Alex Silva Lima
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Alex Silva Lima has a total of 45 co-authors. Here are the top co-authors by number of shared publications:
- Mauro Bertotti
Department of Fundamental Chemistry, Institute of Chemistry, University of São Paulo, São Paulo, Brazil
10 shared publications - Carla Santana Santos
Analytical Chemistry- Center for Electrochemical Sciences (CES) Faculty of Chemistry and Biochemistry Ruhr University Bochum Universitätsstraße. 150 44780 Bochum Germany
3 shared publications - Marcos Roberto Vasconcelos Lanza
São Carlos Institute of Chemistry, University of São Paulo - USP, Avenida Trabalhador São Carlense 400, São Carlos, SP, 13566-590, Brazil
3 shared publications Mauro Bertotti
3 shared publications- Thiago Regis Longo Cesar Paixao
Universidade de São Paulo
3 shared publications Gabriel N. Meloni
Universidade de São Paulo
2 shared publications
Latest Publications
- 30 January 2018
- Published by American Chemical Society (ACS) in Analytical Chemistry
- Vol. 90 (4) , 2587-2593
Monitoring H2O2 inside Aspergillus fumigatus with an Integrated Microelectrode: The Role of Peroxiredoxin Protein Prx1
In vivo studies on the degradation of exogenous hydrogen peroxide (H2O2) in the microenvironment of Aspergillus fumigatus fungus were performed by using an integrated Pt microelectrode. Three A. fumigatus strains were used to confirm the role of the cytosolic protein Prx1 on the defense mechanism of this microorganism: a wild-type strain, capable to express the protein Prx1; a Δprx strain, whose gene prx1 was removed; and a complemented Δprx1::prx1+ strain derivatized from the Δprx and in which the gene prx1 was re-introduced. The fabricated microelectrode was shown to be an innocent probe for in situ and real-time measurements of H2O2 in such microenvironments, with potential applications in investigations involving the mechanism of oxidative stress.
- 30 January 2018
- Published by American Chemical Society (ACS) in Analytical Chemistry
- Vol. 90 (4) , 2587-2593
Monitoring H2O2 inside Aspergillus fumigatus with an Integrated Microelectrode: The Role of Peroxiredoxin Protein Prx1
In vivo studies on the degradation of exogenous hydrogen peroxide (H2O2) in the microenvironment of Aspergillus fumigatus fungus were performed by using an integrated Pt microelectrode. Three A. fumigatus strains were used to confirm the role of the cytosolic protein Prx1 on the defense mechanism of this microorganism: a wild-type strain, capable to express the protein Prx1; a Δprx strain, whose gene prx1 was removed; and a complemented Δprx1::prx1+ strain derivatized from the Δprx and in which the gene prx1 was re-introduced. The fabricated microelectrode was shown to be an innocent probe for in situ and real-time measurements of H2O2 in such microenvironments, with potential applications in investigations involving the mechanism of oxidative stress.
- 1 January 2018
- Published by Elsevier in Biosensors and Bioelectronics
- Vol. 99, 108-114
In-vivo electrochemical monitoring of H2O2 production induced by root-inoculated endophytic bacteria in Agave tequilana leaves
- 1 January 2018
- Published by Elsevier in Biosensors and Bioelectronics
- Vol. 99, 108-114
In-vivo electrochemical monitoring of H2O2 production induced by root-inoculated endophytic bacteria in Agave tequilana leaves
- 18 August 2017
- Published by American Chemical Society (ACS) in Analytical Chemistry
- Vol. 89 (18) , 9946-9952
Characterization of Nanopipet-Supported ITIES Tips for Scanning Electrochemical Microscopy of Single Solid-State Nanopores
Nanoscale scanning electrochemical microscopy (SECM) is a powerful scanning probe technique that enables high-resolution imaging of chemical processes at single nanometer-sized objects. However, it has been a challenging task to quantitatively understand nanoscale SECM images, which requires accurate characterization of the size and geometry of nanoelectrode tips. Herein, we address this challenge through transmission electron microscopy (TEM) of quartz nanopipets for SECM imaging of single solid-state nanopores by using nanopipet-supported interfaces between two immiscible electrolyte solutions (ITIES) as tips. We take advantage of the high resolution of TEM to demonstrate that laser-pulled quartz nanopipets reproducibly yield not only an extremely small tip diameter of ∼30 nm, but also a substantial tip roughness of ∼5 nm. The size and roughness of a nanopipet can be reliably determined by optimizing the intensity of the electron beam not to melt or deform the quartz nanotip without a metal coating. Electrochemically, the nanoscale ITIES supported by a rough nanotip gives higher amperometric responses to tetrabutylammonium than expected for a 30 nm diameter disc tip. The finite element simulation of sphere-cap ITIES tips accounts for the high current responses and also reveals that the SECM images of 100 nm diameter Si3N4 nanopores are enlarged along the direction of the tip scan. Nevertheless, spatial resolution is not significantly compromised by a sphere-cap tip, which can be scanned in closer proximity to the substrate. This finding augments the utility of a protruded tip, which can be fabricated and miniaturized more readily to facilitate nanoscale SECM imaging.
