Zhirui Su
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Zhirui Su has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Rulei Xiao
Nanjing University
2 shared publications - Xiangfei Chen
Nanjing University
2 shared publications - Yuechun Shi
YongJiang Laboratory
2 shared publications - Zhenxing Sun
YongJiang Laboratory
2 shared publications - Gen Lv
Key Laboratory of Intelligent Optical Sensing and Manipulation of the Ministry of Education, Nanjing University-Tongding Joint Lab for Large-scale Photonic Integrated Circuits, National Laboratory of Solid-State Microstructures, College of Engineering and Applied Science, Institute of Optical Communication Engineering, Nanjing University, Nanjing, China
1 shared publication - Jilin Zheng
Army Engineering University of PLA, Nanjing, China
1 shared publication
Latest Publications
- 29 June 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 38 (21) , 6038-6046
High Single-Mode Stability Tunable In-Series Laser Array With High Wavelength-spacing Uniformity
Multi-wavelength distributed feedback laser array based tunable semiconductor lasers have been widely used owing to their high mode stability and simple tuning scheme. Comparing with the in-parallel laser array, the in-series one can avoid a large power loss caused by the optical combiner. However, the single-mode stability of an in-series laser array is vulnerable to the reflections of other lasers. Here we experimentally demonstrated a tunable in-series laser array with high single-mode stability and high uniformity of wavelength spacing. To reduce the impact of such reflections, the Bragg gratings in different lasers were designed in phase, and the grating phase error was reduced by utilizing the reconstruction-equivalent-chirp technique. Besides, a three-section laser structure was applied in each laser to increase the priority of the dominant lasing mode. Four lasers with small wavelength-spacings of 2.5 nm were integrated in the in-series laser array. According to the measurement results of 40 in-series laser arrays (160 lasers), wavelength deviations of 90.6% lasers were within ±0.2 nm, average wavelength spacings of 97.5% of the measured laser arrays were deviated from the design within ±0.2 nm, and SMSRs of 96.3% lasers were above 45 dB. The output power was above 25 mW and the relative intensity noise was below -130 dB/Hz. Like the in-parallel laser array, the proposed laser array can be applied in either continuous wavelength tuning or fast channel switching. For the continuous wavelength tuning applications, the 10-nm tuning range was obtained with a temperature tuning range of less than 20 °C. For the fast channel switching applications, 4 channels with 2.5-nm spacing are available, and the switching time between two channels was less than 300 ns.
- 29 June 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 38 (21) , 6038-6046
High Single-Mode Stability Tunable In-Series Laser Array With High Wavelength-spacing Uniformity
Multi-wavelength distributed feedback laser array based tunable semiconductor lasers have been widely used owing to their high mode stability and simple tuning scheme. Comparing with the in-parallel laser array, the in-series one can avoid a large power loss caused by the optical combiner. However, the single-mode stability of an in-series laser array is vulnerable to the reflections of other lasers. Here we experimentally demonstrated a tunable in-series laser array with high single-mode stability and high uniformity of wavelength spacing. To reduce the impact of such reflections, the Bragg gratings in different lasers were designed in phase, and the grating phase error was reduced by utilizing the reconstruction-equivalent-chirp technique. Besides, a three-section laser structure was applied in each laser to increase the priority of the dominant lasing mode. Four lasers with small wavelength-spacings of 2.5 nm were integrated in the in-series laser array. According to the measurement results of 40 in-series laser arrays (160 lasers), wavelength deviations of 90.6% lasers were within ±0.2 nm, average wavelength spacings of 97.5% of the measured laser arrays were deviated from the design within ±0.2 nm, and SMSRs of 96.3% lasers were above 45 dB. The output power was above 25 mW and the relative intensity noise was below -130 dB/Hz. Like the in-parallel laser array, the proposed laser array can be applied in either continuous wavelength tuning or fast channel switching. For the continuous wavelength tuning applications, the 10-nm tuning range was obtained with a temperature tuning range of less than 20 °C. For the fast channel switching applications, 4 channels with 2.5-nm spacing are available, and the switching time between two channels was less than 300 ns.
- 31 January 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 38 (8) , 2299-2307
Design of Four-Channel Wavelength-Selectable In-Series DFB Laser Array With 100-GHz Spacing
A four-channel wavelength-selectable in-series DFB laser array with good single-longitudinal-mode (SLM) property is proposed and theoretically analyzed. To realize good SLM property, a linearly chirped Bragg grating with multiple phase shifts are implemented in the laser cavity. In addition, two reflector sections with chirped Bragg grating are specially designed for reflection compensation at both ends. In our simulation, the split-step time-domain model with coupled-wave equations and carrier rate equations are used. Based on the simulation results, all the channels work with low threshold currents and the SLM properties are considerably enhanced compared with the conventional in-series laser array. Notably a high precision control of grating phase is required in the practical fabrication due to the ultra-small variation of grating period. Therefore, the reconstruction-equivalent-chirp technique is discussed to provide the fabrication of high-precision grating. In addition, the complex heterogeneous integration or butt-joint technique is not required during the whole fabrication process, which simplifies the fabrication and reduces the cost. The proposed wavelength-selectable in-series laser array is deemed to be applied in the dense wavelength division multiplexing technology, especially when fast wavelength switching is needed, such as in the application of NGPON2.
- 31 January 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 38 (8) , 2299-2307
Design of Four-Channel Wavelength-Selectable In-Series DFB Laser Array With 100-GHz Spacing
A four-channel wavelength-selectable in-series DFB laser array with good single-longitudinal-mode (SLM) property is proposed and theoretically analyzed. To realize good SLM property, a linearly chirped Bragg grating with multiple phase shifts are implemented in the laser cavity. In addition, two reflector sections with chirped Bragg grating are specially designed for reflection compensation at both ends. In our simulation, the split-step time-domain model with coupled-wave equations and carrier rate equations are used. Based on the simulation results, all the channels work with low threshold currents and the SLM properties are considerably enhanced compared with the conventional in-series laser array. Notably a high precision control of grating phase is required in the practical fabrication due to the ultra-small variation of grating period. Therefore, the reconstruction-equivalent-chirp technique is discussed to provide the fabrication of high-precision grating. In addition, the complex heterogeneous integration or butt-joint technique is not required during the whole fabrication process, which simplifies the fabrication and reduces the cost. The proposed wavelength-selectable in-series laser array is deemed to be applied in the dense wavelength division multiplexing technology, especially when fast wavelength switching is needed, such as in the application of NGPON2.