Hossein Jafari-Nodoushan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Hossein Jafari-Nodoushan has a total of 23 co-authors. Here are the top co-authors by number of shared publications:
- Mohammad Ali Faramarzi
Department of Pharmaceutical Biotechnology, Faculty of Pharmacy and Biotechnology Research Center, Tehran University of Medical Sciences, Tehran, Iran
3 shared publications - Nasrin Samadi
Department of Drug and Food Control, Faculty of Pharmacy, Tehran University of Medical Sciences, Tehran, Iran
2 shared publications Somayeh Mojtabavi
Department of Pharmaceutical Biotechnology, Faculty of Pharmacy, Tehran University of Medical Sciences, P.O. Box 14155-6451, Tehran 1417614411, Islamic Republic of Iran
2 shared publicationsAli Mohamad Ranjbar
Department of pharmacognosy, Faculty of Pharmacy, Shahid Sadoughi University of Medical Sciences, Yazd, Iran
1 shared publicationAlieh Ameri
Pharmaceutical Sciences and Cosmetic Products Research Center, Kerman University of Medical Sciences, Kerman, Islamic Republic of Iran
1 shared publication- Amir Reza Abdollahi
Department of Drug and Food Control Faculty of Pharmacy Tehran University of Medical Sciences Tehran Iran tums.ac.ir
1 shared publication
Latest Publications
- Open Access
- 1 January 2026
- Published by Wiley in International Journal of Microbiology
- Vol. 2026 (1)
When the Medium Skews the Message: Commercial Mueller–Hinton Agar Media and Their Effect on Antibiogram Results of Imipenem, Ciprofloxacin, and Gentamicin Against Standard and Clinical Strains of Pseudomonas aeruginosa
Accurate antimicrobial susceptibility testing (AST) is essential for guiding effective therapy and monitoring antibiotic resistance, particularly for Pseudomonas aeruginosa , a pathogen noted for its intrinsic and adaptive resistance mechanisms. Mueller–Hinton agar (MHA) is the standard medium for AST; however, variations in its composition among commercial brands can significantly affect test outcomes. This study evaluated the influence of five different commercial MHAs (HiMedia, Merck, Condalab, Quelab, and Sigma) on the antibiogram results of imipenem, ciprofloxacin, and gentamicin against both standard ( P. aeruginosa ATCC 15442) and 50 clinical isolates. Three inoculation methods, swab, pour plate, and double‐layer, were compared with identify the most reproducible approach. Inductively coupled plasma mass spectrometry (ICP‐MS) was used to quantify divalent cations (Ca 2+ , Mg 2+ , Zn 2+ , Mn 2+ , Fe 2+ ) in each medium, and microscopic examination assessed gel microstructure. The double‐layer method demonstrated the lowest coefficient of variation, indicating superior reproducibility compared with the swab and pour plate techniques. Significant differences were observed among media in inhibition zone diameters, with Quelab and Condalab producing consistently smaller zones ( p < 0.05). Cation analysis revealed wide variability, with calcium and magnesium levels differing up to fourfold across brands and being associated with differences in antibiotic activity, particularly for gentamicin and ciprofloxacin. Microscopic evaluation revealed minor gel‐structure variations without measurable impact on antibiotic diffusion. Susceptibility profiles also differed among MHA brands. These findings highlight the potential importance of medium composition, particularly cation concentration, in the variability of AST results. Standardization and rigorous quality control of commercial MHAs are essential to ensure reliable, reproducible, and clinically meaningful susceptibility testing.
