Yong Guo
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Yong Guo has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Jingchang Zhao
School of Materials and Energy, Yunnan University, Kunming, People’s Republic of China
7 shared publications Junlang Tan
School of Materials and Energy, Yunnan University, Kunming, People’s Republic of China
6 shared publications- Junlang Tan
School of Materials and Energy Yunnan University Kunming P.R. China
3 shared publications Jingchang Zhao
2 shared publicationsFutong Ren
School of Materials and Energy Yunnan University Kunming P.R. China
1 shared publicationGuang Ma
1 shared publication
Latest Publications
- 16 February 2023
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 106 (6) , 3462-3470
Giant dielectric response and grain heterogeneity of Y 2/3 Cu 3 Ti 4 O 12 –TiO 2 composite ceramics fabricated by hydrothermal process
Due to the boom of the electronic information industry, dielectric ceramic materials are widely applied in passive components such as multilayer ceramic capacitors. In this article, Y 2/3 Cu 3 Ti 4 O 12 –TiO 2 composite ceramics with outstanding dielectric properties ( ε r = 2.29 × 10 6 at 20 Hz, ε r = 4.49×10 5 at 1 kHz) were successfully prepared by hydrothermal and in situ solid‐state methods. The minimum dielectric loss value (at 1 kHz) of the obtained composite ceramics is about 0.57. The experimental results show that Y 2/3 Cu 3 Ti 4 O 12 has a composite perovskite structure with cation vacancies, which causes internal electron‐pinned defect‐dipole, and the easy entry of excessive titanium ions to produce donor defects. Meanwhile, the heterogeneous grains with a pomegranate‐like microstructure were observed in the prepared composite ceramics, and interfacial polarization between subgrain boundaries was substantiated by impedance analysis. The abundant weakly trapped electrons and more polarized interfaces formed by grain and subgrain boundaries are the primary sources of the excellent dielectric properties of composite ceramics.
- 16 February 2023
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 106 (6) , 3462-3470
Giant dielectric response and grain heterogeneity of Y 2/3 Cu 3 Ti 4 O 12 –TiO 2 composite ceramics fabricated by hydrothermal process
Due to the boom of the electronic information industry, dielectric ceramic materials are widely applied in passive components such as multilayer ceramic capacitors. In this article, Y 2/3 Cu 3 Ti 4 O 12 –TiO 2 composite ceramics with outstanding dielectric properties ( ε r = 2.29 × 10 6 at 20 Hz, ε r = 4.49×10 5 at 1 kHz) were successfully prepared by hydrothermal and in situ solid‐state methods. The minimum dielectric loss value (at 1 kHz) of the obtained composite ceramics is about 0.57. The experimental results show that Y 2/3 Cu 3 Ti 4 O 12 has a composite perovskite structure with cation vacancies, which causes internal electron‐pinned defect‐dipole, and the easy entry of excessive titanium ions to produce donor defects. Meanwhile, the heterogeneous grains with a pomegranate‐like microstructure were observed in the prepared composite ceramics, and interfacial polarization between subgrain boundaries was substantiated by impedance analysis. The abundant weakly trapped electrons and more polarized interfaces formed by grain and subgrain boundaries are the primary sources of the excellent dielectric properties of composite ceramics.
