Florian Christ
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Florian Christ has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
- Arash Alimardani Lavasan
Research Group Computational Soil Mechanics and Foundation Engineering (COMPSOIL), Department of Engineering, Faculty of Science, Technology and Medicine University of Luxembourg Luxembourg Luxembourg
2 shared publications - Torsten Wichtmann
Ruhr-Universität Bochum
2 shared publications - Wolfgang Lieske
Geotechnical Engineering, Georg Agricola University of Applied Sciences
2 shared publications Charlotte Herz
Soil Mechanics, Foundation Engineering and Environmental Geotechnics, Ruhr-Universität Bochum 2 , Universitätsstr. 150, Bochum, NRW 44801
1 shared publication- Christina Krikelis
Ruhr-Universität Bochum
1 shared publication - Diego Nicolás Petraroia
Institute of Concrete Structures, Ruhr University Bochum Bochum Germany
1 shared publication
Latest Publications
- Open Access
- 16 August 2025
- Published by Springer Nature in Acta Geotechnica
- Vol. 21 (1) , 3-16
Impact of reconstitution on the hydro-mechanical behaviour of Opalinus clay shale
This study investigates the impact of clay shale reconstitution on its hydro-mechanical behaviour, using grain size distribution as a key parameter to assess the degree of sample preparation. This topic is of practical relevance, as the characterisation of fine-grained soils often relies on their intrinsic properties, typically measured after reconstitution. While fine-grained soils that can be homogenised with minimal mechanical effort follow a fairly uniform preparation process, this is not the case for materials requiring initial pulverisation. To address this, three batches of remoulded Opalinus Clay samples (fine, medium, and coarse) were prepared. Their hydration curves, swelling pressure, and compressibility behaviour were analysed. Additional classification tests, pore size distribution measurements, and X-ray diffraction (XRD) analyses were performed to support physical characterisation. XRD revealed no preferential breakage of specific clay minerals or segregation of grain sizes. Test results indicated that preserved bonding in coarser grains acts as an additional attractive force, limiting hydration potential and reducing water adsorption. In contrast, finer materials showed higher hydration and swelling pressure due to increased surface area. While compressibility behaviour remained similar across samples at high stress, coarse-grained samples exhibited overconsolidated behaviour at low stresses, attributable to the structural integrity of larger grains.
- 16 August 2025
- Published by Springer Nature in Acta Geotechnica
- Vol. 21 (1) , 3-16
Open AccessImpact of reconstitution on the hydro-mechanical behaviour of Opalinus clay shale
This study investigates the impact of clay shale reconstitution on its hydro-mechanical behaviour, using grain size distribution as a key parameter to assess the degree of sample preparation. This topic is of practical relevance, as the characterisation of fine-grained soils often relies on their intrinsic properties, typically measured after reconstitution. While fine-grained soils that can be homogenised with minimal mechanical effort follow a fairly uniform preparation process, this is not the case for materials requiring initial pulverisation. To address this, three batches of remoulded Opalinus Clay samples (fine, medium, and coarse) were prepared. Their hydration curves, swelling pressure, and compressibility behaviour were analysed. Additional classification tests, pore size distribution measurements, and X-ray diffraction (XRD) analyses were performed to support physical characterisation. XRD revealed no preferential breakage of specific clay minerals or segregation of grain sizes. Test results indicated that preserved bonding in coarser grains acts as an additional attractive force, limiting hydration potential and reducing water adsorption. In contrast, finer materials showed higher hydration and swelling pressure due to increased surface area. While compressibility behaviour remained similar across samples at high stress, coarse-grained samples exhibited overconsolidated behaviour at low stresses, attributable to the structural integrity of larger grains.
