Fatemeh Razi Astaraei
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Fatemeh Razi Astaraei has a total of 67 co-authors. Here are the top co-authors by number of shared publications:
- Ali Khatibi
Department of Renewable Energies and Environment, Faculty of New Sciences and Technologies, University of Tehran, Tehran, Iran
4 shared publications - Mohammad Hossein Ahmadi
Shahrood University of Technology
4 shared publications - Mohammad Hossein Jahangir
University of Tehran
4 shared publications Barat Ghobadian
Department of Biosystems Engineering Tarbiat Modares University Tehran Iran
3 shared publicationsOmid Tavakoli
School of Chemical Engineering, College of Engineering, University of Tehran, Tehran, Iran
3 shared publicationsBagher Mokhtari Shahdost
Department of Renewable Energies and Environment Faculty of New Sciences and Technologies University of Tehran Tehran Iran
2 shared publications
Latest Publications
- Open Access
- 24 October 2026
- Published by Elsevier in Energy Conversion and Management: X
- Vol. 32
Numerical and techno-economic analysis of PEMFCs with optimized flow-channel cross-section and turbulator design
- 24 October 2026
- Published by Elsevier in Energy Conversion and Management: X
- Vol. 32
Open AccessNumerical and techno-economic analysis of PEMFCs with optimized flow-channel cross-section and turbulator design
- 13 October 2026
- Published by Oxford University Press (OUP) in Integrated Environmental Assessment and Management
A novel life cycle assessment of lithium-thionyl chloride batteries in smart gas meters: Carbon, toxicity, and energy footprint
The rapid deployment of smart gas meters has increased reliance on lithium-thionyl chloride (LTC) batteries, which serve as the dominant power source due to their long service life and operational reliability. Despite their widespread use, their life cycle environmental burdens have received less attention. This study addresses this research gap by providing a life cycle assessment (LCA) of LTC batteries used in smart gas meters, based on 500,000 D-size cells over a 30-year service life. The results demonstrated a total carbon footprint of 1,434,654 kg CO2-eq (28.7 kg CO2-eq kg−1 battery) using the ReCiPe method, with electricity consumption and heavy fuel oil contributing 48.56% and 22.68% of the total global warming potential (GWP), respectively. The midpoint impacts identified marine ecotoxicity (45.3%) and freshwater ecotoxicity (25.8%) as the dominant impact categories, mostly driven by nickel (up to 59% contribution). Endpoint results illustrated damages of 5.37 disability-adjusted life years (DALY) to human health, 0.00876 species·yr to ecosystems, and 178,326 USD in resource scarcity. The energy demand of LTC battery manufacturing was strongly fossil-based, with 92.6% supplied from nonrenewable energy sources. Scenario analysis highlighted that switching to wind or solar energy can decrease GWP by ∼46%, while considering the transportation of 10 t.km, increased GWP by 31.3% and endpoint damages by >29.6%. Monte Carlo analysis based on 10,000 runs confirmed data robustness, with a coefficient of variation of less than 15% for most impact categories. The findings provide a transparent and application-specific LCA framework for LTC batteries and highlight key intervention points to decrease the environmental burdens associated with large-scale smart gas meter deployment.
- 13 October 2026
- Published by Oxford University Press (OUP) in Integrated Environmental Assessment and Management
A novel life cycle assessment of lithium-thionyl chloride batteries in smart gas meters: Carbon, toxicity, and energy footprint
The rapid deployment of smart gas meters has increased reliance on lithium-thionyl chloride (LTC) batteries, which serve as the dominant power source due to their long service life and operational reliability. Despite their widespread use, their life cycle environmental burdens have received less attention. This study addresses this research gap by providing a life cycle assessment (LCA) of LTC batteries used in smart gas meters, based on 500,000 D-size cells over a 30-year service life. The results demonstrated a total carbon footprint of 1,434,654 kg CO2-eq (28.7 kg CO2-eq kg−1 battery) using the ReCiPe method, with electricity consumption and heavy fuel oil contributing 48.56% and 22.68% of the total global warming potential (GWP), respectively. The midpoint impacts identified marine ecotoxicity (45.3%) and freshwater ecotoxicity (25.8%) as the dominant impact categories, mostly driven by nickel (up to 59% contribution). Endpoint results illustrated damages of 5.37 disability-adjusted life years (DALY) to human health, 0.00876 species·yr to ecosystems, and 178,326 USD in resource scarcity. The energy demand of LTC battery manufacturing was strongly fossil-based, with 92.6% supplied from nonrenewable energy sources. Scenario analysis highlighted that switching to wind or solar energy can decrease GWP by ∼46%, while considering the transportation of 10 t.km, increased GWP by 31.3% and endpoint damages by >29.6%. Monte Carlo analysis based on 10,000 runs confirmed data robustness, with a coefficient of variation of less than 15% for most impact categories. The findings provide a transparent and application-specific LCA framework for LTC batteries and highlight key intervention points to decrease the environmental burdens associated with large-scale smart gas meter deployment.
