Céline Richard
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Céline Richard has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
Anne-Marie Cazabat
2 shared publications- David Allan Beattie
Future Industries Institute, University of South Australia, Mawson Lakes, SA 5095, Australia
2 shared publications - Marta Krasowska
Future Industries Institute, University of South Australia, Mawson Lakes, SA 5095, Australia
2 shared publications - Tracey T. M. Ho
Future Industries Institute, University of South Australia, Mawson Lakes, South Australia, 5095, Australia
2 shared publications U. Delabre
Laboratoire de Physique Statistique de l'ENS, Paris
2 shared publicationsUlysse Delabre
Université Pierre et Marie Curie et LPS-ENS, UMR 8550 du CNRS, 24 rue Lhomond, 75231 Paris Cedex 05, France
2 shared publications
Latest Publications
- 7 October 2015
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 31 (41) , 11249-11259
In Situ ATR FTIR Spectroscopic Study of the Formation and Hydration of a Fucoidan/Chitosan Polyelectrolyte Multilayer
The formation of fucoidan/chitosan-based polyelectrolyte multilayers (PEMs) has been studied with in situ Fourier transform infrared (FTIR) spectroscopy. Attenuated total reflectance (ATR) FTIR spectroscopy has been used to follow the sequential build-up of the multilayer, with peaks characteristic of each polymer being seen to increase in intensity with each respective adsorption stage. In addition, spectral processing has allowed for the extraction of spectra from individual adsorbed layers, which have been used to provide unambiguous determination of the adsorbed mass of the PEM at each stage of formation. The PEM was seen to undergo a transition in growth regimes during build-up: from supra-linear to linear. In addition, the wettability of the PEM has been probed at each stage of the build-up, using the captive bubble contact angle technique. The contact angles were uniformly low, but showed variation in value depending on the nature of the outer polymer layer, and this variation correlated with the o...
- 7 October 2015
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 31 (41) , 11249-11259
In Situ ATR FTIR Spectroscopic Study of the Formation and Hydration of a Fucoidan/Chitosan Polyelectrolyte Multilayer
The formation of fucoidan/chitosan-based polyelectrolyte multilayers (PEMs) has been studied with in situ Fourier transform infrared (FTIR) spectroscopy. Attenuated total reflectance (ATR) FTIR spectroscopy has been used to follow the sequential build-up of the multilayer, with peaks characteristic of each polymer being seen to increase in intensity with each respective adsorption stage. In addition, spectral processing has allowed for the extraction of spectra from individual adsorbed layers, which have been used to provide unambiguous determination of the adsorbed mass of the PEM at each stage of formation. The PEM was seen to undergo a transition in growth regimes during build-up: from supra-linear to linear. In addition, the wettability of the PEM has been probed at each stage of the build-up, using the captive bubble contact angle technique. The contact angles were uniformly low, but showed variation in value depending on the nature of the outer polymer layer, and this variation correlated with the o...
- 31 October 2013
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 117 (45) , 23676-23684
Molecularly-Thin Precursor Films of Imidazolium-Based Ionic Liquids on Mica
- 31 October 2013
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 117 (45) , 23676-23684
Molecularly-Thin Precursor Films of Imidazolium-Based Ionic Liquids on Mica
- 1 October 2011
- Published by Elsevier in Advances in Colloid and Interface Science
- Vol. 168 (1-2) , 29-39
Experimental study of hybrid nematic wetting films
- 1 October 2011
- Published by Elsevier in Advances in Colloid and Interface Science
- Vol. 168 (1-2) , 29-39
Experimental study of hybrid nematic wetting films
- 17 August 2010
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 26 (16) , 13368-13376
Thin Liquid Crystal Films on Liquids in the Nematic Range of Temperatures
- 17 August 2010
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 26 (16) , 13368-13376
Thin Liquid Crystal Films on Liquids in the Nematic Range of Temperatures
- 17 November 2008
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry B
- Vol. 113 (12) , 3647-3652
Thin Nematic Films on Liquid Substrates
Thin films of cyanobiphenyl liquid crystals (nCB) deposited on water or glycerol have been studied in the nematic temperature range. A common property of the systems is the hybrid anchoring conditions at the film interfaces. The preferred orientation of the nematic director is planar at the liquid interface, and it is homeotropic and somewhat weaker at the air interface. The resulting structure of the film depends on its thickness. Films thicker than 0.5 μm show the usual defects of nematics. Between 0.5 μm and 20−30 nm, complex instability patterns such as stripes, “chevrons”, or squares are observed in extended films. Then there is a forbidden range of thickness below in which much thinner structures (usually monolayers and trilayers) are present. The present paper investigates this common behavior in various systems and gives arguments for its analysis.
- 17 November 2008
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry B
- Vol. 113 (12) , 3647-3652
Thin Nematic Films on Liquid Substrates
Thin films of cyanobiphenyl liquid crystals (nCB) deposited on water or glycerol have been studied in the nematic temperature range. A common property of the systems is the hybrid anchoring conditions at the film interfaces. The preferred orientation of the nematic director is planar at the liquid interface, and it is homeotropic and somewhat weaker at the air interface. The resulting structure of the film depends on its thickness. Films thicker than 0.5 μm show the usual defects of nematics. Between 0.5 μm and 20−30 nm, complex instability patterns such as stripes, “chevrons”, or squares are observed in extended films. Then there is a forbidden range of thickness below in which much thinner structures (usually monolayers and trilayers) are present. The present paper investigates this common behavior in various systems and gives arguments for its analysis.
- 1 September 2008
- Published by Oxford University Press (OUP) in Europhysics Letters
- Vol. 83 (6) , 66004
Line tension of nematic pancakes at the air-water interface: Static and dynamic measurements
The line tension of nematic Langmuir films on water is investigated using the 6CB member of the cyanobiphenyl liquid-crystals series. Both static and dynamic measurements are performed independently. The line tension increases linearly with film thickness up to 0.2 μm. The increment of line tension is significantly smaller than for the smectic 8CB compound, due to the difference in the allowed elastic deformations of smectic and nematic films. A simple model of the nematic edge accounts both for the linear dependence and the order of magnitude of the line tension. Moreover, it sheds new light on the structure of thin nematic films on liquid substrates.
- 1 September 2008
- Published by Oxford University Press (OUP) in Europhysics Letters
- Vol. 83 (6) , 66004
Line tension of nematic pancakes at the air-water interface: Static and dynamic measurements
The line tension of nematic Langmuir films on water is investigated using the 6CB member of the cyanobiphenyl liquid-crystals series. Both static and dynamic measurements are performed independently. The line tension increases linearly with film thickness up to 0.2 μm. The increment of line tension is significantly smaller than for the smectic 8CB compound, due to the difference in the allowed elastic deformations of smectic and nematic films. A simple model of the nematic edge accounts both for the linear dependence and the order of magnitude of the line tension. Moreover, it sheds new light on the structure of thin nematic films on liquid substrates.
- 7 March 2008
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 24 (8) , 3998-4006
Nematic Pancakes Revisited
- 7 March 2008
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 24 (8) , 3998-4006
Nematic Pancakes Revisited