CPChan-Yong Park

Chan-Yong Park

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Chan-Yong Park has a total of 12 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Conformally Gated Surface Conducting Behaviors of Single-Walled Carbon Nanotube Thin-Film-Transistors

    by Kyung-Tae Kim, Keon Woo Lee, Sanghee Moon, Joon Bee Park, Chan-Yong Park, Seung-Ji Nam, Jaehyun Kim, Myoung-Jae Lee, Jae Sang Heo, Sung Kyu Park

    Semiconducting single-walled carbon nanotubes (s-SWCNTs) have gathered significant interest in various emerging electronics due to their outstanding electrical and mechanical properties. Although large-area and low-cost fabrication of s-SWCNT field effect transistors (FETs) can be easily achieved via solution processing, the electrical performance of the solution-based s-SWCNT FETs is often limited by the charge transport in the s-SWCNT networks and interface between the s-SWCNT and the dielectrics depending on both s-SWCNT solution synthesis and device architecture. Here, we investigate the surface and interfacial electro-chemical behaviors of s-SWCNTs. In addition, we propose a cost-effective and straightforward process capable of minimizing polymers bound to s-SWCNT surfaces acting as an interfering element for the charge carrier transport via a heat-assisted purification (HAP). With the HAP treated s-SWCNTs, we introduced conformal dielectric configuration for s-SWCNT FETs, which are explored by a carefully designed wide array of electrical and chemical characterizations with finite-element analysis (FEA) computer simulation. For more favorable gate-field-induced surface and interfacial behaviors of s-SWCNT, we implemented conformally gated highly capacitive s-SWCNT FETs with ion-gel dielectrics, demonstrating field-effect mobility of ~8.19 cm2/V⋅s and on/off current ratio of ~105 along with negligible hysteresis.


  • Open Access

    Skin-Compatible Amorphous Oxide Thin-Film-Transistors with a Stress-Released Elastic Architecture

    by Kyung-Tae Kim, Seung-Han Kang, Seung-Ji Nam, Chan-Yong Park, Jeong-Wan Jo, Jae-Sang Heo, Sung-Kyu Park

    A highly reliable reverse-trapezoid-structured polydimethylsiloxane (PDMS) is demonstrated to achieve mechanically enhanced amorphous indium-gallium-zinc oxide (a-IGZO) thin-film-transistors (TFTs) for skin-compatible electronics. Finite element analysis (FEA) simulation reveals that the stress within a-IGZO TFTs can be efficiently reduced compared to conventional substrates. Based on the results, a conventional photolithography process was employed to implement the reverse-trapezoid homogeneous structures using a negative photoresist (NPR). Simply accessible photolithography using NPR enabled high-resolution patterning and thus large-area scalable device architectures could be obtained. The a-IGZO TFTs on the reverse-trapezoid-structured PDMS exhibited a maximum saturation mobility of 6.06 cm2V−1s−1 under a drain bias voltage of 10 V with minimal strain stress. As a result, the proposed a-IGZO TFTs, including stress-released architecture, exhibited highly enhanced mechanical properties, showing saturation mobility variation within 12% under a strain of 15%, whereas conventional planar a-IGZO TFTs on PDMS showed mobility variation over 10% even under a 1% strain and failed to operate beyond a 2% strain.