Monika Napieraj
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Monika Napieraj has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Piotr Górski
Politechnika Opolska Wydział Budownictwa i Architektury
4 shared publications Eduard Konopka
3 shared publicationsPiotr Górski
Prof.; Opole University of Technology, Faculty of Civil Engineering and Architecture , Katowicka 48 , Opole , Poland
2 shared publications- Karolina Jurasz-Drozdowska
Opole University of Technology, Faculty of Civil Engineering and Architecture, Katowicka 48,45-758 Opole, Poland
1 shared publication Patryk Jarysz
Aspekt Laboratorium Sp. z o.o.
1 shared publicationPeter Breuer
Stuttgart University of Applied Sciences, Department of Geomatics, Computer Science and Mathematics Schellingstraβe 24, Stuttgart 70174, Germany
1 shared publication
Latest Publications
- Open Access
- 22 June 2026
- Published by Road and Bridge Research Institute in Roads and Bridges – Drogi i Mosty
- Vol. 25 (2) , 115-126
Selected aspects of strengthening orthotropic steel decks in steel bridges with UHPC thin-overlay technology
The article presents a review of current achievements and selected results of material research in the field of strengthening orthotropic steel decks in steel bridges using a thin Ultra High Performance Concrete (UHPC) overlay to increase their load-bearing capacity and fatigue life. The review study confirmed a 40% to 80% reduction in stresses in the bridge deck structure. The authors’ experimental research focused on 70 mm thick UHPC overlays on two existing bridges with spans of 41 m and 292 m. It includes an assessment of the effect of the void content in the fresh concrete mix on the bulk density of hardened concrete, the increase in concrete strength over time, the effect of the number of freezing cycles on the Young's modulus of concrete and the strength of the UHPC-steeldeck slab bond including the static slab deflections. The deflection of the bridge deck slab with the UHPC overlay in the three-point bending test was decreased by half, while the limit load values breaking the UHPC-steel bond zone using epoxy resin in the test plates were 150 kN and 162 kN. The presented results have important cognitive significance because they concern the tests of the UHPC overlay made on existing bridge structures.
- 22 June 2026
- Published by Road and Bridge Research Institute in Roads and Bridges – Drogi i Mosty
- Vol. 25 (2) , 115-126
Open AccessSelected aspects of strengthening orthotropic steel decks in steel bridges with UHPC thin-overlay technology
The article presents a review of current achievements and selected results of material research in the field of strengthening orthotropic steel decks in steel bridges using a thin Ultra High Performance Concrete (UHPC) overlay to increase their load-bearing capacity and fatigue life. The review study confirmed a 40% to 80% reduction in stresses in the bridge deck structure. The authors’ experimental research focused on 70 mm thick UHPC overlays on two existing bridges with spans of 41 m and 292 m. It includes an assessment of the effect of the void content in the fresh concrete mix on the bulk density of hardened concrete, the increase in concrete strength over time, the effect of the number of freezing cycles on the Young's modulus of concrete and the strength of the UHPC-steeldeck slab bond including the static slab deflections. The deflection of the bridge deck slab with the UHPC overlay in the three-point bending test was decreased by half, while the limit load values breaking the UHPC-steel bond zone using epoxy resin in the test plates were 150 kN and 162 kN. The presented results have important cognitive significance because they concern the tests of the UHPC overlay made on existing bridge structures.
- Open Access
- 1 September 2025
- Published by Walter de Gruyter GmbH in Architecture, Civil Engineering, Environment
- Vol. 18 (3) , 191-203
Dynamic Identification of A Cable-Stayed Bridge Induced by Random Traffic Flow
The paper presents an experimental study of the dynamic response of a cable-stayed road bridge with a steel-UHPC (Ultra High Performance Concrete) composite deck slab, excited by daily random traffic flow along a three-lane highway with high traffic intensity. For this purpose, temporary in-situ measurements of vertical vibration accelerations of the box girder were performed along the entire length of the bridge. The measured data were then analyzed using three estimation techniques, i.e., the Peak Picking, Frequency Domain Decomposition, and Random Decrement technique. Their impact on the obtained results was determined. The results obtained using these approaches were compared. The first five modal frequencies and mode shapes of the bridge-vehicle system, as well as the corresponding damping ratios, were analyzed. It was found that the obtained vibration frequency values were variable in the range of 0.1-3.1%. In the case of the damping ratio, the variability in the range of 19-44% was observed, which may indicate a high sensitivity of this parameter to dynamic effects induced by traffic flow. Moreover, it was shown that the extracted modal shapes, corresponding to the natural frequencies of the bridge in the range up to 2.1 Hz, are related to the bending, torsion, and bending-torsion forms. The frequency components of bridge vibrations related to vehicle movement were in the range of 8-16 Hz. The obtained results provided essential data that can be helpful in monitoring the dynamic behavior and technical state of other bridges with a similar structural system.
