Jie Tan
Research Subjects
Jie Tan has a total of 28 co-authors. Here are the top co-authors by number of shared publications:
Hui Cai
Tianjin Branch of CNOOC Ltd
4 shared publicationsChun-Yan Liu
Tianjin Branch of CNOOC Ltd
3 shared publicationsYan-Lai Li
Tianjin Branch of CNOOC Ltd, Tianjin, China
3 shared publicationsYing-Xian Liu
Tianjin Branch of CNOOC Ltd
3 shared publicationsChunyan Liu
Tianjin Branch of CNOOC Ltd
2 shared publicationsDong Liu
Tianjin Branch of CNOOC Ltd
2 shared publications
Latest Publications
- Open Access
- 1 September 2025
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 3048 (1)
Numerical Simulation Study on Water Breakthrough Law of Horizontal Wells in Offshore Bottom Water Reservoir
The low height of oil columns, significant differences in fluid properties, high initial water content, and rapid increase in water content in offshore bottom water reservoirs lead to the rapid entry of the oil field into a high water content period during production, posing severe challenges to development efficiency and economic benefits. This article aims to study the water breakthrough law along the horizontal well in the bottom water reservoir of the X Oilfield. By analyzing the main controlling factors such as crude oil viscosity, permeability, bottom water energy, interlayer distribution, drainage policy, and oil column height, a two-stage bottom water reservoir horizontal well production model is established using numerical simulation software. By adjusting the model parameters, the study simulates the displacement mechanism and sweep law of bottom water reservoirs under different conditions, and evaluates the three-dimensional utilization effect of the reservoir. The results show that the increase in crude oil viscosity delays water breakthrough, and the energy of bottom water mainly affects the early water breakthrough time. The reasonable discharge volume affects the water breakthrough speed and the use of low-permeability sections. The interlayer delays the formation of water ridges and weakens the influence of permeability differences. The height of the oil column affects the water breakthrough difference and overall development effect. The research results provide theoretical guidance for tapping and adjusting the potential of offshore bottom water reservoirs.
- 1 September 2025
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 3048 (1)
Open AccessNumerical Simulation Study on Water Breakthrough Law of Horizontal Wells in Offshore Bottom Water Reservoir
The low height of oil columns, significant differences in fluid properties, high initial water content, and rapid increase in water content in offshore bottom water reservoirs lead to the rapid entry of the oil field into a high water content period during production, posing severe challenges to development efficiency and economic benefits. This article aims to study the water breakthrough law along the horizontal well in the bottom water reservoir of the X Oilfield. By analyzing the main controlling factors such as crude oil viscosity, permeability, bottom water energy, interlayer distribution, drainage policy, and oil column height, a two-stage bottom water reservoir horizontal well production model is established using numerical simulation software. By adjusting the model parameters, the study simulates the displacement mechanism and sweep law of bottom water reservoirs under different conditions, and evaluates the three-dimensional utilization effect of the reservoir. The results show that the increase in crude oil viscosity delays water breakthrough, and the energy of bottom water mainly affects the early water breakthrough time. The reasonable discharge volume affects the water breakthrough speed and the use of low-permeability sections. The interlayer delays the formation of water ridges and weakens the influence of permeability differences. The height of the oil column affects the water breakthrough difference and overall development effect. The research results provide theoretical guidance for tapping and adjusting the potential of offshore bottom water reservoirs.
- 3 June 2025
- Published by Springer Nature
- p. 807-819
Progress and Research Direction of Enhanced Oil Recovery Technology in Bohai Oilfield
- 3 June 2025
- Published by Springer Nature
- p. 807-819
Progress and Research Direction of Enhanced Oil Recovery Technology in Bohai Oilfield
- Open Access
- 14 May 2024
- Published by Atlantis Press SARL
- p. 719-728
Experimental Study on the Mechanism of Thermal Composite Chemical Efficiency Enhancement in Offshore Heavy Oil Reservoir
- 14 May 2024
- Published by Atlantis Press SARL
- p. 719-728
Open AccessExperimental Study on the Mechanism of Thermal Composite Chemical Efficiency Enhancement in Offshore Heavy Oil Reservoir
- 21 March 2024
- Published by Springer Nature
- p. 1542-1564
Physical Simulation Experiment on Water Breakthrough and Control Along the Horizontal Well in Bottom Water Reservoir
- 21 March 2024
- Published by Springer Nature
- p. 1542-1564
Physical Simulation Experiment on Water Breakthrough and Control Along the Horizontal Well in Bottom Water Reservoir
- 21 March 2024
- Published by Springer Nature
- p. 526-556
The Physical Experiment of Displacement in an Offshore Fluvial Heavy Oil Reservoir
- 21 March 2024
- Published by Springer Nature
- p. 526-556
The Physical Experiment of Displacement in an Offshore Fluvial Heavy Oil Reservoir
- Open Access
- 22 September 2021
- Published by Springer Nature in Journal of Petroleum Exploration and Production Technology
- Vol. 12 (3) , 521-546
Physical simulation of residual oil displacement production in offshore strong bottom water reservoir
The C oilfield is located in the Bohai Bay Basin, a typical strong bottom water reservoir. Oilfield reservoir and oil–water distribution are complex. At present, the C oilfield has entered the high water cut development stage, and it is challenging to stabilize oil and control water. The reservoir with an imperfect well pattern has dominant bottom water ridge channels, uneven oil–water interface uplift, limited water drive sweep range, and low inter-well reservoir production degree. The oil layer between the horizontal section of the production well and the top of the reservoir cannot be effectively developed, and the remaining oil is enriched. Therefore, it is urgent to explore new energy supplement methods to improve inter-well and vertical remaining oil production in the C oilfield. In this study, the displacement medium is optimized through indoor experimental simulation. From the experimental results, the remaining oil between the sand bodies can be used in heavy oil reservoirs, and the residual oil between wells can be significantly utilized in the alternate displacement of gas and foam, and the recovery degree of the reservoir is increased by 12.44%. The remaining oil at the top of the reservoir can be used in the upper reservoir to increase the remaining oil in the top of the reservoir by injecting gas and foam alternately in the new reservoir. The final recovery of the reservoir is increased by 6.00%. This experimental study guides tapping the potential of the remaining oil in the offshore strong bottom water reservoir.