- Open Access
- 11 July 2026
- Published by Elsevier in SSRN Electronic Journal
Dual-Loop Recirculation Enhances Pollutant Removal, Biomass Recovery, and Bioelectricity Generation in an Integrated Photobioreactor–Microbial Fuel Cell Treating Real Municipal Wastewater
The integration of microalgae-based photobioreactors (PBRs) with microbial fuel cells (MFCs) offers a promising strategy for simultaneous wastewater treatment, biomass recovery, and renewable energy generation. However, the influence of internal recirculation on the overall performance of integrated PBR–MFC systems remains poorly understood. In this study, a novel dual-loop PBR–MFC configuration incorporating simultaneous cathode and anode effluent recirculation was developed and optimized using real municipal wastewater. The effects of cathode recirculation ratio (10–30%), anode recirculation ratio (10–30%), hydraulic retention time (24–72 h), and light intensity (50–200 μmolphotons m⁻² s⁻¹) on chemical oxygen demand (COD), total nitrogen (TN), total phosphorus (TP) removal, biomass production, and maximum power density were investigated using Response Surface Methodology with a Box–Behnken design. Hydraulic retention time was identified as the dominant factor governing pollutant removal, whereas light intensity affected nutrient assimilation and biomass production. Maximum power density exhibited a quadratic response, highlighting the need to balance substrate availability with electroactive microbial activity. Under the optimized operating conditions (25.5% cathode recirculation, 22.9% anode recirculation, 69.6 h HRT, and 172 μmolphotons.m⁻².s⁻¹), the integrated system achieved 96.7% COD, 93.7% TN, and 92.5% TP removal, together with 1751.2 mg.L⁻¹ biomass production and a maximum power density of 110.5 mW.m⁻². Compared with identical operation without recirculation, the proposed strategy increased biomass production by approximately 12% and power density by 21%, while improving nutrient removal. These findings demonstrate that controlled dual-loop recirculation is an effective process-intensification strategy for improving the environmental and bioelectrochemical performance of integrated PBR–MFC systems treating real municipal wastewater.
- 11 July 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessDual-Loop Recirculation Enhances Pollutant Removal, Biomass Recovery, and Bioelectricity Generation in an Integrated Photobioreactor–Microbial Fuel Cell Treating Real Municipal Wastewater
The integration of microalgae-based photobioreactors (PBRs) with microbial fuel cells (MFCs) offers a promising strategy for simultaneous wastewater treatment, biomass recovery, and renewable energy generation. However, the influence of internal recirculation on the overall performance of integrated PBR–MFC systems remains poorly understood. In this study, a novel dual-loop PBR–MFC configuration incorporating simultaneous cathode and anode effluent recirculation was developed and optimized using real municipal wastewater. The effects of cathode recirculation ratio (10–30%), anode recirculation ratio (10–30%), hydraulic retention time (24–72 h), and light intensity (50–200 μmolphotons m⁻² s⁻¹) on chemical oxygen demand (COD), total nitrogen (TN), total phosphorus (TP) removal, biomass production, and maximum power density were investigated using Response Surface Methodology with a Box–Behnken design. Hydraulic retention time was identified as the dominant factor governing pollutant removal, whereas light intensity affected nutrient assimilation and biomass production. Maximum power density exhibited a quadratic response, highlighting the need to balance substrate availability with electroactive microbial activity. Under the optimized operating conditions (25.5% cathode recirculation, 22.9% anode recirculation, 69.6 h HRT, and 172 μmolphotons.m⁻².s⁻¹), the integrated system achieved 96.7% COD, 93.7% TN, and 92.5% TP removal, together with 1751.2 mg.L⁻¹ biomass production and a maximum power density of 110.5 mW.m⁻². Compared with identical operation without recirculation, the proposed strategy increased biomass production by approximately 12% and power density by 21%, while improving nutrient removal. These findings demonstrate that controlled dual-loop recirculation is an effective process-intensification strategy for improving the environmental and bioelectrochemical performance of integrated PBR–MFC systems treating real municipal wastewater.
