Zinaida L. Denisova
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Zinaida L. Denisova has a total of 36 co-authors. Here are the top co-authors by number of shared publications:
- Lyudmyla I Veligura
National Academy of Sciences of Ukraine
10 shared publications - Nataliya A. Vlasenko
National Academy of Sciences of Ukraine
5 shared publications - Pavel F. Oleksenko
National Academy of Sciences of Ukraine
5 shared publications M. A. Mukhlyo
National Academy of Sciences of Ukraine
3 shared publicationsN. A. Vlasenko
3 shared publications- Evgeniy G. Gule
National Academy of Sciences
2 shared publications
Latest Publications
- Open Access
- 3 July 2013
- Published by Wiley in Annalen der Physik
- Vol. 525 (12) , 889-905
ZnS:Cr and ZnSe:Cr thin‐film waveguide structures as electrically pumped laser media with an impact excitation mechanism
ZnS:Cr and ZnSe:Cr are the focus of studies as media for broadly tunable optically pumped lasers operating in the near‐ and mid‐IR regions. It is of great interest to obtain such lasers electrically pumped. The effective electrical excitation of Cr2+ ions was demonstrated only in the case of the impact mechanism for thin‐film structures with insulator layers between an electroluminescent film and electrodes, which prevent avalanche breakdown at high electric field (≥ 1 MV/cm). To obtain lasing, the waveguide electroluminescent structures were used. For the first time, the stimulated emission and the laser oscillation were demonstrated in the ZnS:Cr waveguide structures. Although the lasing is unstable as yet, these results lay the foundations of a new direction in laser physics aimed at creation of electrically pumped lasers by dint of impact excitation. Published results concerning various aspects of ZnS:Cr and ZnSe:Cr thin films and waveguide structures as promising electrically pumped laser media are reviewed. The causes of the instability of the laser oscillation and means of improving their characteristics are also considered.
- 3 July 2013
- Published by Wiley in Annalen der Physik
- Vol. 525 (12) , 889-905
Open AccessZnS:Cr and ZnSe:Cr thin‐film waveguide structures as electrically pumped laser media with an impact excitation mechanism
ZnS:Cr and ZnSe:Cr are the focus of studies as media for broadly tunable optically pumped lasers operating in the near‐ and mid‐IR regions. It is of great interest to obtain such lasers electrically pumped. The effective electrical excitation of Cr2+ ions was demonstrated only in the case of the impact mechanism for thin‐film structures with insulator layers between an electroluminescent film and electrodes, which prevent avalanche breakdown at high electric field (≥ 1 MV/cm). To obtain lasing, the waveguide electroluminescent structures were used. For the first time, the stimulated emission and the laser oscillation were demonstrated in the ZnS:Cr waveguide structures. Although the lasing is unstable as yet, these results lay the foundations of a new direction in laser physics aimed at creation of electrically pumped lasers by dint of impact excitation. Published results concerning various aspects of ZnS:Cr and ZnSe:Cr thin films and waveguide structures as promising electrically pumped laser media are reviewed. The causes of the instability of the laser oscillation and means of improving their characteristics are also considered.
- 18 June 2011
- Published by Pleiades Publishing Ltd in Semiconductors
- Vol. 45 (6) , 836
Erratum to: “Electronic States on Silicon Surface after Deposition and Annealing of SiO x Films”
The following corrections are to be introduced into the paper: 1. The sentence "The latter PL band in the photoconductivity spectrum is likely to be caused by the change in the photocurrent sign in this region" (page 591, the right hand column, the 12th line from the top) should be replaced by "The latter is not represented in the photoconductivity spectrum probably because of the change in the photocurrent sign in this region". 2. The reference to Fig. 3 on the seventh line in the same column should be changed to reference to Fig. 4. 3. In Ref.
- 18 June 2011
- Published by Pleiades Publishing Ltd in Semiconductors
- Vol. 45 (6) , 836
Erratum to: “Electronic States on Silicon Surface after Deposition and Annealing of SiO x Films”
The following corrections are to be introduced into the paper: 1. The sentence "The latter PL band in the photoconductivity spectrum is likely to be caused by the change in the photocurrent sign in this region" (page 591, the right hand column, the 12th line from the top) should be replaced by "The latter is not represented in the photoconductivity spectrum probably because of the change in the photocurrent sign in this region". 2. The reference to Fig. 3 on the seventh line in the same column should be changed to reference to Fig. 4. 3. In Ref.
