Jonas Hansryd
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Jonas Hansryd has a total of 70 co-authors. Here are the top co-authors by number of shared publications:
P.A. Andrekson
Dept. of Microtechnol. & Nanosci., Chalmers Univ. of Technol., Goteborg, Sweden
27 shared publicationsM. Westlund
Dept. of Microtechnol. & Nanosci., Chalmers Univ. of Technol., Goteborg, Sweden
11 shared publicationsJie Li
9 shared publications- Magnus Karlsson
Chalmers University of Technology
9 shared publications H. Sunnerud
Dept. of Microtechnol. & Nanosci., Chalmers Univ. of Technol., Goteborg, Sweden
8 shared publicationsB. Bakhshi
7 shared publications
Latest Publications
- 1 December 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 883-885
D-band SiGe transceiver modules based on silicon-micromachined integration
This paper reports on 130 GHz transceiver modules consisting of integrated multi-functional chipsets in a commercial 130nm SiGe BiCMOS process. The interconnect between the chipset and the package is non-galvanic and is realized in silicon micromachining technique. After successful fabrication and assembly, the individual Tx and Rx modules as well as the combined Tx-Rx link were tested using CW signals. Then realtime data transport over the link were carried out using different modulation formats and bandwidths. With 16QAM over a 750 MHz channel a 2.66 Gbit/s data rate was demonstrated with BER−11 . These tests show that the D-band modules, obtained in a single implementation trial, work well functionally. The interconnect method is applicable to the full D-band and expected to also support frequencies in the sub-millimeter-wave range where traditional methods become challenging to apply.
- 1 December 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 883-885
D-band SiGe transceiver modules based on silicon-micromachined integration
This paper reports on 130 GHz transceiver modules consisting of integrated multi-functional chipsets in a commercial 130nm SiGe BiCMOS process. The interconnect between the chipset and the package is non-galvanic and is realized in silicon micromachining technique. After successful fabrication and assembly, the individual Tx and Rx modules as well as the combined Tx-Rx link were tested using CW signals. Then realtime data transport over the link were carried out using different modulation formats and bandwidths. With 16QAM over a 750 MHz channel a 2.66 Gbit/s data rate was demonstrated with BER−11 . These tests show that the D-band modules, obtained in a single implementation trial, work well functionally. The interconnect method is applicable to the full D-band and expected to also support frequencies in the sub-millimeter-wave range where traditional methods become challenging to apply.
- 1 January 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-3
A 40.2 bps/Hz Single Polarization 4x4 Line-of-Sight MIMO Link With Unsynchronized Oscillators
Line-of-sight MIMO (LOS-MIMO) has the potential to greatly improve the capacity and spectral efficiency of microwave links in backhaul networks. In this paper we present results from an outdoor experiment with a single polarization LOS-MIMO system with four spatial streams in a single channel and unsynchronized oscillators, with which we achieve an uncoded spectral efficiency of 40.2 bps/Hz for a 14 MHz channel with 6.6 · 10-3 bit error ratio. We also discuss the performance limitations of the system.
- 1 January 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-3
A 40.2 bps/Hz Single Polarization 4x4 Line-of-Sight MIMO Link With Unsynchronized Oscillators
Line-of-sight MIMO (LOS-MIMO) has the potential to greatly improve the capacity and spectral efficiency of microwave links in backhaul networks. In this paper we present results from an outdoor experiment with a single polarization LOS-MIMO system with four spatial streams in a single channel and unsynchronized oscillators, with which we achieve an uncoded spectral efficiency of 40.2 bps/Hz for a 14 MHz channel with 6.6 · 10-3 bit error ratio. We also discuss the performance limitations of the system.
