Roman Glazkov
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Roman Glazkov has a total of 27 co-authors. Here are the top co-authors by number of shared publications:
Nikita V. Babaev
Digiton Systems,Saint-Petersburg,Russia
2 shared publicationsVitaly V. Moshkov
State University of Telecommunications Saint-Petersburg,The Bonch-Bruevich Saint-Petersburg,Russia
2 shared publicationsAlexander Pyattaev
YL-Verkot Oy,Tampere,Finland
1 shared publication- Andrey Samuylov
Department of Electrical Engineering and Communications, Tampere University, Tampere, Finland
1 shared publication Berna Ozbek
Izmir Institute of Technology,Department of Electrical and Electronics Engineering,Turkey
1 shared publicationDmitri Moltchanov
Tampere University,Unit of Electrical Engineering,Finland
1 shared publication
Latest Publications
- Open Access
Provisioning of Fog Computing over Named-Data Networking in Dynamic Wireless Mesh Systems
Fog computing is today considered a promising candidate to improve the user experience in dynamic on-demand computing services. However, its ubiquitous application would require support for this service in wireless multi-hop mesh systems, where the use of conventional IP-based solutions is challenging. As a complementary solution, in this paper, we consider a Named-Data Networking (NDN) approach to enable fog computing services in autonomous dynamic mesh formations. In particular, we jointly implement two critical mechanisms required to extend the NDN-based fog computing architecture to wireless mesh systems. These are (i) dynamic face management systems and (ii) a learning-based route discovery strategy. The former makes it possible to solve NDN issues related to an inability to operate over a broadcast medium. Also, it improves the data-link layer reliability by enabling unicast communications between mesh nodes. The learning-based forwarding strategy, on the other hand, efficiently reduces the amount of overhead needed to find routes in the dynamically changing mesh networks. Our numerical results show that, for static wireless meshes, our proposal makes it possible to fully benefit from the computing resources sporadically available up to several hops away from the consumer. Additionally, we investigate the impacts of various traffic types and NDN caching capabilities, revealing that the latter result in much better system performance while the popularity of the compute service contributes to additional performance gains.
Open AccessProvisioning of Fog Computing over Named-Data Networking in Dynamic Wireless Mesh Systems
Fog computing is today considered a promising candidate to improve the user experience in dynamic on-demand computing services. However, its ubiquitous application would require support for this service in wireless multi-hop mesh systems, where the use of conventional IP-based solutions is challenging. As a complementary solution, in this paper, we consider a Named-Data Networking (NDN) approach to enable fog computing services in autonomous dynamic mesh formations. In particular, we jointly implement two critical mechanisms required to extend the NDN-based fog computing architecture to wireless mesh systems. These are (i) dynamic face management systems and (ii) a learning-based route discovery strategy. The former makes it possible to solve NDN issues related to an inability to operate over a broadcast medium. Also, it improves the data-link layer reliability by enabling unicast communications between mesh nodes. The learning-based forwarding strategy, on the other hand, efficiently reduces the amount of overhead needed to find routes in the dynamically changing mesh networks. Our numerical results show that, for static wireless meshes, our proposal makes it possible to fully benefit from the computing resources sporadically available up to several hops away from the consumer. Additionally, we investigate the impacts of various traffic types and NDN caching capabilities, revealing that the latter result in much better system performance while the popularity of the compute service contributes to additional performance gains.
- 1 June 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-7
In-Network Dynamic Compute Orchestration Over Mobile Edge Systems
In this paper, we propose a new service orchestration approach for in-network fully distributed dynamic compute composition with limited involvement from the consumer and no centralized coordinator. The service is composed fully inside the network including assembling data and software, and compute node selection, leveraging standardized NDN functionalities. The use of the proposed approach will enable smooth support of dynamic compute services over wireless/mobile edge and edge/fog NDN-based systems, where the use of conventional IP approach faces fundamental difficulties related to dynamic allocation of IP addresses. We will also outline extensions of the proposed approach for streaming data, function chaining and re-use of partially computed results. Our numerical results show that the proposed method improves service reliability at the edge by increasing the Interest satisfaction by 5-10 times depending on the considered deployment, network topology, and resources.
- 1 June 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-7
In-Network Dynamic Compute Orchestration Over Mobile Edge Systems
In this paper, we propose a new service orchestration approach for in-network fully distributed dynamic compute composition with limited involvement from the consumer and no centralized coordinator. The service is composed fully inside the network including assembling data and software, and compute node selection, leveraging standardized NDN functionalities. The use of the proposed approach will enable smooth support of dynamic compute services over wireless/mobile edge and edge/fog NDN-based systems, where the use of conventional IP approach faces fundamental difficulties related to dynamic allocation of IP addresses. We will also outline extensions of the proposed approach for streaming data, function chaining and re-use of partially computed results. Our numerical results show that the proposed method improves service reliability at the edge by increasing the Interest satisfaction by 5-10 times depending on the considered deployment, network topology, and resources.
