Shin-Ya Kishioka
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Shin-Ya Kishioka has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
Akifumi Yamada
Department of Chemistry, Faculty of Engineering, Nagaoka University of Technology, 1603-1 Kamitomioka, Nagaoka, Niigata 940-2188, Japan
4 shared publicationsHiroshi Sakaguchi
Department of Chemistry, Faculty of Engineering, Nagaoka University of Technology, Kamitomioka, Nagaoka, Niigata 940-2188, Japan, Research Institute of Electronics, Shizuoka University, Johoku, Hamamatsu, Shizuoka 432-8011, Japan, and Precursory Research for Embryonic Science and Technology (PRESTO), Japan Science and Technology Agency, 4-1-8 Honcho, Kawaguchi 332-0012, Japan
1 shared publicationJunichi Nishino
Department of Chemistry, Faculty of Engineering, Nagaoka University of Technology, Kamitomioka, Nagaoka, Niigata 940-2188, Japan, Research Institute of Electronics, Shizuoka University, Johoku, Hamamatsu, Shizuoka 432-8011, Japan, and Precursory Research for Embryonic Science and Technology (PRESTO), Japan Science and Technology Agency, 4-1-8 Honcho, Kawaguchi 332-0012, Japan
1 shared publicationRyoichi Aogaki
National Research Laboratory for Magnetic Science, Japan Science and Technology Corporation, Kawaguchi, Saitama 333‐0848, Japan
1 shared publicationTsuyoshi Kosugi
Department of Chemistry, Faculty of Engineering, Nagaoka University of Technology, 1603‐1 Kamitomioka, Nagaoka, Niigata 940‐2188, Japan
1 shared publication
Latest Publications
- 4 August 2007
- Published by American Chemical Society (ACS) in Analytical Chemistry
- Vol. 79 (17) , 6851-6856
Fabrication of Stable, Highly Flat Gold Film Electrodes with an Effective Thickness on the Order of 10 nm
Stable gold film electrodes were fabricated by a combination of sputtered gold and an epoxy adhesion layer on a glass substrate using the template-stripped technique. An XRR scan analysis indicated the thickness and roughness of the gold layer to be on the order of 10 nm and subnanometer, respectively. In spite of their small thickness, the electrode had sufficient conductivity and stuck to the subject during the electrochemical measurements as did the usual gold working electrodes.
- 4 August 2007
- Published by American Chemical Society (ACS) in Analytical Chemistry
- Vol. 79 (17) , 6851-6856
Fabrication of Stable, Highly Flat Gold Film Electrodes with an Effective Thickness on the Order of 10 nm
Stable gold film electrodes were fabricated by a combination of sputtered gold and an epoxy adhesion layer on a glass substrate using the template-stripped technique. An XRR scan analysis indicated the thickness and roughness of the gold layer to be on the order of 10 nm and subnanometer, respectively. In spite of their small thickness, the electrode had sufficient conductivity and stuck to the subject during the electrochemical measurements as did the usual gold working electrodes.
- 5 June 2006
- Published by Elsevier in Electrochimica Acta
- Vol. 51 (22) , 4582-4588
Electro-oxidation of N-hydroxy imides for redox mediator in acetonitrile containing lutidine as a base
- 5 June 2006
- Published by Elsevier in Electrochimica Acta
- Vol. 51 (22) , 4582-4588
Electro-oxidation of N-hydroxy imides for redox mediator in acetonitrile containing lutidine as a base
- 7 April 2005
- Published by Wiley in Electroanalysis
- Vol. 17 (8) , 724-726
Electrochemical Determination of a Free Chlorine Residual Using Cathodic Potential‐Step Chronocoulometry
The cathodic reaction of chlorine residual (CR) combined with anodic pre‐electrolysis enables the quantification of CR as a gaseous chlorine. Potential‐step chronocoulometry was successfully applied to extend the CR detection range.
- 7 April 2005
- Published by Wiley in Electroanalysis
- Vol. 17 (8) , 724-726
Electrochemical Determination of a Free Chlorine Residual Using Cathodic Potential‐Step Chronocoulometry
The cathodic reaction of chlorine residual (CR) combined with anodic pre‐electrolysis enables the quantification of CR as a gaseous chlorine. Potential‐step chronocoulometry was successfully applied to extend the CR detection range.
- 31 August 2004
- Published by Elsevier in Bioelectrochemistry
- Vol. 64 (1) , 109-112
Simultaneous determination of charge number and diffusion coefficient of 2-chloro-1,4-dimethoxybenzene in acetonitrile using potential-step chronoamperometry
- 31 August 2004
- Published by Elsevier in Bioelectrochemistry
- Vol. 64 (1) , 109-112
Simultaneous determination of charge number and diffusion coefficient of 2-chloro-1,4-dimethoxybenzene in acetonitrile using potential-step chronoamperometry
- 1 October 2001
- Published by Wiley in Electroanalysis
- Vol. 13 (14) , 1161-1164
Electrochemical Detection of Magnetic Convection: Effect of High Magnetic Fields on O2/O2− Electrode Reaction in Acetonitrile
- 1 October 2001
- Published by Wiley in Electroanalysis
- Vol. 13 (14) , 1161-1164
Electrochemical Detection of Magnetic Convection: Effect of High Magnetic Fields on O2/O2− Electrode Reaction in Acetonitrile