- 15 May 2011
- Published by Pleiades Publishing Ltd in Semiconductors
- Vol. 45 (5) , 587-592
Electronic states on silicon surface after deposition and annealing of SiO x films
The spectrum of the photoconductivity induced by the polarization field of charges at surface states and traps in the film bulk has been analyzed to determine the energy band diagram at the c-Si-SiO x interface and the changes in the electronic states after the film annealing. It is found that the energy bands are bent at the Si-SiO x interface and the Si surface is enriched in electrons. In equilibrium the photocurrent peak at 1.1 eV is due to the band-to-band transitions in the silicon part of the interface. Annealing shifts the peak to higher energies; this shift increases with an increase in the annealing temperature from 650 to 1000°C. This effect is accompanied by a decrease in the photocurrent at ≤1.1 eV and weakening of the band-edge photoluminescence near the Si surface. The changes revealed are explained by the formation of an oxide layer with Si nanoclusters at the Si-SiO x interface upon annealing. This process is caused by oxygen diffusion from the SiO x film, which occurs mainly via defects on the Si wafer surface. The photoconductivity spectrum of the samples charged by short-term application of a negative potential to silicon exhibits electronic transitions in the SiO x film, both from the matrix electronic states and from the states of the defects and Si nanoclusters in the film.
- 15 May 2011
- Published by Pleiades Publishing Ltd in Semiconductors
- Vol. 45 (5) , 587-592
Electronic states on silicon surface after deposition and annealing of SiO x films
The spectrum of the photoconductivity induced by the polarization field of charges at surface states and traps in the film bulk has been analyzed to determine the energy band diagram at the c-Si-SiO x interface and the changes in the electronic states after the film annealing. It is found that the energy bands are bent at the Si-SiO x interface and the Si surface is enriched in electrons. In equilibrium the photocurrent peak at 1.1 eV is due to the band-to-band transitions in the silicon part of the interface. Annealing shifts the peak to higher energies; this shift increases with an increase in the annealing temperature from 650 to 1000°C. This effect is accompanied by a decrease in the photocurrent at ≤1.1 eV and weakening of the band-edge photoluminescence near the Si surface. The changes revealed are explained by the formation of an oxide layer with Si nanoclusters at the Si-SiO x interface upon annealing. This process is caused by oxygen diffusion from the SiO x film, which occurs mainly via defects on the Si wafer surface. The photoconductivity spectrum of the samples charged by short-term application of a negative potential to silicon exhibits electronic transitions in the SiO x film, both from the matrix electronic states and from the states of the defects and Si nanoclusters in the film.
- 27 October 2008
- Published by Wiley in Physica Status Solidi (b)
- Vol. 245 (11) , 2550-2557
Cr‐related energy levels and mechanism of Cr2+ ion photorecharge in ZnS:Cr
- 27 October 2008
- Published by Wiley in Physica Status Solidi (b)
- Vol. 245 (11) , 2550-2557
Cr‐related energy levels and mechanism of Cr2+ ion photorecharge in ZnS:Cr
- 1 November 2007
- Published by Wiley in Journal of the Society for Information Display
- Vol. 15 (11) , 937-941
Comparison of some characteristics of thin‐film‐electroluminescent ZnS: Er, F planar and edge emitters
Abstract— The following main differences have been revealed in the characteristics of an edge thin‐film‐electroluminescent ZnS: Er,F emitter compared to those of a similar planar emitter: (1) the 1.535‐μm band more highly dominates over other bands in the EL spectrum; (2) the voltage (V) dependence of the intensity of this band is the strongest; (3) the 1.535‐μm band narrows with increasing voltage and its frequency. The above differences are explained, firstly, by smaller optical losses in the ZnS: Er,F film for the near‐infrared emission than for the visible one and, secondly, by an optical amplification over the 1.535‐μm band in the edge emitter.
