Qi Li
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Qi Li has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
- Guiling Wu
Shanghai Jiao Tong University
4 shared publications - Liang Hu
Department of Computer Science and Technology, Tongji University, Shanghai, China
4 shared publications Jianping Chen
Jiaxing Time-Transfer Photoelectric Company Ltd
3 shared publicationsJinbo Zhang
3 shared publications- Faxing Zuo
Shanghai Jiao Tong University
1 shared publication - Jianping Chen
State Key Laboratory of Photonics and Communications, Department of Electronic Engineering, Shanghai Jiao Tong University, Shanghai, China
1 shared publication
Latest Publications
- 8 August 2023
- Published by Optica Publishing Group in Optics Express
- Vol. 31 (17) , 28078-28088
Photonic millimeter-wave transfer with balanced dual-heterodyne phase noise detection and cancellation
We report on the realization of long-haul and high-precision millimeter-wave (mm-wave) transfer through a fiber-optic link based on balanced dual-heterodyne phase noise detection. The balanced dual-heterodyne detection is achieved by detecting the fiber phase noise superimposed two intermediate frequency (IF) signals without requiring a local synchronization signal and its output is used to compensate the fiber-induced phase noise by actuating the frequency of the one optical carrier. The proposed scheme can effectively get rid of the effect of the local reference, largely simplifying the configuration at the local site. Additionally, we model and experimentally study the noise contribution coming from the out-of-band, which can be effectively suppressed to the below of the system noise floor with a fractional frequency instability of 1.9 × 10−17 at 10,000 s by designing and implementing a high-precision temperature control module with a peak-to-peak temperature fluctuation of no more than 0.002 K. We experimentally demonstrate that a 100 GHz mm-wave signal to be transmitted over a 150 km fiber-optic link can achieve the fractional frequency instabilities of less than 3.4 × 10−14 at 1 s and 3.5 × 10−17 at 10,000 s.
- 8 August 2023
- Published by Optica Publishing Group in Optics Express
- Vol. 31 (17) , 28078-28088
Photonic millimeter-wave transfer with balanced dual-heterodyne phase noise detection and cancellation
We report on the realization of long-haul and high-precision millimeter-wave (mm-wave) transfer through a fiber-optic link based on balanced dual-heterodyne phase noise detection. The balanced dual-heterodyne detection is achieved by detecting the fiber phase noise superimposed two intermediate frequency (IF) signals without requiring a local synchronization signal and its output is used to compensate the fiber-induced phase noise by actuating the frequency of the one optical carrier. The proposed scheme can effectively get rid of the effect of the local reference, largely simplifying the configuration at the local site. Additionally, we model and experimentally study the noise contribution coming from the out-of-band, which can be effectively suppressed to the below of the system noise floor with a fractional frequency instability of 1.9 × 10−17 at 10,000 s by designing and implementing a high-precision temperature control module with a peak-to-peak temperature fluctuation of no more than 0.002 K. We experimentally demonstrate that a 100 GHz mm-wave signal to be transmitted over a 150 km fiber-optic link can achieve the fractional frequency instabilities of less than 3.4 × 10−14 at 1 s and 3.5 × 10−17 at 10,000 s.
- 11 May 2022
- Published by Optica Publishing Group in Optics Express
- Vol. 30 (11) , 18402-18414
Multiple-access relay stations for long-haul fiber-optic radio frequency transfer
We report on the realization of a long-haul radio frequency (RF) transfer scheme by using multiple-access relay stations (MARSs). The proposed scheme with independent link noise compensation for each fiber sub-link effectively solves the limitation of compensation bandwidth for long-haul transfer. The MARS can have the capability to share the same modulated optical signal for the front and rear fiber sub-links, simplifying the configuration at the repeater station and enabling the transfer system to have the multiple-access capability. At the same time, we for the first time theoretically model the effect of the MARS position on the fractional frequency instability of the fiber-optic RF transfer, demonstrating that the MARS position has little effect on system’s performance when the ratio of the front and rear fiber sub-links is around 1:1. We experimentally demonstrate a 1 GHz signal transfer by using one MARS connecting 260 and 280 km fiber links with the fractional frequency instabilities of less than 5.9 × 10−14 at 1 s and 8.5 × 10−17 at 10,000 s at the remote site and of 5.6 × 10−14 and 6.6 × 10−17 at the integration times of 1 s and 10,000 s at the MARS. The proposed scalable technique can arbitrarily add the same MARSs in the fiber link, which has great potential in realizing ultra-long-haul RF transfer.
