Liliana Inés Perez
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Liliana Inés Perez has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Fracisco Ezequiel Veiras
Electrónica e Informática, Instituto Nacional de Tecnología Industrial, P.O. Box B1650WAB, B1650KNA San Martín, Argentina
4 shared publications Eduardo O. Acosta
1 shared publicationFernando Ciocci
Laboratorio de Optica, Departamento de Física , Facultad de Ciencias Exactas y Naturales, Universidad de Buenos Aires , 1428, Buenos Aires, Argentina
1 shared publicationGerman E. Caro
1 shared publication- Ligia Ciocci Brazzano
Universidad de Buenos Aires 1 , Facultad de Ingeniería, Buenos Aires
1 shared publication M. T. Garea
GLOmAe, Departamento de Física, Facultad de Ingeniería, Universidad de Buenos Aires, Av. Paseo Colón 850, Ciudad Autónoma de Buenos Aires C1063ACV, Argentina
1 shared publication
Latest Publications
- 16 June 2021
- Published by Taylor & Francis in Journal of Modern Optics
- Vol. 68 (13) , 689-698
Design of reflectivity-based surface plasmon resonance optical sensors for ultrasound detection
Sensors based on surface plasmon resonance present attractive features for the detection of narrow acoustic pulses since they can behave as quasi-point detectors. In order to detect fast ultrasound pressure waves, the system senses the intensity of the reflected beam for a fixed angle of incidence and for a fixed wavelength. Therefore, optimal conditions for Kretschmann's glass-metal-water configuration are presented. Optimization is performed by means of numerical simulations of the reflectivity curves for different low-cost metallic films with different thicknesses and angles of incidence. Zn, Ti, Cr, Al, and Cu are evaluated and compared with Au. In addition, the wavelength selection is discussed, and the oxidation effects are also briefly analysed.
- 16 June 2021
- Published by Taylor & Francis in Journal of Modern Optics
- Vol. 68 (13) , 689-698
Design of reflectivity-based surface plasmon resonance optical sensors for ultrasound detection
Sensors based on surface plasmon resonance present attractive features for the detection of narrow acoustic pulses since they can behave as quasi-point detectors. In order to detect fast ultrasound pressure waves, the system senses the intensity of the reflected beam for a fixed angle of incidence and for a fixed wavelength. Therefore, optimal conditions for Kretschmann's glass-metal-water configuration are presented. Optimization is performed by means of numerical simulations of the reflectivity curves for different low-cost metallic films with different thicknesses and angles of incidence. Zn, Ti, Cr, Al, and Cu are evaluated and compared with Au. In addition, the wavelength selection is discussed, and the oxidation effects are also briefly analysed.
- Open Access
- 1 April 2016
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 87 (4) , 043113
A birefringent polarization modulator: Application to phase measurement in conoscopic interference patterns
Conoscopic interferometry for crystal characterization is a very well-known technique with increasing applications in different fields of technology. The advantage of the scheme proposed here is the introduction of a polarization modulator that allows the recovery of the phase information contained in conoscopic interferograms. This represents a real advantage since the most relevant physical information of the sample under study is usually contained in the phase of the fringe pattern. Moreover, this technique works successfully even when there are no visible fringes. The setup employed is a simple conoscopic interferometer where the elements under study correspond to two birefringent crystal slabs and a commercial mica wave plate. It allows the crystals to be characterized and the wave plate retardance to be measured as a function of the angle of incidence. The modulator itself consists of a single tiltable crystal plate which, by means of phase shifting techniques, permits the recovery of a phase map for each sample. It is inexpensive and it can be easily calibrated, so it works with a wide range of phase shifting interferometry algorithms. We show that our scheme is easily adaptable to algorithms that require either a low or high amount of interferograms.
- 1 April 2016
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 87 (4) , 043113
Open AccessA birefringent polarization modulator: Application to phase measurement in conoscopic interference patterns
Conoscopic interferometry for crystal characterization is a very well-known technique with increasing applications in different fields of technology. The advantage of the scheme proposed here is the introduction of a polarization modulator that allows the recovery of the phase information contained in conoscopic interferograms. This represents a real advantage since the most relevant physical information of the sample under study is usually contained in the phase of the fringe pattern. Moreover, this technique works successfully even when there are no visible fringes. The setup employed is a simple conoscopic interferometer where the elements under study correspond to two birefringent crystal slabs and a commercial mica wave plate. It allows the crystals to be characterized and the wave plate retardance to be measured as a function of the angle of incidence. The modulator itself consists of a single tiltable crystal plate which, by means of phase shifting techniques, permits the recovery of a phase map for each sample. It is inexpensive and it can be easily calibrated, so it works with a wide range of phase shifting interferometry algorithms. We show that our scheme is easily adaptable to algorithms that require either a low or high amount of interferograms.
- 1 January 2008
- Published by Optica Publishing Group
- p. PDPA2
Phase Shift Formulas for Waveplates in Oblique Incidence
An explicit expression for phase difference introduced by ideal waveplates is obtained based on Fermat’s principle. The results obtained differ from the ones in literature and turn out to be useful for their design.
- 1 January 2008
- Published by Optica Publishing Group
- p. PDPA2
Phase Shift Formulas for Waveplates in Oblique Incidence
An explicit expression for phase difference introduced by ideal waveplates is obtained based on Fermat’s principle. The results obtained differ from the ones in literature and turn out to be useful for their design.
- 1 December 1998
- Published by Taylor & Francis in Journal of Modern Optics
- Vol. 45 (12) , 2487-2502
Nonspecular first-order effects in Kretschmann's configuration
First-order nonspecular effects for Gaussian beams reflected on the first interface of a system formed by two interfaces of isotropic materials are studied. The complex lateral displacement is analytically determined and the validity of the approximations made is analysed. It is shown that the lateral displacement is independent of the beam waist and the approximation results suitable even for very narrow beams near Brewster's condition. With a dielectric-metal-dielectric configuration (Kretschmann's) and under resonance conditions, lateral displacements of up to 25% of the beam width can be obtained.
- 1 December 1998
- Published by Taylor & Francis in Journal of Modern Optics
- Vol. 45 (12) , 2487-2502
Nonspecular first-order effects in Kretschmann's configuration
First-order nonspecular effects for Gaussian beams reflected on the first interface of a system formed by two interfaces of isotropic materials are studied. The complex lateral displacement is analytically determined and the validity of the approximations made is analysed. It is shown that the lateral displacement is independent of the beam waist and the approximation results suitable even for very narrow beams near Brewster's condition. With a dielectric-metal-dielectric configuration (Kretschmann's) and under resonance conditions, lateral displacements of up to 25% of the beam width can be obtained.