AMAisha M. Moustafa

Aisha M. Moustafa

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Aisha M. Moustafa has a total of 88 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Impact of nickel doping on the optical, magnetic and electrical properties of CMFC ferrite

    by A. M. Moustafa, A. A. Ward, A. F. Mabied, S. A. Gad

    The multifunctional properties of spinel ferrites can be effectively tailored through Ni substitution, particularly in systems where cation redistribution and electron hopping mechanisms govern the structural, optical, electrical, and magnetic responses. In this work, Cu₀.₇Mg₀.₃₋ₓNiₓFe₁.₇Cr₀.₃O₄ CMFC ferrites (0.05 ≤ x ≤ 0.30) were synthesized and systematically investigated using XRD, SEM, optical and transport properties analysis. Ni incorporation promoted improved lattice ordering and cation redistribution within the spinel structure, leading to modifications in electronic polarizability and charge transport pathways. These changes were reflected in a systematic widening of the optical band gap from 3.2 to 3.7 eV, accompanied by a reduction in the refractive index. Magnetic measurements confirmed the retention of soft ferromagnetic behaviour, although the saturation magnetization gradually decreased from 20.33 to 18.54 emu g⁻¹ due to variations in cation occupancy and superexchange interactions. The saturation magnetization slightly reduced while preserving soft magnetic behavior with low coercivity (44–57 G). The results of the magnetic properties indicated that, the magnetic response for specific applications such as High-Frequency Transformer Cores, Electromagnetic Interference (EMI) Suppression and Magnetic Recording Heads. Dielectric analysis performed over the frequency range 10⁻¹–1 M Hz at 30 °C revealed pronounced low-frequency dispersion associated with Maxwell–Wagner interfacial polarization at low frequency. The combined structural, optical, electrical, and magnetic characteristics indicate that Ni-substituted Cu–Mg ferrites are promising materials for MHz-frequency electronic devices, including high-frequency transformer cores, electromagnetic interference suppression, and magnetic recording components.

  • Crystal structure, optical, magnetic and transport properties of the (Ba1-xLax)1.07(Ti1-yFey)8O16 hollandite

    by A.M. Moustafa, I.A. Abdel-Latif, Sh I. Hussien, Kh M. Roumaih, S.A. Gad


  • Evaluation of Nanocrystalline Magnetic ErFeO3 Composite for the Sorptive Removal of Cesium and Cobalt Ion from Aqueous Solution

    by I. A. Abdel-Latif, H. S. Hassan, A. M. Moustafa, S. A. Gad, Sh I. Hussein, Kh M. Roumaih

    The effect of nano-scale size in the magnetic semiconductor rare Earth ferrite system, ErFeO3, has been studied. The orthorhombic crystal structure in the nano-scale was found for ErFeO3 prepared by the sol-gel method to be 8 nm. Fe-O stretching vibration was identified in the IR band at around 561 cm−1, whereas the O-Fe-O deformation vibration was identified in the band at about 437 cm−1. The semiconducting behavior of ErFeO3 was found, and its energy gap equals 1.75 eV. As the frequency increases, the charge transport mechanism showed transition from the small polaron model, dominated by thermally activated hopping, to a quantum mechanical tunneling model, where charge carriers move through the material by tunneling between localized states without trapping. This transition is driven by the charge carriers having less time to become localized at higher frequencies, allowing for more direct tunneling transport. The new application of nano-crystalline ErFeO3 to remove hazardous elements was evaluated. The adsorption isotherm of Cs(I) and Co(II) by ErFeO3 nanocomposite was studied. The findings of the present studies highlight the potential use of ErFeO3 as a new, efficacious sorbent for removing Cs(I) and Co(II) from the waste stream, providing a reliable and efficient solution to environmental pollution.