- 22 September 2021
- Published by Springer Nature in Journal of Petroleum Exploration and Production Technology
- Vol. 12 (3) , 521-546
Open AccessPhysical simulation of residual oil displacement production in offshore strong bottom water reservoir
The C oilfield is located in the Bohai Bay Basin, a typical strong bottom water reservoir. Oilfield reservoir and oil–water distribution are complex. At present, the C oilfield has entered the high water cut development stage, and it is challenging to stabilize oil and control water. The reservoir with an imperfect well pattern has dominant bottom water ridge channels, uneven oil–water interface uplift, limited water drive sweep range, and low inter-well reservoir production degree. The oil layer between the horizontal section of the production well and the top of the reservoir cannot be effectively developed, and the remaining oil is enriched. Therefore, it is urgent to explore new energy supplement methods to improve inter-well and vertical remaining oil production in the C oilfield. In this study, the displacement medium is optimized through indoor experimental simulation. From the experimental results, the remaining oil between the sand bodies can be used in heavy oil reservoirs, and the residual oil between wells can be significantly utilized in the alternate displacement of gas and foam, and the recovery degree of the reservoir is increased by 12.44%. The remaining oil at the top of the reservoir can be used in the upper reservoir to increase the remaining oil in the top of the reservoir by injecting gas and foam alternately in the new reservoir. The final recovery of the reservoir is increased by 6.00%. This experimental study guides tapping the potential of the remaining oil in the offshore strong bottom water reservoir.
- Open Access
- 5 September 2021
- Published by Springer Nature in Journal of Petroleum Exploration and Production Technology
- Vol. 11 (11) , 4087-4115
Experimental study on percolation mechanism and displacement characteristics of cold recovery in offshore heavy oil field
The heavy oil reservoir is a special kind of oil and gas reservoir that differs from the conventional reservoir in many ways. Due to the high viscosity of crude oil, it is not easy to recover. When the viscosity of underground crude oil exceeds 150 cp, the land heavy oil field is generally developed by thermal recovery. S.Z. oilfield is a heavy oil reservoir in the Bohai Sea, with surface crude oil viscosity of 3000–25,000 cp and underground crude oil viscosity of 400–1000 cp. Limited by offshore equipment, the development strategy of land oilfields can't be directly applied. High production capacity is obtained through the cold production development of horizontal branch experimental wells, and the water drive production capacity can reach 40–70 m3/day. At present, there is a lack of research on cold recovery development under the viscosity of crude oil. The existing primary research and common knowledge are challenging to support efficient development technology for effectively producing heavy oil reservoirs. In this paper, through physical simulation experiments, the phase behavior and rheological properties of crude oil in the target block are studied, and the rheological properties of crude oil are clarified. Then, the depletion production and water flooding experiments are carried out, and the displacement characteristics and laws of water flooding cold production are analyzed. Finally, the indoor experiments of water flooding sweep efficiency and oil displacement efficiency in the target block are carried out. Clear its micro and macro spread. It provides technical support for the effective production of offshore heavy oil fields.
