Xiong Zou
Research Subjects
Xiong Zou has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Ya Fan
Air Force Early Warning Academy, Wuhan 430019, China
2 shared publications - Dingwang Yu
College of Electronic Science, National University of Defense Technology, Changsha, China
1 shared publication Fang-Zhi Geng
Air Force Early Warning Academy, Wuhan 430019, China
1 shared publicationHuabing Yang
Air Force Early Warning Academy, Wuhan, Hubei, China
1 shared publicationHuan Qian
Air Force Early Warning Academy, Wuhan, Hubei, China
1 shared publicationJing Li
Early Warning Academy, Wuhan, China
1 shared publication
Latest Publications
- Open Access
- 27 November 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 13, 203736-203742
A Design Method of High Scanning Rate LWA Based on Multi-Layer SIW
For leaky-wave antennas (LWAs), a higher scanning rate implies a smaller operating bandwidth without reducing the beam scanning range. This characteristic reduces the antenna‘s requirements on the operating frequency range of the signal source and alleviates the demand for increasingly scarce spatial spectrum resources. In existing technologies, the primary approach to enhancing the scanning rate involves modifying the antenna‘s radiating elements. Any alteration to the form of these elements would impose challenges in maintaining high scanning rates. This paper employs multi-layer substrates to extend the propagation paths between adjacent radiating elements, thereby designing a high-scanning-rate SIW LWA. The spacing between adjacent radiating elements is calculated based on in-phase feeding requirements and grating lobe suppression criteria, while the number of substrate layers is determined by scanning rate targets. This method effectively enhances the scanning rate of SIW LWAs by increasing the substrate layer count. It allows flexible selection of substrate layers and radiating element spacing according to scanning rate requirements, offering adaptability to various radiating element configurations. Two eye-shaped LWAs with 3- and 5-layer substrates designed using this method increases the scanning rate from 24.4°/GHz to 45.5°/GHz and 72.9°/GHz, validating the effectiveness of the proposed approach. The measured results of the 3-layer substrate antenna demonstrate good consistency with the simulated results.
- 27 November 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 13, 203736-203742
Open AccessA Design Method of High Scanning Rate LWA Based on Multi-Layer SIW
For leaky-wave antennas (LWAs), a higher scanning rate implies a smaller operating bandwidth without reducing the beam scanning range. This characteristic reduces the antenna‘s requirements on the operating frequency range of the signal source and alleviates the demand for increasingly scarce spatial spectrum resources. In existing technologies, the primary approach to enhancing the scanning rate involves modifying the antenna‘s radiating elements. Any alteration to the form of these elements would impose challenges in maintaining high scanning rates. This paper employs multi-layer substrates to extend the propagation paths between adjacent radiating elements, thereby designing a high-scanning-rate SIW LWA. The spacing between adjacent radiating elements is calculated based on in-phase feeding requirements and grating lobe suppression criteria, while the number of substrate layers is determined by scanning rate targets. This method effectively enhances the scanning rate of SIW LWAs by increasing the substrate layer count. It allows flexible selection of substrate layers and radiating element spacing according to scanning rate requirements, offering adaptability to various radiating element configurations. Two eye-shaped LWAs with 3- and 5-layer substrates designed using this method increases the scanning rate from 24.4°/GHz to 45.5°/GHz and 72.9°/GHz, validating the effectiveness of the proposed approach. The measured results of the 3-layer substrate antenna demonstrate good consistency with the simulated results.
- 2 June 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 69 (11) , 7947-7952
A Substrate-Integrated Waveguide Leaky-Wave Antenna Based on Eye-Shaped Transverse Slot
At present, there are few reports of broadside antennas based on the transverse slots in SIWs, because those slot structures often exist as open stopbands (OSB), which restrict radiation in the broadside direction. In this communication, a new type of transverse slot element, eye-shaped transverse slot element with a high phase shift, is proposed. The phase constant of this element can vary linearly, which can lead to continuous beam scanning from the backward-to-forward direction. The relationship between the phase difference and the element size is obtained by simulation. What is more, a leaky-wave antenna with element spacing slightly larger than half-waveguide wavelength is described, and its internal field distribution is analyzed. The measured results show that the main beam can scan from −56° to 39° when the frequency increases from 9.1 to 13 GHz, while the gain ranges from 9 to 11.7 dBi in the passband with an effective length of 110 mm. Because of its small antenna length, wide beam scanning range, and high gain, the antenna can be widely used in wireless communication or radar systems.
- 2 June 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 69 (11) , 7947-7952
A Substrate-Integrated Waveguide Leaky-Wave Antenna Based on Eye-Shaped Transverse Slot
At present, there are few reports of broadside antennas based on the transverse slots in SIWs, because those slot structures often exist as open stopbands (OSB), which restrict radiation in the broadside direction. In this communication, a new type of transverse slot element, eye-shaped transverse slot element with a high phase shift, is proposed. The phase constant of this element can vary linearly, which can lead to continuous beam scanning from the backward-to-forward direction. The relationship between the phase difference and the element size is obtained by simulation. What is more, a leaky-wave antenna with element spacing slightly larger than half-waveguide wavelength is described, and its internal field distribution is analyzed. The measured results show that the main beam can scan from −56° to 39° when the frequency increases from 9.1 to 13 GHz, while the gain ranges from 9 to 11.7 dBi in the passband with an effective length of 110 mm. Because of its small antenna length, wide beam scanning range, and high gain, the antenna can be widely used in wireless communication or radar systems.
- 14 February 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Components Letters
- Vol. 27 (3) , 227-229
Phase Inverters Based on Substrate Integrated Waveguide
Phase inverters (PI) suit a wide range of applications for microwave systems. There are lots of reports about PIs based on microstrip or coplanar waveguide, some of which obtain simple configurations and wide bandwidths. However, there are few reports about PI based on substrate integrated waveguide (SIW). Inspired by a microstrip PI constituted by an interdigital slot and metallic vias, a new SIW PI is proposed for the first time. Furthermore, a phase shifter is inserted to the SIW PI in order to compensate the signal delay. Both prototype and compensation-type PIs represent good transmission performance with return loss better than 10 dB in 8.3-13 GHz. The bandwidth of the prototype can reach 47.6% with phase deviation less than 10° compared with 38-mm transmission line, which shows more excellent performance.
- 14 February 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Components Letters
- Vol. 27 (3) , 227-229
Phase Inverters Based on Substrate Integrated Waveguide
Phase inverters (PI) suit a wide range of applications for microwave systems. There are lots of reports about PIs based on microstrip or coplanar waveguide, some of which obtain simple configurations and wide bandwidths. However, there are few reports about PI based on substrate integrated waveguide (SIW). Inspired by a microstrip PI constituted by an interdigital slot and metallic vias, a new SIW PI is proposed for the first time. Furthermore, a phase shifter is inserted to the SIW PI in order to compensate the signal delay. Both prototype and compensation-type PIs represent good transmission performance with return loss better than 10 dB in 8.3-13 GHz. The bandwidth of the prototype can reach 47.6% with phase deviation less than 10° compared with 38-mm transmission line, which shows more excellent performance.