- 11 May 2022
- Published by Optica Publishing Group in Optics Express
- Vol. 30 (11) , 18402-18414
Multiple-access relay stations for long-haul fiber-optic radio frequency transfer
We report on the realization of a long-haul radio frequency (RF) transfer scheme by using multiple-access relay stations (MARSs). The proposed scheme with independent link noise compensation for each fiber sub-link effectively solves the limitation of compensation bandwidth for long-haul transfer. The MARS can have the capability to share the same modulated optical signal for the front and rear fiber sub-links, simplifying the configuration at the repeater station and enabling the transfer system to have the multiple-access capability. At the same time, we for the first time theoretically model the effect of the MARS position on the fractional frequency instability of the fiber-optic RF transfer, demonstrating that the MARS position has little effect on system’s performance when the ratio of the front and rear fiber sub-links is around 1:1. We experimentally demonstrate a 1 GHz signal transfer by using one MARS connecting 260 and 280 km fiber links with the fractional frequency instabilities of less than 5.9 × 10−14 at 1 s and 8.5 × 10−17 at 10,000 s at the remote site and of 5.6 × 10−14 and 6.6 × 10−17 at the integration times of 1 s and 10,000 s at the MARS. The proposed scalable technique can arbitrarily add the same MARSs in the fiber link, which has great potential in realizing ultra-long-haul RF transfer.
- 15 February 2022
- Published by Optica Publishing Group in Optics Letters
- Vol. 47 (4) , 1005-1008
Fiber-optic joint time and frequency transmission with enhanced time precision
We propose a high-precision joint time and frequency transmission scheme based on bidirectional wavelength division multiplexing transmission over an optical fiber link. The time signal is generated based on the phase-stable frequency signal with employment of a dedicated designed low-jitter event generator. Time synchronization is realized by eliminating the time difference between the time signals of the master and slave stations, which is determined by accurate two-way time comparison. In this way, thanks to the high stability of the frequency transmission, low jitter of the dedicated designed event generator, and the high accuracy of the two-way time comparison, a high precision time signal with enhanced time stability and accuracy can be obtained at the slave station, which is synchronized to the master station. Experimentally, a joint time and frequency transmission system is demonstrated over a 62-km urban fiber link. The results show a time stability in terms of time deviation (TDEV) of 3.5 ps/s and 430 fs/10,000 s, and an accuracy of better than 20 ps can be realized.
- 15 February 2022
- Published by Optica Publishing Group in Optics Letters
- Vol. 47 (4) , 1005-1008
Fiber-optic joint time and frequency transmission with enhanced time precision
We propose a high-precision joint time and frequency transmission scheme based on bidirectional wavelength division multiplexing transmission over an optical fiber link. The time signal is generated based on the phase-stable frequency signal with employment of a dedicated designed low-jitter event generator. Time synchronization is realized by eliminating the time difference between the time signals of the master and slave stations, which is determined by accurate two-way time comparison. In this way, thanks to the high stability of the frequency transmission, low jitter of the dedicated designed event generator, and the high accuracy of the two-way time comparison, a high precision time signal with enhanced time stability and accuracy can be obtained at the slave station, which is synchronized to the master station. Experimentally, a joint time and frequency transmission system is demonstrated over a 62-km urban fiber link. The results show a time stability in terms of time deviation (TDEV) of 3.5 ps/s and 430 fs/10,000 s, and an accuracy of better than 20 ps can be realized.
