Dominik Kwiatkowski
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Dominik Kwiatkowski has a total of 693 co-authors. Here are the top co-authors by number of shared publications:
- Grzegorz Filo
Faculty of Mechanical Engineering, Cracow University of Technology, 31-864 Cracow, Poland
3 shared publications A. A. Festchenko
2 shared publicationsA. A. Piskun
2 shared publicationsA. Apostolou
KVI -Center for Advanced Radiation Technology University of Groningen Groningen The Netherlands
2 shared publicationsA. Arefiev
2 shared publicationsA. Boukharov
2 shared publications
Latest Publications
- 15 February 2019
- Published by Faculty of Mechanical Engineering in Strojniški vestnik - Journal of Mechanical Engineering
- Vol. 65 (2) , 103-112
Numerical and Experimental Study of a Novel Valve Using the Return Stream Energy to Adjust the Speed of a Hydraulic Actuator
This article discusses the possibility of increasing the speed of movement of a single-sided hydraulic cylinder piston rod using a fluid stream from the return line. Directing the return stream back to the supply line instead of the fluid reservoir causes significant increase in the inflow rate to the actuator. This situation may arise when the piston rod of the cylinder is not fully loaded on part of the movement range. As part of this work, we proposed a solution in the form of a novel control valve, consisting of a throttle valve and a differential valve controlled by the pressure difference between the supply line and the return line. A geometric model was created using SolidWorks, then a simulation model was made in Matlab/Simulink. Next, simulations were carried out to prove that the use of the return fluid stream gives a possibility of a significant increase in the piston rod speed. The results of the numerical analyses were verified on a test bench where the valve prototype was tested. Speed characteristics of the piston rod against both payload force and throttle valve setting were determined. High convergence with the simulation results was obtained. It has also been confirmed that the proposed solution can be advantageous in practical applications.
- 15 February 2019
- Published by Faculty of Mechanical Engineering in Strojniški vestnik - Journal of Mechanical Engineering
- Vol. 65 (2) , 103-112
Numerical and Experimental Study of a Novel Valve Using the Return Stream Energy to Adjust the Speed of a Hydraulic Actuator
This article discusses the possibility of increasing the speed of movement of a single-sided hydraulic cylinder piston rod using a fluid stream from the return line. Directing the return stream back to the supply line instead of the fluid reservoir causes significant increase in the inflow rate to the actuator. This situation may arise when the piston rod of the cylinder is not fully loaded on part of the movement range. As part of this work, we proposed a solution in the form of a novel control valve, consisting of a throttle valve and a differential valve controlled by the pressure difference between the supply line and the return line. A geometric model was created using SolidWorks, then a simulation model was made in Matlab/Simulink. Next, simulations were carried out to prove that the use of the return fluid stream gives a possibility of a significant increase in the piston rod speed. The results of the numerical analyses were verified on a test bench where the valve prototype was tested. Speed characteristics of the piston rod against both payload force and throttle valve setting were determined. High convergence with the simulation results was obtained. It has also been confirmed that the proposed solution can be advantageous in practical applications.