- 1 November 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 234-236
A 143 GHz InP-Based Radio Link Characterized in Long-Term Outdoor Measurement
- 1 November 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 234-236
A 143 GHz InP-Based Radio Link Characterized in Long-Term Outdoor Measurement
- 1 November 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 31-33
Fixed Wireless Communication Links Beyond 100 GHZ
- 1 November 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 31-33
Fixed Wireless Communication Links Beyond 100 GHZ
- 30 October 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 66 (1) , 315-322
The Wet-Antenna Effect—A Factor to be Considered in Future Communication Networks
Accurate design of the fading margin in wireless communication networks requires good modeling of the relationship between the rain rate and the attenuation. In this paper we discuss the effect of the wet antenna on the fading margin. We claim that this effect is not negligible in commercial E-band (i.e., 60 GHz – 90 GHz) technologies, where the microwave links are relatively short and the sensitivity of the signal to attenuation induced by rain is significant. Consequently, we propose a method for estimating the wet antenna induced attenuation so it can be incorporated in the current models. Different from previous studies, our proposed method can be implemented on received signal level measurements which are standardly produced by commercial microwave links, and a single rain gauge. We demonstrate our results using actual measurements taken by 73 GHz commercial microwave links of about 1 km, provided by Ericsson.
- 30 October 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 66 (1) , 315-322
The Wet-Antenna Effect—A Factor to be Considered in Future Communication Networks
Accurate design of the fading margin in wireless communication networks requires good modeling of the relationship between the rain rate and the attenuation. In this paper we discuss the effect of the wet antenna on the fading margin. We claim that this effect is not negligible in commercial E-band (i.e., 60 GHz – 90 GHz) technologies, where the microwave links are relatively short and the sensitivity of the signal to attenuation induced by rain is significant. Consequently, we propose a method for estimating the wet antenna induced attenuation so it can be incorporated in the current models. Different from previous studies, our proposed method can be implemented on received signal level measurements which are standardly produced by commercial microwave links, and a single rain gauge. We demonstrate our results using actual measurements taken by 73 GHz commercial microwave links of about 1 km, provided by Ericsson.
- 1 March 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
Angular Resolved Site Characterization of Non-Line-of-Sight Wireless Links
A method and equipment for characterization of wireless paths to potential radio sites are presented. In particular, a measurement set-up is presented and experimentally verified that characterizes possible propagation paths between a hub site and a remote site that can be either in line-of-sight or non-line-ofsight. The characterization includes finding the best possible paths in terms of propagation loss, estimate the microwave path distances, and providing photo documentation of the detected paths. Such measurement can be automated and performed for a large number of possible sites before actual deployment. By using the characterization equipment presented here, an angular path direction resolution of ±2° and a path distance accuracy of better than ±5 meter can be obtained. A full scan and path characterization can be performed in less than 15 minutes per site. The method is demonstrated at 28 GHz in two different scenarios.
- 1 March 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
Angular Resolved Site Characterization of Non-Line-of-Sight Wireless Links
A method and equipment for characterization of wireless paths to potential radio sites are presented. In particular, a measurement set-up is presented and experimentally verified that characterizes possible propagation paths between a hub site and a remote site that can be either in line-of-sight or non-line-ofsight. The characterization includes finding the best possible paths in terms of propagation loss, estimate the microwave path distances, and providing photo documentation of the detected paths. Such measurement can be automated and performed for a large number of possible sites before actual deployment. By using the characterization equipment presented here, an angular path direction resolution of ±2° and a path distance accuracy of better than ±5 meter can be obtained. A full scan and path characterization can be performed in less than 15 minutes per site. The method is demonstrated at 28 GHz in two different scenarios.