- 1 September 2025
- Published by Walter de Gruyter GmbH in Architecture, Civil Engineering, Environment
- Vol. 18 (3) , 191-203
Open AccessDynamic Identification of A Cable-Stayed Bridge Induced by Random Traffic Flow
The paper presents an experimental study of the dynamic response of a cable-stayed road bridge with a steel-UHPC (Ultra High Performance Concrete) composite deck slab, excited by daily random traffic flow along a three-lane highway with high traffic intensity. For this purpose, temporary in-situ measurements of vertical vibration accelerations of the box girder were performed along the entire length of the bridge. The measured data were then analyzed using three estimation techniques, i.e., the Peak Picking, Frequency Domain Decomposition, and Random Decrement technique. Their impact on the obtained results was determined. The results obtained using these approaches were compared. The first five modal frequencies and mode shapes of the bridge-vehicle system, as well as the corresponding damping ratios, were analyzed. It was found that the obtained vibration frequency values were variable in the range of 0.1-3.1%. In the case of the damping ratio, the variability in the range of 19-44% was observed, which may indicate a high sensitivity of this parameter to dynamic effects induced by traffic flow. Moreover, it was shown that the extracted modal shapes, corresponding to the natural frequencies of the bridge in the range up to 2.1 Hz, are related to the bending, torsion, and bending-torsion forms. The frequency components of bridge vibrations related to vehicle movement were in the range of 8-16 Hz. The obtained results provided essential data that can be helpful in monitoring the dynamic behavior and technical state of other bridges with a similar structural system.
- 1 November 2020
- Published by Elsevier in Measurement
- Vol. 164
Variability evaluation of dynamic characteristics of highway steel bridge based on daily traffic-induced vibrations
- 1 November 2020
- Published by Elsevier in Measurement
- Vol. 164
Variability evaluation of dynamic characteristics of highway steel bridge based on daily traffic-induced vibrations
- 19 November 2019
Load capacity of the XX. century
- Open Access
- 1 January 2019
- Published by The IULT in Wroclaw in Logistics and Transport
- Vol. 44 (4) , 15-24
LOAD CAPACITY OF THE XX. CENTURY BRIDGES
This article is a compilation of all standards governing the payloads for road bridges in our country starting before the II World War, and ending on the Eurocode. The article also includes a comparative analysis of the effort of the structures subjected to loads compliant with these standards. On their basis, the load-bearing of the bridge was estimated.
- 1 January 2019
- Published by The IULT in Wroclaw in Logistics and Transport
- Vol. 44 (4) , 15-24
Open AccessLOAD CAPACITY OF THE XX. CENTURY BRIDGES
This article is a compilation of all standards governing the payloads for road bridges in our country starting before the II World War, and ending on the Eurocode. The article also includes a comparative analysis of the effort of the structures subjected to loads compliant with these standards. On their basis, the load-bearing of the bridge was estimated.
- Open Access
- 20 September 2018
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 419 (1) , 012009
Effectiveness of GPS technology in monitoring of traffic-induced response of highway steel bridge
Despite some disadvantages, regarding the limited accuracy, the Global Positioning System (GPS) is widely used in monitoring of long-span bridges. This paper is concerned with the analysis of the capabilities and limitations of the use of the GPS technology in monitoring of semi-static and dynamic vertical responses of a highway steel cable-stayed bridge excited by traffic loads. The field test was conducted on the Maxau Rhine Bridge, located over the Rhine River near Karlsruhe, Germany. The so-called baseline method with the Post-Processing mode was applied using two units Leica Viva GS15. The basic characteristics of the GPS background noise before and after filtering were examined in the time and frequency domain. The natural frequencies of the bridge were extracted based on the vertical dynamic displacements recorded in the mid-span of the bridge using GPS and accelerometer. It was shown that the GPS receivers were able to measure only two primary modal frequencies of the bridge. The obtained experimental results proved that the GPS system is an efficient tool in measuring the vertical semi-static displacements of the bridge with satisfactory accuracy. Moreover, GPS is capable of tracking the vertical vibrations of long-period bridges to a few millimeters.
- 20 September 2018
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 419 (1) , 012009
Open AccessEffectiveness of GPS technology in monitoring of traffic-induced response of highway steel bridge
Despite some disadvantages, regarding the limited accuracy, the Global Positioning System (GPS) is widely used in monitoring of long-span bridges. This paper is concerned with the analysis of the capabilities and limitations of the use of the GPS technology in monitoring of semi-static and dynamic vertical responses of a highway steel cable-stayed bridge excited by traffic loads. The field test was conducted on the Maxau Rhine Bridge, located over the Rhine River near Karlsruhe, Germany. The so-called baseline method with the Post-Processing mode was applied using two units Leica Viva GS15. The basic characteristics of the GPS background noise before and after filtering were examined in the time and frequency domain. The natural frequencies of the bridge were extracted based on the vertical dynamic displacements recorded in the mid-span of the bridge using GPS and accelerometer. It was shown that the GPS receivers were able to measure only two primary modal frequencies of the bridge. The obtained experimental results proved that the GPS system is an efficient tool in measuring the vertical semi-static displacements of the bridge with satisfactory accuracy. Moreover, GPS is capable of tracking the vertical vibrations of long-period bridges to a few millimeters.
- 10 January 2017
- Vol. 1, 39-44
Badanie charakterystyk dynamicznych wysokiego komina przemysłowego
- 1 December 2015
- Vol. 28, 89-96
Organization of non-normative transport in Poland