Afak Meftah
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Afak Meftah has a total of 44 co-authors. Here are the top co-authors by number of shared publications:
Nouredine Sengouga
Laboratory of Semiconducting and Metallic Materials (LMSM), University of Biskra, Biskra, Algeria
8 shared publications- Nouredine Sengouga
Laboratory of Semiconducting and Metallic Materials (LMSM), University of Mohamed Khider, Biskra, Algeria
6 shared publications Amjad Meftah
Laboratory of Semiconducting and Metallic Materials (LMSM), University of Biskra, Biskra, Algeria
5 shared publications- Mohammed Henini
University of Nottingham
3 shared publications - Madani Labed
Department of Semiconductor Systems Engineering and Convergence Engineering for Intelligent Drone, Sejong University, Seoul, Republic of Korea
2 shared publications - Mohamed Labed
Université Mohamed Khider de Biskra, Biskra, Algeria
2 shared publications
Latest Publications
- 14 December 2023
- Published by Springer Nature in Optical and Quantum Electronics
- Vol. 56 (2) , 1-21
Gallium oxide as an electron transport, a window, an UV and a hole blocking layer for high performance perovskite solar cell: a simulation study
- 14 December 2023
- Published by Springer Nature in Optical and Quantum Electronics
- Vol. 56 (2) , 1-21
Gallium oxide as an electron transport, a window, an UV and a hole blocking layer for high performance perovskite solar cell: a simulation study
- Open Access
- 24 March 2022
- Published by MDPI AG in Nanomaterials
- Vol. 12 (7) , 1061
Physical Operations of a Self-Powered IZTO/β-Ga2O3 Schottky Barrier Diode Photodetector
In this work, a self-powered, solar-blind photodetector, based on InZnSnO (IZTO) as a Schottky contact, was deposited on the top of Si-doped β-Ga2O3 by the sputtering of two-faced targets with InSnO (ITO) as an ohmic contact. A detailed numerical simulation was performed by using the measured J–V characteristics of IZTO/β-Ga2O3 Schottky barrier diodes (SBDs) in the dark. Good agreement between the simulation and the measurement was achieved by studying the effect of the IZTO workfunction, β-Ga2O3 interfacial layer (IL) electron affinity, and the concentrations of interfacial traps. The IZTO/β-Ga2O3 (SBDs) was tested at a wavelength of 255 nm with the photo power density of 1 mW/cm2. A high photo-to-dark current ratio of and a photoresponsivity of 0.64 mA/W were obtained at 0 V as self-powered operation. Finally, with increasing power density the photocurrent increased, and a 17.80 mA/W responsivity under 10 mW/cm2 was obtained.- 24 March 2022
- Published by MDPI AG in Nanomaterials
- Vol. 12 (7) , 1061
Open AccessPhysical Operations of a Self-Powered IZTO/β-Ga2O3 Schottky Barrier Diode Photodetector
In this work, a self-powered, solar-blind photodetector, based on InZnSnO (IZTO) as a Schottky contact, was deposited on the top of Si-doped β-Ga2O3 by the sputtering of two-faced targets with InSnO (ITO) as an ohmic contact. A detailed numerical simulation was performed by using the measured J–V characteristics of IZTO/β-Ga2O3 Schottky barrier diodes (SBDs) in the dark. Good agreement between the simulation and the measurement was achieved by studying the effect of the IZTO workfunction, β-Ga2O3 interfacial layer (IL) electron affinity, and the concentrations of interfacial traps. The IZTO/β-Ga2O3 (SBDs) was tested at a wavelength of 255 nm with the photo power density of 1 mW/cm2. A high photo-to-dark current ratio of and a photoresponsivity of 0.64 mA/W were obtained at 0 V as self-powered operation. Finally, with increasing power density the photocurrent increased, and a 17.80 mA/W responsivity under 10 mW/cm2 was obtained. - 4 December 2019
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 11 (48) , 23459-23474
Effects of high- k gate dielectrics on the electrical performance and reliability of an amorphous indium–tin–zinc–oxide thin film transistor (a-ITZO TFT): an analytical survey
This study is a numerical simulation obtained by using Silvaco Atlas software to investigate the effect of different types of dielectric layers, inserted between the channel and the gate, on the performance and reliability of an a-ITZO TFT. Replacing the SiO2 oxide layer with a high-k dielectric layer gives the concept of the electrical thickness, known by the equivalent oxide thickness (EOT) in which the physical thickness (PT) can be increased to improve the device reliability without increasing the effective thickness of the gate dielectric. A range of different high-k dielectric materials was suggested. For low-k SiO2 (k = 3.9), the electrical parameters extracted are: Ci = 3.45 × 10−8 F cm−2, Ion = 2.23 × 10−6 A, Ioff = 2.17 × 10−13 A, Ion/Ioff = 1.02 × 107, EOT = 100 nm, VT = −0.61 V, μFE = 29.75 cm2 V−1 s−1, SS = 7.91 × 10−2 V per decade and Von = −0.95 V. Replacing SiO2 by a high-k dielectric material, such as SrTiO3 (k = 300), leads to effects similar to the effects of reducing the physical thickness of the gate dielectric but without actually reducing this physical thickness. This allows improving the outputs of the a-ITZO TFT as it leads to an increase in Ci, Ion and Ion/Ioff to the values Ci = 2.66 × 10−6 F cm−2, Ion = 2.86 × 10−4 A, and Ion/Ioff = 8.80 × 109, respectively, and the decrease in EOT, Ioff, VT, μFE, SS and Von to the values EOT = 1.3 nm, Ioff = 3.25 × 10−14 A, VT = −0.428 V, μFE = 26.66 cm2 V−1 s−1, SS = 6.12 × 10−2 V per decade and Von = −0.75 V, respectively, without leakage effects.