- 1 November 2007
- Published by Wiley in Journal of the Society for Information Display
- Vol. 15 (11) , 937-941
Comparison of some characteristics of thin‐film‐electroluminescent ZnS: Er, F planar and edge emitters
Abstract— The following main differences have been revealed in the characteristics of an edge thin‐film‐electroluminescent ZnS: Er,F emitter compared to those of a similar planar emitter: (1) the 1.535‐μm band more highly dominates over other bands in the EL spectrum; (2) the voltage (V) dependence of the intensity of this band is the strongest; (3) the 1.535‐μm band narrows with increasing voltage and its frequency. The above differences are explained, firstly, by smaller optical losses in the ZnS: Er,F film for the near‐infrared emission than for the visible one and, secondly, by an optical amplification over the 1.535‐μm band in the edge emitter.
- 18 June 2004
- Published by Wiley in Journal of the Society for Information Display
- Vol. 12 (2) , 179-182
Near‐infrared‐emitting ZnS: Er and ZnS(Se): Cr TFEL devices
Abstract— Electroluminescent near‐infrared (NIR) emitters are of interest in creating special displays for applications such as communications, chemical sensoring, friend‐and‐foe identification, aligning and checking systems that detect NIR radiation, medicine, etc. By performing this research, known NIR emitters (thermal sources, semiconductor diodes and lasers, and solid‐state lasers) were supplemented by NIR‐emitting TFEL devices based on ZnS: Er(F) and ZnS(Se): Cr electron‐beam‐evaporated films. Some characteristics of these devices as NIR emitters are given. There are two narrow intensive bands at ∼980 and ∼1530 nm in the emission spectrum of ZnS: Er(F) TFEL devices. The broadband emission is the range of from 1.8 μm up to 2.7 μm takes place in the ZnS(Se): Cr devices. The wavelength of the peak emission can be varied owing to interference. The mechanism of electroluminescence in the ZnS: Er(F) and ZnS(Se): Cr devices is the direct impact excitation of Er3+ and Cr2+ ions, respectively.
- 18 June 2004
- Published by Wiley in Journal of the Society for Information Display
- Vol. 12 (2) , 179-182
Near‐infrared‐emitting ZnS: Er and ZnS(Se): Cr TFEL devices
Abstract— Electroluminescent near‐infrared (NIR) emitters are of interest in creating special displays for applications such as communications, chemical sensoring, friend‐and‐foe identification, aligning and checking systems that detect NIR radiation, medicine, etc. By performing this research, known NIR emitters (thermal sources, semiconductor diodes and lasers, and solid‐state lasers) were supplemented by NIR‐emitting TFEL devices based on ZnS: Er(F) and ZnS(Se): Cr electron‐beam‐evaporated films. Some characteristics of these devices as NIR emitters are given. There are two narrow intensive bands at ∼980 and ∼1530 nm in the emission spectrum of ZnS: Er(F) TFEL devices. The broadband emission is the range of from 1.8 μm up to 2.7 μm takes place in the ZnS(Se): Cr devices. The wavelength of the peak emission can be varied owing to interference. The mechanism of electroluminescence in the ZnS: Er(F) and ZnS(Se): Cr devices is the direct impact excitation of Er3+ and Cr2+ ions, respectively.
- 1 October 2003
- Published by Elsevier in Journal of Crystal Growth
- Vol. 257 (3-4) , 263-271
Effects of photoassisted deposition and/or photoassisted annealing on characteristics of ZnS:Mn thin-film electroluminescent devices
- 1 October 2003
- Published by Elsevier in Journal of Crystal Growth
- Vol. 257 (3-4) , 263-271
Effects of photoassisted deposition and/or photoassisted annealing on characteristics of ZnS:Mn thin-film electroluminescent devices
- 1 September 2002
- Published by Wiley in Physica Status Solidi (a)
- Vol. 193 (2) , 338-346
Effect of Co-Doping with Oxygen on the Characteristics of ZnS : Mn Thin-Film Electroluminescent Structures
- 1 September 2002
- Published by Wiley in Physica Status Solidi (a)
- Vol. 193 (2) , 338-346
Effect of Co-Doping with Oxygen on the Characteristics of ZnS : Mn Thin-Film Electroluminescent Structures
- 15 June 2000
- Published by Elsevier in Journal of Crystal Growth
- Vol. 216 (1-4) , 249-255
On nature of centers responsible for inherent memory in ZnS:Mn thin-film electroluminescent devices
- 15 June 2000
- Published by Elsevier in Journal of Crystal Growth
- Vol. 216 (1-4) , 249-255
On nature of centers responsible for inherent memory in ZnS:Mn thin-film electroluminescent devices