Georgios Mitrentsis
Georgios Mitrentsis has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Hendrik Lens
Institute of Combustion and Power Plant Technology University of Stuttgart 70569 Stuttgart Germany
5 shared publications - Konstantinos N. Genikomsakis
Inteligg P.C., Karaiskaki 28, 10554 Athens, Greece
2 shared publications - Antony Hilliard
Hitachi Energy Res, Montreal, PQ, Canada
1 shared publication - Christos Ioakimidis
Inteligg P.C., Karaiskaki 28, 10554 Athens, Greece
1 shared publication - David Marino
Hitachi Energy Res, Montreal, PQ, Canada
1 shared publication Dimitrios Savvidis
DG Clima, European Commission, Brussels, Belgium
1 shared publication
Latest Publications
- 29 June 2024
- Published by Elsevier in Electric Power Systems Research
- Vol. 235
Intelligent alarm flood management for power systems
- 29 June 2024
- Published by Elsevier in Electric Power Systems Research
- Vol. 235
Intelligent alarm flood management for power systems
- Top Cited Papers
- 14 January 2022
- Published by Elsevier in Applied Energy
- Vol. 309
An interpretable probabilistic model for short-term solar power forecasting using natural gradient boosting
- 14 January 2022
- Published by Elsevier in Applied Energy
- Vol. 309
Top Cited PapersAn interpretable probabilistic model for short-term solar power forecasting using natural gradient boosting
- 8 February 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Smart Grid
- Vol. 12 (4) , 2952-2965
Data-Driven Dynamic Models of Active Distribution Networks Using Unsupervised Learning Techniques on Field Measurements
The development of realistic dynamic models for active distribution networks (ADNs) is a challenging problem faced by both the transmission system operators and academia due to the random and complex nature of loads and distributed generation. Real field measurements are often not available and when they are, they usually contain various dynamics, irrelevant data, and outliers. This article proposes a three-stage methodology to effectively build a set of dynamic models for an ADN based on field measurements. In the first stage, an unsupervised learning method identifies and then discards all the irrelevant data for the model parameter estimation. In the next stage, the remaining data are clustered into groups with similar dynamics while in the third stage, a nonlinear dynamic model is developed for each of the derived groups. This papers concludes that, in spite of the large number of measurements representing a wide range of grid configurations, the general dynamic characteristics of an ADN can be accurately captured and modeled using a limited number of clusters. The proposed method is validated using real data from six substations in Southern Germany.
- 8 February 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Smart Grid
- Vol. 12 (4) , 2952-2965
Data-Driven Dynamic Models of Active Distribution Networks Using Unsupervised Learning Techniques on Field Measurements
The development of realistic dynamic models for active distribution networks (ADNs) is a challenging problem faced by both the transmission system operators and academia due to the random and complex nature of loads and distributed generation. Real field measurements are often not available and when they are, they usually contain various dynamics, irrelevant data, and outliers. This article proposes a three-stage methodology to effectively build a set of dynamic models for an ADN based on field measurements. In the first stage, an unsupervised learning method identifies and then discards all the irrelevant data for the model parameter estimation. In the next stage, the remaining data are clustered into groups with similar dynamics while in the third stage, a nonlinear dynamic model is developed for each of the derived groups. This papers concludes that, in spite of the large number of measurements representing a wide range of grid configurations, the general dynamic characteristics of an ADN can be accurately captured and modeled using a limited number of clusters. The proposed method is validated using real data from six substations in Southern Germany.
- 20 January 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Systems
- Vol. 36 (3) , 2709-2712
A Dynamic Active Distribution Network Equivalent for Enhancing the Generalization Capability of the Exponential Recovery Model in Stability Studies
This letter introduces an enhancement of the exponential recovery model (ERM) in order to widen its applicability and generalization capability from purely load-composed distribution networks to active distribution networks (ADNs), while maintaining its nonlinear characteristics. Although recent approaches proposed modifications of the ERM to tackle its limitation to capture bidirectional power flows, these may fail to generalize to new test scenarios with significant distributed generation (DG) due to their direct dependence on the measured power at the point of common coupling. In ADNs, this value does not represent the actual power demand of the loads. To address this issue, a new methodology based on nonlinear functions and the actual change of the signals is presented. The efficacy of the proposed model to capture the general ADN dynamics is validated using field measurements acquired over one year.
- 20 January 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Systems
- Vol. 36 (3) , 2709-2712
A Dynamic Active Distribution Network Equivalent for Enhancing the Generalization Capability of the Exponential Recovery Model in Stability Studies
This letter introduces an enhancement of the exponential recovery model (ERM) in order to widen its applicability and generalization capability from purely load-composed distribution networks to active distribution networks (ADNs), while maintaining its nonlinear characteristics. Although recent approaches proposed modifications of the ERM to tackle its limitation to capture bidirectional power flows, these may fail to generalize to new test scenarios with significant distributed generation (DG) due to their direct dependence on the measured power at the point of common coupling. In ADNs, this value does not represent the actual power demand of the loads. To address this issue, a new methodology based on nonlinear functions and the actual change of the signals is presented. The efficacy of the proposed model to capture the general ADN dynamics is validated using field measurements acquired over one year.
- 1 January 2020
- Published by Elsevier in IFAC-PapersOnLine
- Vol. 53 (2) , 13024-13029
Unsupervised learning method for clustering dynamic behavior in the context of power systems
- 1 January 2020
- Published by Elsevier in IFAC-PapersOnLine
- Vol. 53 (2) , 13024-13029
Unsupervised learning method for clustering dynamic behavior in the context of power systems
- 1 October 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Energy consumption model of electric scooter for routing applications: Experimental validation
Given the low driving range of electric vehicles (EVs), the estimation of energy consumption plays a critical role in EV routing applications that compute energy efficient or optimal paths. The present work introduces an accurate and computationally efficient model to estimate the energy consumption of an electric scooter (e-scooter) under real-world driving conditions. The proposed model employs a dynamic approach to simulate the efficiency of the e-scooter motor and takes into account its overload capabilities in terms of torque or power requirements for highly demanding parts of a route. The calibration and experimental validation of the model was based on field measurements from test routes with a total distance over 100 km. The results show that the accuracy of the model coupled with its lightweight implementation using MATLAB code render it particularly suitable for route planning applications.
- 1 October 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Energy consumption model of electric scooter for routing applications: Experimental validation
Given the low driving range of electric vehicles (EVs), the estimation of energy consumption plays a critical role in EV routing applications that compute energy efficient or optimal paths. The present work introduces an accurate and computationally efficient model to estimate the energy consumption of an electric scooter (e-scooter) under real-world driving conditions. The proposed model employs a dynamic approach to simulate the efficiency of the e-scooter motor and takes into account its overload capabilities in terms of torque or power requirements for highly demanding parts of a route. The calibration and experimental validation of the model was based on field measurements from test routes with a total distance over 100 km. The results show that the accuracy of the model coupled with its lightweight implementation using MATLAB code render it particularly suitable for route planning applications.