- 1 January 2026
- Published by Wiley in International Journal of Microbiology
- Vol. 2026 (1)
Open AccessWhen the Medium Skews the Message: Commercial Mueller–Hinton Agar Media and Their Effect on Antibiogram Results of Imipenem, Ciprofloxacin, and Gentamicin Against Standard and Clinical Strains of Pseudomonas aeruginosa
Accurate antimicrobial susceptibility testing (AST) is essential for guiding effective therapy and monitoring antibiotic resistance, particularly for Pseudomonas aeruginosa , a pathogen noted for its intrinsic and adaptive resistance mechanisms. Mueller–Hinton agar (MHA) is the standard medium for AST; however, variations in its composition among commercial brands can significantly affect test outcomes. This study evaluated the influence of five different commercial MHAs (HiMedia, Merck, Condalab, Quelab, and Sigma) on the antibiogram results of imipenem, ciprofloxacin, and gentamicin against both standard ( P. aeruginosa ATCC 15442) and 50 clinical isolates. Three inoculation methods, swab, pour plate, and double‐layer, were compared with identify the most reproducible approach. Inductively coupled plasma mass spectrometry (ICP‐MS) was used to quantify divalent cations (Ca 2+ , Mg 2+ , Zn 2+ , Mn 2+ , Fe 2+ ) in each medium, and microscopic examination assessed gel microstructure. The double‐layer method demonstrated the lowest coefficient of variation, indicating superior reproducibility compared with the swab and pour plate techniques. Significant differences were observed among media in inhibition zone diameters, with Quelab and Condalab producing consistently smaller zones ( p < 0.05). Cation analysis revealed wide variability, with calcium and magnesium levels differing up to fourfold across brands and being associated with differences in antibiotic activity, particularly for gentamicin and ciprofloxacin. Microscopic evaluation revealed minor gel‐structure variations without measurable impact on antibiotic diffusion. Susceptibility profiles also differed among MHA brands. These findings highlight the potential importance of medium composition, particularly cation concentration, in the variability of AST results. Standardization and rigorous quality control of commercial MHAs are essential to ensure reliable, reproducible, and clinically meaningful susceptibility testing.
- 8 October 2022
- Published by Elsevier in Colloids and Surfaces B: Biointerfaces
- Vol. 220, 112910
A survey on the stabilizing effect of osmolytes on the ultrasound-irradiated lipase for efficient enzymatic hydrolysis of coconut oil
- 8 October 2022
- Published by Elsevier in Colloids and Surfaces B: Biointerfaces
- Vol. 220, 112910
A survey on the stabilizing effect of osmolytes on the ultrasound-irradiated lipase for efficient enzymatic hydrolysis of coconut oil
- Open Access
- 3 June 2022
- Published by Springer Nature in Scientific Reports
- Vol. 12 (1) , 1-16
Instantaneous synthesis and full characterization of organic–inorganic laccase-cobalt phosphate hybrid nanoflowers
A novel approach termed the "concentrated method" was developed for the instant fabrication of laccase@Co3(PO4)2•hybrid nanoflowers (HNFs). The constructed HNFs were obtained by optimizing the concentration of cobalt chloride and phosphate buffer to reach the highest activity recovery. The incorporation of 30 mM CoCl2 and 160 mM phosphate buffer (pH 7.4) resulted in a fast anisotropic growth of the nanomaterials. The purposed method did not involve harsh conditions and prolonged incubation of precursors, as the most reported approaches for the synthesis of HNFs. The catalytic efficiency of the immobilized and free laccase was 460 and 400 M−1S−1, respectively. Also, the enzymatic activity of the prepared biocatalyst was 113% of the free enzyme (0.5 U mL−1). The stability of the synthesized HNFs was enhanced by 400% at pH 6.5–9.5 and the elevated temperatures. The activity of laccase@Co3(PO4)2•HNFs declined to 50% of the initial value after 10 reusability cycles, indicating successful immobilization of the enzyme. Structural studies revealed a 32% increase in the α-helix content after hybridization with cobalt phosphate, which improved the activity and stability of the immobilized laccase. Furthermore, the fabricated HNFs exhibited a considerable ability to remove moxifloxacin as an emerging pollutant. The antibiotic (10 mg L−1) was removed by 24% and 75% after 24 h through adsorption and biodegradation, respectively. This study introduces a new method for synthesizing HNFs, which could be used for the fabrication of efficient biocatalysts, biosensors, and adsorbents for industrial, biomedical, and environmental applications.
- 3 June 2022
- Published by Springer Nature in Scientific Reports
- Vol. 12 (1) , 1-16
Open AccessInstantaneous synthesis and full characterization of organic–inorganic laccase-cobalt phosphate hybrid nanoflowers
A novel approach termed the "concentrated method" was developed for the instant fabrication of laccase@Co3(PO4)2•hybrid nanoflowers (HNFs). The constructed HNFs were obtained by optimizing the concentration of cobalt chloride and phosphate buffer to reach the highest activity recovery. The incorporation of 30 mM CoCl2 and 160 mM phosphate buffer (pH 7.4) resulted in a fast anisotropic growth of the nanomaterials. The purposed method did not involve harsh conditions and prolonged incubation of precursors, as the most reported approaches for the synthesis of HNFs. The catalytic efficiency of the immobilized and free laccase was 460 and 400 M−1S−1, respectively. Also, the enzymatic activity of the prepared biocatalyst was 113% of the free enzyme (0.5 U mL−1). The stability of the synthesized HNFs was enhanced by 400% at pH 6.5–9.5 and the elevated temperatures. The activity of laccase@Co3(PO4)2•HNFs declined to 50% of the initial value after 10 reusability cycles, indicating successful immobilization of the enzyme. Structural studies revealed a 32% increase in the α-helix content after hybridization with cobalt phosphate, which improved the activity and stability of the immobilized laccase. Furthermore, the fabricated HNFs exhibited a considerable ability to remove moxifloxacin as an emerging pollutant. The antibiotic (10 mg L−1) was removed by 24% and 75% after 24 h through adsorption and biodegradation, respectively. This study introduces a new method for synthesizing HNFs, which could be used for the fabrication of efficient biocatalysts, biosensors, and adsorbents for industrial, biomedical, and environmental applications.
