Ajay Kumar Singh
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Ajay Kumar Singh has a total of 34 co-authors. Here are the top co-authors by number of shared publications:
- Deepak Singh Panwar
Department of Chemical Engineering, School of Engineering, P P Savani University, Kosamba, Surat, Gujarat - 394125, India
5 shared publications Partha Narayan Hajra
Oil and Natural Gas Corporation Ltd
4 shared publications- Udayan Singh
Department of Chemical and Biological Engineering, Northwestern University, Evanston, IL, United States
3 shared publications Abha Rani
Department of Applied Mathematics, Indian Institute of Technology (Indian School of Mines), Dhanbad, INDIA
2 shared publicationsB.D. Banerjee
2 shared publicationsV.K. Saxena
Department of Fuel & Mineral Engineering, IIT(ISM), Dhanbad, India
2 shared publications
Latest Publications
- 12 August 2024
- Published by Elsevier in Energy and Climate Change
- Vol. 5
Technological and policy directions for scaling-up blue hydrogen in India
- 12 August 2024
- Published by Elsevier in Energy and Climate Change
- Vol. 5
Technological and policy directions for scaling-up blue hydrogen in India
- 18 March 2019
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- Vol. 42 (6) , 664-675
Prospective evaluation of hydrocarbon generation potential of Umarsar lignite, India
The organic richness, thermal maturity, oil generation potential, liquefaction behavior hydrocarbon generation potential and geochemical properties of 12 lignite samples from Umarsar lignite mines of Kutch district, Gujarat, India were investigated. The lignite samples studied shows that they are significantly rich in total organic carbon (TOC) content which varies from 36.92 to 51.99 wt%. Tmax and HI index value show that these thermally immature lignite contains Types II-III and Type III kerogen; which is also anticipated from plot between released hydrocarbon (S2) yield and TOC. The cross plot between HI index and TOC demonstrates that the samples fall in fair oil source. The reflectance value varies from 0.23% to 0.28% and confirm it is immature in nature. The huminite maceral (>70.34%) dominates while liptinite >15.53% and inertinite occur in subordinated amount. High quantity of huminite and liptinite macerals shows its aptness towards liquid and gas hydrocarbon formation. The HI index and H/C values favor significant quality of hydrocarbon (gas and oil) potential.
- 18 March 2019
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- Vol. 42 (6) , 664-675
Prospective evaluation of hydrocarbon generation potential of Umarsar lignite, India
The organic richness, thermal maturity, oil generation potential, liquefaction behavior hydrocarbon generation potential and geochemical properties of 12 lignite samples from Umarsar lignite mines of Kutch district, Gujarat, India were investigated. The lignite samples studied shows that they are significantly rich in total organic carbon (TOC) content which varies from 36.92 to 51.99 wt%. Tmax and HI index value show that these thermally immature lignite contains Types II-III and Type III kerogen; which is also anticipated from plot between released hydrocarbon (S2) yield and TOC. The cross plot between HI index and TOC demonstrates that the samples fall in fair oil source. The reflectance value varies from 0.23% to 0.28% and confirm it is immature in nature. The huminite maceral (>70.34%) dominates while liptinite >15.53% and inertinite occur in subordinated amount. High quantity of huminite and liptinite macerals shows its aptness towards liquid and gas hydrocarbon formation. The HI index and H/C values favor significant quality of hydrocarbon (gas and oil) potential.
- 8 March 2019
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- Vol. 42 (7) , 824-834
Assessment of hydrocarbon generation potential of bituminous coal from Raniganj Basin, India
The present work deals with a study based on the geochemical techniques such as Rock-Eval pyrolysis, total organic carbon content (TOC), and detailed petrographic study to assess hydrocarbon generation potential of coal. A graph between TOC against hydrogen index (HI) has been plotted to detect the type of generating hydrocarbon, which lies in fair oil source. The significant amount of TOC and HI supports the formation of hydrocarbon. The vitrinite reflectance value and Tmax (431°C–446°C) also confirm that samples are matured enough to generate liquid and gaseous hydrocarbon in coal. The coal samples also contain sufficient quantity of vitrinite and liptinite macerals varying from 70.28% to 75.41 wt%, which confirm the production of liquid hydrocarbon. The cross-plot between H/C and O/C atomic ratio indicates that samples were predominant in the bituminous rank and having kerogen Type III makes it suitable for hydrocarbon generation. Similar results were found in Rock-Eval pyrolysis analysis (Types II-III and Type III kerogen). Seyler’s diagram reveals that most of the samples are per-hydrous in nature.