- 12 September 2022
- Published by Springer Nature in MRS Advances
- Vol. 7 (30) , 736-740
Microstructure and dielectric properties of CaCu3Ti4O12 ceramics by lanthanum/europium co-doping
- 12 September 2022
- Published by Springer Nature in MRS Advances
- Vol. 7 (30) , 736-740
Microstructure and dielectric properties of CaCu3Ti4O12 ceramics by lanthanum/europium co-doping
- 3 September 2022
- Published by Elsevier in Materials Chemistry and Physics
- Vol. 291
Microstructure, dielectric response and impedance spectroscopy of SrCu3Ti4O12 ceramics prepared by a sol-gel technique
- 3 September 2022
- Published by Elsevier in Materials Chemistry and Physics
- Vol. 291
Microstructure, dielectric response and impedance spectroscopy of SrCu3Ti4O12 ceramics prepared by a sol-gel technique
- 16 August 2022
- Published by Springer Nature in MRS Communications
- Vol. 12 (5) , 734-737
Dielectric properties and microstructure of CCTO/SnO2 composite ceramics prepared by solid-state method
- 16 August 2022
- Published by Springer Nature in MRS Communications
- Vol. 12 (5) , 734-737
Dielectric properties and microstructure of CCTO/SnO2 composite ceramics prepared by solid-state method
- 11 March 2022
- Published by Elsevier in Ceramics International
- Vol. 48 (12) , 17795-17801
Microstructure and electrical properties of nano-scale SnO2 hydrothermally coated CCTO-based composite ceramics
- 11 March 2022
- Published by Elsevier in Ceramics International
- Vol. 48 (12) , 17795-17801
Microstructure and electrical properties of nano-scale SnO2 hydrothermally coated CCTO-based composite ceramics
- 1 February 2022
- Published by Elsevier in Materials Chemistry and Physics
- Vol. 278
Influence of CTO additives on microstructure and electrical properties of CCTO ceramics
- 1 February 2022
- Published by Elsevier in Materials Chemistry and Physics
- Vol. 278
Influence of CTO additives on microstructure and electrical properties of CCTO ceramics
- 27 January 2022
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 33 (4) , 1807-1816
Microstructure, morphology, and dielectric properties of in situ synthesized CCTO/CTO/TiO2 composite ceramics
- 27 January 2022
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 33 (4) , 1807-1816
Microstructure, morphology, and dielectric properties of in situ synthesized CCTO/CTO/TiO2 composite ceramics
- 23 May 2021
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry C
- Vol. 9 (25) , 8011-8019
Microstructure and colossal permittivity of CaTiO3 ceramics covered with nano-sized CuO and TiO2 by the hydrothermal method
The influence of covering nano-sized TiO2 and CuO on the microstructure and permittivity of CaTiO3 ceramics was studied.
- 23 May 2021
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry C
- Vol. 9 (25) , 8011-8019
Microstructure and colossal permittivity of CaTiO3 ceramics covered with nano-sized CuO and TiO2 by the hydrothermal method
The influence of covering nano-sized TiO2 and CuO on the microstructure and permittivity of CaTiO3 ceramics was studied.
- Open Access
- 1 January 2021
- Published by Elsevier in SSRN Electronic Journal
Microstructure and Improved Dielectric Properties of CaCu 3Ti 4O 12 Ceramics by Lanthanum/Europium Co-Doping
In this work, (La, Eu) co-doped CaCu3Ti4O12 ceramics (Ca1-xLaxCu3Ti4-xEuxO12, x = 0.1, 0.3, and 0.5) were prepared by the traditional solid-state method. The XRD results of ceramics confirmed the formation of the single-phase CCTO and a residual amount of CaTiO3. The refined calculation found that the lattice constant of CLCTEO ceramics will be significantly increased due to the co-doping of La and Eu. The FESEM analysis showed a smaller grain size for the co-doped CCTO. Impedance measurements indicated that the (La, Eu) co-doped CCTO ceramics have higher dielectric permittivity than the single-doped with La and Eu. The most negligible dielectric loss was achieved in CLCTEO ceramics with x = 0.1, and a low tanδ of 0.013 was observed at 800kHz for room temperature. The results indicated that the co-doping method is an effective method to improve the dielectric properties.
- 1 January 2021
- Published by Elsevier in SSRN Electronic Journal
Open AccessMicrostructure and Improved Dielectric Properties of CaCu 3Ti 4O 12 Ceramics by Lanthanum/Europium Co-Doping
In this work, (La, Eu) co-doped CaCu3Ti4O12 ceramics (Ca1-xLaxCu3Ti4-xEuxO12, x = 0.1, 0.3, and 0.5) were prepared by the traditional solid-state method. The XRD results of ceramics confirmed the formation of the single-phase CCTO and a residual amount of CaTiO3. The refined calculation found that the lattice constant of CLCTEO ceramics will be significantly increased due to the co-doping of La and Eu. The FESEM analysis showed a smaller grain size for the co-doped CCTO. Impedance measurements indicated that the (La, Eu) co-doped CCTO ceramics have higher dielectric permittivity than the single-doped with La and Eu. The most negligible dielectric loss was achieved in CLCTEO ceramics with x = 0.1, and a low tanδ of 0.013 was observed at 800kHz for room temperature. The results indicated that the co-doping method is an effective method to improve the dielectric properties.