- Open Access
- 25 September 2017
- Published by Maad Rayan Publishing Company in Advanced Pharmaceutical Bulletin
- Vol. 7 (3) , 441-450
Formulation and Optimization of Oral Mucoadhesive Patches of Myrtus Communis by Box Behnken Design
Purpose: Recurrent aphthous stomatitis (RAS) is the most common painful ulcerative disease of oral mucosa happening in ~20% of people. Aimed to develop Myrtus communis L. (Myrtle) containing oral patches, we applied box-behnken design to evaluate the effect of polymers such as Polyvinyl pyrrolidone (PVP), Gelatin, Methylcellulose (MC) and Pectin. Methods: The patches properties such as tensile strength, folding endurance, swelling index, thickness, mucoadhesive strength and the pattern of myrtle release were evaluated as dependent variables. Then, the model was adjusted according to the best fitted equation with box behnken design. Results: The results indicated that preparation of myrtle patch with hydrophilic polymers showed the disintegration time up to 24h and more. Using of polyvinyl pyrrolidone as a water soluble polymer and a pore-former polymer led to faster release of soluble materials from the patch to 29 (min-1). Also it decreases swelling index by increasing the patch disintegration. Gelatin and Pectin, with rigid matrix and water interaction properties, decreased the swelling ratio. Pectin increased the tensile strength, but gelatin produced an opposite effect. Thinner Myrtle patch (about 28µm) was obtained by formulation of methyl cellulose with equal ratio with polyvinyl pyrrolidone or gelatin. Conclusion: Altogether, the analysis showed that the optimal formulation was achieved with of 35.04 mg of Gelatin, 7.22 mg of Pectin, 7.20 mg of polyvinyl pyrrolidone, 50.52 mg of methyl cellulose and 20 mg of Myrtle extract.
- 25 September 2017
- Published by Maad Rayan Publishing Company in Advanced Pharmaceutical Bulletin
- Vol. 7 (3) , 441-450
Open AccessFormulation and Optimization of Oral Mucoadhesive Patches of Myrtus Communis by Box Behnken Design
Purpose: Recurrent aphthous stomatitis (RAS) is the most common painful ulcerative disease of oral mucosa happening in ~20% of people. Aimed to develop Myrtus communis L. (Myrtle) containing oral patches, we applied box-behnken design to evaluate the effect of polymers such as Polyvinyl pyrrolidone (PVP), Gelatin, Methylcellulose (MC) and Pectin. Methods: The patches properties such as tensile strength, folding endurance, swelling index, thickness, mucoadhesive strength and the pattern of myrtle release were evaluated as dependent variables. Then, the model was adjusted according to the best fitted equation with box behnken design. Results: The results indicated that preparation of myrtle patch with hydrophilic polymers showed the disintegration time up to 24h and more. Using of polyvinyl pyrrolidone as a water soluble polymer and a pore-former polymer led to faster release of soluble materials from the patch to 29 (min-1). Also it decreases swelling index by increasing the patch disintegration. Gelatin and Pectin, with rigid matrix and water interaction properties, decreased the swelling ratio. Pectin increased the tensile strength, but gelatin produced an opposite effect. Thinner Myrtle patch (about 28µm) was obtained by formulation of methyl cellulose with equal ratio with polyvinyl pyrrolidone or gelatin. Conclusion: Altogether, the analysis showed that the optimal formulation was achieved with of 35.04 mg of Gelatin, 7.22 mg of Pectin, 7.20 mg of polyvinyl pyrrolidone, 50.52 mg of methyl cellulose and 20 mg of Myrtle extract.