- 5 September 2021
- Published by Springer Nature in Journal of Petroleum Exploration and Production Technology
- Vol. 11 (11) , 4087-4115
Open AccessExperimental study on percolation mechanism and displacement characteristics of cold recovery in offshore heavy oil field
The heavy oil reservoir is a special kind of oil and gas reservoir that differs from the conventional reservoir in many ways. Due to the high viscosity of crude oil, it is not easy to recover. When the viscosity of underground crude oil exceeds 150 cp, the land heavy oil field is generally developed by thermal recovery. S.Z. oilfield is a heavy oil reservoir in the Bohai Sea, with surface crude oil viscosity of 3000–25,000 cp and underground crude oil viscosity of 400–1000 cp. Limited by offshore equipment, the development strategy of land oilfields can't be directly applied. High production capacity is obtained through the cold production development of horizontal branch experimental wells, and the water drive production capacity can reach 40–70 m3/day. At present, there is a lack of research on cold recovery development under the viscosity of crude oil. The existing primary research and common knowledge are challenging to support efficient development technology for effectively producing heavy oil reservoirs. In this paper, through physical simulation experiments, the phase behavior and rheological properties of crude oil in the target block are studied, and the rheological properties of crude oil are clarified. Then, the depletion production and water flooding experiments are carried out, and the displacement characteristics and laws of water flooding cold production are analyzed. Finally, the indoor experiments of water flooding sweep efficiency and oil displacement efficiency in the target block are carried out. Clear its micro and macro spread. It provides technical support for the effective production of offshore heavy oil fields.
- Open Access
- 4 September 2021
- Published by Springer Nature in Journal of Petroleum Exploration and Production Technology
- Vol. 11 (11) , 4131-4146
Experimental study on waterflooding development of low-amplitude reservoir with big bottom water
For offshore reservoirs with a big bottom water range, the water cut rises quickly and soon enters the ultra-high water cut stage. After entering the ultra-high water cut stage, due to the influence of offshore production facilities, there are few potential tapping measures, so it is urgent to explore the feasibility study of artificial water injection development. The quasi-three-dimensional and two-dimensional displacement experiments are designed using the experimental similarity criteria according to the actual reservoir parameters. Several experimental schemes are designed, fluid physical properties, interlayer distribution, and development mode according to the actual reservoir physical properties. Through the visualization of experimental equipment, the bottom water reservoir is visually stimulated. The displacement and sweep law of natural water drive and artificial water injection in bottom water reservoir with or without an interlayer, different viscosity, and different well spacing is analyzed. The following conclusions are obtained: (1) For reservoirs with a viscosity of 150 cp. The recovery factor after water injection is slightly higher than before water injection. However, the recovery factor is lower than that without injection production. The reason is that the increment of injection conversion is limited to reduce one production well after injection conversion. (2) For reservoirs with a viscosity of 30 cp. The recovery factor after injection is 39.8%, which is slightly higher than 38.9% without injection. (3) For reservoirs with a viscosity of 150 cp. In the case of the interlayer. The recovery factor after injection is 30.7%, which is significantly higher than 24.8% without injection. (4) After the well spacing of the low-viscosity reservoir is reduced, the recovery factor reaches 46.1%, which is higher than 38.9% of the non-infill scheme. After the infill well in a low-viscosity reservoir is transferred to injection, the recovery factor is 45.6%, which has little change compared with non-injection, and most of the cumulative production fluid is water. The feasibility and effect of water flooding in a strong bottom water reservoir are demonstrated. This study provides the basis for the proposal of production well injection conversion and the adjustment of production parameters in the highest water cut stage of a big bottom water reservoir.
- 4 September 2021
- Published by Springer Nature in Journal of Petroleum Exploration and Production Technology
- Vol. 11 (11) , 4131-4146
Open AccessExperimental study on waterflooding development of low-amplitude reservoir with big bottom water
For offshore reservoirs with a big bottom water range, the water cut rises quickly and soon enters the ultra-high water cut stage. After entering the ultra-high water cut stage, due to the influence of offshore production facilities, there are few potential tapping measures, so it is urgent to explore the feasibility study of artificial water injection development. The quasi-three-dimensional and two-dimensional displacement experiments are designed using the experimental similarity criteria according to the actual reservoir parameters. Several experimental schemes are designed, fluid physical properties, interlayer distribution, and development mode according to the actual reservoir physical properties. Through the visualization of experimental equipment, the bottom water reservoir is visually stimulated. The displacement and sweep law of natural water drive and artificial water injection in bottom water reservoir with or without an interlayer, different viscosity, and different well spacing is analyzed. The following conclusions are obtained: (1) For reservoirs with a viscosity of 150 cp. The recovery factor after water injection is slightly higher than before water injection. However, the recovery factor is lower than that without injection production. The reason is that the increment of injection conversion is limited to reduce one production well after injection conversion. (2) For reservoirs with a viscosity of 30 cp. The recovery factor after injection is 39.8%, which is slightly higher than 38.9% without injection. (3) For reservoirs with a viscosity of 150 cp. In the case of the interlayer. The recovery factor after injection is 30.7%, which is significantly higher than 24.8% without injection. (4) After the well spacing of the low-viscosity reservoir is reduced, the recovery factor reaches 46.1%, which is higher than 38.9% of the non-infill scheme. After the infill well in a low-viscosity reservoir is transferred to injection, the recovery factor is 45.6%, which has little change compared with non-injection, and most of the cumulative production fluid is water. The feasibility and effect of water flooding in a strong bottom water reservoir are demonstrated. This study provides the basis for the proposal of production well injection conversion and the adjustment of production parameters in the highest water cut stage of a big bottom water reservoir.