ENEtienne Nowak

Etienne Nowak

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Etienne Nowak has a total of 15 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Toward the Understanding on Threshold Voltage Drift Mechanisms in GaN MOSc-HEMTs Through the Influence of Device Architecture

    by C. Leurquin, W. Vandendaele, M.-A. Jaud, R. Lavieville, B. Mohamad, C. Masante, G. Despesse, E. Nowak

    In this article, the impact of device architecture on threshold voltage VTH instabilities during OFF state operation under a high drain voltage stress on GaN-on-Si MOSc HEMTs is thoroughly investigated. Measurement-stress–measurement high-voltage bias temperature instability (HVBTI) technique using ultrafast VGS ramp was used in this study. This measurement technique was carried out on various gate length ( ${L}_{G}$ ), ohmic length (LOHM), and field plate (FP) length. HVBTI transients performed at different ${L}_{G}$ highlight that increasing the gate length induces a better electrostatic control under the gate via a gate shielding. TCAD simulations support the claim that the relaxation peak is linked to the charge redistribution of ionized ${C}_{N}$ (-) traps under the gate. This charge redistribution during the relaxation phase is enhanced using a larger ohmic contact area. The electric field at gate and source FP corners has a strong impact on ionized ${C}_{N}$ acceptor traps located in the GaN:C layer close to the gate and consequently on positive VTH degradation observed for short stress duration. Substrate biasing and TCAD simulations suggest that the ${C}_{N}$ traps’ deionization and trapping in the volume of the gate oxide is related to the presence of free holes in the GaN:C layer.


  • Open Access

    Advances in Emerging Memory Technologies: From Data Storage to Artificial Intelligence

    by Gabriel Molas, Etienne Nowak

    This paper presents an overview of emerging memory technologies. It begins with the presentation of stand-alone and embedded memory technology evolution, since the appearance of Flash memory in the 1980s. Then, the progress of emerging memory technologies (based on filamentary, phase change, magnetic, and ferroelectric mechanisms) is presented with a review of the major demonstrations in the literature. The potential of these technologies for storage applications addressing various markets and products is discussed. Finally, we discuss how the rise of artificial intelligence and bio-inspired circuits offers an opportunity for emerging memory technology and shifts the application from pure data storage to storage and computing tasks, and also enlarges the range of required specifications at the device level due to the exponential number of new systems and architectures.


  • Switching Event Detection and Self-Termination Programming Circuit for Energy Efficient ReRAM Memory Arrays

    by M. Alayan, E. Muhr, A. Levisse, M. Bocquet, M. Moreau, E. Nowak, G. Molas, E. Vianello, J. M. Portal

    Energy efficiency remains a challenge for the design of non-volatile resistive memories (ReRAMs) arrays. This memory technology suffers from intrinsic variability in switching speed, programming voltages and resistance levels. The programming conditions of memory elements (e.g. pulse widths and amplitudes) must cover the tail bits to avoid programming failures. Switching time of ReRAMs shows wide distributions. Therefore, fast cells are subjects for electrical stress after their switching and energy waste since programming currents are typically large for this technology (tens of lA). In this paper, we present a Write Termination (WT) circuit to stop the programming operation when the switching event occurs in the selected memory element. The proposed design is sensitive to current variations that take place when the memory element switches between two different resistance states (LRS and HRS). This WT scheme reduces the power consumption by 97+%, 93+% and 65+% during Forming, RESET and SET operations respectively. Our estimations show that area efficiency of 70% for a memory array is achievable when the presented WT circuit is integrated in near-memory peripheries. The demonstrated WT circuit is suitable for different ReRAM technologies with small overhead penalty and shows robustness against CMOS and ReRAM variabilities.