico-chemical properties
- Open Access
- 11 September 2022
- Published by MDPI AG in Applied Sciences
- Vol. 12 (18) , 9123
Physico-Chemical Features of Undoped and Fe/Cu-Doped Na0.67MnO2-Layered Cathodes for Sodium Batteries
Na0.67MnO2 (NMO) stands out among the layered cathode materials used for sodium batteries due to its high-capacity values, low cost, and environmental friendliness. Unfortunately, many drawbacks arise during cycling, but nanostructure tailoring and doping can help to mitigate them. Our aim was to synthesize undoped and Cu- or Fe-doped NMO samples via the sol-gel route, with a different cooling step to room temperature, i.e., in a natural way or via quenching. The formation of a mixture of polymorphs was observed, as well as differences in the external morphology of the powders’ grains. The use of spectroscopic techniques, Mössbauer spectroscopy for the Fe-doped samples and Electron paramagnetic resonance, allowed us to gain insights into the oxidation states of transition metals and to make suggestions about the magnetic ordering, as well as on the possible presence of magnetic impurities. Cyclic voltammetry and galvanostatic cycling results were interpreted on the basis of the spectroscopic data: the introduction of substituents, in general, worsens the capacity values, due to the decrease in the P2 amount and the introduction of structural distortions. The structural stability of the samples in air as a function of time was also analyzed via X-ray diffraction, demonstrating the positive effect of Cu presence.
- 11 September 2022
- Published by MDPI AG in Applied Sciences
- Vol. 12 (18) , 9123
Open AccessPhysico-Chemical Features of Undoped and Fe/Cu-Doped Na0.67MnO2-Layered Cathodes for Sodium Batteries
Na0.67MnO2 (NMO) stands out among the layered cathode materials used for sodium batteries due to its high-capacity values, low cost, and environmental friendliness. Unfortunately, many drawbacks arise during cycling, but nanostructure tailoring and doping can help to mitigate them. Our aim was to synthesize undoped and Cu- or Fe-doped NMO samples via the sol-gel route, with a different cooling step to room temperature, i.e., in a natural way or via quenching. The formation of a mixture of polymorphs was observed, as well as differences in the external morphology of the powders’ grains. The use of spectroscopic techniques, Mössbauer spectroscopy for the Fe-doped samples and Electron paramagnetic resonance, allowed us to gain insights into the oxidation states of transition metals and to make suggestions about the magnetic ordering, as well as on the possible presence of magnetic impurities. Cyclic voltammetry and galvanostatic cycling results were interpreted on the basis of the spectroscopic data: the introduction of substituents, in general, worsens the capacity values, due to the decrease in the P2 amount and the introduction of structural distortions. The structural stability of the samples in air as a function of time was also analyzed via X-ray diffraction, demonstrating the positive effect of Cu presence.
- 24 February 2022
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 126 (9) , 4698-4709
Spectroscopic Techniques and DFT Calculations to Highlight the Effect of Fe3+ on the Properties of FeNb11O29, Anode Material for Lithium-Ion Batteries
- 24 February 2022
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 126 (9) , 4698-4709
Spectroscopic Techniques and DFT Calculations to Highlight the Effect of Fe3+ on the Properties of FeNb11O29, Anode Material for Lithium-Ion Batteries
- Open Access
Self-Supported Fibrous Sn/SnO2@C Nanocomposite as Superior Anode Material for Lithium-Ion Batteries
Low-cost and simple methods are constantly chased in order to produce less expensive lithium-ion batteries (LIBs) while possibly increasing the energy and power density as well as the volumetric capacity in order to boost a rapid decarbonization of the transport sector. Li alloys and tin-carbon composites are promising candidates as anode materials for LIBs both in terms of capacity and cycle life. In the present paper, electrospinning was employed in the preparation of Sn/SnOx@C composites, where tin and tin oxides were homogeneously dispersed in a carbonaceous matrix of carbon nanofibers. The resulting self-standing and light electrode showed a greatly enhanced performance compared to a conventional electrode based on the same starting materials that are simply mixed to obtain a slurry then deposited on a Cu foil. Fast kinetics were achieved with more than 90% of the reaction that resulted being surface-controlled, and stable capacities of about 300 mAh/g over 500 cycles were obtained at a current density of 0.5 A/g.