- 4 December 2019
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 11 (48) , 23459-23474
Effects of high- k gate dielectrics on the electrical performance and reliability of an amorphous indium–tin–zinc–oxide thin film transistor (a-ITZO TFT): an analytical survey
This study is a numerical simulation obtained by using Silvaco Atlas software to investigate the effect of different types of dielectric layers, inserted between the channel and the gate, on the performance and reliability of an a-ITZO TFT. Replacing the SiO2 oxide layer with a high-k dielectric layer gives the concept of the electrical thickness, known by the equivalent oxide thickness (EOT) in which the physical thickness (PT) can be increased to improve the device reliability without increasing the effective thickness of the gate dielectric. A range of different high-k dielectric materials was suggested. For low-k SiO2 (k = 3.9), the electrical parameters extracted are: Ci = 3.45 × 10−8 F cm−2, Ion = 2.23 × 10−6 A, Ioff = 2.17 × 10−13 A, Ion/Ioff = 1.02 × 107, EOT = 100 nm, VT = −0.61 V, μFE = 29.75 cm2 V−1 s−1, SS = 7.91 × 10−2 V per decade and Von = −0.95 V. Replacing SiO2 by a high-k dielectric material, such as SrTiO3 (k = 300), leads to effects similar to the effects of reducing the physical thickness of the gate dielectric but without actually reducing this physical thickness. This allows improving the outputs of the a-ITZO TFT as it leads to an increase in Ci, Ion and Ion/Ioff to the values Ci = 2.66 × 10−6 F cm−2, Ion = 2.86 × 10−4 A, and Ion/Ioff = 8.80 × 109, respectively, and the decrease in EOT, Ioff, VT, μFE, SS and Von to the values EOT = 1.3 nm, Ioff = 3.25 × 10−14 A, VT = −0.428 V, μFE = 26.66 cm2 V−1 s−1, SS = 6.12 × 10−2 V per decade and Von = −0.75 V, respectively, without leakage effects.
- 3 April 2019
- Published by IOP Publishing in Materials Research Express
- Vol. 6 (7) , 075904
Simulation of the effect of deep defects created by hydrogen on the performance of amorphous indium gallium zinc oxide thin film transistor (a-IGZO TFT)
- 3 April 2019
- Published by IOP Publishing in Materials Research Express
- Vol. 6 (7) , 075904
Simulation of the effect of deep defects created by hydrogen on the performance of amorphous indium gallium zinc oxide thin film transistor (a-IGZO TFT)
- Top Cited Papers
- 1 March 2019
- Published by Elsevier in Solar Energy
- Vol. 181, 372-378
Electron and hole transport layers optimization by numerical simulation of a perovskite solar cell
- 1 March 2019
- Published by Elsevier in Solar Energy
- Vol. 181, 372-378
Top Cited PapersElectron and hole transport layers optimization by numerical simulation of a perovskite solar cell
- 3 December 2018
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 48 (2) , 1018-1030
Numerical Simulation and Optimization of An a-ITZO TFT Based on a Bi-Layer Gate Dielectrics
- 3 December 2018
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 48 (2) , 1018-1030
Numerical Simulation and Optimization of An a-ITZO TFT Based on a Bi-Layer Gate Dielectrics
- 3 September 2018
- Published by Springer Nature in Applied Nanoscience
- Vol. 8 (8) , 1865-1875
Effect of the interfacial (low-k SiO2 vs high-k Al2O3) dielectrics on the electrical performance of a-ITZO TFT
- 3 September 2018
- Published by Springer Nature in Applied Nanoscience
- Vol. 8 (8) , 1865-1875
Effect of the interfacial (low-k SiO2 vs high-k Al2O3) dielectrics on the electrical performance of a-ITZO TFT
- 1 July 2018
- Published by Allerton Press in Applied Solar Energy
- Vol. 54 (4) , 261-269
Semi-Analytical Simulation and Optimization of AlGaAs/GaAs p-i-n Quantum Well Solar Cell
This paper deals with a AlGaAs/GaAs p-i-n quantum well solar cell. The doped region are based on AlGaAs semiconductor while the intrinsic region “ I” contain multi quantum well (MQW) system...
- 1 July 2018
- Published by Allerton Press in Applied Solar Energy
- Vol. 54 (4) , 261-269
Semi-Analytical Simulation and Optimization of AlGaAs/GaAs p-i-n Quantum Well Solar Cell
This paper deals with a AlGaAs/GaAs p-i-n quantum well solar cell. The doped region are based on AlGaAs semiconductor while the intrinsic region “ I” contain multi quantum well (MQW) system...