Ryo Saito
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Ryo Saito has a total of 17 co-authors. Here are the top co-authors by number of shared publications:
- Hidenori Kitai
Advanced Power Electronics Research Center, National Institute of Advanced Industrial Science and Technology 3 , Umezono 1-1-1, Tsukuba, Ibaraki 308-8568, Japan
1 shared publication - Katsuyuki Takahashi
Iwate University
1 shared publication - Ken-Ichi Shimizu
Hokkaido University N-21, W-10
1 shared publication Kenichi Kon
Institute for Catalysis, Hokkaido University, N-21, W-10, Sapporo 001-0021, Japan
1 shared publication- Kiyokazu Yasuda
Division of Materials and Manufacturing Science, Graduate School of Engineering, Osaka University, Osaka 565-0817, Japan
1 shared publication - Koichi Takaki
Iwate University
1 shared publication
Latest Publications
- 8 March 2022
- Published by Elsevier in Journal of Catalysis
- Vol. 408, 294-302
Enhancement of the hydrodesulfurization and C−S bond cleavage activities of rhodium phosphide catalysts by platinum addition
- 8 March 2022
- Published by Elsevier in Journal of Catalysis
- Vol. 408, 294-302
Enhancement of the hydrodesulfurization and C−S bond cleavage activities of rhodium phosphide catalysts by platinum addition
- 1 June 2021
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 92 (6) , 064706
Development of compact inductive energy storage pulsed-power generator driven by 13 kV SiC-MOSFET
A compact inductive energy storage (IES) pulsed-power generator that is driven by a novel 13 kV silicon carbide (SiC)-MOSFET is developed and molded into a compact modified TO-268. In this article, the switching characteristics required for IES pulsed-power generator development are evaluated. The maximum slew rates at MOSFET turn-on and turn-off are 157 and 129 kV/μs, respectively, at an input voltage of 10 kV. The maximum current flow from the drain to the source terminal is limited to 128 A during short-circuit switching. The on-resistance between the drain and source terminals increases during the SiC-MOSFET’s on state. It increases with the voltage and its minimum value is 1.07 Ω. These characteristics show that the device is suitable for use as an opening switch because of its low on-resistance and rapid large-current cutoff at high operating voltages. The characteristics of an IES pulsed-power generator composed of a SiC-MOSFET, a capacitor, and a pulsed transformer with a turn ratio of 5:15 are also evaluated. The output voltage peak and full width at half maximum reach 31.4 kV and 55 ns, respectively, at a charging voltage of 1100 V. The maximum energy transfer efficiency is 50.2% of the input energy with a load resistance of 2.5 kΩ. The results show that the MOSFET has excellent potential to support the development of a compact plasma generation system that offers better performance pulsed-power generators driven by semiconductor devices.
- 1 June 2021
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 92 (6) , 064706
Development of compact inductive energy storage pulsed-power generator driven by 13 kV SiC-MOSFET
A compact inductive energy storage (IES) pulsed-power generator that is driven by a novel 13 kV silicon carbide (SiC)-MOSFET is developed and molded into a compact modified TO-268. In this article, the switching characteristics required for IES pulsed-power generator development are evaluated. The maximum slew rates at MOSFET turn-on and turn-off are 157 and 129 kV/μs, respectively, at an input voltage of 10 kV. The maximum current flow from the drain to the source terminal is limited to 128 A during short-circuit switching. The on-resistance between the drain and source terminals increases during the SiC-MOSFET’s on state. It increases with the voltage and its minimum value is 1.07 Ω. These characteristics show that the device is suitable for use as an opening switch because of its low on-resistance and rapid large-current cutoff at high operating voltages. The characteristics of an IES pulsed-power generator composed of a SiC-MOSFET, a capacitor, and a pulsed transformer with a turn ratio of 5:15 are also evaluated. The output voltage peak and full width at half maximum reach 31.4 kV and 55 ns, respectively, at a charging voltage of 1100 V. The maximum energy transfer efficiency is 50.2% of the input energy with a load resistance of 2.5 kΩ. The results show that the MOSFET has excellent potential to support the development of a compact plasma generation system that offers better performance pulsed-power generators driven by semiconductor devices.
- 1 March 2021
- Published by Elsevier in Solid State Ionics
- Vol. 361, 115566
Synthesis, crystal structure and ionic conductivity of MgAl2X8 (X = Cl, Br)
- 1 March 2021
- Published by Elsevier in Solid State Ionics
- Vol. 361, 115566
Synthesis, crystal structure and ionic conductivity of MgAl2X8 (X = Cl, Br)
- Open Access
- 1 August 2014
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 61, 012007
Effect of surface roughening of aluminum plates on the strength of bonds formed between aluminum and polyphenylene sulfide by thermosonic bonding
- 1 August 2014
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 61, 012007
Open AccessEffect of surface roughening of aluminum plates on the strength of bonds formed between aluminum and polyphenylene sulfide by thermosonic bonding