Open AccessSelf-Supported Fibrous Sn/SnO2@C Nanocomposite as Superior Anode Material for Lithium-Ion Batteries
Low-cost and simple methods are constantly chased in order to produce less expensive lithium-ion batteries (LIBs) while possibly increasing the energy and power density as well as the volumetric capacity in order to boost a rapid decarbonization of the transport sector. Li alloys and tin-carbon composites are promising candidates as anode materials for LIBs both in terms of capacity and cycle life. In the present paper, electrospinning was employed in the preparation of Sn/SnOx@C composites, where tin and tin oxides were homogeneously dispersed in a carbonaceous matrix of carbon nanofibers. The resulting self-standing and light electrode showed a greatly enhanced performance compared to a conventional electrode based on the same starting materials that are simply mixed to obtain a slurry then deposited on a Cu foil. Fast kinetics were achieved with more than 90% of the reaction that resulted being surface-controlled, and stable capacities of about 300 mAh/g over 500 cycles were obtained at a current density of 0.5 A/g.
- Open Access
- 9 December 2021
- Published by MDPI AG in Applied Sciences
- Vol. 11 (24) , 11713
ZnFe2O4, a Green and High-Capacity Anode Material for Lithium-Ion Batteries: A Review
Ferrites, a broad class of ceramic oxides, possess intriguing physico-chemical properties, mainly due to their unique structural features, that, during these last 50–60 years, made them the materials of choice for many different applications. They are, indeed, applied as inductors, high-frequency materials, for electric field suppression, as catalysts and sensors, in nanomedicine for magneto-fluid hyperthermia and magnetic resonance imaging, and, more recently, in electrochemistry. In particular, ZnFe2O4 and its solid solutions are drawing scientists’ attention for the application as anode materials for lithium-ion batteries (LIBs). The main reasons are found in the low cost, abundance, and environmental friendliness of both Zn and Fe precursors, high surface-to-volume ratio, relatively short path for Li-ion diffusion, low working voltage of about 1.5 V for lithium extraction, and the high theoretical specific capacity (1072 mAh g−1). However, some drawbacks are represented by fast capacity fading and poor rate capability, resulting from a low electronic conductivity, severe agglomeration, and large volume change during lithiation/delithiation processes. In this review, the main synthesis methods of spinels will be briefly discussed before presenting the most recent and promising electrochemical results on ZnFe2O4 obtained with peculiar morphologies/architectures or as composites, which represent the focus of this review.
- 9 December 2021
- Published by MDPI AG in Applied Sciences
- Vol. 11 (24) , 11713
Open AccessZnFe2O4, a Green and High-Capacity Anode Material for Lithium-Ion Batteries: A Review
Ferrites, a broad class of ceramic oxides, possess intriguing physico-chemical properties, mainly due to their unique structural features, that, during these last 50–60 years, made them the materials of choice for many different applications. They are, indeed, applied as inductors, high-frequency materials, for electric field suppression, as catalysts and sensors, in nanomedicine for magneto-fluid hyperthermia and magnetic resonance imaging, and, more recently, in electrochemistry. In particular, ZnFe2O4 and its solid solutions are drawing scientists’ attention for the application as anode materials for lithium-ion batteries (LIBs). The main reasons are found in the low cost, abundance, and environmental friendliness of both Zn and Fe precursors, high surface-to-volume ratio, relatively short path for Li-ion diffusion, low working voltage of about 1.5 V for lithium extraction, and the high theoretical specific capacity (1072 mAh g−1). However, some drawbacks are represented by fast capacity fading and poor rate capability, resulting from a low electronic conductivity, severe agglomeration, and large volume change during lithiation/delithiation processes. In this review, the main synthesis methods of spinels will be briefly discussed before presenting the most recent and promising electrochemical results on ZnFe2O4 obtained with peculiar morphologies/architectures or as composites, which represent the focus of this review.
