Oleksandr A. Orlenko
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Oleksandr A. Orlenko has a total of 36 co-authors. Here are the top co-authors by number of shared publications:
- Gennadiy P. Pochanin
Department of Radiophysical Introscopy, O. Ya. Usikov Institute for Radiophysics and Electronics of the National Academy of Science of Ukraine, 61085 Kharkiv, Ukraine
8 shared publications - Vadym P. Ruban
O.Ya. Usikov Institute for Radiophysics and Electronics of the National Academy of Sciences of Ukraine, Kharkiv, Ukraine
8 shared publications - Lorenzo Capineri
Department of Information Engineering, Università degli Studi di Firenze, Via S. Marta 3, 50139 Florence, Italy
4 shared publications - Tetiana Ogurtsova
A. Ya. Usikov Institute of radiophysics and electronics of NAS of Ukraine, Kharkiv, Ukraine
4 shared publications - Fronefield Crawford
Franklin and Marshall College
3 shared publications - Luca Bossi
Universit degli Studi di Firenze,Department of Information Engineering,Florence,Italy
2 shared publications
Latest Publications
- Open Access
- 5 March 2026
- Published by V. N. Karazin Kharkiv National University in East European Journal of Physics
- No. 1,p. 496-506
Reduction of Amplitude and Duration of Post-Pulse Oscillations in Bow Tie Active Radiating Antenna
The paper investigates one of the ways of suppressing post-pulse oscillations in ultra-wideband (UWB) electromagnetic pulses radiated by a bow-tie type antenna excited in active mode (the pulse generator is located directly on the radiator). Since this excitation method does not require balancing or other elements that match the impedances, conditions are created for increasing the radiated power with the same power consumption. To suppress post-pulse oscillations in the radiated field, resistive elements with high resistance are used. They are located near the excitation region in order to absorb the non-radiated part of the excitation signal energy accumulated in the antenna. The influence of the antenna form factor and load resistance on the shape of the radiated signal is experimentally analyzed.
- 5 March 2026
- Published by V. N. Karazin Kharkiv National University in East European Journal of Physics
- No. 1,p. 496-506
Open AccessReduction of Amplitude and Duration of Post-Pulse Oscillations in Bow Tie Active Radiating Antenna
The paper investigates one of the ways of suppressing post-pulse oscillations in ultra-wideband (UWB) electromagnetic pulses radiated by a bow-tie type antenna excited in active mode (the pulse generator is located directly on the radiator). Since this excitation method does not require balancing or other elements that match the impedances, conditions are created for increasing the radiated power with the same power consumption. To suppress post-pulse oscillations in the radiated field, resistive elements with high resistance are used. They are located near the excitation region in order to absorb the non-radiated part of the excitation signal energy accumulated in the antenna. The influence of the antenna form factor and load resistance on the shape of the radiated signal is experimentally analyzed.
- 1 September 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 50-56
Application of the Industry 4.0 Paradigm to the Design of a UWB Radiolocation System for Humanitarian Demining
The modern world is characterized by the pervasive use of computers, sensors, robotics, and Internet connectivity. This represents a new industrial revolution, dubbed Industry 4.0. In this paper, we discuss the application of the Industry 4.0 paradigm to creating a robotic search-and-detection platform intended for humanitarian demining. This is based on the combination and interaction of two microwave radars - including a UWB multi-sensor array, and a holographic imager - as well as 3-D optical cameras, remote navigation, and GPS tracking. The concepts introduced by Industry 4.0 represent an important opportunity for the scientific community to adopt new approaches in the design and use of UWB radar systems, and how data from these systems can be shared, archived, and processed in a decentralized manner accessible to the worldwide community
- 1 September 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 50-56
Application of the Industry 4.0 Paradigm to the Design of a UWB Radiolocation System for Humanitarian Demining
The modern world is characterized by the pervasive use of computers, sensors, robotics, and Internet connectivity. This represents a new industrial revolution, dubbed Industry 4.0. In this paper, we discuss the application of the Industry 4.0 paradigm to creating a robotic search-and-detection platform intended for humanitarian demining. This is based on the combination and interaction of two microwave radars - including a UWB multi-sensor array, and a holographic imager - as well as 3-D optical cameras, remote navigation, and GPS tracking. The concepts introduced by Industry 4.0 represent an important opportunity for the scientific community to adopt new approaches in the design and use of UWB radar systems, and how data from these systems can be shared, archived, and processed in a decentralized manner accessible to the worldwide community
- 1 June 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-4
Terrain Analysis in Eastern Ukraine and the Design of a Robotic Platform Carrying GPR Sensors for Landmine Detection
We are designing and building a multi-sensor semi-autonomous vehicle to assist in humanitarian demining in the Donbass conflict zone, Ukraine. The vehicle will carry impulse GPR for fast target detection, and holographic GPR for discrimination of mines from clutter. The design includes the possibility to add additional sensor. To ensure that the vehicle is compatible with actual Donbass conditions, the COTS dimensions of the selected vehicle (Clearpath Robotics “Jackal”), and relief profiles from two transects collected on the edge of the conflict zone, were compared using morphological filtering terrain analysis. The analysis shows that the vehicle can traverse the recorded transects with no threat of nose-in failure, and minimal threat of hang-up failure. Preliminary testing of the holographic radar mounted on the vehicle show that it can effectively image the footprint of mine-like targets, with resolution of a little more than one centimeter.
