ABA. V. Bogdanov

A. V. Bogdanov

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


A. V. Bogdanov has a total of 130 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Borehole muon tomograph for search and evaluation of ore deposits

    by A. A. Golubev, A. V. Kantsyrev, I. G. Alekseev, A. V. Bogdanov, R. O. Gavrilin, A. O. Khurchiev, D. S. Kolesnikov, E. M. Ladigina, M. A. Lapshin, A. I. Mishletsov, et al.

    This work presents the development and testing of the borehole muon tomograph to search for ore by measuring the attenuation of the cosmic ray muon flux in the rock. The borehole muon tomograph is designed to carry out measurements at depths up to 1500 m.w.e., with the capacity to be placed in water-filled boreholes, with an effective radius of surface research being no less than 400 m. The borehole muon tomograph consists of four detector modules, each having a length of 2.4 m and an outer diameter of 89 mm. The modules are connected consecutively, and the overall length of the tomograph is about 9 m. The borehole muon tomograph contains more than 600 signal acquisition channels coming from scintillating optical fibers that are placed on three cylindrical layers nested inside each other. On the outer layer, the optical fiber is placed parallel to the cylinder axis, while on the inner and middle layers, it is placed spirally in opposite directions. The borehole muon tomograph detector allows for the measurement of angular parameters with a precision of ∼17 mrad on the azimuth angle in the range from 0° to 360° and ∼19 mrad on the zenith angle in the range from 10° to 90°. A method for reconstructing the average rock density by measuring the attenuation of the muon flux has been developed. To reconstruct and visualize a three-dimensional density distribution of the studied area, a program and algorithm were developed based on the Simultaneous Iterative Reconstruction Technique method. Tests of the borehole muon tomograph performed on a test site have shown its full operational capability, and based on the results, a 3D density reconstruction of a test object has been made with an accuracy of determining the average areal density in a solid angle within 5%. Such a level of accuracy is achievable after accumulating sufficient muon statistics (at least 5 × 105 muons).

  • Open Access

    Monitoring of the heavy-ion beam distribution using poly- and monochromatic x-ray fluorescence imaging

    by Ş. Zähter, O. N. Rosmej, P. Beloiu, A. Bogdanov, A. Golubev, M. Gyrdymov, J. Jacoby, A. Kantsyrev, R. Loetzsch, M. Nicolai, et al.

    In this work, the first proof of the principal of an in situ diagnostics of the heavy-ion beam intensity distribution in irradiation of solid targets is proposed. In this scheme, x-ray fluorescence that occurs in the interaction of heavy-ions with target atoms is used for imaging purposes. The x-ray conversion to optical radiation and a transport-system was developed, and its first test was performed in experiments at the Universal Linear Accelerator in Darmstadt, Germany. The Au-beam intensity distribution on thin foils and Cu-mesh targets was imaged using multiple x-ray pinholes (polychromatic imaging) and 2D monochromatic imaging of Cu Kα radiation by using a toroidally bent silicon crystal. The presented results are of importance for application in experiments on the investigation of the equation of states of high energy density matter using high intensity GeV/u heavy-ion beams of ≥1010 particles/100 ns.

  • Study of the Z-Pinch Plasma Initiated by the Electron Beam

    by A. A. Drozdovsky, A. V. Bogdanov, R. O. Gavrilin, S. A. Drozdovsky, A. V. Kantsyrev, V. A. Panyushkin, I. V. Rudskoi, S. M. Savin, P. V. Sasorov, V. V. Yanenko

    A lot of activities are carried out to develop compact laser accelerators. The transportation and focusing of beams in Z-pinch-type discharges, which requires thorough investigations into methods for...


  • High‐explosive generators of dense low‐temperature plasma for proton radiography

    by V.B. Mintsev, N.S. Shilkin, V.YA. Ternovoi, D.N. Nikolaev, D.S. Yuriev, A.A. Golubev, A.V. Kantsyrev, A.V. Skobliakov, A.V. Bogdanov, D.V. Varentsov, et al.