- 18 August 2017
- Published by American Chemical Society (ACS) in Analytical Chemistry
- Vol. 89 (18) , 9946-9952
Characterization of Nanopipet-Supported ITIES Tips for Scanning Electrochemical Microscopy of Single Solid-State Nanopores
Nanoscale scanning electrochemical microscopy (SECM) is a powerful scanning probe technique that enables high-resolution imaging of chemical processes at single nanometer-sized objects. However, it has been a challenging task to quantitatively understand nanoscale SECM images, which requires accurate characterization of the size and geometry of nanoelectrode tips. Herein, we address this challenge through transmission electron microscopy (TEM) of quartz nanopipets for SECM imaging of single solid-state nanopores by using nanopipet-supported interfaces between two immiscible electrolyte solutions (ITIES) as tips. We take advantage of the high resolution of TEM to demonstrate that laser-pulled quartz nanopipets reproducibly yield not only an extremely small tip diameter of ∼30 nm, but also a substantial tip roughness of ∼5 nm. The size and roughness of a nanopipet can be reliably determined by optimizing the intensity of the electron beam not to melt or deform the quartz nanotip without a metal coating. Electrochemically, the nanoscale ITIES supported by a rough nanotip gives higher amperometric responses to tetrabutylammonium than expected for a 30 nm diameter disc tip. The finite element simulation of sphere-cap ITIES tips accounts for the high current responses and also reveals that the SECM images of 100 nm diameter Si3N4 nanopores are enlarged along the direction of the tip scan. Nevertheless, spatial resolution is not significantly compromised by a sphere-cap tip, which can be scanned in closer proximity to the substrate. This finding augments the utility of a protruded tip, which can be fabricated and miniaturized more readily to facilitate nanoscale SECM imaging.
- 1 July 2017
- Published by Elsevier in Microchemical Journal
- Vol. 133, 149-154
Development of non-enzymatic and highly selective hydrogen peroxide sensor based on nanoporous gold prepared by a simple unusual electrochemical approach
- 1 July 2017
- Published by Elsevier in Microchemical Journal
- Vol. 133, 149-154
Development of non-enzymatic and highly selective hydrogen peroxide sensor based on nanoporous gold prepared by a simple unusual electrochemical approach
- 4 February 2017
- Published by Springer Nature in Electrocatalysis
- Vol. 8 (3) , 189-195
Synthesis and Characterization of ZrO2/C as Electrocatalyst for Oxygen Reduction to H2O2
- 4 February 2017
- Published by Springer Nature in Electrocatalysis
- Vol. 8 (3) , 189-195
Synthesis and Characterization of ZrO2/C as Electrocatalyst for Oxygen Reduction to H2O2
- 12 February 2016
- Published by Wiley in Electroanalysis
- Vol. 28 (7) , 1441-1447
Fabrication and Use of Dual‐function Iridium Oxide Coated Gold SECM Tips. An Application to pH Monitoring above a Copper Electrode Surface during Nitrate Reduction.
The fabrication of a gold microelectrode modified with iridium oxide film (IrOx) and its use as tip with a dual function in SECM experiments is reported. The defective structure of the coating onto the microelectrode surface was used as strategy to combine the advantages of both amperometric (for current‐distance determination) and potentiometric (for pH sensing) SECM operation modes. Approach curves, using oxygen and hexaammineruthenium(III) as redox mediators, were obtained without significant loss of the performance and reproducibility of the potentiometric pH response. This allowed the precise positioning of the proposed tip above a substrate in SECM experiments and, subsequently, to monitor pH at the substrate surface. The IrOx modified microelectrode was applied successfully in SECM experiments involving the local proton consumption during the nitrate reduction at a copper cathode surface.
- 12 February 2016
- Published by Wiley in Electroanalysis
- Vol. 28 (7) , 1441-1447
Fabrication and Use of Dual‐function Iridium Oxide Coated Gold SECM Tips. An Application to pH Monitoring above a Copper Electrode Surface during Nitrate Reduction.
The fabrication of a gold microelectrode modified with iridium oxide film (IrOx) and its use as tip with a dual function in SECM experiments is reported. The defective structure of the coating onto the microelectrode surface was used as strategy to combine the advantages of both amperometric (for current‐distance determination) and potentiometric (for pH sensing) SECM operation modes. Approach curves, using oxygen and hexaammineruthenium(III) as redox mediators, were obtained without significant loss of the performance and reproducibility of the potentiometric pH response. This allowed the precise positioning of the proposed tip above a substrate in SECM experiments and, subsequently, to monitor pH at the substrate surface. The IrOx modified microelectrode was applied successfully in SECM experiments involving the local proton consumption during the nitrate reduction at a copper cathode surface.
- 1 September 2014
- Published by Elsevier in Electrochimica Acta
- Vol. 139, 1-6
The use of copper and cobalt phthalocyanines as electrocatalysts for the oxygen reduction reaction in acid medium
- 1 September 2014
- Published by Elsevier in Electrochimica Acta
- Vol. 139, 1-6
The use of copper and cobalt phthalocyanines as electrocatalysts for the oxygen reduction reaction in acid medium
- 9 May 2013
- Published by Wiley in Electroanalysis
- Vol. 25 (6) , 1395-1399
Determination of Paracetamol in Presence of Ascorbic Acid in Pharmaceutical Products by Scanning Electrochemical Microscopy
- 9 May 2013
- Published by Wiley in Electroanalysis
- Vol. 25 (6) , 1395-1399
Determination of Paracetamol in Presence of Ascorbic Acid in Pharmaceutical Products by Scanning Electrochemical Microscopy
- 1 September 2012
- Published by Elsevier in Electrochimica Acta
- Vol. 78, 446-451
Scanning electrochemical microscopy investigation of nitrate reduction at activated copper cathodes in acidic medium
- 1 September 2012
- Published by Elsevier in Electrochimica Acta
- Vol. 78, 446-451
Scanning electrochemical microscopy investigation of nitrate reduction at activated copper cathodes in acidic medium