- 1 June 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-4
Terrain Analysis in Eastern Ukraine and the Design of a Robotic Platform Carrying GPR Sensors for Landmine Detection
We are designing and building a multi-sensor semi-autonomous vehicle to assist in humanitarian demining in the Donbass conflict zone, Ukraine. The vehicle will carry impulse GPR for fast target detection, and holographic GPR for discrimination of mines from clutter. The design includes the possibility to add additional sensor. To ensure that the vehicle is compatible with actual Donbass conditions, the COTS dimensions of the selected vehicle (Clearpath Robotics “Jackal”), and relief profiles from two transects collected on the edge of the conflict zone, were compared using morphological filtering terrain analysis. The analysis shows that the vehicle can traverse the recorded transects with no threat of nose-in failure, and minimal threat of hang-up failure. Preliminary testing of the holographic radar mounted on the vehicle show that it can effectively image the footprint of mine-like targets, with resolution of a little more than one centimeter.
- 1 June 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
Estimation of Lane Width for Object Detection Using Impulse GPR with “1Tx and 4Rx” Antenna System
This paper reports on an experimental study of object detection and location using UWB Impulse GPR with a specialized “1Tx and 4Rx” antenna system. Algorithms for data collection and processing are described. The results of the study demonstrate the ability of the radar to cover a lane width of more than 60 cm with the antenna array at a height of 37 cm. Within the lane the system can readily detect an antipersonnel landmine simulant. Preliminary analysis of laboratory testing data (in air) has also shown the capability of the proposed processing to estimate the distance between the object and each Rx antenna with an accuracy of 0.8 cm for distances up to approximately 40 cm.
- 1 June 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
Estimation of Lane Width for Object Detection Using Impulse GPR with “1Tx and 4Rx” Antenna System
This paper reports on an experimental study of object detection and location using UWB Impulse GPR with a specialized “1Tx and 4Rx” antenna system. Algorithms for data collection and processing are described. The results of the study demonstrate the ability of the radar to cover a lane width of more than 60 cm with the antenna array at a height of 37 cm. Within the lane the system can readily detect an antipersonnel landmine simulant. Preliminary analysis of laboratory testing data (in air) has also shown the capability of the proposed processing to estimate the distance between the object and each Rx antenna with an accuracy of 0.8 cm for distances up to approximately 40 cm.
- 1 May 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 206-209
Near field zone of the UWB bow-tie dipoles
The experimentally obtained time-amplitude dependences of near-zone EM fields of the UWB planar “bow-tie” radiators have been presented in the work. The dependence of post-pulse oscillation amplitudes on the radiator shape and the magnitude of load resistance have been investigated. Conditions of the effective radiation of EM pulses with a required amplitude and the least long-drawn-out and amplitude-suppressed post-pulse oscillations have been determined.
