Jie Huang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Jie Huang has a total of 33 co-authors. Here are the top co-authors by number of shared publications:
- Kei May Lau
The Hong Kong University of Science and Technology
8 shared publications - Liying Lin
Hong Kong University of Science and Technology,Department of Electronic and Computer Engineering,Hong Kong,China
8 shared publications - Wei Luo
Hong Kong University of Science and Technology,Department of Electronic and Computer Engineering,Hong Kong,China
8 shared publications - Qi Lin
Electrical and Computer Engineering Department, University of Virginia 1 , Charlottesville, Virginia 22904
5 shared publications Wen Gu
Hong Kong University of Science and Technology,Department of Electronic and Computer Engineering,Hong Kong,China
3 shared publications- Jingxian Chen
Guangdong Provincial Key Laboratory of Information Photonics Technology, School of Materials and Energy, Guangdong University of Technology, Guangzhou 510006, P. R. China
2 shared publications
Latest Publications
- 21 August 2024
- Published by American Chemical Society (ACS) in ACS Photonics
- Vol. 11 (9) , 3578-3584
GaAs Microdisk Lasers with Al2O3 Passivation Selectively Grown on SOI
- 21 August 2024
- Published by American Chemical Society (ACS) in ACS Photonics
- Vol. 11 (9) , 3578-3584
GaAs Microdisk Lasers with Al2O3 Passivation Selectively Grown on SOI
- 24 January 2024
- Published by American Chemical Society (ACS) in Crystal Growth & Design
- Vol. 24 (3) , 1302-1307
GaAs Templates Selectively Grown on Silicon-on-Insulator for Lasers in Silicon Photonics
- 24 January 2024
- Published by American Chemical Society (ACS) in Crystal Growth & Design
- Vol. 24 (3) , 1302-1307
GaAs Templates Selectively Grown on Silicon-on-Insulator for Lasers in Silicon Photonics
- Open Access
- 25 December 2023
- Published by AIP Publishing in Applied Physics Letters
- Vol. 123 (26)
Comparison of quantum well structures for room temperature continuous wave 980 nm lasers grown on (001) Si by MOCVD
We report room temperature (RT) continuous-wave (CW) lasing of quantum well (QW) lasers grown on (001) Si substrates emitting at 980 nm. Two different QW structures, including conventional compressively strained InGaAs/GaAs QWs and strain-compensated InGaAs/GaAs/GaAsP QWs, were investigated. Photoluminescence properties and device performance of both structures on native GaAs and (001) Si substrates are discussed. By adding GaAsP barriers to the InGaAs/GaAs QWs, the lowest threshold current density of ridge waveguide edge-emitting QW lasers obtained on Si is 550 A/cm2, measured on a 10 μm × 2 mm device at RT. The working temperature of the InGaAs/GaAs/GaAsP QW lasers grown on Si can be over 95 °C in the CW mode. This work suggests a feasible approach to improve the 980 nm laser performance on Si for monolithic optoelectronic integration.
- 25 December 2023
- Published by AIP Publishing in Applied Physics Letters
- Vol. 123 (26)
Open AccessComparison of quantum well structures for room temperature continuous wave 980 nm lasers grown on (001) Si by MOCVD
We report room temperature (RT) continuous-wave (CW) lasing of quantum well (QW) lasers grown on (001) Si substrates emitting at 980 nm. Two different QW structures, including conventional compressively strained InGaAs/GaAs QWs and strain-compensated InGaAs/GaAs/GaAsP QWs, were investigated. Photoluminescence properties and device performance of both structures on native GaAs and (001) Si substrates are discussed. By adding GaAsP barriers to the InGaAs/GaAs QWs, the lowest threshold current density of ridge waveguide edge-emitting QW lasers obtained on Si is 550 A/cm2, measured on a 10 μm × 2 mm device at RT. The working temperature of the InGaAs/GaAs/GaAsP QW lasers grown on Si can be over 95 °C in the CW mode. This work suggests a feasible approach to improve the 980 nm laser performance on Si for monolithic optoelectronic integration.
- 12 November 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
Comparison of InP QDs and GaAsP QW lasers grown by MOCVD
InP self-assembled quantum dots were grown on the GaAsP matrix by MOCVD. Electrically pumped GaAsP QW lasers without embedded QDs and InP QDs lasers were investigated, with the latter showing lower threshold current density.