- 1 September 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
Demonstration of Analog Millimeter-Wave Fronthaul Link for 64-QAM LTE Signal Transmission
Centralized baseband architecture is believed to be cost efficient and to offer high network performance. The fronthaul network, connecting the centralized baseband to distributed remote radios, requires high capacity and low latency transport links, due to the stringent specifications of the data interface, known as common public radio interface (CPRI). Today, fronthaul links are mostly based on digital CPRI over fibers, although it is possible to realize CPRI over wireless technology with the drawback of poor bandwidth efficiency. In this paper, we propose an analog wireless fronthaul concept to enable bandwidth efficient and scalable fronthaul networks. The basic idea is to transport narrow band analog radio signals over millimeter-wave bands instead of multi-gigabit digital signals. The phase and frequency impairments introduced by high frequency carriers are effectively reduced using an analog pilot-based mitigation technique. As a proof-of-concept demonstration, an analog fronthaul link is implemented, and the link performance is verified for 20 MHz 64-QAM LTE transmission over 70/80 GHz (E-band). The measured error vector magnitude (EVM) is about 3% with 10% pilot bandwidth overhead.
- 1 September 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
Demonstration of Analog Millimeter-Wave Fronthaul Link for 64-QAM LTE Signal Transmission
Centralized baseband architecture is believed to be cost efficient and to offer high network performance. The fronthaul network, connecting the centralized baseband to distributed remote radios, requires high capacity and low latency transport links, due to the stringent specifications of the data interface, known as common public radio interface (CPRI). Today, fronthaul links are mostly based on digital CPRI over fibers, although it is possible to realize CPRI over wireless technology with the drawback of poor bandwidth efficiency. In this paper, we propose an analog wireless fronthaul concept to enable bandwidth efficient and scalable fronthaul networks. The basic idea is to transport narrow band analog radio signals over millimeter-wave bands instead of multi-gigabit digital signals. The phase and frequency impairments introduced by high frequency carriers are effectively reduced using an analog pilot-based mitigation technique. As a proof-of-concept demonstration, an analog fronthaul link is implemented, and the link performance is verified for 20 MHz 64-QAM LTE transmission over 70/80 GHz (E-band). The measured error vector magnitude (EVM) is about 3% with 10% pilot bandwidth overhead.
- 1 September 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 19308876,p. 1-3
5G wireless communication beyond 2020
In the last twenty years we have seen a revolution comparable to the industrialization. We have gone from voice, to data, to mobile broadband to a situation where half of the two-year olds in Sweden use internet. We have changed how we are creating and sharing knowledge, how we interact with family and friends, how we work and how we do business. We have seen traditional industries transform... music, media ... and how more and more industries are rapidly digitalizing and mobilizing - realizing the need for good ICT solutions where mobility is becoming not only an opportunity, but a necessity.
- 1 September 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 19308876,p. 1-3
5G wireless communication beyond 2020
In the last twenty years we have seen a revolution comparable to the industrialization. We have gone from voice, to data, to mobile broadband to a situation where half of the two-year olds in Sweden use internet. We have changed how we are creating and sharing knowledge, how we interact with family and friends, how we work and how we do business. We have seen traditional industries transform... music, media ... and how more and more industries are rapidly digitalizing and mobilizing - realizing the need for good ICT solutions where mobility is becoming not only an opportunity, but a necessity.
- 1 September 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-3
5G wireless communication beyond 2020
In the last twenty years we have seen a revolution comparable to the industrialization. We have gone from voice, to data, to mobile broadband to a situation where half of the two-year olds in Sweden use internet. We have changed how we are creating and sharing knowledge, how we interact with family and friends, how we work and how we do business. We have seen traditional industries transform... music, media ... and how more and more industries are rapidly digitalizing and mobilizing - realizing the need for good ICT solutions where mobility is becoming not only an opportunity, but a necessity.
- 1 September 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-3
5G wireless communication beyond 2020
In the last twenty years we have seen a revolution comparable to the industrialization. We have gone from voice, to data, to mobile broadband to a situation where half of the two-year olds in Sweden use internet. We have changed how we are creating and sharing knowledge, how we interact with family and friends, how we work and how we do business. We have seen traditional industries transform... music, media ... and how more and more industries are rapidly digitalizing and mobilizing - realizing the need for good ICT solutions where mobility is becoming not only an opportunity, but a necessity.