- 1 May 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 206-209
Near field zone of the UWB bow-tie dipoles
The experimentally obtained time-amplitude dependences of near-zone EM fields of the UWB planar “bow-tie” radiators have been presented in the work. The dependence of post-pulse oscillation amplitudes on the radiator shape and the magnitude of load resistance have been investigated. Conditions of the effective radiation of EM pulses with a required amplitude and the least long-drawn-out and amplitude-suppressed post-pulse oscillations have been determined.
- 1 May 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 36-39
Antenna pattern measurements: UWB impulse and multifrequency signals comparison
This paper describes some aspects of wideband (or ultrawideband) measurements of characteristics of antennas which does not require expensive anechoic chambers. The idea of the method is based on exciting the antenna under test by very short impulse which spectrum covers the band of interest and on analysis of spectra of the radiated signals. Reliability of the method is proved by comparison of simulated and measured results of antenna pattern investigations.
- 1 May 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 36-39
Antenna pattern measurements: UWB impulse and multifrequency signals comparison
This paper describes some aspects of wideband (or ultrawideband) measurements of characteristics of antennas which does not require expensive anechoic chambers. The idea of the method is based on exciting the antenna under test by very short impulse which spectrum covers the band of interest and on analysis of spectra of the radiated signals. Reliability of the method is proved by comparison of simulated and measured results of antenna pattern investigations.
- 1 April 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-3
Measurements of antenna properties in time domain
The authors of this work have designed, manufactured, tested and applied an ultra-wideband measurement system (MS) for investigating characteristics of antennas in the operating frequency band of up to 2 GHz. The synamic range of the measured signals is at least 80 dB. The use of fairly strong signals for excitation of radiating antenna extends the power budget by 40 dB else. The absence of reflections from interfering objects in the test signal enabled us to utilize the entire dynamic range. In the paper; features of instrumentation are briefly described, and an example of measurement results is presented.
- 1 April 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-3
Measurements of antenna properties in time domain
The authors of this work have designed, manufactured, tested and applied an ultra-wideband measurement system (MS) for investigating characteristics of antennas in the operating frequency band of up to 2 GHz. The synamic range of the measured signals is at least 80 dB. The use of fairly strong signals for excitation of radiating antenna extends the power budget by 40 dB else. The absence of reflections from interfering objects in the test signal enabled us to utilize the entire dynamic range. In the paper; features of instrumentation are briefly described, and an example of measurement results is presented.
- 1 July 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
Experimental results of a microwave tomography approach applied to a differential measurement configuration
The capabilities of a microwave inverse scattering algorithm for GPR data processing are tested against experimental data gathered by means of a prototypical GPR system. The approach is based on the Born approximation (BA) and exploits a differential contactless measurement configuration. Accordingly, the data are obtained as the difference of the electrical fields gathered at two symmetrical positions with respect to the source location. The use of the differential configuration allows to reduce substantially the mutual direct coupling between the transmitting and receiving parts of the antenna system and this makes it possible to increase power budget of the GPR system.
- 1 July 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
Experimental results of a microwave tomography approach applied to a differential measurement configuration
The capabilities of a microwave inverse scattering algorithm for GPR data processing are tested against experimental data gathered by means of a prototypical GPR system. The approach is based on the Born approximation (BA) and exploits a differential contactless measurement configuration. Accordingly, the data are obtained as the difference of the electrical fields gathered at two symmetrical positions with respect to the source location. The use of the differential configuration allows to reduce substantially the mutual direct coupling between the transmitting and receiving parts of the antenna system and this makes it possible to increase power budget of the GPR system.
- 1 September 2012
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 75-77
UWB pulse generators
Techniques for generation of UWB pulses of subnanosecond duration by semiconductor devices are considered in the given work. Characteristics of step recovery diode (SRD) generators and serial pulse diode generators are investigated. The original circuit solutions increasing both the amplitude and the pulse repetition rate are presented. A generator circuit with symmetrical loading allowing to use this generator in the active antenna is proposed.
- 1 September 2012
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 75-77
UWB pulse generators
Techniques for generation of UWB pulses of subnanosecond duration by semiconductor devices are considered in the given work. Characteristics of step recovery diode (SRD) generators and serial pulse diode generators are investigated. The original circuit solutions increasing both the amplitude and the pulse repetition rate are presented. A generator circuit with symmetrical loading allowing to use this generator in the active antenna is proposed.