Anupama Surenjan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Anupama Surenjan has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
- Thalappil Pradeep
Indian Institute of Technology Madras
3 shared publications Balaji Sambandam
2 shared publicationsLigy Philip
2 shared publicationsPooja Pandey
2 shared publicationsSreelal Mohanan
Department of Aerospace Engineering, Indian Institute of Technology Madras, Chennai, India
2 shared publications- Basavaraju Manu
Department of Civil Engineering, National Institute of Technology, Karnataka, Surathkal 575025, India
1 shared publication
Latest Publications
- Open Access
- 1 October 2026
- Published by IWA Publishing in Water Supply
- Vol. 26 (10) , 1011-1026
Heterogeneous Fenton-like oxidation of phenalkamine condensate using iron oxide nanoparticles: catalytic performance, kinetics, and reusability
Graphical abstract showing Fenton-like oxidation of phenalkamine condensate using FeNP, achieving 85.11% COD removal from an initial COD of 140,000 mg/L. SEM analysis shows agglomerated spherical particles, while FTIR confirms Fe–O and other characteristic bonds. XRD identifies danalite, spinelloid, hematite, and iron oxide phases. Catalyst reusability was evaluated over four treatment cycles. Phenalkamine, a reaction product of cardanol, formaldehyde, and amines, is a highly valuable commercial product. The phenalkamine condensate is characterized by high pH, high chemical oxygen demand (COD) (140,000 mg/L), and comparatively low biochemical oxygen demand (BOD), making it challenging to degrade. In this study, heterogeneous Fenton-like oxidation using commercially obtained iron oxide nanoparticles (FeNPs) was investigated for treating real phenalkamine condensate. The FeNPs were characterized using SEM-EDS, XRD, FTIR, and BET techniques. XRD analysis confirmed hematite (Fe2O3) as the dominant crystalline phase with minor mixed crystalline reflections. The investigation also explored the influence of different parameters, including initial pH, H2O2 dosage, catalyst dosage, reaction time, and temperature. Optimal conditions are as follows: pH = 3.5, H2O2/COD ratio = 2, H2O2/FeNP ratio = 10, reaction period of 300 min at 313 K, and the maximum COD removal efficiency reached 85.11%. The degradation followed pseudo-first-order kinetics with a reaction rate constant of 0.00591 min−1 and an activation energy of 15.75 kJ/mol, indicating diffusion-controlled reaction. Comparison with conventional Fenton's oxidation demonstrated the superior performance of the FeNP catalyst. Furthermore, catalyst reusability studies revealed that the FeNPs could be reused for up to three cycles. This research contributes significant insights into the utilization of FeNPs as efficient catalysts for the degradation of phenalkamine condensate.
- 1 October 2026
- Published by IWA Publishing in Water Supply
- Vol. 26 (10) , 1011-1026
Open AccessHeterogeneous Fenton-like oxidation of phenalkamine condensate using iron oxide nanoparticles: catalytic performance, kinetics, and reusability
Graphical abstract showing Fenton-like oxidation of phenalkamine condensate using FeNP, achieving 85.11% COD removal from an initial COD of 140,000 mg/L. SEM analysis shows agglomerated spherical particles, while FTIR confirms Fe–O and other characteristic bonds. XRD identifies danalite, spinelloid, hematite, and iron oxide phases. Catalyst reusability was evaluated over four treatment cycles. Phenalkamine, a reaction product of cardanol, formaldehyde, and amines, is a highly valuable commercial product. The phenalkamine condensate is characterized by high pH, high chemical oxygen demand (COD) (140,000 mg/L), and comparatively low biochemical oxygen demand (BOD), making it challenging to degrade. In this study, heterogeneous Fenton-like oxidation using commercially obtained iron oxide nanoparticles (FeNPs) was investigated for treating real phenalkamine condensate. The FeNPs were characterized using SEM-EDS, XRD, FTIR, and BET techniques. XRD analysis confirmed hematite (Fe2O3) as the dominant crystalline phase with minor mixed crystalline reflections. The investigation also explored the influence of different parameters, including initial pH, H2O2 dosage, catalyst dosage, reaction time, and temperature. Optimal conditions are as follows: pH = 3.5, H2O2/COD ratio = 2, H2O2/FeNP ratio = 10, reaction period of 300 min at 313 K, and the maximum COD removal efficiency reached 85.11%. The degradation followed pseudo-first-order kinetics with a reaction rate constant of 0.00591 min−1 and an activation energy of 15.75 kJ/mol, indicating diffusion-controlled reaction. Comparison with conventional Fenton's oxidation demonstrated the superior performance of the FeNP catalyst. Furthermore, catalyst reusability studies revealed that the FeNPs could be reused for up to three cycles. This research contributes significant insights into the utilization of FeNPs as efficient catalysts for the degradation of phenalkamine condensate.