- 16 September 2025
- Published by Elsevier in Solar Energy
- Vol. 301
Integrated modeling of energy generation and water resource management utilizing floating photovoltaic (FPV) technology in semi-arid regions
- 16 September 2025
- Published by Elsevier in Solar Energy
- Vol. 301
Integrated modeling of energy generation and water resource management utilizing floating photovoltaic (FPV) technology in semi-arid regions
- 22 August 2025
- Published by Springer Nature in International Journal of Energy and Water Resources
- Vol. 9 (4) , 2579-2589
Interconnected sustainability and resilience: optimizing energy supply for petrochemical plants
- 22 August 2025
- Published by Springer Nature in International Journal of Energy and Water Resources
- Vol. 9 (4) , 2579-2589
Interconnected sustainability and resilience: optimizing energy supply for petrochemical plants
- Open Access
- 11 May 2025
- Published by Springer Nature in Research Square
Experimental and Numerical Parametric study of horizontal photobioreactor on the growth rate of Chlorella vulgaris microalgae
Microalgae have gained considerable attention due to their extensive application in the production of biofuels and water treatment. In this paper, the effects of three main parameters, namely the light intensity, aeration rate, and diameter of the photobioreactors (PBR), were simultaneously examined on the microalgae growth rate and energy cost of the horizontal PBR. Regarding the number of variables, the response surface method in the Design Expert software was employed to attain a deeper insight into the influence of these factors on biomass production and energy costs. The biomass and energy equations were obtained based on the numerical analysis. The highest biomass production rate (1.9 g/L per day) was attained under a light intensity of 625 µmol/s/m², photobioreactor diameter of 5 cm, and aeration rate of 0.18 L/min with the cost of 504.6 cents per day. At the optimum point, although the biomass production showed a 26.8% decline, it resulted in a 53% decrement in the energy costs. Therefore, the investigation of microalgae production at the highest efficiency and lowest costs in this research can promote the application of this useful and renewable biomass.
- 11 May 2025
- Published by Springer Nature in Research Square
Open AccessExperimental and Numerical Parametric study of horizontal photobioreactor on the growth rate of Chlorella vulgaris microalgae
Microalgae have gained considerable attention due to their extensive application in the production of biofuels and water treatment. In this paper, the effects of three main parameters, namely the light intensity, aeration rate, and diameter of the photobioreactors (PBR), were simultaneously examined on the microalgae growth rate and energy cost of the horizontal PBR. Regarding the number of variables, the response surface method in the Design Expert software was employed to attain a deeper insight into the influence of these factors on biomass production and energy costs. The biomass and energy equations were obtained based on the numerical analysis. The highest biomass production rate (1.9 g/L per day) was attained under a light intensity of 625 µmol/s/m², photobioreactor diameter of 5 cm, and aeration rate of 0.18 L/min with the cost of 504.6 cents per day. At the optimum point, although the biomass production showed a 26.8% decline, it resulted in a 53% decrement in the energy costs. Therefore, the investigation of microalgae production at the highest efficiency and lowest costs in this research can promote the application of this useful and renewable biomass.
- Open Access
- 22 April 2025
- Published by Elsevier in Energy Nexus
- Vol. 18
Addressing water scarcity and energy sustainability through PV-desalination systems: A case study on the southern coast of Iran
- 22 April 2025
- Published by Elsevier in Energy Nexus
- Vol. 18
Open AccessAddressing water scarcity and energy sustainability through PV-desalination systems: A case study on the southern coast of Iran
- Open Access
COVID-19 impact on wind and solar energy sector and cost of energy prediction based on machine learning
- 8 March 2024
- Published by Elsevier in Renewable Energy
- Vol. 225
GIS-AHP-GAMS based analysis of wind and solar energy integration for addressing energy shortage in industries: A case study
- 8 March 2024
- Published by Elsevier in Renewable Energy
- Vol. 225
GIS-AHP-GAMS based analysis of wind and solar energy integration for addressing energy shortage in industries: A case study