- 3 January 2022
- Published by Optica Publishing Group in Applied Optics
- Vol. 61 (2) , 455-462
1.7 µm gain-switched and mode-locked hybrid Tm–Ho codoped fiber laser signal generation and optimization
We propose and experimentally demonstrate 1.7 µm gain-switched and mode-locked hybrid laser signal generation using a modulated pump and the nonlinear polarization rotation (NPR) effect. In the laser scheme, a 1.55 µm amplified modulated optical signal was used as a homemade pump. A bidirectional pumping configuration was adopted by splitting the homemade pump. A 1 m long thulium–holmium (Tm–Ho) codoped fiber was used as the gain medium. A fiber Bragg grating was employed as a spectral filter. The mode-locked laser pulse was obtained with a central wavelength of 1724 nm. The repetition rate was 11.81 MHz and the pulse width was 65.27 ps. Additionally, the gain-switched pulse sequences with a repetition rate from 50 kHz to 200 kHz were obtained by the modulated pump. Moreover, the mode-locked pulse train was filtered and modulated by the shape of the gain-switched pulse, and the hybrid pulse train was then obtained. Furthermore, the hybrid laser signals were analyzed and optimized by applying different waveforms of the modulated pump. The experimental results showed that the generated laser pulse driven by the sinusoidal signal has a better SNR (49.39 dB).
- 3 January 2022
- Published by Optica Publishing Group in Applied Optics
- Vol. 61 (2) , 455-462
1.7 µm gain-switched and mode-locked hybrid Tm–Ho codoped fiber laser signal generation and optimization
We propose and experimentally demonstrate 1.7 µm gain-switched and mode-locked hybrid laser signal generation using a modulated pump and the nonlinear polarization rotation (NPR) effect. In the laser scheme, a 1.55 µm amplified modulated optical signal was used as a homemade pump. A bidirectional pumping configuration was adopted by splitting the homemade pump. A 1 m long thulium–holmium (Tm–Ho) codoped fiber was used as the gain medium. A fiber Bragg grating was employed as a spectral filter. The mode-locked laser pulse was obtained with a central wavelength of 1724 nm. The repetition rate was 11.81 MHz and the pulse width was 65.27 ps. Additionally, the gain-switched pulse sequences with a repetition rate from 50 kHz to 200 kHz were obtained by the modulated pump. Moreover, the mode-locked pulse train was filtered and modulated by the shape of the gain-switched pulse, and the hybrid pulse train was then obtained. Furthermore, the hybrid laser signals were analyzed and optimized by applying different waveforms of the modulated pump. The experimental results showed that the generated laser pulse driven by the sinusoidal signal has a better SNR (49.39 dB).
- 7 June 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 33 (13) , 660-663
Fiber Radio Frequency Transfer Using Bidirectional Frequency Division Multiplexing Dissemination
We report on the realization of a novel fiber-optic radio frequency (RF) transfer scheme with the bidirectional frequency division multiplexing (FDM) dissemination technique. Here, the proper bidirectional frequency map used in the forward and backward directions for suppressing the backscattering noise and ensuring the symmetry of the bidirectional transfer RF signals within one telecommunication channel. We experimentally demonstrated a 0.9 GHz signal transfer over a 120 km optical link with the relative frequency stabilities of 2.2 ×10 -14 at 1 s and 4.6 ×10 -17 at 20000 s. The implementation of phase noise compensation at the remote site has the capability to perform RF transfer over a branching fiber network with the proposed technique as needed by large-scale scientific experiments.
- 7 June 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 33 (13) , 660-663
Fiber Radio Frequency Transfer Using Bidirectional Frequency Division Multiplexing Dissemination
We report on the realization of a novel fiber-optic radio frequency (RF) transfer scheme with the bidirectional frequency division multiplexing (FDM) dissemination technique. Here, the proper bidirectional frequency map used in the forward and backward directions for suppressing the backscattering noise and ensuring the symmetry of the bidirectional transfer RF signals within one telecommunication channel. We experimentally demonstrated a 0.9 GHz signal transfer over a 120 km optical link with the relative frequency stabilities of 2.2 ×10 -14 at 1 s and 4.6 ×10 -17 at 20000 s. The implementation of phase noise compensation at the remote site has the capability to perform RF transfer over a branching fiber network with the proposed technique as needed by large-scale scientific experiments.