- Open Access
- 18 March 2023
- Published by Springer Nature
- p. 253-327
Tunnel Linings
In this chapter, important research results for the development of a robust and damage-tolerant multimaterial tunnel lining are presented. This includes the production, design and optimization of fiber-reinforced hybrid segmental lining systems based on numerical models and experimental investigations under tunneling loads. In addition, novel tail void grouting materials are developed and optimized regarding their infiltration and hardening behavior while taking the interaction with the surrounding ground into account. In order to expand the applicability of mechanized tunneling regarding soils characterized by significant swelling potential due to water uptake by clay minerals, a deformable segmental lining system is presented. The risk of damage due to high localized loads is reduced by the integration of additional radial protective layers on the lining segments and a compressible annular gap grout, which protect the tunnel structure by undergoing high deformations after reaching a certain yielding load. However, the deformability of such support systems affects the distribution of the stresses around the tunnel which governs the magnitude and buildup of the swelling pressure in the soil. Therefore, the development of damage tolerant lining systems requires a material and structural design which ensures an optimal soil-structure interaction through a synergy of computational and experimental techniques.
- 18 March 2023
- Published by Springer Nature
- p. 253-327
Open AccessTunnel Linings
In this chapter, important research results for the development of a robust and damage-tolerant multimaterial tunnel lining are presented. This includes the production, design and optimization of fiber-reinforced hybrid segmental lining systems based on numerical models and experimental investigations under tunneling loads. In addition, novel tail void grouting materials are developed and optimized regarding their infiltration and hardening behavior while taking the interaction with the surrounding ground into account. In order to expand the applicability of mechanized tunneling regarding soils characterized by significant swelling potential due to water uptake by clay minerals, a deformable segmental lining system is presented. The risk of damage due to high localized loads is reduced by the integration of additional radial protective layers on the lining segments and a compressible annular gap grout, which protect the tunnel structure by undergoing high deformations after reaching a certain yielding load. However, the deformability of such support systems affects the distribution of the stresses around the tunnel which governs the magnitude and buildup of the swelling pressure in the soil. Therefore, the development of damage tolerant lining systems requires a material and structural design which ensures an optimal soil-structure interaction through a synergy of computational and experimental techniques.
- 24 May 2022
- Published by ASTM International in Geotechnical Testing Journal
- Vol. 45 (4) , 819-836
Evaluation of the Penetration Behavior of Viscous Fluids into Porous Media in the Context of Volume Determination
The current study addresses the penetration of viscous fluids into compacted clay samples in the context of volume determination. The volume of compacted clay samples was measured with established methods (paraffin-coated clod method, pycnometer method) and uncoated immersion weighing (IW) with three different fluids (silicone oil, paraffin oil, and canola oil). The suitability of the methods was evaluated statistically. The amount of penetrated liquid into the sample was tracked over time and analyzed. Experimental data were fitted with a modified Washburn’s equation considering different pore sizes in the sample. The fitting yielded very good matches. IW was found to generate the most accurate (i.e., smallest error measurements) and reproducible results for volume determination among the established methods. Thereby, paraffin and silicone oil performed best for IW. The penetration of liquids into the sample was found to be negligibly small for those two liquids in the relevant time range for conducting an IW.
- 24 May 2022
- Published by ASTM International in Geotechnical Testing Journal
- Vol. 45 (4) , 819-836
Evaluation of the Penetration Behavior of Viscous Fluids into Porous Media in the Context of Volume Determination
The current study addresses the penetration of viscous fluids into compacted clay samples in the context of volume determination. The volume of compacted clay samples was measured with established methods (paraffin-coated clod method, pycnometer method) and uncoated immersion weighing (IW) with three different fluids (silicone oil, paraffin oil, and canola oil). The suitability of the methods was evaluated statistically. The amount of penetrated liquid into the sample was tracked over time and analyzed. Experimental data were fitted with a modified Washburn’s equation considering different pore sizes in the sample. The fitting yielded very good matches. IW was found to generate the most accurate (i.e., smallest error measurements) and reproducible results for volume determination among the established methods. Thereby, paraffin and silicone oil performed best for IW. The penetration of liquids into the sample was found to be negligibly small for those two liquids in the relevant time range for conducting an IW.
