Ana Aline C. Alcanfor
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Ana Aline C. Alcanfor has a total of 34 co-authors. Here are the top co-authors by number of shared publications:
- Adriana Nunes Correia
Universidade Federal do Ceará Campus do Pici, Bl 940
4 shared publications - Bruno Gomes Linhares
Department of Metallurgical and Materials Engineering
2 shared publications - Caio Victor Pereira Pascoal
Department of Metallurgical and Materials Engineering
2 shared publications - Daniel de Castro Girão
Núcleo de Tecnologia e Qualidade Industrial do Ceará, Brasil; Universidade Federal do Ceará, Brasil
2 shared publications Diego F. Dias
Universidade Federal do Ceará Campus do Pici
2 shared publications- Natalia Gomes Sousa
Universidade Federal do Ceará Campus do Pici, Bl 940
2 shared publications
Latest Publications
- Open Access
- 9 September 2026
- Published by Elsevier in Electrochimica Acta
- Vol. 579
Correlating thermal sensitization with intergranular corrosion susceptibility and passive film semiconducting behavior in low-nickel QN1803 austenitic stainless steel
- 9 September 2026
- Published by Elsevier in Electrochimica Acta
- Vol. 579
Open AccessCorrelating thermal sensitization with intergranular corrosion susceptibility and passive film semiconducting behavior in low-nickel QN1803 austenitic stainless steel
- Open Access
- 31 July 2026
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 11 (31) , 45939-45948
Sustainable CuIn Electrodeposition from Deep Eutectic Solvents: Influence of Ethylene Glycol and Urea
The electrodeposition of CuIn coatings on platinum was investigated using CuCl2.2H2O and InCl3 in the deep eutectic solvents (DES) 1ChCl:2EG (1 choline chloride: 2 ethylene glycol) and 1ChCl:2U (1 choline chloride: 2 urea). The cyclic voltammograms of the CuIn solution showed three reduction processes: the first two associated with Cu2+/Cu+ and Cu+/Cu and the third with In3+/In. Physicochemical properties, such as viscosity and specific mass, were measured at different temperatures for Cu2+ and In3+ cations. Increasing the temperature reduced viscosity and increased diffusion coefficient (D) values for the species studied in both solvents. The solvadynamic radius values decreased with increasing temperature for both species in 1ChCl:2EG, whereas the opposite was observed in 1ChCl:2U. Scanning electron microscopy (SEM) analysis of the coatings was performed potentiostatically at different temperatures and cation ratios. For 1ChCl:2EG, granular morphologies were observed, and the grain size increased with increasing temperature. By altering the In3+ concentration in the solution, an increase of approximately 20 wt % in the coatings was achieved. This was followed in relation to the result obtained from the equimolar solution. 1ChCl:2U coatings exhibited a granular morphology with Cu at 100 wt % at 296 K, whereas at 343 K, at more negative potentials, they exhibited 45 wt %. By altering the cation ratio, the cation with a higher concentration in the electrolytic solution predominated. The results show that examining CuIn electrodeposition in different media is essential to producing high-quality coatings.
- 31 July 2026
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 11 (31) , 45939-45948
Open AccessSustainable CuIn Electrodeposition from Deep Eutectic Solvents: Influence of Ethylene Glycol and Urea
The electrodeposition of CuIn coatings on platinum was investigated using CuCl2.2H2O and InCl3 in the deep eutectic solvents (DES) 1ChCl:2EG (1 choline chloride: 2 ethylene glycol) and 1ChCl:2U (1 choline chloride: 2 urea). The cyclic voltammograms of the CuIn solution showed three reduction processes: the first two associated with Cu2+/Cu+ and Cu+/Cu and the third with In3+/In. Physicochemical properties, such as viscosity and specific mass, were measured at different temperatures for Cu2+ and In3+ cations. Increasing the temperature reduced viscosity and increased diffusion coefficient (D) values for the species studied in both solvents. The solvadynamic radius values decreased with increasing temperature for both species in 1ChCl:2EG, whereas the opposite was observed in 1ChCl:2U. Scanning electron microscopy (SEM) analysis of the coatings was performed potentiostatically at different temperatures and cation ratios. For 1ChCl:2EG, granular morphologies were observed, and the grain size increased with increasing temperature. By altering the In3+ concentration in the solution, an increase of approximately 20 wt % in the coatings was achieved. This was followed in relation to the result obtained from the equimolar solution. 1ChCl:2U coatings exhibited a granular morphology with Cu at 100 wt % at 296 K, whereas at 343 K, at more negative potentials, they exhibited 45 wt %. By altering the cation ratio, the cation with a higher concentration in the electrolytic solution predominated. The results show that examining CuIn electrodeposition in different media is essential to producing high-quality coatings.
- Open Access
- 7 January 2026
- Published by Elsevier in Materials Chemistry and Physics
- Vol. 352
Enhanced pitting resistance of novel low-nickel austenitic stainless steel QN1803 compared to conventional 300-series grades in aggressive chloride environments
- 7 January 2026
- Published by Elsevier in Materials Chemistry and Physics
- Vol. 352
Open AccessEnhanced pitting resistance of novel low-nickel austenitic stainless steel QN1803 compared to conventional 300-series grades in aggressive chloride environments
- 1 September 2023
- Published by Elsevier in Journal of Molecular Liquids
- Vol. 390
Modelling approach applied to SnIn coatings from choline chloride/ethylene glycol deep eutectic solvent
- 1 September 2023
- Published by Elsevier in Journal of Molecular Liquids
- Vol. 390
Modelling approach applied to SnIn coatings from choline chloride/ethylene glycol deep eutectic solvent
- 1 May 2017
- Published by Elsevier in Electrochimica Acta
- Vol. 235, 553-560
Electrodeposition of indium on copper from deep eutectic solvents based on choline chloride and ethylene glycol
- 1 May 2017
- Published by Elsevier in Electrochimica Acta
- Vol. 235, 553-560
Electrodeposition of indium on copper from deep eutectic solvents based on choline chloride and ethylene glycol