- 19 September 2025
- Published by Springer Nature in Process Integration and Optimization for Sustainability
- Vol. 10 (1) , 319-334
CFD Modeling and Analysis of the Effect of Baffles in an Immobilized Annular Photocatalytic Reactor for Ethylene Degradation
- 19 September 2025
- Published by Springer Nature in Process Integration and Optimization for Sustainability
- Vol. 10 (1) , 319-334
CFD Modeling and Analysis of the Effect of Baffles in an Immobilized Annular Photocatalytic Reactor for Ethylene Degradation
- 10 April 2025
- Published by Elsevier in Chemical Engineering and Processing - Process Intensification
- Vol. 213
Exploring the potential of cashew nut shell biochar for chlorpyrifos pesticide removal
- 10 April 2025
- Published by Elsevier in Chemical Engineering and Processing - Process Intensification
- Vol. 213
Exploring the potential of cashew nut shell biochar for chlorpyrifos pesticide removal
- 3 January 2025
- Published by Springer Nature in Process Integration and Optimization for Sustainability
- Vol. 9 (2) , 471-485
Photocatalytic Reactor Modelling Incorporating Computational Fluid Dynamics (CFD) for Water and Air purification: A Concise Review
- 3 January 2025
- Published by Springer Nature in Process Integration and Optimization for Sustainability
- Vol. 9 (2) , 471-485
Photocatalytic Reactor Modelling Incorporating Computational Fluid Dynamics (CFD) for Water and Air purification: A Concise Review
- Open Access
- 2 February 2024
- Published by IWA Publishing in Water Practice & Technology
- Vol. 19 (3) , 824-838
Green synthesis, characterisation, and performance evaluation of ZnO/TiO2 nanocomposite for cationic and anionic dye removal from aqueous solutions under solar irradiation
Utilising plant extract for the synthesis of nanocomposite shows great potential as a viable substitute for conventional chemical method. In this study, ZnO/TiO2 composite of three different weight ratios (1:2, 1:1, and 2:1) were green synthesised using hibiscus leaf extract as the capping agent. The synthesised composites were characterised using X-ray Diffraction (XRD), Field Emission Scanning Electron Microscopy (FESEM), UV–Vis Diffuse Reflectance Spectroscopy (UV–Vis DRS), Energy Dispersive X-ray Spectrometer (EDS), and Fourier Transform Infrared Spectroscopy (FTIR). XRD results confirmed the presence of wurtzite ZnO and anatase TiO2 in the composite. FTIR and FESEM analysis confirmed the formation of the composite. The composite was used for the removal of methylene blue and methyl orange dye under solar radiation. The degradation rate constant (k) of the composite with 1:2 weight ratio was 1.9 times the k value of pure TiO2. The effect of photocatalyst amount, initial pH of the dye solution, and reusability of the catalyst was investigated. The TiO2 and ZnO/TiO2 samples indicated a bandgap of 3.14 and 2.98 eV, respectively, which suggests better photocatalytic activity and also making the composite more active in the visible region.
- 2 February 2024
- Published by IWA Publishing in Water Practice & Technology
- Vol. 19 (3) , 824-838
Open AccessGreen synthesis, characterisation, and performance evaluation of ZnO/TiO2 nanocomposite for cationic and anionic dye removal from aqueous solutions under solar irradiation
Utilising plant extract for the synthesis of nanocomposite shows great potential as a viable substitute for conventional chemical method. In this study, ZnO/TiO2 composite of three different weight ratios (1:2, 1:1, and 2:1) were green synthesised using hibiscus leaf extract as the capping agent. The synthesised composites were characterised using X-ray Diffraction (XRD), Field Emission Scanning Electron Microscopy (FESEM), UV–Vis Diffuse Reflectance Spectroscopy (UV–Vis DRS), Energy Dispersive X-ray Spectrometer (EDS), and Fourier Transform Infrared Spectroscopy (FTIR). XRD results confirmed the presence of wurtzite ZnO and anatase TiO2 in the composite. FTIR and FESEM analysis confirmed the formation of the composite. The composite was used for the removal of methylene blue and methyl orange dye under solar radiation. The degradation rate constant (k) of the composite with 1:2 weight ratio was 1.9 times the k value of pure TiO2. The effect of photocatalyst amount, initial pH of the dye solution, and reusability of the catalyst was investigated. The TiO2 and ZnO/TiO2 samples indicated a bandgap of 3.14 and 2.98 eV, respectively, which suggests better photocatalytic activity and also making the composite more active in the visible region.