- 8 March 2019
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- Vol. 42 (7) , 824-834
Assessment of hydrocarbon generation potential of bituminous coal from Raniganj Basin, India
The present work deals with a study based on the geochemical techniques such as Rock-Eval pyrolysis, total organic carbon content (TOC), and detailed petrographic study to assess hydrocarbon generation potential of coal. A graph between TOC against hydrogen index (HI) has been plotted to detect the type of generating hydrocarbon, which lies in fair oil source. The significant amount of TOC and HI supports the formation of hydrocarbon. The vitrinite reflectance value and Tmax (431°C–446°C) also confirm that samples are matured enough to generate liquid and gaseous hydrocarbon in coal. The coal samples also contain sufficient quantity of vitrinite and liptinite macerals varying from 70.28% to 75.41 wt%, which confirm the production of liquid hydrocarbon. The cross-plot between H/C and O/C atomic ratio indicates that samples were predominant in the bituminous rank and having kerogen Type III makes it suitable for hydrocarbon generation. Similar results were found in Rock-Eval pyrolysis analysis (Types II-III and Type III kerogen). Seyler’s diagram reveals that most of the samples are per-hydrous in nature.
- 2 January 2019
- Published by Taylor & Francis in Environmental Practice
- Vol. 21 (1) , 36-40
Better accounting of greenhouse gas emissions from Indian coal mining activities — A field perspective
Fugitive methane emissions from coal mining activities have been frequently talked about in the literature due to concerns about climate change. However, indirect and direct CO2 emissions may also result from coal mining processes. The indirect CO2 emissions include those from diesel combustion from equipment while direct CO2 emissions are a relatively new area of research and have been recently brought into the purview of the Intergovernmental Panel on Climate Change (IPCC) inventory guidelines. We discuss some of the preliminary results which can give some directions into the potential research areas for better accounting of greenhouse gas emissions from coal mining activities. These have been derived from practical studies undertaken at selected coal mines in India.
- 2 January 2019
- Published by Taylor & Francis in Environmental Practice
- Vol. 21 (1) , 36-40
Better accounting of greenhouse gas emissions from Indian coal mining activities — A field perspective
Fugitive methane emissions from coal mining activities have been frequently talked about in the literature due to concerns about climate change. However, indirect and direct CO2 emissions may also result from coal mining processes. The indirect CO2 emissions include those from diesel combustion from equipment while direct CO2 emissions are a relatively new area of research and have been recently brought into the purview of the Intergovernmental Panel on Climate Change (IPCC) inventory guidelines. We discuss some of the preliminary results which can give some directions into the potential research areas for better accounting of greenhouse gas emissions from coal mining activities. These have been derived from practical studies undertaken at selected coal mines in India.
- 26 September 2018
- Published by Taylor & Francis in International Journal of Green Energy
- Vol. 15 (12) , 732-743
Coal mine gas: a new fuel utilization technique for India
Methane is associated with the coal has caused disaster in underground coal mines all over the world. However, coal mine gas utilization for fuel is a well-proven technology. Due to the different compositions of mine gas (0.1–95% CH4), this technology is still in a developing stage in India. Based on mine-specific measurement of the rate of emission, all the underground coal mines in India have been categorized into Degree I, Degree II, and Degree III. Coal mine methane is a general description for all methane released prior to, during, and after mining operations. As such, there is considerable variability in flow rate and composition of the various gas emissions during mining operations. From extraction technology and utilization perspective, coal mine gas is classified into four categories: (1) virgin coalbed methane or pre-mining degasification, (2) coal mine methane or degasification of working seams, (3) ventilation air methane, (4) abandoned mine methane. It is useful to explore the entire range of uses for all forms of coal mine gas to maximize the viability of each opportunity. Coal mine gas utilization/mitigation technologies are divided into five board categories: natural gas substitution, direct use at or near the mine site, electricity generation and cogeneration, chemical feedstock and simple destruction. Opportunities of implementation of these options in India have been discussed in this paper. This study will help to motivate both applied and theoretical research work on coal mine gas sites in India and after detailed analysis, it will provide basic data to interested industries.