- Open Access
- 1 January 2018
- Published by Cracow University of Technology in Technical Transactions
- Vol. 2018 (2) , 211-218
Nonlinear static analysis of air cushion in SolidWorks Simulation 2016
Nonlinear static analysis of air cushion in SolidWorks Simulation 2016
- 1 January 2018
- Published by Cracow University of Technology in Technical Transactions
- Vol. 2018 (2) , 211-218
Open AccessNonlinear static analysis of air cushion in SolidWorks Simulation 2016
Nonlinear static analysis of air cushion in SolidWorks Simulation 2016
- Open Access
Experimental access to Transition Distribution Amplitudes with the PANDA experiment at FAIR
Baryon-to-meson Transition Distribution Amplitudes (TDAs) encoding valuable new information on hadron structure appear as building blocks in the collinear factorized description for several types of hard exclusive reactions. In this paper, we address the possibility of accessing nucleon-to-pion ($\pi N$) TDAs from $\bar{p}p \to e^+e^- \pi^0$ reaction with the future \={P}ANDA detector at the FAIR facility. At high center of mass energy and high invariant mass squared of the lepton pair $q^2$, the amplitude of the signal channel $\bar{p}p \to e^+e^- \pi^0$ admits a QCD factorized description in terms of $\pi N$ TDAs and nucleon Distribution Amplitudes (DAs) in the forward and backward kinematic regimes. Assuming the validity of this factorized description, we perform feasibility studies for measuring $\bar{p}p \to e^+e^- \pi^0$ with the \={P}ANDA detector. Detailed simulations on signal reconstruction efficiency as well as on rejection of the most severe background channel, i.e. $\bar{p}p \to \pi^+\pi^- \pi^0$ were performed for the center of mass energy squared $s = 5$ GeV$^2$ and $s = 10$ GeV$^2$, in the kinematic regions $3.0 < q^2 < 4.3$ GeV$^2$ and $5 < q^2 < 9$ GeV$^2$, respectively, with a neutral pion scattered in the forward or backward cone $| \cos\theta_{\pi^0}| > 0.5 $ in the proton-antiproton center of mass frame. Results of the simulation show that the particle identification capabilities of the \={P}ANDA detector will allow to achieve a background rejection factor of $5\cdot 10^7$ ($1\cdot 10^7$) at low (high) $q^2$ for $s=5$ GeV$^2$, and of $1\cdot 10^8$ ($6\cdot 10^6$) at low (high) $q^2$ for $s=10$ GeV$^2$, while keeping the signal reconstruction efficiency at around $40\%$. At both energies, a clean lepton signal can be reconstructed with the expected statistics corresponding to $2$ fb$^{-1}$ of integrated luminosity. (.../...)Open AccessExperimental access to Transition Distribution Amplitudes with the PANDA experiment at FAIR
Baryon-to-meson Transition Distribution Amplitudes (TDAs) encoding valuable new information on hadron structure appear as building blocks in the collinear factorized description for several types of hard exclusive reactions. In this paper, we address the possibility of accessing nucleon-to-pion ($\pi N$) TDAs from $\bar{p}p \to e^+e^- \pi^0$ reaction with the future \={P}ANDA detector at the FAIR facility. At high center of mass energy and high invariant mass squared of the lepton pair $q^2$, the amplitude of the signal channel $\bar{p}p \to e^+e^- \pi^0$ admits a QCD factorized description in terms of $\pi N$ TDAs and nucleon Distribution Amplitudes (DAs) in the forward and backward kinematic regimes. Assuming the validity of this factorized description, we perform feasibility studies for measuring $\bar{p}p \to e^+e^- \pi^0$ with the \={P}ANDA detector. Detailed simulations on signal reconstruction efficiency as well as on rejection of the most severe background channel, i.e. $\bar{p}p \to \pi^+\pi^- \pi^0$ were performed for the center of mass energy squared $s = 5$ GeV$^2$ and $s = 10$ GeV$^2$, in the kinematic regions $3.0 < q^2 < 4.3$ GeV$^2$ and $5 < q^2 < 9$ GeV$^2$, respectively, with a neutral pion scattered in the forward or backward cone $| \cos\theta_{\pi^0}| > 0.5 $ in the proton-antiproton center of mass frame. Results of the simulation show that the particle identification capabilities of the \={P}ANDA detector will allow to achieve a background rejection factor of $5\cdot 10^7$ ($1\cdot 10^7$) at low (high) $q^2$ for $s=5$ GeV$^2$, and of $1\cdot 10^8$ ($6\cdot 10^6$) at low (high) $q^2$ for $s=10$ GeV$^2$, while keeping the signal reconstruction efficiency at around $40\%$. At both energies, a clean lepton signal can be reconstructed with the expected statistics corresponding to $2$ fb$^{-1}$ of integrated luminosity. (.../...) - Open Access
- 28 August 2015
- Published by Springer Nature in The European Physical Journal A
- Vol. 51 (8) , 107
Experimental access to Transition Distribution Amplitudes with the P̄ANDA experiment at FAIR
- 28 August 2015
- Published by Springer Nature in The European Physical Journal A
- Vol. 51 (8) , 107
Open AccessExperimental access to Transition Distribution Amplitudes with the P̄ANDA experiment at FAIR