- 4 December 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 2633-2637
Testbed SDR Implementation Approach for Millimetre Wave IoT Applications
Millimetre wave (mmWave) communication is a promising technology which can fulfil the growing demands for spectrum for future wireless networks. One of the key areas for the development of the mmWave networks is the Internet of Things (IoT) communications within fifth generation (5G) and beyond 5G networks. For significant analysis and development of the compliant IoT systems through testbed implementation, current mmWave spectrum transceivers are too expensive when substantial number of the nodes is required by the IoT applications. Considering all the above, it is suggested to use Software Defined Radio (SDR) transceivers with a lower frequency band and with an increased distance between the nodes. The idea is to scale observation time and distance to emulate mmWave radio without actual mmWave hardware. Using scaling factors for the certain system parameters to keep the signal characteristics in accordance with the mmWave band makes it possible. This approach allows to develop mmWave IoT testbeds with significant improvement in the system scalability and cost-effectiveness without the need to transmit and receive the signal in the mmWave band. In this paper, the concept of SDR-based Hardware-in-the-loop (HIL) system combined with the observation time and distance scaling approach is proposed. As an example, a testbed with a simple Wireless Physical Network Coding scheme is implemented and demonstrated.
- 4 December 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 2633-2637
Testbed SDR Implementation Approach for Millimetre Wave IoT Applications
Millimetre wave (mmWave) communication is a promising technology which can fulfil the growing demands for spectrum for future wireless networks. One of the key areas for the development of the mmWave networks is the Internet of Things (IoT) communications within fifth generation (5G) and beyond 5G networks. For significant analysis and development of the compliant IoT systems through testbed implementation, current mmWave spectrum transceivers are too expensive when substantial number of the nodes is required by the IoT applications. Considering all the above, it is suggested to use Software Defined Radio (SDR) transceivers with a lower frequency band and with an increased distance between the nodes. The idea is to scale observation time and distance to emulate mmWave radio without actual mmWave hardware. Using scaling factors for the certain system parameters to keep the signal characteristics in accordance with the mmWave band makes it possible. This approach allows to develop mmWave IoT testbeds with significant improvement in the system scalability and cost-effectiveness without the need to transmit and receive the signal in the mmWave band. In this paper, the concept of SDR-based Hardware-in-the-loop (HIL) system combined with the observation time and distance scaling approach is proposed. As an example, a testbed with a simple Wireless Physical Network Coding scheme is implemented and demonstrated.
- 1 January 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 42-44
Web SDR-based QoS Monitoring System for Wireless Networks Analysis
This article discusses the use of the WebSDR platform, which allows using the software-defined radio (SDR) technology to independently configure the receiver for several users simultaneously. It allows not only listening the sound, but also monitor wireless networks of various ranges (including mobile communication network, broadcasting). This paper describes a monitoring system prototype based on the RTL - SDR broadband radio scanner dongle in relation to the analogue radio broadcasting in the 87.5 - 108.0 MHz band and. An option of using the developed system in practice is presented.
- 1 January 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 42-44
Web SDR-based QoS Monitoring System for Wireless Networks Analysis
This article discusses the use of the WebSDR platform, which allows using the software-defined radio (SDR) technology to independently configure the receiver for several users simultaneously. It allows not only listening the sound, but also monitor wireless networks of various ranges (including mobile communication network, broadcasting). This paper describes a monitoring system prototype based on the RTL - SDR broadband radio scanner dongle in relation to the analogue radio broadcasting in the 87.5 - 108.0 MHz band and. An option of using the developed system in practice is presented.
- 1 January 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 17-20
Research and Implementation of Energy Dispersal Algorithm for DRM System
The article investigates the randomization algorithm of the OFDM signal energy used in modern digital broadcasting systems. Transmission part of the DRM system was modeled in MATLAB/Simulink software environment, bit sequences allocation tests were conducted using the original information signal and the corresponding modulation symbols with a scrambling algorithm and without it.
- 1 January 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 17-20
Research and Implementation of Energy Dispersal Algorithm for DRM System
The article investigates the randomization algorithm of the OFDM signal energy used in modern digital broadcasting systems. Transmission part of the DRM system was modeled in MATLAB/Simulink software environment, bit sequences allocation tests were conducted using the original information signal and the corresponding modulation symbols with a scrambling algorithm and without it.
- 1 January 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 21-23
GNU Radio Based RDS Transceiver for Data Communication
The article describes the technology of data reception and transmission according to the RDS standard. A transceiver model using the GNU Radio software development toolkit has been developed. The transmitter is implemented on the Hack RF One hardware platform. The receiver is implemented on the RTL-SDR (RTL2832u) hardware platform. The idea of using RDS technology in the unlicensed frequency band for commercial use in the field of housing and communal services is proposed.
- 1 January 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 21-23
GNU Radio Based RDS Transceiver for Data Communication
The article describes the technology of data reception and transmission according to the RDS standard. A transceiver model using the GNU Radio software development toolkit has been developed. The transmitter is implemented on the Hack RF One hardware platform. The receiver is implemented on the RTL-SDR (RTL2832u) hardware platform. The idea of using RDS technology in the unlicensed frequency band for commercial use in the field of housing and communal services is proposed.