- 26 September 2018
- Published by Taylor & Francis in International Journal of Green Energy
- Vol. 15 (12) , 732-743
Coal mine gas: a new fuel utilization technique for India
Methane is associated with the coal has caused disaster in underground coal mines all over the world. However, coal mine gas utilization for fuel is a well-proven technology. Due to the different compositions of mine gas (0.1–95% CH4), this technology is still in a developing stage in India. Based on mine-specific measurement of the rate of emission, all the underground coal mines in India have been categorized into Degree I, Degree II, and Degree III. Coal mine methane is a general description for all methane released prior to, during, and after mining operations. As such, there is considerable variability in flow rate and composition of the various gas emissions during mining operations. From extraction technology and utilization perspective, coal mine gas is classified into four categories: (1) virgin coalbed methane or pre-mining degasification, (2) coal mine methane or degasification of working seams, (3) ventilation air methane, (4) abandoned mine methane. It is useful to explore the entire range of uses for all forms of coal mine gas to maximize the viability of each opportunity. Coal mine gas utilization/mitigation technologies are divided into five board categories: natural gas substitution, direct use at or near the mine site, electricity generation and cogeneration, chemical feedstock and simple destruction. Opportunities of implementation of these options in India have been discussed in this paper. This study will help to motivate both applied and theoretical research work on coal mine gas sites in India and after detailed analysis, it will provide basic data to interested industries.
- 1 August 2018
- Published by Elsevier in International Journal of Coal Geology
- Vol. 196, 1-18
Influence of coal composition and maturity on methane storage capacity of coals of Raniganj Coalfield, India
- 1 August 2018
- Published by Elsevier in International Journal of Coal Geology
- Vol. 196, 1-18
Influence of coal composition and maturity on methane storage capacity of coals of Raniganj Coalfield, India
- 25 June 2018
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- Vol. 40 (16) , 1897-1909
Coalbed methane-produced water characteristics and insights from the Jharia coalfield in India
Coalbed methane (CBM) has emerged as one of India’s important unconventional natural gas sources in the past decade. A number of environmental questions flank the commercial development of CBM and its holistic success, one of which is coproduced water management. Present work aims at assessing the geochemistry of co-produced water samples collected from CBM wells in Jharia coalfield, India. It is found that pH is within accepted limits and the bacterial contamination is minimal. The major ions present in the water samples are sodium and bicarbonate. It is observed that the produced water is generally influenced by a mix of evaporite dissolution and silicate weathering and the samples are oversaturated with respect to calcite and dolomite. Subsequently, an assessment of the energy requirements of membrane-based technologies (such as reverse osmosis and nanofiltration) has been performed. The estimated energy consumption is 0.45–1.40 kWh per cubic meter of water, for differing levels of sodium desired in treated water. Membrane-based methods seem to be effective for treatment of CBM co-produced water, and the selection of membranes can be based on the geochemistry and also the level of treatment desired.
- 25 June 2018
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- Vol. 40 (16) , 1897-1909
Coalbed methane-produced water characteristics and insights from the Jharia coalfield in India
Coalbed methane (CBM) has emerged as one of India’s important unconventional natural gas sources in the past decade. A number of environmental questions flank the commercial development of CBM and its holistic success, one of which is coproduced water management. Present work aims at assessing the geochemistry of co-produced water samples collected from CBM wells in Jharia coalfield, India. It is found that pH is within accepted limits and the bacterial contamination is minimal. The major ions present in the water samples are sodium and bicarbonate. It is observed that the produced water is generally influenced by a mix of evaporite dissolution and silicate weathering and the samples are oversaturated with respect to calcite and dolomite. Subsequently, an assessment of the energy requirements of membrane-based technologies (such as reverse osmosis and nanofiltration) has been performed. The estimated energy consumption is 0.45–1.40 kWh per cubic meter of water, for differing levels of sodium desired in treated water. Membrane-based methods seem to be effective for treatment of CBM co-produced water, and the selection of membranes can be based on the geochemistry and also the level of treatment desired.
- 1 February 2018
- Published by Springer Nature
- p. 37-82
Coalbed Methane Potential Assessment
- 1 February 2018
- Published by Springer Nature
- p. 83-98
Economic and Environmental Aspects
- 1 February 2018
- Published by Springer Nature
- p. 21-35
Current Status of CBM in India