    The article reviews the design and physical applications of high‐explosive generators for dense low‐temperature plasma. The PUMA proton microscope with magnetic optics at the Institute for Theoretical and Experimental Physics by A.I. Alikhanov of National Research Centre «Kurchatov Institute» (Moscow, Russia) was used to diagnose the plasma. The generators were developed for measurements of the equation of state of non‐ideal plasma, investigation of phase transitions in hydrogen or molecular gases, and studies of the properties of the interior of Giant planets. A proposal was made to repeat the experiments with explosive generators using the proton microscope PRIOR (Proton Microscope for Facility for Anti‐proton and Ion Research) at the GSI Helmholtzzentrum fur Schwerionenforschung (Darmstadt, Germany) and at the designed proton microscope at the Institute for Nuclear Research (Troitsk, Russia).


  • Open Access

    Monte-Carlo Geant4 numerical simulation of experiments at 247-MeV proton microscope

    by A V Kantsyrev, A V Skoblyakov, A V Bogdanov, A A Golubev, N S Shilkin, D S Yuriev, V B Mintsev

    A radiographic facility for an investigation of fast dynamic processes with areal density of targets up to 5 g/cm2 is under development on the basis of high-current proton linear accelerator at the Institute for Nuclear Research (Troitsk, Russia). A virtual model of the proton microscope developed in a software toolkit Geant4 is presented in the article. Fullscale Monte-Carlo numerical simulation of static radiographic experiments at energy of a proton beam 247 MeV was performed. The results of simulation of proton radiography experiments with static model of shock-compressed xenon are presented. The results of visualization of copper and polymethyl methacrylate step wedges static targets also described.


  • Installation for studying the plasma of Z-pinch initiated by an electron beam

    by A. A. Drozdovsky, A. V. Bogdanov, R. O. Gavrilin, A. A. Golubev, S. A. Drozdovsky, I. V. Roudskoy, S. M. Savin, P. V. Sasorov, V. V. Yanenko


  • Quadrupole lenses on the basis of permanent magnets for a PRIOR proton microscope prototype

    by A. V. Kantsyrev, V. A. Panyushkin, A. A. Golubev, A. V. Bogdanov, A. V. Bakhmutova, E. M. Ladygina, N. V. Markov, O. S. Sergeeva, Vic. S. Skachkov, A. I. Semennikov, et al.


  • Commissioning of the PRIOR proton microscope

    by D. Varentsov, O. Antonov, A. Bakhmutova, C. W. Barnes, A. Bogdanov, C. R. Danly, S. Efimov, M. Endres, A. Fertman, A. A. Golubev, et al.

    Recently, a new high energy proton microscopy facility PRIOR (Proton Microscope for FAIR Facility for Anti-proton and Ion Research) has been designed, constructed, and successfully commissioned at GSI Helmholtzzentrum für Schwerionenforschung (Darmstadt, Germany). As a result of the experiments with 3.5–4.5 GeV proton beams delivered by the heavy ion synchrotron SIS-18 of GSI, 30 μm spatial and 10 ns temporal resolutions of the proton microscope have been demonstrated. A new pulsed power setup for studying properties of matter under extremes has been developed for the dynamic commissioning of the PRIOR facility. This paper describes the PRIOR setup as well as the results of the first static and dynamic proton radiography experiments performed at GSI.


  • An electron gun for physical research

    by A. A. Drozdovsky, A. V. Bogdanov, R. O. Gavrilin, A. A. Golubev, S. A. Drozdovsky, A. V. Kantsyrev, E. M. Ladygina, S. M. Savin, Yu. B. Stasevich, A. V. Khudomyasov, et al.

    An electron gun with a cold cathode is developed for physical research with energy to 300 keV. The gun operates in the pulsed mode. Current amplitude is to 100 A, and pulse duration is 100 ns. The first results of the experimental investigation are represented.


  • Electronic gun for physical researches

    by A. A. Drozdovsky, A. V. Bogdanov, R. O. Gavrilin, A. A. Golubev, S. A. Drozdovsky, A. V. Kantsyrev, E. M. Ladygina, I. V. Roudskoy, S. M. Savin, V. V. Yanenko

    For researches on plasma physics has been designed and constructed the electronic gun with the cold cathode on energy to 300 keV. The gun have the parameters: time width of pulses - 100 ns, current amplitude - 100 A, repetition rate - 100 Hz. The desorption emitter is a set of thin mica and copper plates. Results of the fabrication and testing are reported.