JDJoan E. Deffeyes

Joan E. Deffeyes

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Joan E. Deffeyes has a total of 11 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Modulatory Effects of the Ipsi and Contralateral Ventral Premotor Cortex (PMv) on the Primary Motor Cortex (M1) Outputs to Intrinsic Hand and Forearm Muscles inCebus apella

    by Stephan Quessy, Sandrine L. Côté, Adjia Hamadjida, Joan Deffeyes, Numa Dancause

    The ventral premotor cortex (PMv) is a key node in the neural network involved in grasping. One way PMv can carry out this function is by modulating the outputs of the primary motor cortex (M1) to intrinsic hand and forearm muscles. As many PMv neurons discharge when grasping with either arm, both PMv within the same hemisphere (ipsilateral; iPMv) and in the opposite hemisphere (contralateral; cPMv) could modulate M1 outputs. Our objective was to compare modulatory effects of iPMv and cPMv on M1 outputs to intrinsic hand and forearm muscles. We used paired-pulse protocols with intracortical microstimulations in capuchin monkeys. A conditioning stimulus was applied in either iPMv or cPMv simultaneously or prior to a test stimulus in M1 and the effects quantified in electromyographic signals. Modulatory effects from iPMv were predominantly facilitatory, and facilitation was much more common and powerful on intrinsic hand than forearm muscles. In contrast, while the conditioning of cPMv could elicit facilitatory effects, in particular to intrinsic hand muscles, it was much more likely to inhibit M1 outputs. These data show that iPMv and cPMv have very different modulatory effects on the outputs of M1 to intrinsic hand and forearm muscles.


  • Improved Corrosion Protection of Al Alloys by System Approach Interface Engineering: Part 3—AA7075-T6

    by C. E. Moffitt, C. M. Reddy, Q. S. Yu, D. M. Wieliczka, R. Johnson, J. E. Deffeyes, H. K. Yasuda

    This study investigates the development of chromate-free corrosion protection systems for AA7075-T6 ([7B]) based on the concept of system approach interface engineering (SAIE) by means of chemical and plasma techniques. An anode magnetron-enhanced direct current (DC) cathodic plasma process was used to enhance the interfacial bonding and the protection offered by a cathodically electrodeposited, epoxy-based primer (E-coat) on [7B]. Corrosion test results indicated that superior corrosion properties were achieved on [7B] with the aid of plasma interface engineering, tailoring specific properties of the interfaces. When tested in SO2 salt spray, several of these plasma-modified systems outperformed, and many of them performed comparably to the controls used in this study: chromate conversion-coated and then Deft primer-coated (Deft 44-GN-36) [7B] panels, as well as chromate conversion-coated and then cathodic E-coated [7B] panels. When tested by the Prohesion salt spray method, the corrosion protection performance of the best systems was close to or equal to the controls. The corrosion protection properties of [7B] were found to be strongly dependent on the surface preparation of the alloy, which was investigated by x-ray photoelectron spectroscopy (XPS). Plasma polymer-coated systems prepared on [7B] surfaces, with a deoxidization process in combination with the E-coat, displayed the most enhanced corrosion resistance.