- 12 November 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
Comparison of InP QDs and GaAsP QW lasers grown by MOCVD
InP self-assembled quantum dots were grown on the GaAsP matrix by MOCVD. Electrically pumped GaAsP QW lasers without embedded QDs and InP QDs lasers were investigated, with the latter showing lower threshold current density.
- 12 November 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
980 nm QW lasers with GaAsP barriers monolithically grown on (001) Si by MOCVD
We report CW lasing of QW lasers grown on Si emitting at 980 nm. Strain-compensated InGaAs/GaAs/GaAsP QW structures were implemented and compared with conventional compressively strained InGaAs/GaAs QWs. Device performance of these two structures grown on Si and GaAs substrates are investigated.
- 12 November 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
980 nm QW lasers with GaAsP barriers monolithically grown on (001) Si by MOCVD
We report CW lasing of QW lasers grown on Si emitting at 980 nm. Strain-compensated InGaAs/GaAs/GaAsP QW structures were implemented and compared with conventional compressively strained InGaAs/GaAs QWs. Device performance of these two structures grown on Si and GaAs substrates are investigated.
- 24 April 2023
- Published by Optica Publishing Group in Optics Express
- Vol. 31 (10) , 15326-15333
980 nm electrically pumped continuous lasing of QW lasers grown on silicon
Investigation of high-performance lasers monolithically grown on silicon (Si) could promote the development of silicon photonics in regimes other than the 1.3 -1.5 µm band. 980 nm laser, a widely used pumping source for erbium-doped fiber amplifier (EDFA) in the optical fiber communication system, can be used as a demonstration for shorter wavelength lasers. Here, we report continuous wave (CW) lasing of 980 nm electrically pumped quantum well (QW) lasers directly grown on Si by metalorganic chemical vapor deposition (MOCVD). Utilizing the strain compensated InGaAs/GaAs/GaAsP QW structure as the active medium, the lowest threshold current obtained from the lasers on Si was 40 mA, and the highest total output power was near 100 mW. A statistical comparison of lasers grown on native GaAs and Si substrates was conducted and it reveals a somewhat higher threshold for devices on Si. Internal parameters, including modal gain and optical loss are extracted from experimental results and the variation on different substrates could provide a direction to further laser optimization through further improvement of the GaAs/Si templates and QW design. These results demonstrate a promising step towards optoelectronic integration of QW lasers on Si.
- 24 April 2023
- Published by Optica Publishing Group in Optics Express
- Vol. 31 (10) , 15326-15333
980 nm electrically pumped continuous lasing of QW lasers grown on silicon
Investigation of high-performance lasers monolithically grown on silicon (Si) could promote the development of silicon photonics in regimes other than the 1.3 -1.5 µm band. 980 nm laser, a widely used pumping source for erbium-doped fiber amplifier (EDFA) in the optical fiber communication system, can be used as a demonstration for shorter wavelength lasers. Here, we report continuous wave (CW) lasing of 980 nm electrically pumped quantum well (QW) lasers directly grown on Si by metalorganic chemical vapor deposition (MOCVD). Utilizing the strain compensated InGaAs/GaAs/GaAsP QW structure as the active medium, the lowest threshold current obtained from the lasers on Si was 40 mA, and the highest total output power was near 100 mW. A statistical comparison of lasers grown on native GaAs and Si substrates was conducted and it reveals a somewhat higher threshold for devices on Si. Internal parameters, including modal gain and optical loss are extracted from experimental results and the variation on different substrates could provide a direction to further laser optimization through further improvement of the GaAs/Si templates and QW design. These results demonstrate a promising step towards optoelectronic integration of QW lasers on Si.