  • Effect of Film Thickness on the Electrical Resistivity and Optical Functions Distribution of Iron Tris(8-hydroxyquinoline) Thin Films

    by L. M. El-Khalawany, S. A. Gad, A. M. Moustafa, Amira Nassar, E. M. El-Menyawy

    Iron tris(8-hydroxyquinoline) (Feq3) was synthesized and investigated by X-ray photoemission spectroscopy. It crystalizes in triclinic polycrystalline structure in powder form, whereas the Feq3 films, with different thickness values (12, 20, 35, and 42 nm), have an amorphous structure. The influence of film thickness on the electrical resistivity and the optical properties is reported. The morphology of Feq3 was investigated in terms of field-emission scanning electron microscope. Electrical resistivity measurements indicate an inverse proportionality to the film thickness. The optical properties of Feq3 films were investigated in terms of photoluminescence spectra and spectrophotometric measurements of transmittance and reflectance. The optical functions such as absorption coefficient and refractive index of the films were calculated. The dependence of the Feq3 film thickness on the optical energy band gap and dispersion parameters was studied. The outcomes indicate that the Feq3 films are of great importance for applications in organic solar cells and light emitting diodes.


  • Open Access

    Mg2+ Doped ZCFAO Spinel Ferrite: Structural, Optical, Dielectric and Magnetic Explorations

    by A. M. Moustafa, S. A. Gad, H. M. Hashem

    A series of Mg doped ZCFAO (Zn0.3−xMgxCu0.7Al0.3Fe1.7O4 (0.05 ≤ x ≤ 0.25) spinel samples were synthesized by solid state reaction method. XRD, was utilized to investigate the structure phase, microstructural characteristics, The optical properties were analyzed; Biological instruments Sp-150 potentiostate is employed to investigate the dielectric measurements in the frequency range of 10 Hz to 1 MHz at various temperatures from 300 to 650 K. Vibrating sample magnetometer VSM was employed to examine the magnetic characteristics in the applied magnetic field ranging from − 20 to 20 kG. The creation of a single-phase cubic spinel was validated by X-ray analysis. The leverage of replacing Zn by Mg leads to enhancement in the lattice parameters, reducing both of the degree of inversion, crystal distortion and compelled these samples to be normal spinel. It turned out that as the degree of inversion sank, the crystallite size declined. The values of dislocations density was found in the order of 10−5 which reveal improving and completing the crystallization of the ferrite samples. The samples have an optical energy gap in the range 3.1–3.38 eV, according to the inferred optical characteristics. The dielectric constant revealed the normal behavior of spinel ferrite it decreases with increasing frequency and enhanced with increasing temperature. It seems that the microstructure of the compound consists of both high-conductive grains and low-conductive grain boundaries, which has been confirmed by the complex impedance. Additionally, the presence of the Maxwell–Wagner relaxation process is also detected. This information can provide valuable insights into the properties and behavior of the compound. Using Nyquist plot, the sample impedance characteristics were interpreted while taking grain and grain boundary contributions into account. The magnetic properties proved that doping ZCFAO with diamagnetic cations (Mg) increases both of saturation magnetization from 16.416 up to 29.983 emu/g and the magnetocrystalline anisotropic constant from 1319.24 to 1612.804 because the two main factors that influence the magnetic properties are the distribution of cations between the octahedral and tetrahedral sites and the magnetic moment of each of its cations. Novelty of our work replacing Zn by Mg (both of them diamagnetic materials) enhance the magnetic properties. Synthesized materials may reexamine the mechanisms underlying Mg2+ induced cationic exchange in ZCFAO and have prospective uses as soft-magnetic materials.


  • Structural, Magnetic, and Dielectric Spectroscopy Investigations of Multiferroic Composite Based on Perovskite–Spinel Approach

    by A. M. Moustafa, S. A. Gad, G. M Turky, L. M. Salah

    Multiferroic composite materials with the nominal composition (La0.8Gd0.2FeO3)1−x(Mn0.5Cu0.5Fe2O4)x, x = 0.0≤x≤1 were prepared using the co-precipition method. XRD, FTIR and Raman were utilized to investigate the structure phase, microstructural characteristics, vibrational bands. The optical properties were analyzed; the VSM was used to investigate the magnetic properties of the composites. Broadband dielectric spectroscopy is employed to investigate the dielectric and electrical performance of the prepared multiferroic composites. Rietveld refinement of the XRD patterns confirmed the orthorhombic phase for lanthanum gadolinium iron oxide (La0.8Gd0.2FeO3) and cubic phase for manganese copper ferrite (Mn0.5Cu0.5Fe2O4). The crystallite size of LGFO phase pointed out that it increases with increasing the MCFO phase, while the microstrain found to decline. The FTIR results elucidated the tetrahedral and octahedral bands. The deduced optical properties revealed that the samples have optical energy gap in the range 4.18 −4.5 eV. The magnetic properties revealed that the composites exhibit typical ferromagnetic hysteresis loops, indicating the presence of ordered magnetic structure. The frequency dependence of permittivity ε′(f) and real part of complex conductivity, σ′(f) exhibits a development of a net of micro-capacitors like behavior that stores charge carriers.