- 1 June 2019
- Published by Elsevier in Optical Materials
- Vol. 92, 373-378
Effects of reaction atmosphere on physico-chemical properties of V-doped FeNb11O29
- 1 June 2019
- Published by Elsevier in Optical Materials
- Vol. 92, 373-378
Effects of reaction atmosphere on physico-chemical properties of V-doped FeNb11O29
- 21 May 2019
- Published by Wiley in ChemistrySelect
- Vol. 4 (19) , 5656-5661
The Doping of FeNb 11 O 29 as a Way to Improve Its Electrochemical Performances
FeNb 11 O 29 , with the possibility to exchange up to 23 electrons per formula unit and a theoretical capacity value of 400 mAh/g, is nowadays a very promising anode material for Li‐ion batteries. However, the improvement of its electrochemical performances is still an open challenge, and the doping is a well‐recognized method to obtain this goal. In this paper, orthorhombic Fe 0.8 Mn 0.2 Nb 11 O 29 and Fe 0.8 V 0.2 Nb 11 O 29 samples were prepared by solid state synthesis. The redox processes, as determined by cyclic voltammetry, involve only Fe and Nb ions as in the undoped compound. FeNb 11 O 29 is a well‐known mixed oxide with pseudocapacitive behavior, which is increased with the Mn doping. The doped samples show better performances during long term cycling at 2 C, with capacities of 240 and 220 mAh/g and capacity retention of 100.9 and 98.7% for Mn and V doped respectively.
- 21 May 2019
- Published by Wiley in ChemistrySelect
- Vol. 4 (19) , 5656-5661
The Doping of FeNb 11 O 29 as a Way to Improve Its Electrochemical Performances
FeNb 11 O 29 , with the possibility to exchange up to 23 electrons per formula unit and a theoretical capacity value of 400 mAh/g, is nowadays a very promising anode material for Li‐ion batteries. However, the improvement of its electrochemical performances is still an open challenge, and the doping is a well‐recognized method to obtain this goal. In this paper, orthorhombic Fe 0.8 Mn 0.2 Nb 11 O 29 and Fe 0.8 V 0.2 Nb 11 O 29 samples were prepared by solid state synthesis. The redox processes, as determined by cyclic voltammetry, involve only Fe and Nb ions as in the undoped compound. FeNb 11 O 29 is a well‐known mixed oxide with pseudocapacitive behavior, which is increased with the Mn doping. The doped samples show better performances during long term cycling at 2 C, with capacities of 240 and 220 mAh/g and capacity retention of 100.9 and 98.7% for Mn and V doped respectively.
- 1 February 2019
- Published by Elsevier in Electrochimica Acta
- Vol. 296, 938-944
Orthorhombic and monoclinic modifications of FeNb11O29, as promising anode materials for lithium batteries: Relationships between pseudocapacitive behaviour and structure
- 1 February 2019
- Published by Elsevier in Electrochimica Acta
- Vol. 296, 938-944
Orthorhombic and monoclinic modifications of FeNb11O29, as promising anode materials for lithium batteries: Relationships between pseudocapacitive behaviour and structure
- 12 October 2018
- Published by Royal Society of Chemistry (RSC) in Dalton Transactions
- Vol. 47 (44) , 15816-15826
Deepening the shear structure FeNb11O29: influence of polymorphism and doping on structural, spectroscopic and magnetic properties
FeNb11O29, an intriguing and promising material is emerging in the last few years due to its peculiar structural features.
- 12 October 2018
- Published by Royal Society of Chemistry (RSC) in Dalton Transactions
- Vol. 47 (44) , 15816-15826
Deepening the shear structure FeNb11O29: influence of polymorphism and doping on structural, spectroscopic and magnetic properties
FeNb11O29, an intriguing and promising material is emerging in the last few years due to its peculiar structural features.