- 24 February 2023
- Published by Elsevier in Photonics and Nanostructures - Fundamentals and Applications
- Vol. 54, 101117
NbS2-nanosheet-based saturable absorber for 1.5 µm and 2 µm ultrafast fiber lasers
- 24 February 2023
- Published by Elsevier in Photonics and Nanostructures - Fundamentals and Applications
- Vol. 54, 101117
NbS2-nanosheet-based saturable absorber for 1.5 µm and 2 µm ultrafast fiber lasers
- 17 November 2022
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 132 (19) , 193103
GaAs on (001) Si templates for near-infrared InP quantum dot lasers
We investigated the effects of thermal cycle annealing (TCA) at high temperatures on the defect density and morphology of GaAs epilayers grown on (001) Si substrates. Several types of TCA combined with dislocation filter layers (DFLs) were introduced to reduce the defect densities in the GaAs grown on Si substrates. Plan-view transmission electron microscopy shows that the defect density of a 2.7 μm-thick GaAs/Si template with optimized TCA and DFLs is 1.4 × 107 cm−2, lower than a 1.1 μm-thick GaAs/Si template by a factor of 40. The surface roughness of the optimized GaAs/Si template is 1.3 nm after insertion of the DFLs. Additionally, optically pumped InP quantum dot micro-disk lasers (MDLs) were fabricated on these GaAs/Si templates to evaluate the template quality. Room-temperature continuous-wave lasing of 1.5 μm-diameter MDLs was observed, with ultralow lasing thresholds ranging from 0.5 to 2 μW.
- 17 November 2022
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 132 (19) , 193103
GaAs on (001) Si templates for near-infrared InP quantum dot lasers
We investigated the effects of thermal cycle annealing (TCA) at high temperatures on the defect density and morphology of GaAs epilayers grown on (001) Si substrates. Several types of TCA combined with dislocation filter layers (DFLs) were introduced to reduce the defect densities in the GaAs grown on Si substrates. Plan-view transmission electron microscopy shows that the defect density of a 2.7 μm-thick GaAs/Si template with optimized TCA and DFLs is 1.4 × 107 cm−2, lower than a 1.1 μm-thick GaAs/Si template by a factor of 40. The surface roughness of the optimized GaAs/Si template is 1.3 nm after insertion of the DFLs. Additionally, optically pumped InP quantum dot micro-disk lasers (MDLs) were fabricated on these GaAs/Si templates to evaluate the template quality. Room-temperature continuous-wave lasing of 1.5 μm-diameter MDLs was observed, with ultralow lasing thresholds ranging from 0.5 to 2 μW.
- 19 October 2022
- Published by Optica Publishing Group in Optics Express
- Vol. 30 (22) , 40750-40755
Electrically pumped InP/GaAsP quantum dot lasers grown on (001) Si emitting at 750 nm
Excellent performance of InAs quantum dot (QD) lasers grown on Si in the datacom and telecom bands has been reported in recent years. InP QD lasers on Si with emission wavelength at 650 nm–750 nm are seldom explored. In this paper, we report the growth and room temperature lasing of electrically pumped InP/GaAsP QD lasers directly grown on (001) Si emitting at 750 nm. The lowest threshold current density obtained is ∼650 A/cm2, measured on a 2 mm × 70 µm device. Moreover, the highest operating temperature of the InP QD laser grown on the GaAs/Si template is above 95°C. This 750 nm near red on-chip light source for the monolithic integration of Si photonics is potentially applicable in display, bio-photonics, and spatial mapping.
- 19 October 2022
- Published by Optica Publishing Group in Optics Express
- Vol. 30 (22) , 40750-40755
Electrically pumped InP/GaAsP quantum dot lasers grown on (001) Si emitting at 750 nm
Excellent performance of InAs quantum dot (QD) lasers grown on Si in the datacom and telecom bands has been reported in recent years. InP QD lasers on Si with emission wavelength at 650 nm–750 nm are seldom explored. In this paper, we report the growth and room temperature lasing of electrically pumped InP/GaAsP QD lasers directly grown on (001) Si emitting at 750 nm. The lowest threshold current density obtained is ∼650 A/cm2, measured on a 2 mm × 70 µm device. Moreover, the highest operating temperature of the InP QD laser grown on the GaAs/Si template is above 95°C. This 750 nm near red on-chip light source for the monolithic integration of Si photonics is potentially applicable in display, bio-photonics, and spatial mapping.
- 21 September 2022
- Published by Elsevier in Journal of Luminescence
- Vol. 252, 119335
Preparation of tellurium nanowires and its application in ultrafast photonics
- 21 September 2022
- Published by Elsevier in Journal of Luminescence
- Vol. 252, 119335
Preparation of tellurium nanowires and its application in ultrafast photonics