Teng Howe Cheng
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Teng Howe Cheng has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Yee Mei Heong
Tun Hussein Onn University of Malaysia
2 shared publications B. C. Kok
Universiti Tun Hussein Onn Malaysia
1 shared publicationC. Uttraphan
Universiti Tun Hussein Onn Malaysia
1 shared publicationChessda Uttraphan
Universiti Tun Hussein Onn Malaysia
1 shared publicationKok Boon Ching
Universiti Tun Hussein Onn Malaysia
1 shared publicationNoor Mazliza Badrul Shah
Faculty of Electrical and Electronic Engineering, FKEE, Universiti Tun Hussein Onn Malaysia, Batu Pahat, Johor, Malaysia
1 shared publication
Latest Publications
- Open Access
- 1 June 2020
- Published by Institute of Advanced Engineering and Science in Indonesian Journal of Electrical Engineering and Computer Science
- Vol. 18 (3) , 1163-1171
Electrical energy production from plant biomass: an analysis model development for Pandanus Amaryllifolius plant microbial fuel cell
Plant microbial fuel cell (P-MFC) is an electrochemical reactor that converts organic compounds to electrical energy through the catalytic reaction from electrochemically active bacteria (EAB). However, there is no sign of an attempt in developing the functional model in predicting the energy conversion and utilization of P-MFC. In this study, an analytic model is proposed to show the whole production process of the organic compound to electrical energy generation. Pandanus Amaryllifolius plant was used as sources of photosynthate, where biomass product from rhizodeposition, acetate was produced, and soil bacteria as the microbial culture, and air as the input to the cathode chamber. The proposed analytical model is able to predict the output of the P-MFC using the parameters from the experiment. The generated data from the model was then compared with the monitored data from the Pandanus Amaryllifolius P-MFC. The results show the electrical power output has a high similarity pattern with the bacterial growth curve model and able to achieve the coulombic efficiency of 95.32%.
- 1 June 2020
- Published by Institute of Advanced Engineering and Science in Indonesian Journal of Electrical Engineering and Computer Science
- Vol. 18 (3) , 1163-1171
Open AccessElectrical energy production from plant biomass: an analysis model development for Pandanus Amaryllifolius plant microbial fuel cell
Plant microbial fuel cell (P-MFC) is an electrochemical reactor that converts organic compounds to electrical energy through the catalytic reaction from electrochemically active bacteria (EAB). However, there is no sign of an attempt in developing the functional model in predicting the energy conversion and utilization of P-MFC. In this study, an analytic model is proposed to show the whole production process of the organic compound to electrical energy generation. Pandanus Amaryllifolius plant was used as sources of photosynthate, where biomass product from rhizodeposition, acetate was produced, and soil bacteria as the microbial culture, and air as the input to the cathode chamber. The proposed analytical model is able to predict the output of the P-MFC using the parameters from the experiment. The generated data from the model was then compared with the monitored data from the Pandanus Amaryllifolius P-MFC. The results show the electrical power output has a high similarity pattern with the bacterial growth curve model and able to achieve the coulombic efficiency of 95.32%.
- Open Access
- 1 April 2020
- Published by Institute of Advanced Engineering and Science in Bulletin of Electrical Engineering and Informatics
- Vol. 9 (2) , 443-451
Study of yeast and sugar in bio-energy generation
This paper demonstrates a simple and cost-effective bio-energy generation through biochemical reaction between yeast and sugar. Correlation of energy released between baker yeast Saccharomyces cerevisiae concentration and sugar solution concentration can be observed significantly over laboratory works. A certain number of electrons is released during the process of ethanol fermentation, in which sugars are broken down into ethanol and carbon dioxide. Consequently, bio-energy can be captured via two copper rods during the fermentation period from different concentration variables using the principle of microbial fuel cell (MFC). In this case, yeast and sugar have been selected as the concentration variables. The experiment works concluded that higher concentration of sugar solution correlates to the increment of energy output. However, the concentration of sugar beyond 0.6g/ml causes instability of the energy output. At the same time, another considerable limiting factor of the energy output is the area of separation membrane. The overabundance of sugar concentration can lead to adverse effects in harvesting the bio-energy.
- 1 April 2020
- Published by Institute of Advanced Engineering and Science in Bulletin of Electrical Engineering and Informatics
- Vol. 9 (2) , 443-451
Open AccessStudy of yeast and sugar in bio-energy generation
This paper demonstrates a simple and cost-effective bio-energy generation through biochemical reaction between yeast and sugar. Correlation of energy released between baker yeast Saccharomyces cerevisiae concentration and sugar solution concentration can be observed significantly over laboratory works. A certain number of electrons is released during the process of ethanol fermentation, in which sugars are broken down into ethanol and carbon dioxide. Consequently, bio-energy can be captured via two copper rods during the fermentation period from different concentration variables using the principle of microbial fuel cell (MFC). In this case, yeast and sugar have been selected as the concentration variables. The experiment works concluded that higher concentration of sugar solution correlates to the increment of energy output. However, the concentration of sugar beyond 0.6g/ml causes instability of the energy output. At the same time, another considerable limiting factor of the energy output is the area of separation membrane. The overabundance of sugar concentration can lead to adverse effects in harvesting the bio-energy.
- 1 October 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 163-168
Applying of MPPT algorithm in Z source inverter for PV solar generation
In this project, the development of MPPT based on Z-Source single phase inverter using a Raspberry Pi with voltage control is proposed in order to increase and boost the inverter output to be greater than the input solar power. The main features of this system is the ability to control the Raspberry Pi gate signal switching inverter while controlling the duty cycle of the pulse width modulation based on MPPT algorithm. In order to ensure the output voltage can be as maintain as desired, MPPT algorithm will make changes to the duty cycle by tracking to maximum power point (MPPT) of the PV cell, while Proportional (P) controller is used in this system as a controller which functions to make sure the inverter output is equal to the target reference value. The effectiveness of this control strategy is implemented in MATLAB Simulink and verified by experimental results using PI reference 5Vpk, 10Vpk and 15Vpk. It is proved that, the voltage can be corrected and stabilized using these control methods.
- 1 October 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 163-168
Applying of MPPT algorithm in Z source inverter for PV solar generation
In this project, the development of MPPT based on Z-Source single phase inverter using a Raspberry Pi with voltage control is proposed in order to increase and boost the inverter output to be greater than the input solar power. The main features of this system is the ability to control the Raspberry Pi gate signal switching inverter while controlling the duty cycle of the pulse width modulation based on MPPT algorithm. In order to ensure the output voltage can be as maintain as desired, MPPT algorithm will make changes to the duty cycle by tracking to maximum power point (MPPT) of the PV cell, while Proportional (P) controller is used in this system as a controller which functions to make sure the inverter output is equal to the target reference value. The effectiveness of this control strategy is implemented in MATLAB Simulink and verified by experimental results using PI reference 5Vpk, 10Vpk and 15Vpk. It is proved that, the voltage can be corrected and stabilized using these control methods.