- Open Access
- 27 September 2023
- Published by IWA Publishing in Water Science & Technology
- Vol. 88 (8) , 2121-2135
CFD modelling of an immobilised photocatalytic reactor for phenol degradation
Photocatalysis is an advanced oxidation process, which has been gaining attention as a sustainable technology for tackling pollution. Optimum design, fabrication and scaling up of novel photocatalytic reactors are faced with problems such as fabrication cost and numerous experimental trials for optimisation. Computational fluid dynamics (CFD), a computer simulation technique can ease the process of scaling up photocatalytic reactors. The current study focuses on CFD modelling of a serpentine flow path photocatalytic reactor with curved baffles for phenol degradation. The investigation compared different reactor configurations to finalise the optimum design with maximum removal efficiency. Initially, a simple cuboidal reactor was chosen with an efficiency of 27%. However, with a serpentine flow path being introduced, the reactor displayed an improved efficiency of 42%. The addition of baffles improved flow homogeneity and degradation efficiency. The investigation showed that serpentine flow increased the residence time and fluid mixing, while the curved baffles prevented flow channelisation, which enhanced the degradation efficiency. Efficiencies corresponding to different baffle types and geometry were also compared and the final reactor design chosen was a horizontal curved baffled serpentine flow reactor with a flow rate of 0.3 L/s and improved efficiency of 43.1% for a residence time of 18.44 s.
- 27 September 2023
- Published by IWA Publishing in Water Science & Technology
- Vol. 88 (8) , 2121-2135
Open AccessCFD modelling of an immobilised photocatalytic reactor for phenol degradation
Photocatalysis is an advanced oxidation process, which has been gaining attention as a sustainable technology for tackling pollution. Optimum design, fabrication and scaling up of novel photocatalytic reactors are faced with problems such as fabrication cost and numerous experimental trials for optimisation. Computational fluid dynamics (CFD), a computer simulation technique can ease the process of scaling up photocatalytic reactors. The current study focuses on CFD modelling of a serpentine flow path photocatalytic reactor with curved baffles for phenol degradation. The investigation compared different reactor configurations to finalise the optimum design with maximum removal efficiency. Initially, a simple cuboidal reactor was chosen with an efficiency of 27%. However, with a serpentine flow path being introduced, the reactor displayed an improved efficiency of 42%. The addition of baffles improved flow homogeneity and degradation efficiency. The investigation showed that serpentine flow increased the residence time and fluid mixing, while the curved baffles prevented flow channelisation, which enhanced the degradation efficiency. Efficiencies corresponding to different baffle types and geometry were also compared and the final reactor design chosen was a horizontal curved baffled serpentine flow reactor with a flow rate of 0.3 L/s and improved efficiency of 43.1% for a residence time of 18.44 s.
- 1 December 2020
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 400, 123323
An efficient system for electro-Fenton oxidation of pesticide by a reduced graphene oxide-aminopyrazine@3DNi foam gas diffusion electrode
- 1 December 2020
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 400, 123323
An efficient system for electro-Fenton oxidation of pesticide by a reduced graphene oxide-aminopyrazine@3DNi foam gas diffusion electrode
- 1 August 2019
- Published by Elsevier in Chemosphere
- Vol. 228, 629-639
Application and performance evaluation of a cost-effective vis- LED based fluidized bed reactor for the treatment of emerging contaminants
- 1 August 2019
- Published by Elsevier in Chemosphere
- Vol. 228, 629-639
Application and performance evaluation of a cost-effective vis- LED based fluidized bed reactor for the treatment of emerging contaminants
- 1 February 2017
- Published by Elsevier in Journal of Environmental Chemical Engineering
- Vol. 5 (1) , 757-767
Synthesis, characterization and performance of visible light active C-TiO 2 for pharmaceutical photodegradation
- 1 February 2017
- Published by Elsevier in Journal of Environmental Chemical Engineering
- Vol. 5 (1) , 757-767
Synthesis, characterization and performance of visible light active C-TiO 2 for pharmaceutical photodegradation