  • Open Access

    Investigation of the structure, magnetic, rheological and mechanical properties of EPDM rubber/Cu-Al-Zn alloy composites

    by Amira Nassar, Doaa Samir, Aisha Moustafa, Wael Mohamed, Salwa El-Sabbagh

    The current research presentsthe development of EPDM rubber including shape memory alloy. The Cu-Al-Zn alloy was modified with the coupling agent3-(Trimethoxysilyl) propyl methacrylate (TMSPM)and then incorporated into Ethylene propylene diene rubber (EPDM) by a 2-roll mill technique.The Cu-alloy behaved as superelasticity capability which can be used in various engineering approaches to smart materials. Microstructure, mechanical, rheological and magnetic properties of Cu-Al-Zn/EPDM composites was studied. The rheometericresults indicated that the incorporation of Cu-Al-Zn as a fillerenhance the curing process. Howeverthecuring time ofCu-Al-Zn/EPDMcomposites was reduced compared to the control sample without Cu-alloy. For the mechanical properties, increasing Cu-alloy loading inthe EPDMcomposites resulted inan increment of elongation at break.The addition of Cu based alloy as fillers improved the magnetization of composites with coupling agent when compared toEPDM rubber and Cu-Al-Zn/EPDMcomposites without coupling agent.


  • Impact of Molybdenum Doping on the Structural, Optical and Dielectric Properties of α -Al 2−x Mo x O 3

    by A. M. Moustafa, S. A. Gad, A. A. Ward

    The effects of Molybdenum (Mo) doping on the structural, optical, and electrical properties of alumina α -Al 2−x Mo x O 3 , (x = 0.02–0.14) synthesized via solid-state reaction method have been studied. X-ray diffraction (XRD) analysis confirms of single-phase hexagonal corundum structure in the range 0.06–0.14. The influence of Mo doping on the structural parameters was estimated from XRD data by applying the Rietveld profile fitting method and Fourier-transform infrared spectroscopy. XRD results revealed that replacing Al with Mo does not affect the unit cell dimensions owing to that Mo occupy the vacant sites available in the crystal structure. The electron density map revealed strong positive peaks corresponding to the position occupied by (Al/Mo) and the intensity of these peaks increases with increasing Mo doping. Optical properties revealed that the energy bandgaps (E g ) increase with increasing MoO 3 , due to the difference in the ionic radius of Al +3 and Mo +3 . The dielectric properties indicated that the values of ε ′ and tan δ increased as molybdenum concentration increased as a result of the free charges build-up at the interfaces. It was found that tan δ peak lies in the region where DC-conductivity dominates which is a clear indication of the contribution of ionic conduction to the dielectric loss.


  • Structural Characteristics, Optical, Transport and Magnetic Properties of Zinc Doped Cobalt Chromium Ferrite Prepared by Co-precipitation Method

    by Aisha Moustafa

    A series of zinc doped cobalt chromium ferrite Co1-xZnxFe1.5Cr0.5O4 (where 0 £ x £ 1) were synthesized by co-precipitation technique. Structural, optical, transport and magnetic properties were characterized by X-ray diffraction (XRD), diffuse reflectance, AC electrical properties and hysteresis loop. XRD analysis indicates that all samples consist of a single-phase cubic spinel structure. Rietveld refinement results indicated an increase in lattice parameter due to the replacement of Co2+ by Zn2+ and migration of Fe3+ ions from A-site to B-site. Optical energy band gaps were calculated and it was found that both Eg1 and Eg2 increase with increasing Zn content. Dielectric constant έ, έ', and dielectric loss tangent tanδ were measured at room temperature as a function of applied frequency and temperature. It was noticed, that έ and έ' increase with temperature increment and decrease with increasing frequency and this anomaly can be explained by Maxwell Wagner two-layer model. Magnetic measurements revealed that the saturation magnetization increases as Zn content increases up to Zn=0.4 and after that, the saturation magnetization decreases.