- 1 December 2020
- Published by Elsevier in Geotextiles and Geomembranes
- Vol. 48 (6) , 973-982
Suction and crack propagation in GCLs subjected to drying and wetting in CaCl2-solutions
- 1 December 2020
- Published by Elsevier in Geotextiles and Geomembranes
- Vol. 48 (6) , 973-982
Suction and crack propagation in GCLs subjected to drying and wetting in CaCl2-solutions
- 1 January 2019
- Published by VDI Fachmedien GmbH and Co. KG in Bauingenieur
- Vol. 94 (12) , 480-487
Ausgleich von Diskontinuitäten im Untergrund durch geotextilbewehrte Polsterschichten/Compensation of subsurface discontinuities by geosynthetic reinforced layers
Zusammenfassung Stetige Bodenbewegungen durch Bergbau sind ein schon lange bekanntes und in einem gewissen Rahmen prognostizierbares Problem. Es kann in bestimmten Gebieten jedoch auch zu unstetigen Bodenbewegungen, wie zum Beispiel Erdstufen, kommen. Für deren Auftreten und Auswirkungen gibt es keine allgemeinen Prognoseverfahren. Der Umgang mit den dadurch entstehenden Schäden an Bauwerken ist aufwendig und kostspielig. An der BAB 57 wurde 2008 eine geotextilbewehrte Polsterschicht eingesetzt, um durch unstetige Bodenbewegungen entstandene Vertikalversätze zu vergleichmäßigen und die Einwirkungen auf das Bauwerk so gering wie möglich zu halten. Für eine sichere und wirtschaftliche Dimensionierung bei solchen Ausführungen ist ein analytischer Berechnungsansatz erstrebenswert. Bisher existiert ein solcher jedoch nicht. Großmaßstäbliche Versuche aus der Literatur zeigen, dass Geogitter die Entwicklung von Scherfugen einschränken, lokale Dehnungen verteilen und so zu einer kontinuierlichen, für das Bauwerk zumindest temporär verträglichen, Verformung beitragen. Unter Berücksichtigung der getätigten Beobachtungen wurde ein analytischer Berechnungsansatz aufgestellt. Der Vergleich der Ergebnisse mit in der Literatur dokumentierten Zentrifugen-Modellversuchen zeigt dabei eine gute Übereinstimmung.
- 1 January 2019
- Published by VDI Fachmedien GmbH and Co. KG in Bauingenieur
- Vol. 94 (12) , 480-487
Ausgleich von Diskontinuitäten im Untergrund durch geotextilbewehrte Polsterschichten/Compensation of subsurface discontinuities by geosynthetic reinforced layers
Zusammenfassung Stetige Bodenbewegungen durch Bergbau sind ein schon lange bekanntes und in einem gewissen Rahmen prognostizierbares Problem. Es kann in bestimmten Gebieten jedoch auch zu unstetigen Bodenbewegungen, wie zum Beispiel Erdstufen, kommen. Für deren Auftreten und Auswirkungen gibt es keine allgemeinen Prognoseverfahren. Der Umgang mit den dadurch entstehenden Schäden an Bauwerken ist aufwendig und kostspielig. An der BAB 57 wurde 2008 eine geotextilbewehrte Polsterschicht eingesetzt, um durch unstetige Bodenbewegungen entstandene Vertikalversätze zu vergleichmäßigen und die Einwirkungen auf das Bauwerk so gering wie möglich zu halten. Für eine sichere und wirtschaftliche Dimensionierung bei solchen Ausführungen ist ein analytischer Berechnungsansatz erstrebenswert. Bisher existiert ein solcher jedoch nicht. Großmaßstäbliche Versuche aus der Literatur zeigen, dass Geogitter die Entwicklung von Scherfugen einschränken, lokale Dehnungen verteilen und so zu einer kontinuierlichen, für das Bauwerk zumindest temporär verträglichen, Verformung beitragen. Unter Berücksichtigung der getätigten Beobachtungen wurde ein analytischer Berechnungsansatz aufgestellt. Der Vergleich der Ergebnisse mit in der Literatur dokumentierten Zentrifugen-Modellversuchen zeigt dabei eine gute Übereinstimmung.